Improvement of the activity of anaerobic sludge by low-intensity ultrasound

This paper aims to study the enhancement effect of low-intensity ultrasound on anaerobic sludge activity and the efficiency of anaerobic wastewater treatment. Dehydrogenate activity (DHA) and the content of coenzyme F(420) were detected to indicate the change of activity of anaerobic sludge induced by ultrasound at 35 kHz. Single-factor and multiple-factor optimization experiments showed that the optimal ultrasonic intensity and irradiation period were 0.2 W/cm(2) and 10 min, respectively, and the biological activity was enhanced dramatically under the optimal condition. The chemical oxygen demand (COD) removal efficiency was increased by ultrasonic treatment and the COD in the effluent was 30% lower than that of the control (without exposure). The hypothetical mechanism of biological activity enhancement by ultrasound was also discussed according to the results.     

Production of lightweight aggregates from mining and industrial wastes

Washing aggregate sludge from a gravel pit, sewage sludge from a wastewater treatment plant (WWTP) and a clay-rich sediment have been physically, chemically and mineralogically characterized. They were mixed, milled and formed into pellets, pre-heated for 5 min and sintered in a rotary kiln at 1150 °C, 1175 °C, 1200 °C and 1225 °C for 10 and 15 min at each temperature. The effects of the raw material characteristics, heating temperatures and dwell times on the loss on ignition (LOI), bloating index (BI), bulk density (ρ_b), apparent and dry particle densities (ρ_a, ρ_d), voids (H), water absorption (WA_24h) and compressive strength (S) were determined. All the mixtures presented a bloating potential taking into consideration the gases released at high temperatures. The products obtained were lightweight aggregates (LWAs) in accordance with Standard UNE-EN-13055-1 (ρ_b ≤ 1.20 g/cm³ or particle density ≤ 2.00 g/cm³). LWAs manufactured with 50% washing aggregate sludge and 50% clay-rich sediment were expanded LWAs (BI > 0) and showed the lowest apparent particle density, the lowest water absorption and the highest compressive strength. It was possible to establish three groups of LWAs on the basis of their properties in comparison to Arlita G3, F3 and F5, commercially available lightweight aggregates manufactured in Spain. Our LWAs may have the same or similar applications as these commercial products, such as horticulture, prefabricated lightweight structures and building structures.     

降解丙烯酰胺的活性污泥培养及驯化研究

采用阶梯式驯化法,控制温度在18℃～24℃,pH在6—8,溶解氧在4—8mg／L,在容积为6L的驯化器中对活性污泥进行培养驯化。经过25d的培养之后,得到了稳定降解丙烯酰胺的活性污泥。驯化后的活性污泥SVI为85—132,COD去除率达70％。     

颗粒化序列间歇式活性污泥反应器工艺处理化粪池污水

在序列间歇式活性污泥反应器(SBR)中成功培养出适应化粪池污水水质的好氧颗粒污泥.并将其应用于化粪池污水的处理.在好氧颗粒污泥培养的第15天左右,SBR中开始出现细小的颗粒,然后微生物在其上繁殖生长使颗粒逐渐增大而成熟;在第24天时,SBR中絮状活性污泥已基本实现了颗粒化.培养出的好氧颗粒污泥对化粪池污水有稳定的处理效果,在进水完全为化粪池污水时,COD、NH_4~+-N、TN的平均去除率分别为77%、61%、47%.但是,由于化粪池污水COD较低,因此无法维持较高的生物量,在后期的稳定运行过程中MLSS始终维持在2 500 mg/L左右.好氧颗粒污泥的同步硝化反硝化作用是其稳定脱氮的保证.     

