Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines

This study investigated the filtration and continuous regeneration of a particulate filter system on an engine test bench, consisting of a diesel oxidation catalyst（DOC） and a catalyzed diesel particulate filter（CDPF）. Both the DOC and the CDPF led to a high conversion of NO to NO2 for continuous regeneration. The filtration efficiency on solid particle number（SPN） was close to100%. The post-CDPF particles were mainly in accumulation mode. The downstream SPN was sensitively influenced by the variation of the soot loading. This phenomenon provides a method for determining the balance point temperature by measuring the trend of SPN concentration.     

Carbonyl emissions from heavy-duty diesel vehicle exhaust in China and the contribution to ozone formation potential

Fifteen heavy-duty diesel vehicles were tested on chassis dynamometer by using typical heavy duty driving cycle and fuel economy cycle. The air from the exhaust was sampled by 2,4- dinitrophenyhydrazine cartridge and 23 carbonyl compounds were analyzed by high performance liquid chromatography. The average emission factor of carbonyls was 97.2 mg/km, higher than that of light-duty diesel vehicles and gasoline-powered vehicles. Formaldehyde, acetaldehyde, acetone and propionaidehyde were the species with the highest emission factors. Main influencing factors for carbonyl emissions were vehicle type, average speed and regulated emission standard, and the impact of vehicle loading was not evident in this study. National emission of carbonyls from diesel vehicles exhaust was calculated for China, 2011, based on both vehicle miles traveled and fuel consumption. Carbonyl emission of diesel vehicle was estimated to be 45.8 Gg, and was comparable to gasolinepowered vehicles （58.4 Gg）. The emissions of formaldehyde, acetaldehyde and acetone were 12.6, 6.9, 3.8 Gg, respectively. The ozone formation potential of carbonyls from diesel vehicles exhaust was 537 mg O3/km, higher than 497 mg O3/km of none-methane hydrocarbons emitted from diesel vehicles.     

Two-step accelerated mineral carbonation and decomposition analysis for the reduction of CO2 emission in the eco-industrial parks

Carbon dioxide（CO2） emissions are a leading contributor to the negative effects of global warming. Globally, research has focused on effective means of reducing and mitigating CO2 emissions. In this study, we examined the efficacy of eco-industrial parks（EIPs） and accelerated mineral carbonation techniques in reducing CO2 emissions in South Korea.First, we used Logarithmic Mean Divisia Index（LMDI） analysis to determine the trends in carbon production and mitigation at the existing EIPs. We found that, although CO2 was generated as byproducts and wastes of production at these EIPs, improved energy intensity effects occurred at all EIPs, and we strongly believe that EIPs are a strong alternative to traditional industrial complexes for reducing net carbon emissions. We also examined the optimal conditions for using accelerated mineral carbonation to dispose of hazardous fly ash produced through the incineration of municipal solid wastes at these EIPs. We determined that this technique most efficiently sequestered CO2 when micro-bubbling, low flow rate inlet gas, and ammonia additives were employed.     

农村沼气在北方农业源减排中的应用浅析

农村沼气作为一种特殊的清洁能源,在沈阳市农村节能减排、应对气候变化和发展低碳经济、促进新农村建设方面发挥了巨大的作用。本文通过对沼气工程在北方地区应用的阐述,力图推动北方农村沼气在农业源减排工作中的应用。     

低温柴油吸收工艺在高温油品储罐罐顶废气净化中的应用

采用罐区减排措施和低温馏分油吸收-脱硫工艺处理高温油品罐罐顶废气,在处理气量43.0~384.5 m3/h,柴油流量10~20 m3/h,吸收柴油温度10~15℃条件下,废气经过净化后,硫化氢和有机硫化物去除率大于97.2%,净化气体非甲烷总烃浓度小于8.35 g/m3,均低于GB20950-2007《储油库大气污染物排放标准》和GB 16297-1996《大气污染物综合排放标准》中相关污染物的限值。     

轻型汽油车CH4和N2O排放因子研究

我国的机动车温室气体排放研究多集中于CO2排放,而CH4和N2O排放的相关研究主要是依据欧美开发的模型进行的,缺乏CH4和N2O实车测试的研究.本研究选取22辆轻型汽油车,利用底盘测功机开展了整车台架测试和采样分析,获得了车辆在NEDC工况下的CH4和N2O排放因子.结果表明,国Ⅰ~国Ⅳ阶段轻型汽油车CH4平均排放因子分别为0.048、0.048、0.038和0.028 g·km-1,N2O则分别为0.045、0.039、0.026和0.021 g·km-1.在轻型汽油车单车排放的CO2、CH4和N2O三类温室气体(以CO2当量计)中,CH4和N2O排放的分担率均随排放标准的加严而逐渐降低,其中CH4排放在温室气体排放中不足0.5%,N2O排放分担率在3.03%~6.35%之间.因此,排放标准的加严可以有效减少CH4和N2O的排放,以减缓机动车排放带来的温室效应.     

