利用白云石石灰去除与回收污泥厌氧消化液中氮和磷

以白云石石灰为实验材料去除与回收污泥厌氧消化液中的氮磷,通过小试实验研究不同投药固液比S/L、初始pH值、反应温度、搅拌速度及反应时间对去除与回收氮磷效果的影响。实验结果表明,在最佳投药固液比S/L为300mg/L,最佳初始pH值范围为8.5~9.5,反应温度为25.0℃,搅拌速度为150 r/min,反应时间为24 h条件下,氨氮(NH+4-N)和磷(PO3-4-P)的去除率分别为37.26%和89.60%。利用X射线衍射仪(XRD)、扫描电镜(SEM)对沉淀产物进行了表征,通过分析可知沉淀产物中含有磷酸铵镁(MAP),可实现废水中氮磷经济有效的回收。     

Hydrothermal liquefaction phase behavior of microalgae & model compounds in fused silica capillary reactor

A fused silica capillary reactor combined with a heating/cooling stage, a microscope and a digital camera were used to investigate phase behavior during the hydrothermal liquefaction of microalgae (Dunaliella tertiolecta) and model compounds, including soya protein and glycine, starch, glucose and xylose, stearic acid and palmitic acid. Bubbles were generated at 246°C and disappeared at 360°C upon heating when Dunaliella tertiolecta used as feedstocks. Moreover, liquid products were generated at 300°C upon heating and oily liquid products began to separate out at 250°C upon cooling. The phase behavior of soya protein was similar to that of the Dunaliella tertiolecta. Meanwhile, there only observed the bubbles generation during hydrothermal liquefaction of glycine. Heating the starch, glucose and xylose above 350°C generated black solids from carbonization. Stearic acid and palmitic acid only had the process of melting, dissolution, dispersion and precipitation.     

As（V）在金红石TiO2颗粒表面吸附特性及机理

通过静态动力学和热力学吸附实验，研究了温度、共存离子以及溶质的初始浓度对As（V）在金红石TiO2颗粒表面吸附的影响，探讨了As（V）在金红石TiO2颗粒表面吸附特性及机理。结果表明，在As（V）初始浓度为10mg／L，pH为7的条件下，25℃时的吸附量0．41mg／g高于30℃时的吸附量0．31mg／g，As（V）在金红石TiO，上的吸附为放热过程。CaCl2和MgCl2的添加对As（V）在金红石TiO2表面吸附起到明显的促进作用。T=25℃，Ca2＋或Mg2＋浓度为10mmol／L时，As（V）吸附量分别为0．64和0．56mg／g，Ca2＋比Mg2＋对As（V）吸附促进作用强。As（V）在金红石TiO2的吸附等温线符合Frendlich方程，Lagergren二级动力学方程能较好地描述As（V）在金红石TiO2颗粒表面吸附的动力学过程。     

臭氧氧化法降解聚氯乙烯离心母液废水中3种有机物

以聚氯乙烯离心母液废水中含量较高的3种有机物(聚乙烯醇、异辛醇和α-甲基苯乙烯)作为目标物,考察臭氧氧化工艺对3种有机物的去除效果,同时考察反应时间、臭氧投加量和初始pH对处理效果的影响。实验结果表明,臭氧氧化处理3种废水的最佳反应时间和臭氧投加量分别为:聚乙烯醇25 min,136 mg/L;异辛醇60min,312 mg/L;α-甲基苯乙烯60 min,32 mg/L。在此条件下,3种有机物的去除率分别为98%、85%和95%。此外,碱性条件有助于臭氧氧化工艺对3种有机物的降解。产物分析结果表明,经臭氧氧化,聚乙烯醇断链后进一步反应生成了草酸单乙酯,异辛醇和α-甲基苯乙烯分别生成了和苯乙酮。     

国产多核处理器芯片TDBI技术研究

随着集成电路的功能越来越复杂,超大规模集成电路的动态老炼越来越成为一项困难的工作。传统针对超大规模集成电路的老炼多采用静态老炼方法,这种方法不能使电路内部的功能节点动作起来,无法保证老炼效果,因此能够实现电路内部所有功能模块全动态激励的TDBI技术越来越受到人们的关注。本文以国产多核处理器芯片为测试对象,为研究多核处理器芯片的TDBI方法进行了芯片老炼测试软硬件系统开发,解决了多核处理器老炼中大功率电源供电、图形存储空间不足等关键技术。     

Effect of fipronil on biogas production performance during anaerobic digestion of chicken manure and corn straw

Fipronil is a broad-spectrum insecticide that has a good control effect on pests of commercial poultry. Although many studies have reported the environmental fate of fipronil, the influence of residual fipronil in poultry waste on biogas production has not been further explored yet. In this article, an experimental comparative study on anaerobic digestion (AD) of chicken manure (CM) and corn straw (CS) with different fipronil concentrations (FCs) was carried at 8% of total solid (TS) and mid-temperature (35?±?1)°C. The results showed that fipronil had a significant effect on biogas production during AD of CM and CS. When the FC is at a low level (≤10?mg·kg^?1), the biogas production rate is increased and the digestion period was shortened, while higher FC (≥ 20?mg·kg^?1) showed an inhibitory effect. During the monitoring of enzyme activity, low FC showed no significant effect on cellulase and saccharase, but the urease activity increased in the early stage. High FC showed inhibition of activity of cellulase and urease, but the saccharase activity was significantly inhibited until FC reached 40?mg·kg^?1. This study also confirms that the environment in anaerobic digester is favorable for the degradation of fipronil, and its half-life is about 15.83?days.     

