湿式旋流弦切除尘器性能实验研究

旋流弦切除尘器作为一种新型湿式除尘器,具有良好的特性。本文在所建立的实验系统上,按湿式除尘性能测试的相关规范,研究了除尘风速、弦切速度与除尘器效率和压力损失间的关系。实验结果显示:在液气比为定值时(0.05 L/m~3),在实验风速范围内,除尘效率存在极值;压力损失符合流体力学的局部阻力规律,并拟合出了除尘器的局部阻力系数。     

黄水为碳源的颗粒污泥除磷机理研究

颗粒污泥作为近年来备受关注的一种生物处理技术,具有结构密实、沉降性好、生物相丰富且活性高等优点。为了了解好氧颗粒污泥除磷机理,以黄水为碳源的同步脱氮除磷颗粒污泥为研究对象,研究颗粒污泥的物理特性、除磷特性,重点研究颗粒污泥中磷的形态及含量,同时研究不同方法对颗粒污泥胞外聚合物(EPS)的提取效果及其对磷去除的影响,揭示该颗粒污泥的除磷机理,为城市污水利用同步脱氮除磷颗粒污泥实现高效低耗除磷提供理论与技术支持。     

某炼铁厂炉顶除尘系统的风量调整与仿真分析研究

某炼铁厂炉顶除尘设备运行中各吸尘点风量失衡,造成除尘系统不能发挥应有的作用.通过对除尘系统各吸尘点风量及阻力、除尘器性能、风机性能等参数进行测试,并利用Fluent对系统内流场分布进行仿真与评估、对系统阻力平衡点进行分析,重新调整各个调节阀的开度,优化系统各吸尘点风量分布.调整后,不仅使系统达到现有条件下最佳除尘效果,而且找出了除尘系统设计及运行缺陷,提出了可行的解决方案.     

粒径控制对好氧颗粒污泥处理高含氮废水的影响

采用序批式反应器(SBR),以不同的缺氧搅拌时长来控制颗粒污泥粒径,探究不同粒径的好氧颗粒污泥系统对高浓度氨氮废水的处理特性。研究表明不同控制策略下的4个反应器(R1~R4)分别得到的主要粒径分布为0.4~0.6,0.6~0.8,0.6~0.8,1.0~1.2 mm;系统稳定阶段氨氮平均去除率分别为83.6%、79.4%、77.7%和73.1%。此外,好氧颗粒污泥系统处理高氨氮废水时,颗粒粒径最小的反应器(R1)在氨氮、总氮和磷酸盐方面具有较好的去除效果,但其颗粒污泥的物化性能并没有体现出较高优势。     

A~3/O-MBR工艺反硝化除磷性能研究

为探究自行设计的A~3/O-MBR工艺脱氮除磷性能,以模拟生活污水为处理对象,重点研究了在内循环回流比(γ)为100%,硝化液回流比(α)分别为100%、200%、300%条件下系统反硝化除磷特性。结果表明:缺氧II区是工艺反硝化除磷的关键,系统具有优良的同步脱氮除磷效果,ρ(COD)出水均低于50 mg/L。当回流比为200%时,系统对TN、TP去除效果最好,平均去除率分别为75.46%和88.94%,出水平均ρ(TN)、ρ(TP)分别为14.97 mg/L和0.48 mg/L。通过静态释/吸磷试验测定不同硝化液回流比条件下反硝化聚磷菌占总聚磷菌的比例及污泥含磷量,当回流比为200%时,反硝化聚磷菌所占比例最高达95.47%,该回流比条件下缺氧II区污泥含磷量最高为23.07 mg/L,最大吸磷量为0.2136 g/d。     

Hp-β-环糊精包络臭氧氧化去除水中PPCPs研究

为提高臭氧的稳定性,采用臭氧化Hp-β-环糊精溶液的方法对臭氧进行包络。考察了臭氧/Hp-β-环糊精包络物的氧化特性,臭氧化量和Hp-β-环糊精浓度对臭氧/Hp-β-环糊精包络物氧化能力的影响,并研究了臭氧/Hp-β-环糊精包络物对二级出水中添加的10种药品和个人护理用品(PPCPs)的去除效果。结果表明:臭氧/Hp-β-环糊精包络物具有持续的氧化能力,增加臭氧化量或Hp-β-环糊精浓度可显著提升臭氧/Hp-β-环糊精包络物的氧化能力。臭氧/Hp-β-环糊精包络物有较强的氧化性;向0.7 g/L的Hp-β-环糊精溶液中通入6 mg臭氧后,PPCPs的去除率为50%~70%,去除率受PPCPs分子结构影响。臭氧/Hp-β-环糊精包络物氧化可与其他氧化技术联合应用于污染物去除或用作臭氧化后的持续氧化。     

