Transport of copper as affected by titania nanoparticles in soil columns

The effects of TiO₂ nanoparticles on the transport of Cu through four different soil columns were studied. For two soils (HB and DX), TiO₂ nanoparticles acted as a Cu carrier and facilitated the transport of Cu. For a third soil (BJ) TiO₂ nanoparticles also facilitated Cu transport but to a much lesser degree, but for a fourth soil (HLJ) TiO₂ nanoparticles retarded the transport of Cu. Linear correlation analysis indicated that soil properties rather than sorption capacities for Cu primary governed whether TiO₂ nanoparticles-facilitated Cu transport. The TiO₂-associated Cu of outflow in the Cu-contaminated soil columns was significantly positively correlated with soil pH and negatively correlated with CEC and DOC. During passage through the soil columns 46.6-99.9% of Cu initially adsorbed onto TiO₂ could be “stripped” from nanoparticles depending on soil, where Cu desorption from TiO₂ nanoparticles increased with decreasing flow velocity and soil pH.     

Determination of ammonium on an integrated microchip with LED-induced fluorescence detection

A simply fabricated microfluidic device integrated with a fluorescence detection system has been developed for on-line determination of ammonium in aqueous samples. A 365-nm light-emitting diode (LED) as an excitation source and a minor band pass filter were mounted into a polydimethylsiloxane (PDMS)-based microchip for the purpose of miniaturization of the entire analytical system. The ammonium sample reacted with o-phthaldialdehyde (OPA) on-chip with sodium sulfite as reducing reagent to produce a fluorescent isoindole derivative, which can emit fluorescence signal at about 425 nm when excited at 365 nm. Effects of pH, flow rate of solutions, concentrations of OPA-reagent, phosphate and sulfite salt were investigated. The calibration curve of ammonium in the range of 0.018-1.8 μupg/mL showed a good linear relationship with R² = 0.9985, and the detection limit was (S/N = 3) 3.6 × 10^-4 μupg/mL. The relative standard deviation was 2.8% (n = 11) by calculating at 0.18 μupg/mL ammonium for repeated detection. The system was applied to determine the ammonium concentration in rain and river waters, even extent to other analytes fluorescence detection by the presented device.     

运用三维荧光光谱解析高温厌氧产氢反应过程对温度变化的响应

为建立反应器运行状态的荧光光谱快速监测方法,应用三维荧光光谱表征了高温厌氧反应器的出水,采用平行因子分析方法分析后得到3种荧光组分——蛋白质、辅酶NADH和核黄素,并获得它们的激发发射光谱图及相对浓度.结果表明,当温度从50 ℃上升到60 ℃的过程中,3种荧光物质的相对浓度均呈现相应的变化,它们与反应器的运行参数呈现明显相关性.进一步研究表明,核黄素是高温厌氧产氢反应中的特有荧光物质,采用标准加入法和二阶校正方法可以测定其实际浓度,出水中核黄素浓度变化范围为0.04~0.13 mg·L^-1.该研究为厌氧产氢反应器的运行监控提供了理论基础.     

山东临沂市集体林权改革环境影响调查研究—以小山口村、魏城村和南垛庄铺为例

本文选取小山口村、魏城村和南垛庄铺三个林权改革试点村作为调查对象,通过描述统计、交叉列联表分析和Ridit分析,就林权改革的方式、林改对经济和环境产生的影响及林权流转三个方面的问题对山东临沂市的集体林权制度改革现状展开调查研究。分析发现,在历经3年的林改中,临沂市始终坚持尊重实际、区别对待,灵活选择林权改革的方式,使当地的林权制度改革受到村民的欢迎。此外,林权改革后,当地的经济收入和生态环境及对林业的投入均有不同程度的提高和改善,村民的营林、护林积极性也大大增加。但是在涉及到林权流转方面的问题时,大部分的村民不能清楚认识到林权的价值,从而使落实处置权的目标短期内难以实现。     

重金属离子与依诺沙星相互作用的荧光光谱法研究

荧光分析法是利用物质的荧光性质对物质进行分析的方法,文章应用荧光法研究了不同温度下重金属离子Cu2+、Pb2+及Mn2+与喹诺酮类药物依诺沙星(ENX)的相互作用。结果表明:Cu2+、Pb2+及Mn2+对ENX内源荧光的猝灭机制属于形成复合物所引起的静态猝灭,利用Stern-Volmer关系式计算了ENX与重金属离子Cu2+、Pb2+及Mn2+之间的猝灭常数KSV及结合位点数,根据热力学参数(自由能变ΔG、焓变ΔH、熵变ΔS)确定了ENX与重金属离子之间的主要作用力类型为静电作用力。该研究为探讨环境中重金属离子与ENX的作用机理和环境效应提供了理论依据。     