新型悬浮填料澄清池中填料对澄清作用的影响初探

为考察可取代传统二沉池的新型悬浮填料澄清池技术的原理及关键参数,小试试验研究了填料对新型悬浮填料澄清池固液分离过程中附着污泥形成及其絮凝性能的影响,并对填料在澄清中的作用机理进行了探讨。结果表明,当泥水界面上升至填料区后,可以形成较悬浮污泥更加致密稳定的附着污泥区,并形成孔道流,强化了对混合液中污泥颗粒的絮凝效果;填料区可以捕捉去除从悬浮污泥区中“逃逸”的微小污泥絮体,并降低出水浊度,有效地保证了出水水质的稳定性。填料的存在发挥了强大的整流作用,降低了雷诺数Re,提高了弗汝德数Fr,从而改善了污泥絮凝的水力条件,提高了澄清能力。     

污泥膨胀状态下原生动物群落结构分析

系统研究了丝状菌膨胀与非丝状菌膨胀2种典型污泥状态下原生动物的群落结构特征及其演变规律。伴随丝状菌的大量增殖,原生动物总量相应减少,匍匐型纤毛虫及有壳类肉足虫数量迅速上升,占据明显的优势地位,典型原生动物为斜管虫（Chilodonella sp.）、小轮毛虫（Trochilia minuta）以及匣壳虫（Centropyxis sp.）;非丝状菌污泥膨胀对原生动物总量及种群结构影响较小,伴随粘性菌胶团的大量出现,各功能类群的比例变化较小,但原生动物总量持续增加,其中菌食性纤毛虫呈线性增加,典型原生动物为钟虫（Vorticella sp.）。     

微生物絮凝剂改善城市污水厂浓缩污泥脱水性能的研究

采用酱油曲霉(Aspergillus sojae)产生的微生物絮凝剂(MBF)作为污泥絮凝脱水剂,对城市污水处理厂浓缩污泥进行调理,确定该絮凝剂对浓缩污泥脱水的处理工艺参数为：微生物絮凝液最佳投加体积为6%～8%（体积比）,发挥絮凝作用的最适污泥温度为28～32℃,最适pH为6～7。经微生物絮凝剂调理的污泥在3 000 r/min离心9 min,污泥脱水率高达82.7%,滤饼含水率降低至77.3%,污泥脱水后体积减至原来的1/5左右。     

污水污泥裂解及其性能的研究

以碘吸附值为裂解残渣吸附性能的指标,通过单因素实验和正交实验,确定了制备裂解残渣的最佳工艺条件,并对残渣的表面元素组成、孔结构组成、晶相组成和吸附性能等性质进行了表征。结果显示：以浓度均为5 mol/L的ZnCl₂和H₂SO₄作活化剂、复配比2∶1、活化温度600℃、活化时间1 h、固液比1∶2.5,制得的裂解残渣酸洗后碘值平均值可达892.8 mg/g;用制备的裂解残渣对苯酚废水进行处理,室温下振荡5 min,苯酚去除率即可达到87.9%,且符合Langmuir吸附等温线方程和Freundlich吸附等温线方程。     

DGGE、T-RFLP 、LH-PCR对两种活性污泥的微生物种群多样性分析的比较

采用基于PCR扩增的分子生态技术DGGE、T-RFLP和LH-PCR,对2种典型污水处理系统中的活性污泥（生活污泥、焦化污泥）进行微生物种群多样性分析;并以此比较3种技术的优劣,提出不同应用条件下研究方法的选择依据。根据实验结果：DGGE得到的条带较多,但误差来源也最多;T-RFLP技术较为灵敏,但需要选择适当的内切酶,严格控制酶切条件,并且文库比对误差较大;而LH-PCR操作简单,结果稳定性较高。虽然目前尚无法判断3种方法的准确性,但LH-PCR在活性污泥的微生物种群多样性分析中已显示出潜在优势。     

Cu~(2+)、Zn~(2+)对生物脱氮系统的影响

Cu2+和Zn2+是污水处理工艺中经常遇到的金属离子.在驯化好的活性污泥系统中,研究了金属离子Cu2+和Zn2+在0～100 mg/L浓度下对活性污泥牛物脱氮系统的影响.试验发现Cu2+＞5 mg/L、Zn2+＞30 ms/L时,对硝化过程具有明显的抑制作用,在同样浓度的试验条件下Cu2+对硝化过程的抑制作用比Zn2+大.Cu2+≤0.5 mg/L时对反硝化过程具有一定的促进作用,有助于提高TN的去除效果;Cu2+＞0.5 mg/L时,对反硝化产牛抑制作用,随着浓度的增加,TN去除率逐渐下降.Zn2+不影响反硝化过程,仅在大于30 mg/L时,对硝化过程产生抑制作用.重金属Cu2+对生物脱氮系统的影响明显强于Zn2+.