放射性废物桶内干燥整备研究进展

桶内干燥具有很高的减容比,已经逐渐被国外核电站用来处理放射性废液,为我国核电废物贮存和处理提供了一条新的途径。详细介绍了电加热、热风加热和微波加热3种桶内干燥装置的研究应用实例,主要内容包括干燥装置的过程控制、干燥产量(蒸发速率和进料速率)、干燥产物的含水率和减容比。通过分析对比得出,电加热和热空气加热型装置投入产出高,但仅适合流动和传热好的废物整备;微波加热型装置前期投入大,适用却更广,尤其适合底泥等一类含有有机物质的废物。     

铁山港海草生态区水体自净能力与水、生、化之间的关系

利用2008年1月～11月间对铁山港湾海草生态区进行的4个季节全面调查所获取的数据资料,首次探讨了该生态区水体自净能力与水动力特征及生物、化学因子之间的关系。结果表明:研究海区之所以具有较强的水体自净能力,其一与该海区具有强潮型的往复流水动力特征有关,在水体自净过程中起主导控制作用;其二与海区具有适宜的水温、快速的复氧能力、富足的溶解氧(DO)水平、最适合好氧微生物繁殖生长的环境条件有关,明显偏低的总有机碳(TOC)含量和丰富的总氮(TN)储量是有机物获得快速降解、营养盐获得快速再生、化学净化能力较强的重要体现;其三与生物链作用所体现的生化过程影响有关,DO含量与生物因子多呈显著以上负相关的季节变化特征以及三种形态N与生物因子在不同季节显示的相关性以事实佐证了这一点;而富足的TN储量、显著偏低的溶解无机氮(DIN)含量与繁盛的浮游动植物生物量及丰富的生物多样性同时出现的特征,正是研究海区具有较强生物净化能力的综合体现。与化学净化能力相比,生物净化能力显示出更强的优势,具有海草生态区的水体自净特点。     

内循环活性炭生物流化床处理农药生产废水的试验研究

采用内循环活性炭生物流化床反应器处理某农药厂生产废水,通过试验研究了该反应器在室温条件下处理农药生产废水的性能.结果表明:当进水pH值控制在7.0～7.5、水力停留时间为6h、曝气量控制在使活性炭处于流化状态时,CODcr的去除率为50％,总氮的去除率为32.33％,同时可生化性明显提高,生物毒性有所降低.     

序批式移动床生物膜反应器富集反硝化聚磷菌及其在单污泥系统中的应用

本文介绍了在单污泥系统中选择和富集反硝化聚磷菌的国内外研究进展,对不同研究者提出的选择和富集反硝化聚磷菌的方法进行了分析和评价,并提出将反硝化聚磷菌与移动床生物膜反应器工艺结合起来,在序批式移动床生物膜反应器悬浮填料上选择和富集反硝化聚磷菌,进一步认识了反硝化聚磷菌的生化特征,使其成为反应器中优势菌群,以及该工艺今后的研究重点。     

微压流化式复合生物反应器处理含酚废水效能的研究

通过连续动态试验,对新型微压流化式复合生物反应器(MP-FHBR)处理模拟苯酚废水的效能进行研究.结果表明,MP-FHBR的COD容积负荷可达4.86kg/(m3·d)、苯酚容积负荷可达1.96kg/(m3·d),出水COD低于200mg/L、出水苯酚浓度低于1mg/L,COD和苯酚去除率分别达到90%和99%以上.当苯酚容积负荷达到2.04kg/(m3·d),苯酚在反应器中逐渐累积,反应器内微生物的TTC-比脱氢酶活性下降.当MP-FHBR进水苯酚浓度为800mg/L时,最佳水力停留时间为9～10h.水力负荷对反应器沉淀池的泥水分离效果影响较大,限制了反应器的进水量,所以MP-FHBR主要适用于处理较高浓度的含酚废水.     