透水混凝土铺装各层对径流污染物的削减试验研究

通过使用人工模拟降雨装置和路面装置,试验研究了径流污染物在透水混凝土路面各结构层的去除情况。结果表明,透水混凝土面层和多孔隙水泥稳定基层对污染物的去除率分别为30%~50%、15%~30%,而级配碎石基层对污染物的去除率不足10%。据分析主要原因为透水混凝土面层和多孔隙水泥稳定基层为多孔介质,并含有水泥,由于水泥自身特性,污染物通过截留过滤、物理和化学吸附以及生物作用被去除。通过阐明各结构层除污的情况为透水混凝土的应用提供了理论依据。     

Simultaneous denitrification and denitrifying phosphorus removal in a full-scale anoxic–oxic process without internal recycle treating low strength wastewater

Performance of a full-scale anoxic-oxic activated sludge treatment plant(4.0×10~5 m~3/day for the first-stage project) was followed during a year.The plant performed well for the removal of carbon,nitrogen and phosphorus in the process of treating domestic wastewater within a temperature range of 10.8℃ to 30.5℃.Mass balance calculations indicated that COD utilization mainly occurred in the anoxic phase,accounting for 88.2% of total COD removal.Ammonia nitrogen removal occurred 13.71% in the anoxic zones and 78.77% in the aerobic zones.The contribution of anoxic zones to total nitrogen(TN) removal was 57.41%.Results indicated that nitrogen elimination in the oxic tanks was mainly contributed by simultaneous nitrification and denitrification(SND).The reduction of phosphorus mainly took place in the oxic zones,51.45% of the total removal.Denitrifying phosphorus removal was achieved biologically by 11.29%.Practical experience proved that adaptability to gradually changing temperature of the microbial populations was important to maintain the plant overall stability.Sudden changes in temperature did not cause paralysis of the system just lower removal efficiency,which could be explained by functional redundancy of microorganisms that may compensate the adverse effects of temperature changes to a certain degree.Anoxic-oxic process without internal recycling has great potential to treat low strength wastewater(i.e.,TN 35 mg/L) as well as reducing operation costs.     

A nanofilter composed of carbon nanotube-silver composites for virus removal and antibacterial activity improvement

We have developed a new nanofilter using a carbon nanotube-silver composite material that is capable of efficiently removing waterborne viruses and bacteria.The nanofilter was subjected to plasma surface treatment to enhance its flow rate,which was improved by approximately 62%.Nanoscale pores were obtained by fabricating a carbon nanotube network and using nanoparticle fixation technology for the removal of viruses.The pore size of the nanofilter was approximately 38 nm and the measured flow rate ranged from 21.0 to 97.2 L/(min·m~2)under a pressure of 1–6 kgf/cm~2 when the amount of loaded carbon nanotube-silver composite was 1.0 mg/cm~2.The nanofilter was tested against Polio-,Noro-,and Coxsackie viruses using a sensitive real-time polymerase chain reaction assay to detect the presence of viral particles within the outflow.No trace of viruses was found to flow through the nanofilter with carbon nanotube-silver composite loaded above 0.8 mg/cm~2.Moreover,the surface of the filter has antibacterial properties to prevent bacterial clogging due to the presence of 20-nm silver nanoparticles,which were synthesized on the carbon nanotube surface.     

Aerobic N2O emission for activated sludge acclimated under different aeration rates in the multiple anoxic and aerobic process

Nitrous oxide (N₂O) is a potent greenhouse gas that can be emitted during biological nitrogen removal. N₂O emission was examined in a multiple anoxic and aerobic process at the aeration rates of 600 mL/min sequencing batch reactor (SBR_L) and 1200 mL/min (SBR_H). The nitrogen removal percentage was 89% in SBR_L and 71% in SBR_H, respectively. N₂O emission mainly occurred during the aerobic phase, and the N₂O emission factor was 10.1% in SBR_L and 2.3% in SBR_H, respectively. In all batch experiments, the N₂O emission potential was high in SBR_L compared with SBR_H. In SBR_L, with increasing aeration rates, the N₂O emission factor decreased during nitrification, while it increased during denitrification and simultaneous nitrification and denitrification (SND). By contrast, in SBR_H the N₂O emission factor during nitrification, denitrification and SND was relatively low and changed little with increasing aeration rates. The microbial competition affected the N₂O emission during biological nitrogen removal.