臭氧氧化法处理焦化废水生化出水的反应动力学

对臭氧氧化去除焦化废水生化出水COD的反应动力学及其影响因素进行了实验研究，结果表明，在臭氧投加量为8．50mg／min，反应温度为20＇E和初始pH为10．61条件下，对COD的降解符合表观一级反应动力学模型，其相关系数R。=0．9991，表观反应速率常数k。。=1．01×10^-3s-1。该条件下，臭氧氧化对COD的降解主要来源于高活性羟基自由基的强氧化作用。在不同的臭氧投加量（4．25～12．75mg／min）、不同的反应温度（10～40℃）和不同的初始pH（3．76～12．53）下，COD的降解也同样遵循一级反应动力学规律。随着臭氧投加量的增大，COD降解的表观反应速率常数从（0．554×10^-3）s-1增加到（1．06×10＆-3）s-1；随着反应温度的升高，表观反应速率常数从（0．427×10^-3）s-1增加到（1．40×10-3）s-1，温度越高反应速率提高的幅度却越小；在初始pH3．76～10．61范围内，表观反应速率常数从（0．218×10^-3）s-1增加到（1．01×10^-3）s-1，在初始pH为12．53时表观反应速率常数下降到（0．857×10^-3）s-1。     

锐钛矿-金红石混合晶型TiO2降解气相苯

用溶胶-凝胶法并通过控制煅烧温度合成不同晶相比的混合晶型纳米TiO_2,在紫外光光照下降解气相苯。考察了苯初始质量浓度、紫外灯光照强度和催化剂加入量对苯去除率的影响;探究了光催化降解气相苯的动力学特征。结果表明:450℃煅烧制备的催化剂降解苯效率最高,此催化剂金红石相质量分数为6.30%;在苯初始质量浓度为74.39 mg/m~3、催化剂加入量为7 g、光照强度为2.18 klux的最佳条件下反应84 min,苯去除率达99.73%;光催化降解率与光照强度之间符合0.5级动力学特征;当催化剂加入量为3 g时,单位时间单位质量催化剂降解苯的质量最多;苯的光催化降解反应均符合一级动力学方程。     

Hazard evaluation for chlorination and amination reactions of fluorocytosine production process

Reaction thermal runaway is one of the most important reasons leading to chemical accidents. With the rapid development of the chemical industry in the world, especially the fine chemical industry, various safety accidents also occur frequently. Therefore, it is necessary to study the exothermic behavior of the reaction process. In this study, reaction calorimeter was used to study the exothermic phenomena during the chlorination reaction and amination reaction. Differential scanning calorimetry was performed on the reactants, and thermogravimetric experiments were performed on the products. In addition, adiabatic experiment was performed to study the thermal runaway behavior of amination products under adiabatic conditions. The results showed that the target reactions generated a large amount of heat in the initial stage. The maximum temperature of amination reaction is higher than the initial decomposition temperature of the amination product under adiabatic condition. The pyrolysis of amination product was divided into three stages. The product had a high apparent activation energy at the beginning of decomposition, and the apparent activation energy decreased as the decomposition progressed.     

Enhanced triallyl isocyanurate (TAIC) degradation through application of an O3/UV process: Performance optimization and degradation pathways

• UV/O₃ process had higher TAIC mineralization rate than O₃ process. • Four possible degradation pathways were proposed during TAIC degradation. • pH impacted oxidation processes with pH of 9 achieving maximum efficiency. • CO₃^2– negatively impacted TAIC degradation while HCO₃^– not. • Cl^– can be radicals scavenger only at high concentration (over 500 mg/L Cl^–). Triallyl isocyanurate (TAIC, C₁₂H₁₅N₃O₃) has featured in wastewater treatment as a refractory organic compound due to the significant production capability and negative environmental impact. TAIC degradation was enhanced when an ozone(O₃)/ultraviolet(UV) process was applied compared with the application of an independent O₃ process. Although 99% of TAIC could be degraded in 5 min during both processes, the O₃/UV process had a 70%mineralization rate that was much higher than that of the independent O₃ process (9%) in 30 min. Four possible degradation pathways were proposed based on the organic compounds of intermediate products identified during TAIC degradation through the application of independent O₃ and O₃/UV processes. pH impacted both the direct and indirect oxidation processes. Acidic and alkaline conditions preferred direct and indirect reactions respectively, with a pH of 9 achieving maximum Total Organic Carbon (TOC) removal. Both CO₃^2– and HCO₃^– decreased TOC removal, however only CO₃^2– negatively impacted TAIC degradation. Effects of Cl^– as a radical scavenger became more marked only at high concentrations (over 500 mg/L Cl^–). Particulate and suspended matter could hinder the transmission of ultraviolet light and reduce the production of HO· accordingly.     