污水污泥间壁热干燥实验研究

研究了污泥间壁热干燥的工艺过程,分析了其工艺参数、冷凝水水质和产生的污染气体,探讨了有机物水解机理.结果表明,污泥含水率与停留时间呈负指数函数相关.收集到的干燥冷凝水属高浓度有机废水,其总有机碳（TOC）、挥发性有机酸（VFA）和氨氮（NH₃-N）浓度均很高,pH值保持在9～9.5.干燥冷凝水中挥发性有机酸和氨氮来源于2部分：低温110 ～130℃时,主要发生蛋白质的水解,生成有机酸和氨氮;高温140～150℃时,主要发生脂肪类的水解,生成有机酸.干燥温度低于150 ℃时,污泥间壁热干燥过程无污染气体产生.     

Emissions of SO2, NO and N2O in a circulating fluidized bed combustor during co-firing coal and biomass

This paper presents the experimental investigations of the emissions of SO2, NO and N2O in a bench scale circulating fluidized bed combustor for coal combustion and co-firing coal and biomass. The thermal capacity of the combustor is 30 kW. The setup is electrically heated during startup. The influence of the excess air, the degree of the air staging, the biomass share and the feeding position of the fuels on the emissions of SO2, NO and N2O were studied. The results showed that an increase in the biomass shares resulted in an increase of the CO concentration in the flue gas, probably due to the high volatile content of the biomass. In co-firing, the emission of SO2 increased with increasing biomass share slightly, however, non-linear increase relationship between SO2 emission and fuel sulfur content was observed. Air staging significantly decreased the NO emission without raising the SO2 level. Although the change of the fuel feeding position from riser to downer resulted in a decrease in the NO emission level, no obvious change was observed for the SO2 level. Taking the coal feeding position R as a reference, the relative NO emission could significantly decrease during co-firing coal and biomass when feeding fuel at position D and keeping the first stage stoichiometry greater than 0.95. The possible mechanisms of the sulfur and nitrogen chemistry at these conditions were discussed and the ways of simultaneous reduction of SO2, NO and N2O were proposed.     

Anaerobic tapered fluidized bed reactor for starch wastewater treatment and modeling using multilayer perceptron neural network

Anaerobic treatability of synthetic sago wastewater was investigated in a laboratory anaerobic tapered fluidized bed reactor(ATFBR) with a mesoporous granular activated carbon(GAC)as a support material.The experimental protocol was defined to examine the effect of the maximum organic loading rate(OLR),hydraulic retention time(HRT),the efficiency of the reactor and to report on its steady- state performance.The reactor was subjected to a steady-state operation over a range of OLR up to 85.44 kg COD/(m~3.d).The COD removal efficiency was found to be 92% in the reactor while the biogas produced in the digester reached 25.38 m~3/(m~3·d) of the reactor. With the increase of OLR from 83.7 kg COD/(m~3.d),the COD removal efficiency decreased.Also an artificial neural network(ANN) model using multilayer perceptron(MLP)has been developed for a system of two input variable and five output dependent variables. For the training of the input-output data,the experimental values obtained have been used.The output parameters predicted have been found to be much closer to the corresponding experimental ones and the model was validated for 30% of the untrained data.The mean square error(MSE)was found to be only 0.0146.     

辅料配比对污泥生物-物理联合干燥的影响

利用自主研制的污泥生物-物理联合干燥反应系统研究了脱水污泥∶树皮∶回流污泥分别为7∶3∶0.5、9∶3∶0.5和12∶3∶0.5时,污泥生物-物理联合干燥过程中温度、含水率等参数的变化规律.结果表明,污泥温度随干燥时间延长先增大后减小,含水率在0～96 h逐渐降低,继续延长反应时间,则变化不明显.当脱水污泥∶树皮∶回流...     

脱水污泥等温干燥特性实验研究及回归分析

利用热重差热分析仪（DTG）对脱水污泥进行干燥实验,测定干燥参数和干燥条件对脱水污泥等温干燥特性的影响,研究了3个温度水平（85℃,100℃,120℃）,5个空气流速（10mL/min,20mL/min,40mL/min,50mL/min,70mL/min）和3个升温速率（15℃/min,20℃/min,40℃/min）。结果表明,样品的干燥速率随着终温的升高、升温速率和空气流速的增大而加快。脱水污泥的干燥过程主要分为加速、恒速和降速3个阶段,且降速干燥段在整个干燥过程中所占的比例较大。其干燥数学模型符合Page方程,经拟合得到 。验证表明,拟合方程算得的MR值与实验结果比较接近。该模型方程可用于描述城市污水污泥的干燥。