多孔氧化铝层制备的研究

采用预腐蚀与交流腐蚀相结合的方法．研究了多孔氧化铝层的制备工艺．探讨了制备工艺中各步骤的作用以及影响因素。利用扫描电镜，研究了多孔氧化铝层制备工艺对铝箔微观形貌的影响。研究表明．交流腐蚀工艺对铝箔表面微观形貌的改变作用最明显。一次后处理后铝箔表面蚀孔变密．氧化膜的结构更加疏松细腻。二次后处理，调整和热处理等步骤对铝箔表面的微观形貌影响不大。     

Numerical Simulation of Synoptic Condition on a Severe Sand Dust Storm

By using observational data and MM5, an observational analysisand numerical study was conducted on the synoptic condition of a severe dust storm that was caused by a Mongolian cyclone whichoccurred from 6 to 8 April 2001. Results illustrated thatthe cyclogenesis was due to the isentropic potential vorticity (IPV) advection in the upper troposphere and the terrain modifiedbaroclinicity in the mid-lower troposphere. The Altai-Sayan complex of mountains blocked the lower level cold air and made the isentropic surface sharply steep. When the air slid down along the isentropic surface the increasing of baroclinicity anddecreasing of stability blew up the vertical vorticity development.The formation of the dust storm was a result of a cyclonic cold front passing across the area. The occurrence of this dust stormwas closely related to the strong surface wind, which was accompanied by a cold front passing, rather than the cyclogenesis, itself. Hence, the reason for the pre-front dust storm formulation was the formation of heating convection. Reasons behind the formation of a black storm (visibilitylower than 50 m), which occurred in the mid-north part ofInner Mongolia, lay in several aspects. Firstly, in thisarea the surface wind was strong, a direct result of thedownward transport in mid-lower troposphere. Secondly,the cold front passed over the effected area near sunsetso the air obtained much more surface heating to form adeeper mixed layer (ML). Thirdly, cooperation between thelower level wind and the terrain made the atmosphere inthis area and acquired the maximum advective contributionnecessary to form a deep post-front ML. The sensitivityexperiment revealed that surface heat flux was important to the frontal lifting. In addition, the forcing of surface heating wasalso seen as the primary forcing mechanism of frontogenesis. Meanwhile, removal of the surface heat flux made the atmosphericstratification became stable and the pre-storm ML very shallow,which weakened the strength of the dust storm.     

Greenhouse impacts of anthropogenic CH4 and N2O emissions in Finland

The Finnish anthropogenic CH₄ emissions in 1990 are estimated to be about 250 Gg, with an uncertainty range extending from 160 to 440 Gg. The most important sources are landfills and animal husbandry. The N₂O emissions, which come mainly from agriculture and the nitric acid industry are about 20 Gg in 1990 (uncertainty range 10–30 Gg). The development of the emissions to the year 2010 is reviewed in two scenarios: the base and the reduction scenarios.According to the base scenario, the Finnish CH₄ emissions will decrease in the near future. Emissions from landfills, energy production, and transportation will decrease because of already decided and partly realized volume and technical changes in these sectors. The average reduction potential of 50%, as assumed in the reduction scenario, is considered achievable.N₂O emissions, on the other hand, are expected to increase as emissions from energy production and transportation will grow due to an increasing use of fluidized bed boilers and catalytic converters in cars. The average reduction potential of 50%, as assumed in the reduction scenario, is optimistic.Anthropogenic CH₄ and N₂O emissions presently cause about 30% of the direct radiative forcing due to Finnish anthropogenic greenhouse gas emissions. This share would be even larger if the indirect impacts of CH₄ were included. The contribution of CH₄ can be controlled due to its relatively short atmospheric lifetime and due to the existing emission reduction potential. Nitrous oxide has a long atmospheric lifetime and its emission control possiblities are limited consequently, the greenhouse impact of N₂O seems to be increasing even if the emissions were limited somehow.     

尿中氚水和总氚的分析测定

用蒸馏-液闪法和氧化蒸馏-液闪法分别测量了氚污染人员尿中的氚水浓度和总氚(氚水和有机氚)浓度。根据72个高于本底水平的尿中氚水和总氚浓度分析比较，认为在氚内污染工作人员的尿中，有机氚与氚水的浓度比值为(5.4 3.7)％。     

Co-treatment of fruit and vegetable waste in sludge digesters. An analysis of the relationship among bio-methane generation,process stability and digestate phytotoxicity

The co-digestion of a variable amount of fruit and vegetable waste in a waste mixed sludge digester was investigated using a pilot scale apparatus. The organic loading rate (OLR) was increased from 1.46 kg VS/m³ day to 2.8 kg VS/m³ day. The hydraulic retention time was reduced from 14 days to about 10 days. Specific bio-methane production increased from about 90 NL/kg VS to the maximum value of about 430 NL/kg VS when OLR was increased from 1.46 kg VS/m³ day to 2.1 kg VS/m³ day. A higher OLR caused an excessive reduction in the hydraulic retention time, enhancing microorganism wash out. Process stability evaluated by the total volatile fatty acids concentration (mg/l) to the alkalinity buffer capacity (eq. mg/l CaCO₃) ratio (i.e. FOS/TAC) criterion was <0.1 indicating high stability for OLR <2.46 kg VS/m³ day. For higher OLR, FOS/TAC increased rapidly. Residual phytotoxicty of the digestate evaluated by the germination index (GI) (%) was quite constant for OLR < 2.46 kg VS/m³ day, which is lower than the 60% limit, indicating an acceptable toxicity level for crops. For OLR > 2.46 kg VS/m³ day, GI decreased rapidly. This corresponding trend between FOS/TAC and GI was further investigated by the definition of the GI ratio (GIR) parameter. Comparison between GIR and FOS/TAC suggests that GI could be a suitable criterion for evaluating process stability.     

