装甲钢自然环境试验与人工加速试验的相关性

对某型装甲钢在酸雨大气环境下自然暴露与人工模拟加速试验的相关性进行了研究。利用腐蚀机理对比、Spearman秩相关系数、灰色关联度、加速转换因子等方法进行了相关性的定性定量评价。评价结果表明模拟加速试验与自然环境暴露试验有较好相关性。     

爆炸冲击波作用下靶板的塑性大变形响应研究

对四边约束方形靶板 ,在爆炸冲击波作用下的塑性大变形响应情况 ,进行了理论分析与试验研究。运用能量守恒的方法 ,同时考虑试验过程中靶板的边界约束条件 ,得到了四边约束方形靶板在爆炸冲击波作用下发生塑性大变形时挠度的半经验公式。理论计算与试验结果吻合性较好 ,这种方法可应用于板结构在爆炸冲击波作用下的毁伤或防护方面的工程预测     

QUALITY OF HYDROMETEOROLOGICAL DATA IN COLD REGIONS1

ABSTRACT: Many users of hydrometeorological records are not aware of the number of inconsistencies and biases that occur in hydrometeorological records. Examples are presented illustrating how the exposures of sites for measurement of precipitation, wind, snow on the ground, and evaporation determine to a large extent how useful the records are for estimating areal conditions. For areas where precipitation in the form of snow produces a significant portion of the runoff, a smaller number of quality records may be more valuable for modeling than a much larger number of records of lower quality. Information is presented to show that the overall value of an operational hydrometeorological network is dependent upon how consistent and representative of average conditions the collected records are, especially for mountainous areas in cold regions.     

Comparison of Soil Extraction Isotherms of Soil Samples Saturated With Nonpolar Liquids

In multiphase systems capillary pressures play a significant role on fluid movement and retention. The facility to predict the effect of different thermal remediation strategies requires the knowledge of the effect of temperature on capillary pressure-saturation relationships in the soils. The objective of recent study was (a) to develop a technique for routinely measuring the pressure-saturation curves of soil samples saturated with a nonpolar liquid at different regulated temperatures (b) to build a database using the measured pressure-saturation curves and the physical, chemical properties of the model soils (c) to establish the dependence of nonaqueous phase liquid retention on the soil properties and the temperature. The retention curves (extraction isotherms) with nonaqueous phase liquid were determined using a modified pressure plate extractor. The wetting phase was a non-aromatic hydrocarbon distillation product. Pressure plates were designed and constructed in the laboratory of our department. The temperature was held constant at 20, 40 and 60 ^∘C. Statistical analysis was performed involving selected soil parameters and the measured nonaqueous phase liquid retention data. The results show that knowing some easily measurable soil parameters (bulk density, particle size distribution, humus and lime content) we can estimate the nonaqueous phase liquid retention of the soils. The measured “extraction isotherms” provide essential information about the temperature-dependency of pressure-saturation curves.     

近50年来广东冬季寒害的特征

利用广东省86个地面气象站近50年(1951-2000年)逐日平均气温和最低气温资料,采用针对冬季经济林果的寒害指标,统计分析了近50年冬季寒害的特征.分析得出:(1)广东冬季寒害频数北多南少,各地平均年均1次,其中严重寒害近4成,严重寒害中又以降温型亚类Ⅲ最为典型,占6成以上.(2)寒害过程降温幅度平均达13.6℃,且越往南越大;过程最低气温平均2.6℃,高于冻害临界值0℃;寒害过程降温平均历时4d.(3)寒害分布于10月末至3月底,其中12月到1月累计占85%,月际分布大致呈以1月为峰值的单峰型;亚类Ⅲ12月和2月多于1月,呈双峰分布.(4)1980年是广东冬季气温变化的分水岭,寒害年均综合频数前30年多(160站次),后20年少(96站次).(5)近50年广东冬季寒害年代际变化特征为:50,60,70年代逐渐增强,80年代迅速减弱,90年代有所回升(依然弱于50年代),年代际寒害由强到弱顺序为:70年代,60年代,50年代,90年代和80年代.     

Efficiency enhancement in solar air heaters by modification of absorber plate-a review

This paper outlines a complete review on modifications made on the absorber plate of solar air heaters in order to improve the turbulence and heat transfer rate, thereby efficiency. Corrugated sheets, fins, extended surfaces, wire mesh, porous medium, etc., are a few of the modifications used. Most of such alterations in the absorber plate resulted with an increase in efficiency but associated with drawback of increased pumping power due to raising friction factor. Pumping power is considered here as a predominant comparison parameters of various solar air heaters with different absorber plate in terms of effective efficiency.     

海上含聚污水电化学处理装置的优化

为解决传统电化学方法在含聚污水处理时电极板消耗严重、絮渣量大的问题,通过改进电极板材料、组合数及结构等,研究适度降解-除油一体化电化学技术,在降低渣泥量的同时保证处理效果。实验结果表明:最佳电极板组合为"网状惰性金属复合物极板(阳)-网状铝极板(阴)-网状铝极板(阴)-网状惰性金属复合物极板(阳)";在电解电流为4.0 A、极板间距为8.0 cm、面体比(电极板面积与处理污水量的比值)为2/17 cm~2/mL、电解时间为30 min的最佳处理条件下,几乎无絮渣产出,含聚污水的浊度去除率为93.3%、聚合物降解率为92.0%、除油率为95.0%,展现了优良的处理效果。     

微电解/斜板沉淀/生物接触氧化处理印刷电路板废水

根据某印刷电路板企业生产废水的水质特点,对废水进行分类收集处理后,采用微电解/斜板沉淀/生物接触氧化工艺处理综合废水。工程运行结果表明,该工艺处理效果稳定,出水水质符合《污水综合排放标准》(GB 8978-1996)的一级排放标准。     

青藏高原土壤柴油降解菌的筛选及降解实验研究

青藏高原北麓河地区土壤为典型的低温土壤环境,夏季高温季节表层土壤(5 cm处)温度仅为9℃,中层(20 cm处)为7.5℃,而40 cm处仅为4℃左右。土壤高温季节为7月中旬至9月上旬,而10月至来年6月土壤日平均温度下降为0℃以下。针对青藏高原低温土壤环境,在北麓河试验现场进行人工模拟柴油污染,16个月后采集污染土样,进行土著低温菌的复合筛选,柴油菌的筛选驯化温度为10℃。经过4次转接复合培养驯化后,菌液中微生物数量可达2.7×1012CFU/mL。筛选后的柴油降解菌90%以上为杆状菌,长度为2~3μm,少见球菌,其直径约为0.5μm。通过柴油摇瓶模拟降解实验,17 d后柴油去除率可达到62%。研究为青藏高原低温条件下的土壤柴油污染土著微生物修复提供了研究基础。     

数显型电热板加热法在河流高锰酸盐指数应急监测中的应用研究

高锰酸盐指数常被作为地表水体受有机污染物和还原性无机物质污染程度的综合指标.采用数显型电热板加热法测定水中高锰酸盐指数,通过实验确定了加热时间和加热温度.并分别采用水浴法和电热板加热法对应急样品进行了高锰酸盐指数的测定,两种测定方法的比对研究结果表明,应急监测时采用数显型电热板加热法测定耗时更短,检测结果与国标法测定没有显著差异,是可行且有效的应急监测替代方法.