活性污泥系统动力学模拟方法的综合分析

活性污泥法的应用现状和污水中氮磷排放标准的日益严格，使得传统数学模型已满足不了目前的要求，需要对活性污泥系统复杂的动力学规律进行有效模拟。文章在综合分析活性污泥动态模型国内外研究现状的基础上，介绍了3种占主流地位的模型：活性污泥数学模型、神经网络模型和混合模型。这3种模型在污水处理的设计、运行控制和工艺优化等方面各有其独到之处。     

Seed yeast cultivation for salad oil manufacturing wastewater treatment

The mixture of five yeast strains obtained from soil could remove about 85% TOC of oil-rich wastewater in batch test.While the highest MLSS was obtained at an N:C of 1:5,the oil removal decreased with the increase of N:C during yeast sludge cultivation.Ammonium chloride was the best nitrogen source for yeast cultivation from the viewpoint of yeast growth and oil utilizxation.An ammonia concentration of over 1300 mg/L led to mass death of yeast at a pH of 5.The ammonia concentration should be controlled at a level of 1000 mg/L or lower.     

复配絮凝剂的筛选及其在炼油污泥中的应用

通过试验筛选出对炼油污泥处理效果好的复配絮凝剂。试验和现场应用结果表明：使用有机高分子絮凝剂(PAM)分别和无机高分子絮凝剂(PAC)复配处理炼油污泥比单独使用任何一种絮凝剂的处理效果更好，复配絮凝剂具有适应性广、投加量少、浮渣少等优点，处理后的污水可以达到排放标准。     

用呼吸仪监测取代酚类化合物对活性污泥的抑制

应用呼吸仪测定活性污泥中微生物的活性。研究了九种取代酚对微生物活性的影响,发现抑制效应与有机物的正辛醇-水分配系数、最低未占轨道能级有着相关联系,并发现取代酚对活性污泥硝化细菌比起异养细菌有着更强的抑制。生物膜比活性污泥具有更好的耐抑制能力,驯化对抗抑制有明显的效果,增大污泥浓度在一定程度上可以减轻毒害。     

循环式活性污泥法处理污水工艺研究

循环式活性污泥法是通过厌氧装置培养优化的活性污泥,然后在曝气池中进行同步的硝化反硝化过程,从而达到脱氮除磷的效果。     

Toxic metals in sewage sludge-amended soils: has promotion of beneficial use discounted the risks?

Land application of contaminated waste products has been defended as beneficial use by some scientists and regulators, based on the premise that the behavior of any toxins accumulated in soils from this practice is reasonably well understood and will not have detrimental agronomic or environmental impacts into the foreseeable future. In this review, I use the case of toxic metals in sewage sludges applied to agricultural land to illustrate that metal behavior in soils and plant uptake is difficult to generalize because it is strongly dependent on the nature of the metal, sludge, soil properties and crop. Nevertheless, permitted agricultural loadings of toxic metals from sewage sludges are typically regulated using the sole criterion of total metal loading or concentrations in soils. Several critical generalizing assumptions about the behavior of sludge-borne metals in soil-crop systems, built into the US EPA risk assessment for metals, have tended to underestimate risks and are shown not to be well justified by published research. It is argued that, in the absence of a basic understanding of metal behavior in each specific situation, a more precautionary approach to toxic metal additions to soils is warranted.     

机械强化污泥回流式一体化活性污泥法的运行机理研究

活性污泥通过机械搅拌强化污泥内循环回流,提高了污泥的活性,并且使污泥浓度可达到4.5kg/m3,用该机械强化污泥回流式一体化活性污泥法处理小区生活污水,当水力停留时间为3h,溶解氧为2.2mg/L,机械搅拌速度为250r/min时,CODcr、氨氮去除率均可达到83% 以上,出水达到国家污水排放一级标准.该一体化活性污泥法简单易行,运行成本低,投资小,操作维护方便,是生活小区生活污水适宜的处理工艺技术.     

废旧电子材料回收利用现状及发展展望

随着科学技术的进步，各类电子产品已经成为人们生活中不可缺少的组成部分，而其发展和普及的背后，我们将面临越来越多淘汰的废旧电子产品对环境带来的压力。与此同时，各类资源的短缺也需要从这些富含众多金属元素的废旧电子材料中找出解决办法。从废旧电子材料回收的紧迫性和必要性出发，分别介绍了目前国内外回收技术的现状及发展方向，并介绍了模型在回收技术发展和实际应用中可以起到的辅助作用。     

A／O-化学除磷工艺中DMBR动态膜成膜条件研究

根据动态膜原理，将0．1mm孔径无纺布为膜材的动态膜反应器（Dynamic Membrane BioReactor，DMBR）应用于A／O-化学除磷工艺之中，在动态膜反应器内完成泥水分离。试验测试了曝气强度、初始膜通量和污泥浓度对动态膜成膜的影响。结果表明，曝气强度和初始膜通量是影响成膜的关键性参数。当曝气强度≥60m^3／m^2·h或初始膜通量≥70L／m^2·h，2h内均不能形成截留性能良好的动态膜。在VSS／SS较低的污泥系统中，适宜的成膜条件为：曝气强度≤40m^3／m^2·h；初始膜通量≤40L/m^2·h。     

膜生物反应器处理印染废水技术研究

采用小试规模(148L/d)的厌氧-好氧膜生物反应器处理印染废水.当水力停留时间为14小时,进水COD、色度分别为208.54～2592.00mg/l、32～256倍,通过水解酸化-体式膜生物反应器试验,系统对COD、色度的去除率分别达到了80%～90%、87.5%.出水水质浓度或指标分别为21.80～363.20mg/l、8倍,具有良好的处理效果.厌氧-好氧膜生物反应器工艺处理印染废水技术可行、操作简单、易于管理、可为工业规模应用提供技术参考.