1株异养硝化-好氧反硝化细菌DK1的分离鉴定及其脱氮特性

从某反应器活性污泥中分离筛选出1株假单胞菌属(Pseudomonas sp.)细菌,命名为DK1,并对该菌进行脱氮特性研究.在以葡萄糖为碳源,C/N量比为5时,分别以NaNO_3和NaNO_2为氮源,二者的好氧反硝化速率为4.09 mg·(L·h)-1和4.43mg·(L·h)~(-1).以二者同时为氮源脱氮率为100%;此外,菌株DK1具有异养硝化性能,NH_4~+-N平均去除速率为2.32mg·(L·h)-1.缺氧时以NO_2~--N为氮源菌株DK1可将一系列梯度浓度NO_2~--N(约100~300 mg·L-1)在36 h内降为0.当NO_3~--N和NO_2~--N同时存在时,菌株DK1会优先利用NO_3~--N进行反硝化.同时该菌株还具有同步硝化反硝化(SND)性能,可同时去除NH_4~+-N、NO_2~--N或NH_4~+-N、NO_3~--N,30 h内脱氮率分别达95.06%和94.69%.相同时间内在NH_4~+-N、NO_2~--N和NO_3~--N三者均存在时,脱氮效果最佳,达100%.菌株DK1的高效SND及反硝化性能表明其在处理含氮废水方面有一定的潜力和应用价值.     

氧化镁基生物质炭高效去除水体中磷的特性

利用花生壳为前驱体,在高温限氧条件下,将氧化镁(MgO)负载于生物质炭(BC)表面制备出氧化镁基生物质炭(MgOBC)复合材料.系统研究了MgO-BC对水体中P的吸附特性,并探讨了溶液pH值、接触时间、竞争离子等因素对P的吸附效果的影响.结果表明,P的最佳吸附初始pH为7~9,过酸过碱的环境均不利于P的吸附;P的吸附过程可在540 min内达到平衡,且动力学曲线较好地符合伪一级和伪二级动力学模型,拟合系数可达97.3%和99.0%;当Cl~-、HCO_3~-、NO_3~-等共存离子的量浓度达到P的10倍时,MgO-BC对P仍具有较强的吸附能力;P的吸附过程较好地符合Langmuir等温模型,拟合系数达99%,理论最大吸附容量为138.07 mg·g~(-1),远高于其它未经改性或改性的生物质炭和几种典型P吸附剂的吸附容量.此外,吸附P后的复合材料可作为肥料施入土壤,可有效实现P的再利用.综上所述,该MgO-BC复合材料在净化实际P污染水体中有着广阔的应用前景.     

Nano-sized Fe2O3/Fe3O4 facilitate anaerobic transformation of hexavalent chromium in soil–water systems

The purpose of this study is to investigate the effects of nano-sized or submicro Fe_2O_3/Fe_3O_4 on the bioreduction of hexavalent chromium(Cr(VI)) and to evaluate the effects of nano-sized Fe_2O_3/Fe_3O_4 on the microbial communities from the anaerobic flooding soil.The results indicated that the net decreases upon Cr(VI) concentration from biotic soil samples amended with nano-sized Fe_2O_3(317.1 ± 2.1 mg/L) and Fe_3O_4(324.0 ± 22.2 mg/L) within21 days,which were approximately 2-fold of Cr(VI) concentration released from blank control assays(117.1 ± 5.6 mg/L).Furthermore,the results of denaturing gradient gel electrophoresis(DGGE) and high-throughput sequencing indicated a greater variety of microbes within the microbial community in amendments with nano-sized Fe_2O_3/Fe_3O_4 than the control assays.Especially,Proteobacteria occupied a predominant status on the phylum level within the indigenous microbial communities from chromium-contaminated soils.Besides,some partial decrease of soluble Cr(VI) in abiotic nano-sized Fe_2O_3/Fe_3O_4 amendments was responsible for the adsorption of nano-sized Fe_2O_3/Fe_3O_4 to soluble Cr(VI).Hence,the presence of nano-sized Fe_2O_3/Fe_3O_4 could largely facilitate the mobilization and biotransformation of Cr(VI) from flooding soils by adsorption and bio-mediated processes.     

燃煤烟气同时脱硫脱硝方法的研究进展及分析

近年来,烟气同时脱硫脱硝技术因占地面积小,可同时控制多种污染物而引起广泛的关注,但该技术多数仍停留在实验阶段。文章重点介绍了等离子体法、固相吸附法、溶液吸收法及微生物法等方法研究进展,对各方法的脱硫脱硝特点及功效进行评述,分析其问题与不足,并提出燃煤烟气同时脱硫脱硝方法的研究方向,为同时脱硫脱硝技术的改进提出建议。     

铁锰氧化物/坡缕石复合材料吸附磷的性能

将铁锰氧化物与坡缕石黏土结合制备了复合材料FO/P、MO/P和FMO/P,由静态吸附实验研究了复合材料吸附磷的性能,考察了氧化物与坡缕石质量比、焙烧温度、溶液p H值、离子强度和振荡时间对吸附量的影响,探讨了吸附动力学、吸附平衡和机理。结果表明,FMO/P的吸附性能优于FO/P和MO/P,铁锰氧化物与坡缕石黏土的质量比为0.1的FMO/P对20mg/L的磷溶液去除率可达95%,吸附量明显受溶液p H的影响,离子强度对吸附量影响较小,磷吸附在复合材料表面主要形成内层络合物,60 min可基本达吸附平衡,过程符合pseudo-second-order方程,具有化学吸附的性质,FMO/P吸附等温线符合Freundlich方程,有不均匀吸附的性质,饱和吸附量达49 mg/g。