德兴铜矿不同年份废石产酸规律研究

矿山选矿废石、尾矿在长期堆积过程中氧化产生的酸性废水会对环境造成严重危害.实验选取德兴铜矿1、5、10和20年废石进行产酸规律研究,静态评价结果显示,4种废石均有产酸潜势,且除1年废石以外均已产酸.为期9个月的动态评价结果表明,4个年份的废石pH均与电导率呈显著负相关,检出离子主要为氟化物、Cu2+、Zn2+、SO2-4、Fe3+.1年废石在整个实验进行中并未产酸,5、10年废石产酸稳定,20年废石产酸缓慢,可推断废石的产酸过程为:不产酸-高速产酸-稳定产酸-产酸速率下降.     

铜氰溶液的电子束辐照降解

研究了铜氰溶液中总氰初始浓度、pH、铜浓度等对总氰降解效率的影响,比较了KCN溶液和铜氰溶液的总氰降解率,初步推断了铜氰溶液在辐照过程中的降解机制.实验结果表明,在同样的辐照剂量下,随着总氰初始浓度的增加,总氰降解率降低,相应的总氰降解G值增大;铜浓度越低,总氰降解率越高;pH越小的铜氰溶液总氰降解率越高.电子束辐照KCN溶液和铜氰溶液的总氰降解反应属于表观一级反应.在相同的辐照剂量下,KCN溶液的总氰降解率比铜氰溶液要高得多.铜氰溶液的电子束辐照降解过程非常复杂,主要是铜氰络合离子逐步离解出的CN-与·OH的反应.     

板材类生物质燃烧及动力学特性热重研究

采用非等温升温法研究了4种板材类生物质在空气气氛下的燃烧特性和动力学特性。通过对TG、DTG等曲线的分析,发现4种板材燃烧过程均可分成3个阶段,即水分蒸发阶段、挥发份析出(或燃烧)阶段和固定碳燃烧阶段。综合燃烧特性:松木集成材>纤维密度板>夹芯胶合板>刨花板。4种板材均具有良好的燃烧特性。4种生物质燃烧均存在1个吸热峰和2个放热峰,分别与挥发分析出峰、挥发分燃烧、固定碳燃烧对应。采用Fridman法和Fridman-Carroll法分别对4种板材的动力学参数进行了计算,2种方法得出的结果符合较好。分析得出:由于生物质燃烧与环境换热、挥发分析出吸热、固定碳燃烧放热等因素作用,4种生物质的表观活化能高温区均低于低温区。动力学计算结果表明:松木集成材平均表观活化能最低,燃烧反应能较容易进行。     

2,4-D Mineralization in soil profiles of a cultivated hummocky landscape in Manitoba,Canada

The objective of this study was to quantify 2,4-D (2,4-dichlorophenoxyacetic acid) mineralization in soil profiles characteristic of hummocky, calcareous-soil landscapes in western Canada. Twenty-five soil cores (8 cm inner diameter, 50 to 125 cm length) were collected along a 360 m transect running west to east in an agricultural field and then segmented by soil-landscape position (upper slopes, mid slopes, lower slopes and depressions) and soil horizon (A, B, and C horizons). In the A horizon, 2,4-D mineralization commenced instantaneously and the mineralization rate followed first-order kinetics. In both the B and C horizons, 2,4-D mineralization only commenced after a lag period of typically 5 to 7 days and the mineralization rate was biphasic. In the A horizon, 2,4-D mineralization parameters including the first-order mineralization rate constant (k ₁), the growth-linked mineralization rate constant (k ₂) and total 2,4-D mineralization at the end of the experiment at 56 days, were most strongly correlated to parameters describing 2,4-D sorption by soil, but were also adequately correlated to soil organic carbon content, soil pH, and carbonate content. In both B and C horizons, there was no significant correlation between 2,4-D mineralization and 2,4-D sorption parameters, and the correlation between soil properties and 2,4-D mineralization parameters was very poor. The k ₁ significantly decreased in sequence of A horizon (0.113% day^?1) > B horizon (0.024% day^?1) = C horizon (0.026% day^?1) and in each soil horizon was greater than k ₂. Total 2,4-D mineralization at 56 days also significantly decreased in sequence of A horizon (42%) > B horizon (31%) = C horizon (27%). In the A horizon, slope position had little influence on k ₁ or k ₂, except that k ₁ was significantly greater in upper slopes (0.170% day^?1) than in lower slopes (0.080% day^?1). Neither k ₁ nor k ₂ was significantly influenced by slope position in the B or C horizons. Total 2,4-D mineralization at 56 days was not influenced by slope positions in any horizon. Our results suggest that, when predicting 2,4-D transport at the field scale, pesticide fate models should consider the strong differences in 2,4-D mineralization between surface and subsurface horizons. This suggests that 2,4-D mineralization is best predicted using a model that has the ability to describe a range of non-linear mineralization curves. We also conclude that the horizontal variations in 2,4-D mineralization at the field scale will be difficult to consider in predictions of 2,4-D transport at the field scale because, within each horizon, 2,4-D mineralization was highly variable across the twenty-five soil cores, and this variability was poorly correlated to soil properties or soil-landscape position.     

