Polychlorinated dibenzo p-dioxins and dibenzofurans emissions in a primary copper smelter in China

Metallurgical production is the largest polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/F) emission source in China. However, PCDD/F monitoring and research are rarely conducted on primary metallurgical production. In this study, a demonstration primary copper smelter in China was selected to investigate PCDD/F characteristics and control. Samples were collected from major PCDD/F release points in the smelter process (fly ashes and waste water sludge). Specific analysis of PCDD/F congeners was carried out using a high resolution gas chromatography/high resolution mass spectrometry method. The results showed that PCDD/Fs might be unintentionally produced in the primary copper smelter processes, with sample concentrations of 180–6110 pg/g dry wt; highly chlorinated PCDD/F homologues were predominant. The toxicity of all the samples was calculated to be 120 pg WHO TEQ/g, fly ashes from the refining process furnaces air pollution control device and sludge were hazardous waste with higher PCDD/F toxicity. Both precursor formation and de novo synthesis were found to contribute to PCDD/F formation in the smelter process. PCDD/F characteristics and formation were compared with reported secondary copper smelters. Life-cycle control of PCDD/F was proposed for retrofitting of this smelter and for similar plants in China's primary copper production sector, including control at the PCDD/F formation, removal and disposal stages.     

The Influence of Anthropogenic Contamination On Metals Release From Coastal Sediment Suspensions with Aerated Sea Water

The zinc, cadmium, copper and lead release from the uncontaminated and contaminated coastal sediments with aerated sea water was studied. the metals transfer to the dissolved forms was monitored during one-two months by differential pulse anodic voltammetry (DPASV). the sediments with different initial degree of contamination were sampled in the Peter the Great Bay, Sea of Japan around Vladivostok-the biggest city in Russian Far East. Sediment contamination by metals led to increased release to solution of zinc due to sulphide oxidation and cadmium on account of organic matter decomposition. the copper behaviour was complicated by strong binding with organic matter and enhancements of copper release can only be seen in sediment with a low organic matter content. Significant lead transfer to dissolved forms was not observed regardless of sediment contamination. the temperature affected the release of cadmium and copper through enhanced organic matter destruction. the dissolved metal fluxes from the sediment transformation are compared with metal fluxes towards bottom. Such comparisons show that second contamination by dissolved metals of the studied coastal environment may be important for cadmium only.     

东湖、汤逊湖和梁子湖沉积物磷形态及pH对磷释放的影响

文章采用淡水沉积物中磷形态标准测试程序(SMT)研究了东湖、汤逊湖和梁子湖沉积物中磷的形态分布,并比较了不同pH条件下沉积物磷释放特征的差异性。结果表明:东湖沉积物总磷质量分数最高,平均值1.232 mg.g-1,其次为汤逊湖(0.762mg.g-1),梁子湖沉积物总磷质量分数最低(0.572 mg.g-1);3个湖泊上覆水总磷质量浓度也表现出类似的变化规律,线性相关性分析显示上覆水中总磷质量浓度与沉积物总磷质量分数显著正相关。东湖和梁子湖沉积物总磷中无机磷和有机磷所占比例较接近,汤逊湖无机磷所占比例远低于有机磷。不同湖泊之间磷形态的分布并没有一定的规律性,湖泊的地理分布以及人为因素可能是造成磷形态差异的主要因素。当pH为2.0~7.0时,3个湖泊沉积物中溶解性活性磷(SRP)释放量均呈先增加后减小的趋势;当pH为7.0~12.0时,SRP释放量呈增加趋势。相关分析结果表明,SRP的释放与有机质的质量分数无显著相关性。方差分析结果显示3个湖泊沉积物在黏粒和粉粒组成上均没有显著差异(P>0.1),表明实验样品的粒径组成不是造成各个湖泊间磷释放差异的原因。不同pH条件下,SRP释放量与沉积物总磷质量分数显著正相关;酸性环境下,SRP释放量与酸式磷(HCl-P)的相关性优于碱式磷(NaOH-P),碱性环境下则刚好相反。     

以缓释肥的形式回收污泥溶解液中磷的研究

以聚合硫酸铁(PFS)为絮凝剂,单宁酸为助凝剂回收污泥溶解液中的磷。研究结果表明:在铁盐投加量为160mg/L,pH为8,单宁酸投加量为10 mg/L条件下,磷酸盐的回收率可达到97.0%。单宁酸促进了混凝沉淀物中磷的释放,表明利用该方法回收磷作为缓释肥的可行性。将沉淀物作为缓释磷肥施用于土壤中能够明显促进黑麦草的生长。     

不同硝/铵比值对小麦幼苗根系释放氢氧根的影响

为研发酸化土壤的生物修复技术,采用水培试验和自动电位滴定装置研究酸性条件下氮素形态对小麦幼苗根系释放氢氧根及培养液pH变化的影响。结果表明,小麦幼苗在初始pH值为4.0,n(NO3-)∶n(NH4+)比值(以下简称硝/铵比)分别为15∶1、3∶1和1∶1的营养液中培养6 d后营养液pH升高,且增幅随硝/铵比的增加而增大,小麦对硝态氮的吸收量和氢氧根释放量呈相同的变化趋势,说明小麦对硝态氮的吸收偏好导致根系释放氢氧根,进而使得培养液pH升高。小麦幼苗在硝/铵比为3∶1,初始pH值分别为4.0、4.5和5.0的营养液中培养6d后,培养液pH和氢氧根释放量的增幅随初始pH的升高而降低,说明低pH条件有利于小麦幼苗对硝态氮的吸收,可促进小麦根系释放更多的氢氧根。10 h的恒定pH试验结果表明,恒定pH条件下小麦根系释放的氢氧根数量大于非恒定pH条件,且硝态氮比例越大,差值越大。因此,可以根据小麦在酸性条件下对硝态氮的吸收偏好建立酸化土壤的生物修复方法,即调节硝态氮含量以加大小麦根系的氢氧根释放量,进而提高土壤pH。     

