Polychlorinated naphthalenes (PCNs) in riverine and marine sediments of the Laizhou Bay area, North China

PCN congeners were analyzed in marine and riverine sediments of the Laizhou Bay area, North China. Concentrations of PCNs ranged from 0.12 to 5.1 ng g⁻¹ dry weight (dw) with a mean value of 1.1 ng g⁻¹ dw. The levels of PCNs varied largely, with industrial group approximately ten folds higher than those of the rural in riverine sediment. A strong impact by direct discharge from local factories was suggested. Similar compositional profiles were found within groups. High resemblance of compositional profiles between industrial samples and Halowax 1014 was observed. It was indicated that PCNs in riverine sediments were mainly from release of industrial usage, with additional contributions from industrial thermal process at certain sites. In marine sediments, it was suggested that PCNs along the coast of Laizhou Bay were mainly controlled by riverine input. While in the central bay, PCN distributions were possibly impacted by combined multiple factors.     

A2O工艺好氧末段溶解氧变化对脱氮除磷影响

采用连续流A2O工艺处理实际的生活污水,研究好氧末段在不同溶解氧(DO)浓度条件下对污泥沉降性能、系统脱氮除磷的影响,同时考察了DO对污泥硝化活性、厌氧释磷速率和反硝化脱氮速率的影响.结果表明,随着末段溶解氧的提高,污泥容积指数SVI从140降至100左右,后又升高到120～170;系统的硝化效果提高,氨氮的去除率从6...     

昌吉州农田地膜污染现状及治理对策

通过对昌吉州农田地膜使用现状进行调查,阐述了地膜污染的危害,并提出了适期揭膜、残膜回收、推广新型生物膜等措施与防治对策。     

无碴轨列车运行引起的环境振动影响评价

对遂渝高速铁路无碴轨道试验段客车运行引起的环境振动进行了现场实测,根据实验数据分析得知:环境振动强度随距离增大而减小,随车速增大而增大,但车厢数量对环境振动强度影响不明显;环境振动主要频率范围为30～120 Hz,距轨道距离、车速、车厢数量对振动主要频率影响不显著;在轨道两侧31.9 m处,速度超过104.7 km/h列车环境振动强度超过GB 10070-1988要求,须采取措施隔振。     

高效氨氧化菌群富集、驯化及其动态变化规律分析

利用选择性培养基对氨氧化菌群进行了连续驯化,得到了氨氮去除效率稳定的氨氧化菌群。采用平板菌落计数法结合聚合酶链式反应-变性梯度凝胶电泳(PCR-DGGE)技术考察了氨氧化菌群在连续传代过程中数量及群落结构的动态变化,并考察了pH值、碳源(HCO3-)浓度和氨氮浓度等因素对氨氧化菌群去除氨氮效率的影响。结果表明,通过连续驯化,氨氧化菌的比例由最初的1.8%提高到了31.3%。在碳源浓度为1.5 mg/L,NH4+-N初始浓度为200 mg/L,pH值为8的条件下,菌群对氨氮的去除率达99%以上。     

一个新的拓扑指数用于芳烃化合物溶解度、分配系数及生物毒性的研究

在分子拓扑理论的基础上，提出了一个新的拓扑指数Yx，并用Yx研究了芳烃化合物的溶解度、分配系数及生物毒(活）性，给出了相关方程。结果表明，新方法计算方便，物理意义明确，预测值与相应的实验值较吻合。     

可靠性理论在公共安全领域的应用研究

对公共安全体系从系统可靠性的视角,综合运用可靠性方面的知识,构建公共安全系统混联模型;进而将可靠性分配理论与故障树分析方法相结合,根据系统安全目标的要求,确定混联系统的第一层次各单元事件的可靠性目标值,对构成各单元的各个下属单元采取最小工作量可靠度分配方法,从而建立系统中各单元可靠度再分配量化模型。通过建筑物火灾引起人员伤亡事故实例,详述系统各单元可靠性分配的计算过程。研究表明,可靠性理论可以成功地应用到公共安全领域;使系统在给定的目标值条件下达到系统的安全性优化,实现了公共安全保障效能,减小灾害损失。     

Cation exchange in a glacial till drumlin at a road salt storage facility

At a former wood preservation plant severely contaminated with coal tar oil, in situ bulk attenuation and biodegradation rate constants for several monoaromatic (BTEX) and polyaromatic hydrocarbons (PAH) were determined using (1) classical first order decay models, (2) Michaelis–Menten degradation kinetics (MM), and (3) stable carbon isotopes, for o-xylene and naphthalene. The first order bulk attenuation rate constant for o-xylene was calculated to be 0.0025 d^− 1 and a novel stable isotope-based first order model, which also accounted for the respective redox conditions, resulted in a slightly smaller biodegradation rate constant of 0.0019 d^− 1. Based on MM-kinetics, the o-xylene concentration decreased with a maximum rate of k_max = 0.1 µg/L/d. The bulk attenuation rate constant of naphthalene retrieved from the classical first order decay model was 0.0038 d^− 1. The stable isotope-based biodegradation rate constant of 0.0027 d^− 1 was smaller in the reduced zone, while residual naphthalene in the oxic part of the plume further downgradient was degraded at a higher rate of 0.0038 d^− 1. With MM-kinetics a maximum degradation rate of k_max = 12 µg/L/d was determined. Although best fits were obtained by MM-kinetics, we consider the carbon stable isotope-based approach more appropriate as it is specific for biodegradation (not overall attenuation) and at the same time accounts for the dominant electron-accepting process. For o-xylene a field based isotope enrichment factor ε_field of − 1.4 could be determined using the Rayleigh model, which closely matched values from laboratory studies of o-xylene degradation under sulfate-reducing conditions.     

Biosorption of nickel(II) from aqueous solution by Aspergillus niger: Response surface methodology and isotherm study

In the present study, the effects of biosorbent Aspergillus niger dosage, initial solution pH and initial Ni(II) concentration on the uptake of Ni(II) by NaOH pretreated biomass of A. niger from aqueous solution were investigated. Batch experiments were carried out in order to model and optimize the biosorption process. The influence of three parameters on the uptake of Ni(II) was described using a response surface methodology (RSM) as well as Langmuir and Freundlich isotherm models. Optimum Ni(II) uptake of 4.82 mg Ni(II) g⁻¹ biomass (70.30%) was achieved at pH 6.25, biomass dosage of 2.98 g L⁻¹ and initial Ni(II) concentration of 30.00 mg L⁻¹ Ni(II). Langmuir and Freundlich were able to describe the biosorption isotherm fairly well. However, prediction of Ni(II) biosorption using Langmuir and Freundlich isotherms was relatively poor in comparison with RSM approaches. The biosorption mechanism was also investigated by using Fourier transfer infrared (FT-IR) analysis of untreated, NaOH pretreated, and Ni(II) loaded A. niger biomass.