干式厌氧消化过程挥发酸对硫酸盐还原菌的影响

在牛粪干式厌氧消化过程中,通过添加不同挥发酸(乙酸、丙酸、丁酸),考察消化稳定阶段,挥发性脂肪酸的分布特征,挥发性脂肪酸酸组成变化对硫酸盐还原菌(SRB)的影响,微生物种群组成和种群间关系。实验结果表明,挥发性脂肪酸对SRB还原速率的贡献依次为:丙酸丁酸乙酸。相比乙酸和丁酸,添加一定量的丙酸,更有利于激活SRB的活性,从而加强SRB与产甲烷菌(MB)的种间协同,保证厌氧系统的稳定运行。     

Mg3MnxAl1-xCO3类水滑石衍生NSR催化剂的制备及其性能评价

采用共沉淀法合成了三元类水滑石Mg_3Mn_xAl_(1-x)CO_3,通过高温煅烧得到其衍生氧化物Mg_3Mn_xAl_(1-x)O_m,再经浸渍负载Pt或BaO后制得新型NO_x存储/再还原(NSR)催化剂。XRD及SEM表征结果显示,当Mn与Al的摩尔比(Mn/Al)大于1时所制备的Mg_3Mn_xAl_(1-x)O_m有杂晶相出现且发生团聚,结合NO_x存储性能评价结果,确定最优Mn/Al为1。BaO负载不利于NO_x的存储,而当Pt负载量为1%(w)时NO_x存储性能最优,250℃条件下的存储量由负载前的0.52 mmol/g提升至0.61 mmol/g。CO_2与NO_x之间存在较强的竞争吸附。负载1%Pt催化剂的NSR性能评价结果表明,8个稀燃-富燃循环后NO_x的去除率为68%,表明催化剂的还原性能仍需加强。     

Emergency shutdown of fluidized bed reaction systems

With several industrial applications of fluidized bed technology recently commercialized worldwide, it becomes essential to develop safe operation methods for fluidized bed reaction systems (FBRSs) to prevent any influence on their process values, which lead to accidents. To preventing any disaster or malfunction in an FBRS, an emergency shutdown system (ESD) is initiated, closing the reaction system in case of any abnormality by effectively isolating the flammable gas. However, an ESD is also prone to the “inactivation problem,” in which in the case of failure it initiates the emergency shutdown, even when the operating conditions of the reaction system are abnormal. It is also vulnerable to a “malfunction problem,” where the emergency shutdown is performed even when the operating conditions of the reaction system are normal. In this study, these problems were solved by investigating a reaction system through the monitoring of appropriate parameters and setting up of trigger levels, which reflect the uniqueness of an FBRS using an ESD. The parameters were identified by analyzing the scenario leading to an accident. The trigger levels were determined as the points at which the loss is smaller in the presence of an ESD, as compared to the value of the loss function in the presence or absence of an ESD. Furthermore, the ESD design model was applied as a case study in the ammoxidation process of propylene. The results showed that an ESD can prevent an approximately 8 billion yen of loss due to accidents in plant operations, against an investment of 200 million yen.     

Degradation of polyacrylamide (PAM) and methane production by mesophilic and thermophilic anaerobic digestion: Effect of temperature and concentration

• PAM degradation in thermophilic AD in comparison with mesophilic AD. • PAM degradation and its impact on thermophilic and mesophilic AD. • Enhanced methane yield in presence of PAM during thermophilic and mesophilic AD. • PAM degradation and microbial community analysis in thermophilic and mesophilic AD. Polyacrylamide (PAM) is generally employed in wastewater treatment processes such as sludge dewatering and therefore exists in the sludge. Furthermore, it degrades slowly and can deteriorate methane yield during anaerobic digestion (AD). The impact or fate of PAM in AD under thermophilic conditions is still unclear. This study mainly focuses on PAM degradation and enhanced methane production from PAM-added sludge during 15 days of thermophilic (55°C) AD compared to mesophilic (35°C) AD. Sludge and PAM dose from 10 to 50 g/kg TSS were used. The results showed that PAM degraded by 76% to 78% with acrylamide (AM) content of 0.2 to 3.3 mg/L in thermophilic AD. However, it degraded only 27% to 30% with AM content of 0.5 to 7.2 mg/L in mesophilic AD. The methane yield was almost 230 to 238.4 mL/g VSS on the 8th day in thermophilic AD but was 115.2 to 128.6 mL/g VSS in mesophilic AD. Mechanism investigation revealed that thermophilic AD with continuous stirring not only enhanced PAM degradation but also boosted the organics release from the sludge with added PAM and gave higher methane yield than mesophilic AD.