焊点热疲劳失效原因分析

某PCBA样品在使用约半年后出现功能失效,该PCBA在封装后进行整体灌胶,将失效样品剥离,发现部分器件直接脱落,通过表面观察、切片分析、EBSD分析、应力分析、热膨胀系数测试等手段对样品进行分析,结果表明:各封装材料存在热失配,且焊点缺陷较多且存在应力集中区,加速焊点的疲劳失效进程,导致PCBA功能失效。     

基于高通量测序的工业园区地下水和土壤细菌群落结构比较研究

为探究工业园区地下水和土壤细菌群落结构、多样性变化特征,采用高通量测序技术对地下水和土壤细菌16S r RNA基因高变区域进行序列测定。通过对Alpha多样性、物种组成、丰度和群落结构的分析,比较地下水和土壤细菌群落结构的异同。Alpha多样性的比较结果表明,土壤细菌群落多样性和丰富度明显高于地下水,地下水细菌群落多样性指数反映出地下水已受到周边污染源的影响。物种注释结果表明,地下水样品共检出48个细菌门,土壤样品共检出50个细菌门。变形菌门(Proteobacteria)、拟杆菌门(Bacteroidetes)和厚壁菌门(Firmicutes)是地下水细菌群落的优势类群,共占93.54%,且该工业园区地下水细菌群落呈现出典型的淡水种群特征;土壤中优势细菌门为Proteobacteria、放线菌门(Actinobacteria)、酸杆菌门(Acidobacteria)、Firmicutes和芽单胞菌门(Gemmatimonadetes),共占85.21%。由于地下水和土壤两者的生态系统和理化环境的差异,致使Actinobacteria、Acidobacteria、绿弯菌门(Chloroflexi)、硝化螺旋菌门(Nitrospirae)、α-变形菌纲(Alphaproteobacteria)、δ-变形菌纲(Deltaproteobacteria)和Gemmatimonadetes占比在地下水和土壤细菌群落间差异显著,同时使地下水和土壤细菌群落各含有一些特有的优势细菌属(地下水2个,土壤4个)。基于高通量测序技术对工业园区样品的测序结果可以为地下水和土壤环境的生态评价提供方法依据。     

热真空试验系统温度均匀度试验研究

热真空试验是航天器研制过程中非常重要的一项试验,作为满足热真空试验必不可少的工具,好的热真空试验系统可以保证试验件在不失真的情况下试验,使试验受控,而热真空试验系统温度均匀度不好,会造成过试验或欠试验的产生。文中以某型热真空试验设备为例,通过试验研究分析其温度均匀度,可以提高热真空试验的精度。     

单轴应力对煤自燃特性参数和导热系数的影响研究

为探究单轴应力作用下煤氧化和传热特性，利用自制荷载加压煤自燃特性参数测定装置对炉体内长焰煤煤样进行程序升温。结合程序升温过程中煤临界温度Tc和Tg，对其进行阶段划分:阶段1为30℃~Tc；阶段2为Tc~Tg。计算了不同单轴应力下2个阶段煤表观活化能和平均耗氧速率。根据能量守恒得出程序升温过程煤导热系数随温度的变化，进一步分析煤导热系数与单轴应力的关系。结果表明:阶段1单轴应力为4 MPa时为临界轴压，煤表观活化能最大，平均耗氧速率最小；阶段2煤表观活化能和平均耗氧速率随单轴应力增大均呈抛物线变化，单轴应力为2.7 MPa时为临界轴压，煤表观活化能最大，平均耗氧速率最小；阶段1和2煤导热系数随温度升高均先减小后增大，并且煤导热系数随单轴应力增大呈三次函数变化。     

Comparative study on performances of a heat-pipe PV/T system and a heat-pipe solar water heating system