Bromination of selected pharmaceuticals in water matrices

The bromination of five selected pharmaceuticals (metoprolol, naproxen, amoxicillin, phenacetin, and hydrochlorothiazide) was studied with these compounds individually dissolved in ultra-pure water. The apparent rate constants for the bromination reaction were determined as a function of the pH, obtaining the sequence amoxicillin > naproxen ? hydrochlorothiazide ≈ phenacetin ≈ metoprolol. A kinetic mechanism specifying the dissociation reactions and the species formed for each compound according to its pK_a value and the pH allowed the intrinsic rate constants to be determined for each elementary reaction. There was fairly good agreement between the experimental and calculated values of the apparent rate constants, confirming the goodness of the proposed reaction mechanism.In a second stage, the bromination of the selected pharmaceuticals simultaneously dissolved in three water matrices (a groundwater, a surface water from a public reservoir, and a secondary effluent from a WWTP) was investigated. The pharmaceutical elimination trend agreed with the previously determined rate constants. The influence of the main operating conditions (pH, initial bromine dose, and characteristics of the water matrix) on the degradation of the pharmaceuticals was established. An elimination concentration profile for each pharmaceutical in the water matrices was proposed based on the use of the previously evaluated apparent rate constants, and the theoretical results agreed satisfactorily with experiment. Finally, chlorination experiments performed in the presence of bromide showed that low bromide concentrations slightly accelerate the oxidation of the selected pharmaceuticals during chlorine disinfection.     

亚超临界水技术在废旧尼龙6解聚中的应用

研究了尼龙6在亚超临界水中的解聚反应,以期为废旧尼龙6的回收利用提供技术参数.实验分别利用气质联用仪和紫外分光光度计对解聚后的液相产物进行定性和定量分析,并考察了不同的反应温度、反应压力和反应时间对液相产物收率的影响.结果表明,液相产物绝大部分为己内酰胺;解聚的最佳条件为370 ℃、25 MPa、60 min;己内酰胺最大收率为96%.通过动力学分析和Arrhenius关系计算,得出尼龙6亚超临界水解聚的活化能为64.4 kJ/mol.     

Degradation kinetics and mechanism of aniline by heat-assisted persulfate oxidation

Oxidation of aniline by persulfate in aqueous solutions was investigated and the reaction kinetic rates under different temperature, persulfate concentration and pH conditions were examined in batch experiments. The results showed that, the aniline degradation followed pseudo first-order reaction model. Aniline degradation rate increased with increasing temperature or persulfate concentration. In the pH range of 3 to 11, a low aniline degradation rate was obtained at strong acid system (pH 3), while a high degradation rate was achieved at strong alkalinity (pH 11). Maximum aniline degradation occurred at pH 7 when the solution was in a weak level of acid and alkalinity (pH 5, 7 and 9). Produced intermediates during the oxidation process were identified using liquid chromatography-mass spectrometry technology. And nitrobenzene, 4-4’-diaminodiphenyl and 1-hydroxy-1,2-diphenylhydrazine have been identified as the major intermediates of aniline oxidation by persulfate and the degradation mechanism of aniline was also tentatively proposed.     

Efficiency and degradation products elucidation of the photodegradation of mefenpyrdiethyl in water interface using TiO2 P-25 and Hombikat UV100

The photodegradation of mefenpyrdiethyl (MFD), an herbicide safener, was investigated in aqueous suspensions by using Degussa P-25 and Hombikat UV100 titanium oxide under simulated sunlight irradiation. The effects of initial concentration of the herbicide, pH, catalysts and hydrogen peroxide doses as well as their combinations were studied and optimized. Accordingly, the kinetic parameters were determined and the effectiveness of the processes was assessed by calculating the rate constants. A pseudo first-order kinetics was observed. Under experimental conditions, the degradation rate constants were strongly influenced using P-25 and no noticeable effect was observed for Hombikat UV100. DFT calculations with B3LYP/6-311+G(2d,p)//B3LYP/6-31+G(d,p) level of theory were performed to check whether significant conformational changes occur when the charge state of the MFD substrate changes and whether these changes could play a role in the dependency of photodegradation rate constant on the studied pH. High resolution mass spectrometry (FT-ICR/MS) was implemented to identify the main degradation products.     

微波催化燃烧气态甲苯特性及床层温度分布

采用浸渍法制备Cu-Mn-Ce/堇青石蜂窝催化剂,于微波催化燃烧装置中考察其对甲苯废气的催化活性与稳定性,并对固定床温度进行了测试分析.研究表明,微波加热下床层温度分布均匀,甲苯的最佳反应温度在230~270℃之间.当停留时间大于9.7s且床层温度高于270℃时,甲苯的降解率大于90%.铜锰铈单金属氧化物及其复合氧化物尖晶石是主要的活性组分,甲苯在其表面上进行准一级反应而被催化氧化.高温对催化剂结构有影响,但重复性试验证实了催化剂的高活性和良好的稳定性.本文为微波催化燃烧技术治理VOCs废气的中试研究及下一步的实际应用提供了理论支持.     

2021年夏季新乡市城区臭氧超标日污染特征及敏感性

基于2021年6～8月新乡市市委党校站点观测的挥发性有机物(VOCs)、常规空气污染物和气象参数,采用基于观测的模型(OBM)对臭氧(O₃)超标日的O₃敏感性和前体物的管控策略进行了研究.结果发现,O₃超标日呈现高温、低湿和低压的气象特征.在臭氧超标日,O₃及其前体物的浓度均有上升.臭氧超标日的VOCs最高浓度组分为含氧挥发性有机物(OVOCs)和烷烃,臭氧生成潜势(OFP)和·OH反应性最大的VOCs组分为OVOCs.通过相对增量反应性(RIR)分析,新乡6月O₃超标日臭氧生成处于VOCs控制区,7月和8月处于VOCs和氮氧化物(NO_x)协同控制区,臭氧生成对烯烃和OVOCs最为敏感.6月各前体物的RIR值在一天中会发生变化,但始终保持为VOCs控制区;7月和8月在上午为VOCs控制区,中午为协同控制区,下午分别为协同控制区和NO_x控制区.通过模拟不同前体物削减情景,结果表明削减VOCs始终有利于管控臭氧,而削减NO_x