Evaluation of thermal reaction for two azo compounds by using 20-L apparatus and calorimetry

Azo compounds are widely involved in the industrial processes of dyes, pigments, initiators, and blowing agents. Unfortunately, these compounds have a bivalent unstable –NN– composition, which can be readily broken when the ambient temperature is elevated. Self-accelerating decomposition might cause a runaway reaction and lead to a fire, explosion, or leakage when the cooling system fails or other events occur. This study investigated the explosion properties, thermal stability parameters, and thermal hazard and mechanism of 2,2′–azobisisobutyronitrile (AIBN) and 2,2′–azobis–2–methylbutyronitrile (AMBN). We used a 20-L apparatus, vent sizing package 2, synchronous thermal analysis, and differential scanning calorimetry under explosive, adiabatic, and dynamic conditions to acquire the explosive curves, thermal curves, and thermodynamic parameters of the substances. Moreover, the differential isoconversional method (Friedman method) and ASTM E698 equation were employed to obtain the apparent activation energy E_a. All the experimental results revealed that AIBN is more dangerous than AMBN. The E_a of AIBN was lower than that of AMBN. The results can be used to construct an azo compound thermal hazard database for use for searches and reference examples by industry and related research areas.     

Detection of Class I and II integrons for the assessment of antibiotic and multidrug resistance among Escherichia coli isolates from agricultural irrigation waters in Bulacan,Philippines

Contaminated irrigation water may greatly affect not only the quality of produce but also the people exposed to it. In this study, agricultural irrigation waters in Bulacan, Philippines were assessed and found to be contaminated with Escherichia coli (E. coli) ranging from 0.58 to 4.51 log₁₀ CFU/mL. A total of 79 isolates of E. coli were confirmed through polymerase chain reaction (PCR) amplifying the uidA gene and were tested for phenotypic resistance using 10 antimicrobials through the Kirby–Bauer disc diffusion method. Forty-six isolates (58.22%) were noted to be multidrug resistant (MDR) with high resistance rate to cephalothin, tetracycline, streptomycin, ampicillin, trimethoprim, nalidixic acid, and chloramphenicol. Moreover, this study also examined the prevalence of Class I and II integrons accounting to 67.39% and 17.39%, respectively, of the MDR E. coli strains using multiplex PCR. The results imply that the agricultural water used in Bulacan is contaminated with the fecal material of man or other animals present in the area, and the presence of MDR bacteria, which pose a potential threat to individuals in these areas, is alarming. In addition, detection of integrons could be a good marker for the identification of MDR isolates. Lastly, this study could develop strategies for the proper management of farming sites leading to the detection of food-borne pathogens and prevention of infectious diseases.     

油田作业废水高效处理技术中试研究

文章根据新疆油田作业废水特征及油田地处干旱区的地理特点,结合国内外含聚合物污水处理的技术现状,以及油田连续生产稳定运行的要求,在含油污水处理技术的基础上,开展了作业废水处理关键技术研究和工艺优化,采用了"隔油—絮凝气浮—深层过滤"技术。中试试验结果表明:处理后废水COD_(Cr)、石油类、SS可分别由680 mg/L、98.6 mg/L、56.2 mg/L降至98.8 mg/L、5.4 mg/L、4.5 mg/L,去除率分别为85.5%、94.5%、92.0%。     

O3氧化结合化学吸收同时脱硫脱硝的动力学及热力学研究

构建了O3氧化多种污染物的反应机制,并对O3氧化SOx、NOx过程进行动力学模拟,然后利用热力学原理计算出Ca(OH)2和CaCO3湿法烟气同时脱硫脱硝吸收反应达到平衡时SOx和NOx的分压力.结果表明,Ca(OH)2作吸收剂湿法烟气同时脱硫脱硝比CaCO3作吸收剂效果好,而且两者几乎100％地去除烟气中的SOx和NO...     

过硫酸钾去除水中的TCE

以地水中的氯代烃污染物三氯乙烯(TCE)为目标污染物,以过硫酸钾溶液为氧化剂,探讨了不同条件下过硫酸钾对TCE的去除效果。实验结果表明,在40℃,过硫酸钾初始浓度为2.43 g/L条件下,反应2 h后,TCE的去除率就可达到96.8%;过硫酸钾对TCE的去除符合一级反应动力学方程,速率常数(K)为1.3364 h-1,半衰期(t1/2)为0.51 h;过硫酸钾对TCE的去除速率在pH为中性附近时最大,其后无论pH升高或降低去除速率均减小;受温度和pH影响较明显,并且反应温度越高,受pH的影响越明显;随离子强度的增加而减小;反应活化能为119.6 kJ/mol;过硫酸钾溶于水生成过硫酸根离子(S2O28-),S2O28-会进一步生成硫酸根自由基(SO4-.),在碱性条件下,SO4-.与OH-反应会进一步生成羟基自由基(.OH)。过硫酸钾对于TCE的去除主要源自SO4-.和.OH的强氧化性。     

308 nm光作用下α-Fe2O3表面HNO3的光解

采用紫外可见光谱(UV-Vis)、傅立叶变换红外光谱(FTIR)及离子色谱(IC)技术对HNO3在α-Fe2O3表面暗反应和308nm下光解反应进行了研究.考察了时间、HNO3浓度、相对湿度(RH)等条件对反应的影响.结果表明,随着HNO3浓度、光照时间的增加,HNO3在气相与α-Fe2O3表面光解产物浓度均呈指数增加;HNO3在α-Fe2O3表面光解产生的NO2、NO分别为气相产生的3.27及3.87倍,而无论气相还是表面光解的NO2浓度均约为NO的2倍.随着RH的增加,HNO3光解产生的HONO的浓度随之呈指数增大,其产率从RH 20%时的0.023增加到90%时的0.087.α-Fe2O3的表面效应在HNO3的表面光解反应中起主导作用.