石灰稳定化污泥恶臭物质释放特征研究

利用污泥-石灰高效混合器制备5%、10%、15%石灰添加量的稳定化污泥,应用Jerome 631-X型便携式硫化氢测定仪、静态吸收等试验方法,分别研究了不同石灰添加比例下污泥还原性硫化物(RSCs)和氨(NH3)的释放特征,并对臭度进行了评价.结果表明:污泥中添加石灰后,RSCs体现出缓释特征;石灰稳定化污泥RSCs的释放量下降明显,连续监测380min后,石灰稳定化污泥处理的RSCs产生量相比等质量原泥处理降低了约85%;恒温培养24h,石灰稳定化污泥的NH3释放量(5.03×10-4mol)相比等质量原泥处理(7.00×10-6mol)提高了约72倍,明显促进了污泥氮向氨气的转化和释放.向污泥中添加少量工业石灰,均匀混合条件下,污泥的臭味强度明显降低,基本达到了抑制恶臭的目的.     

pH和有机酸对氟溶出砖红壤中铝离子的影响

研究砖红壤对F-的吸附反应尤其是随后Al3+的释放过程,有助于增进对土壤酸化过程及其环境影响的理解. 在初步揭示出F-吸附反应以及Al3+释放反应的动力学特征基础上,重点考察了pH和有机酸对上述反应的影响. 结果表明:土壤对F-的吸附反应十分迅速,2 min内吸附量即可达到24 h内总吸附量95%,而土壤中不同含铝矿物的溶解度差异使Al3+的释放过程在前15 min十分迅速,释放量可达24 h内总释放量的80%,随后则逐渐减缓. 降低反应体系pH可促进Al3+释放,但会使F-吸附量减少,这是因为伴随Al3+的释放,部分F-又可以AlF络合物的形态重新进入溶液,尽管在低pH条件下,土壤表面以带正电荷为主而有利于F-吸附. 草酸和抗坏血酸对土壤吸附F-均有抑制作用,但对F-溶出土壤Al3+有促进作用. 此外,草酸对土壤铁氧化物的选择性溶解作用,可使更多F-吸附在土壤铝氧化物位点,并导致Al3+释放量增加.      

有机质对三峡库区消落区沉积物磷释放的影响

以三峡库区丰都消落区沉积物为研究对象,通过分析沉积物中磷的赋存形态,以及去除轻组有机质沉积物和沉积物矿物质对磷的吸附等温曲线,揭示了磷的赋存形态及释放与有机质的关系. 结果表明:消落区本底土壤较沉积物w(总磷),w(有机磷)及w(活性磷)更高,首次覆水时更具潜在释磷风险,夏季出露期有利于沉积物有机质和有机磷积累,沉积物有机质矿化分解对磷释放起促进作用,沉积物中w(有机质)与w(有机磷)呈显著正相关,与w(无机磷)呈负相关.      

生物强化和生物刺激对土壤中PAHs降解的影响

采用生物强化(农田土中添加PAHs污染土或污泥)和生物刺激(PAHs污染土中添加(NH4)2HPO4)2种措施,研究了土壤中13种PAHs的降解及CO2的释放量.结果显示,农田土壤中的微生物对2~5环的PAHs都有较强的降解能力,添加污染土显著增强了对5环PAHs的降解,表明污染土中的微生物对高环PAHs的降解能力更强;添加污泥对促进PAHs降解的作用不明显,可能是好氧培养条件不适合厌氧菌的生长.添加N、P营养盐可显著提高污染土中3~4环PAHs的降解,但5环PAHs在添加和未添加N、P中的降解率始终较低,均小于10%.CO2的释放呈现先增加再降低,再略微增加直至平稳的过程,且与PAHs的降解高度响应,说明PAHs的降解与微生物活性密切相关.     

Worst-case identification of gas dispersion for gas detector mapping using dispersion modeling

To quickly and accurately quantify the material release in process units, gas detectors may be placed according to the results of gas dispersion modeling. DNV's PHAST software is one of the most useful and reliable tools for material dispersion modeling. In this software, fluid dispersion is modeled based on the process conditions, the weather conditions and the specifications of the material release point. However, varying weather conditions throughout the year and the exact determination of the release point on the plot plan and the release elevation are problematic; these issues cause the results to be non-exact and non-integrated. Choosing the most appropriate conditions is challenging. In this paper, a scheme was provided to select the most appropriate conditions for gas dispersion modeling. This scheme approaches modeling based on the worst-case scenario (the situation in which the dispersed gas reaches the detector later in comparison to the other cases). Therefore, different weather conditions, release elevations and release points on the plot plan were modeled for an absorber tower of the Gonbadli Dehydration Unit of the Khangiran Refinery. The worst case of each release condition was then chosen. Finally, gas detectors were placed using the gas dispersion modeling results based on the worst-case scenario.