Biological sulfate removal from acrylic fiber manufacturing wastewater using a two-stage UASB reactor

A two-stage UASB reactor was employed to remove sulfate from acrylic fiber manufacturing wastewater. Mesophilic operation (35±0.5℃) was performed with hydraulic retention time (HRT) varied between 28 and 40 hr. Mixed liquor suspended solids (MLSS) in the reactor was maintained about 8000 mg/L. The results indicated that sulfate removal was enhanced with increasing the ratio of COD/SO₄^2-. At low COD/SO₄^2-, the growth of the sulfate-reducing bacteria (SRB) was carbon-limited. The optimal sulfate removal efficiencies were 75% when the HRT was no less than 38 hr. Sulfidogenesis mainly happened in the sulfate-reducing stage, while methanogenesis in the methane-producing stage. Microbes in sulfate-reducing stage performed granulation better than that in methane-producing stage. Higher extracellular polymeric substances (EPS) content in sulfate-reducing stage helped to adhere and connect the flocculent sludge particles together. SRB accounted for about 31% both in sulfate-reducing stage and methane-producing stage at COD/SO₄^2- ratio of 0.5, while it dropped dramatically from 34% in sulfate-reducing stage to 10% in methane-producing stage corresponding to the COD/SO₄^2- ratio of 4.7. SRB and MPA were predominant in sulfate-reducing stage and methane-producing stage respectively.     

兰州市大气颗粒物多环芳烃的恒能量同步荧光光谱特征研究

通过传统单波长激发/发射荧光光谱法与恒能量同步荧光光谱法进行对比,对大气颗粒物中多环芳烃(PAHs)进行了定性定量分析,采用恒能量同步荧光光谱法在不同能量差下建立了15种典型PAHs成分的恒能量同步荧光法的标准谱库.在各PAHs在最佳能量差下进行定量分析,结果表明,除苊荧光信号响应较差外,其余PAHs的LOD和LOQ分别为0.0580～3.18、0.232～12.7 ng·mL~(-1).15种PAHs的空白和一定浓度下的加标回收率范围在82.8%～120.0%,相对标准偏差范围在0.51%～5.87%之间,以恒能量同步荧光光谱进行了兰州地区大气颗粒物中15种PAHs分布特征分析.     

番茄光合荧光特性及其镉吸收对土壤镉污染的响应

为探究番茄（Lycopersicon esculentum Mill.）对镉污染的修复潜力,采用土壤盆栽试验方法,研究了在土壤镉施加含量为2,4,8,16,24,48mg/kg条件下,番茄生长、光合荧光特性及其镉吸收响应特点.结果表明,在土壤中施加镉含量大于8mg/kg时,番茄叶片叶绿素含量、光合性能和荧光参数,以及生物量显著低于没有施加镉的对照（P<0.05）,表现出较强的Cd敏感性.同时,在所有镉处理中,番茄叶片对镉的富集系数（2.48~6.60）和转移系数（1.21~3.90）均大于1,表现出较强的富集能力,但经计算其土壤Cd去除率较低.因此,供试番茄品种是Cd的敏感作物,对土壤镉污染修复的潜力较小.     

热障涂层对DD6单晶高温合金高周疲劳性能的影响

目的研究电子束物理气相沉积热障涂层对单晶高温合金高周疲劳性能的影响,为热障涂层在涡轮叶片上的应用提供技术支持。方法采用真空电弧镀和电子束物理气相沉积工艺制备YSZ热障涂层,进行900℃条件下高周疲劳性能测试,采用扫描电镜对测试后的试样表面、断口形貌进行观察与分析。结果在900℃、380 MPa条件下,带涂层的DD6单晶试棒循环次数(Nf)超过了107,420 MPa条件下超过了106。通过对DD6单晶试棒断口分析,失效后的带涂层试棒仍以DD6单晶常见滑移解离形式发生破坏。结论高周疲劳性能测试条件下,带YSZ热障涂层的试棒中粘结层率先产生垂直微裂纹,但是裂纹扩展延伸中发生氧化钝化,之后DD6基体沿正常的滑移方向从表面向内部疲劳扩展,带涂层的试棒疲劳裂纹并非由涂层微裂纹直接扩展形成,热障涂层对DD6单晶高温合金高周疲劳性能影响较小。