京津冀区域生产和消费CO2排放的时空特点分析

区分消费和生产二氧化碳排放是对开放的经济区域进行排放责任划分的基础,日渐受到政策制定者的关注.利用经济投入产出-生命周期分析模型,对京津冀区域1997年、2002年和2007年的消费和生产二氧化碳排放时空特征及二氧化碳排放平衡进行分析.结果表明,京津冀区域消费和生产二氧化碳排放呈约4%的年均增长;贸易隐含二氧化碳排放比例为30%~83%,并以国内贸易隐含二氧化碳排放为主;河北的消费和生产二氧化碳排放占区域主导,增速和二氧化碳排放强度高于北京和天津;京津冀区域为二氧化碳排放净流入区域,存在部分排放责任转移;京津为二氧化碳排放净转入地区,冀为二氧化碳排放净转出地区;京津冀三地二氧化碳排放关键部门分布集中且相似度较高,可以考虑区域联合控制.其中,电力、蒸汽、热水生产和供应业和金属冶炼及压延加工业对二氧化碳排放的依赖性最大,承担较大的其他部门的二氧化碳排放责任.投入产出分析解析了地区生产和消费二氧化碳排放情况,有利于区域减排的精细化管理和制定相应对策,并促进区域减排合作.     

北京典型道路交通环境机动车黑碳排放与浓度特征研究

本研究对2009年北京市典型道路(北四环中路西段)进行实际交通流监测和调研,分析了总车流量、车型构成和平均速度的日变化规律.应用北京机动车排放因子模型(EMBEV模型)和颗粒物黑碳排放的研究数据,计算该路段的黑碳平均排放因子和排放强度.根据同期观测的气象数据,应用AERMOD模型对道路黑碳排放进行了扩散模拟,并根据城市背景站点和道路边站点的监测数据对模拟结果进行了验证.研究表明,该路段黑碳平均排放因子与重型柴油车在总车流中所占比例呈现出极强的相关性,由于北京市实行货车区域限行制度,日间时段总车流的平均黑碳排放因子为(9.3±1.2)mg·km-1·veh-1,而夜间时段上升至(29.5±11.1)mg·km-1·veh-1.全天时均黑碳排放强度为17.9~115.3g·km-1·h-1,其中早(7:00—9:00)晚(17:00—19:00)高峰时段的黑碳排放强度分别为(106.1±13.0)g·km-1·h-1和(102.6±6.2)g·km-1·h-1.基于同期监测数据验证,AERMOD模型的模拟效果较好.模拟时段的道路黑碳排放对道路边监测点的平均浓度贡献为(2.8±3.5)μg·m-3.由于局地气象条件差异,日间和夜间的机动车排放对道路边黑碳的模拟浓度存在显著差异.日间时段,小型客车排放对道路边站点的黑碳浓度贡献最高,达(1.07±1.57)μg·m-3;其次为公交车,达(0.58±0.85)μg·m-3.夜间时段货车比例明显上升,其黑碳排放占主导地位,贡献浓度(2.44±2.31)μg·m-3.     

污水生物处理实际工艺中氧化亚氮的释放：现状与挑战

介绍了污水生物处理过程中N2O的产生途径,重点分析了污水厂典型脱氮工艺的N2O释放差异及其原因,提出了城市污水脱氮处理过程N2O减排的具体措施,并估算出全国城镇污水处理厂2011年N2O释放总量约为1.26×109g(以N计),对今后关于城市污水脱氮处理过程N2O产生及减排的研究趋势进行了评估.     

碳排放现状及驱动因素分解实证分析研究——以东莞市为例

根据IPCC碳排放计算指南核算东莞市2005年-2011年期间能源消费的碳排放量,并进行现状分析和采用对数平均权重分解法（LMDI）因素分解分析.研究结果表明：碳排放总量以5.8％速度增长,而碳排放强度以5.8％速度递减;煤是碳排放主源,但所占比重逐年下降;工业碳排放量比重最大,但是增速减慢;交通业、服务业和居民生活碳排放量及所占比重逐年增加;经济规模的扩大是拉动东莞市人均碳排放的决定因素,累计效应远高于能源效率和能源结构对碳减排影响.