The heat-pipe solar water heating (HP-SWH) system and the heat-pipe photovoltaic/thermal (HP-PV/T) system are two practical solar systems, both of which use heat pipes to transfer heat. By selecting appropriate working fluid of the heat-pipes, these systems can be used in the cold region without being frozen. However, performances of these two solar systems are different because the HP-PV/T system can simultaneously provide electricity and heat, whereas the HP-SWH system provides heat only. In order to understand these two systems, this work presents a mathematical model for each system to study their one-day and annual performances. One-day simulation results showed that the HP-SWH system obtained more thermal energy and total energy than the HP-PV/T system while the HP-PV/T system achieved higher exergy efficiency than the HP-SWH system. Annual simulation results indicated that the HP-SWH system can heat the water to the available temperature (45°C) solely by solar energy for more than 121 days per year in typical climate regions of China, Hong Kong, Lhasa, and Beijing, while the HP-PV/T system can only work for not more than 102 days. The HP-PV/T system, however, can provide an additional electricity output of 73.019 kWh/m², 129.472 kWh/m², and 90.309 kWh/m² per unit collector area in the three regions, respectively.     

An experimental apparatus for testing biodiesels based on a CFR engine—setup and validation with different methyl ester blends

A cooperative fuel research (CFR) engine was modified and instrumented in order to control operating conditions and to measure engine parameters and in-cylinder pressure diagrams. Aiming at the comparison of different alternative fuels, an experimental procedure was defined, including cetane number (CN) evaluation and the definition of engine operating quantities in different working points, for fixed levels of compression ratio (CR) and injection advance. An investigation was made considering several blends of methyl-esters of rapeseed oil (RME) and of a mix of vegetable oils (VOME) with conventional diesel oil. The defined experimental procedure was applied to assess CN, engine brake thermal efficiency (bte) and exhaust emissions. Results show that the biodiesel content has a positive influence on soot emissions, with strong reduction, while thermal efficiency and NO_X emissions are negatively affected, which can be justified taking into account fuel properties and changes in combustion process. As observed outcomes are generally in line with those presented in literature, the facility proved to be a suitable tool for basic investigations on alternative fuels to be used in specific applications.     

CMT监测井在黑河流域地下水监测中的应用

以CMT监测井在黑河流域的应用为基础,通过对监测数据和采集的水样进行分析,了解了黑河流域地下水水位动态变化,掌握了黑河流域地下水水化学垂向分布规律,为合理利用黑河流域水资源提供了科学依据。     

蔬菜常用农药在地下水中残留风险评估

为明确蔬菜常用农药在地下水中的环境风险,运用China-Pearl和SCI-GROW模型开展地下水环境暴露评估,并根据我国成人和儿童暴露参数推导25种农药预测无效应浓度(PNEC)。研究发现,25种农药PECgw为0~18.340μg·L-1,成年人PNECgw为0.003~19.654 mg·L-1,儿童PNECgw为0.001~23.253 mg·L-1。成年人和儿童的RQgw值均小于1,表明25种农药按照登记用量使用,我国成人和各年龄阶段儿童直接饮用施用农药区域地下水的环境风险可接受。     

肥煤自燃全过程热动力学特征参数研究

实验测定了林西矿肥煤样品30~900℃煤自燃全过程热动力学特征参数,得出:TG/DTG曲线显示煤样DTG初始临界温度45℃,干裂温度122℃,活性温度195℃,增速温度265℃,质量极大值温度342℃,着火温度465℃,最大热失重速率温度515℃和燃尽温度690℃;DSC曲线显示,煤样初始放热温度60℃、最大热释放速率温度511℃。结合TG-DTG-DSC曲线综合分析可知,煤温达到510℃左右时煤样反应最剧烈。由煤自燃标志气体测定实验系统得出:煤温130℃后CO,CO 2释放量迅速增加,210℃增加速度下降;CH 4,C 2 H 6含量变化具有规律性且两者变化相近;C 2 H 4出现温度为130℃;C 2 H 4/C 2 H 6比值在190~350℃有较强的规律性,呈上升趋势且上升速度较快;350℃之后,CH 4,C 2 H 6,C 2 H 4体积分数均开始急剧增大;C 2 H 4/CO与C 2 H 4/CO 2变化趋势大致相同,在130~350℃时缓慢增长,达到350℃后比值呈指数形式上升。经拟合曲线,得到活化能的3个突变点温度:70,180,220℃,其中180℃与交叉点温度相吻合。通过以上研究,得到了肥煤自燃全过程的热力学特征参数,为实际生产中防治煤自燃提供了理论依据。