GC/MS法测定生物样品中多溴联苯醚类化合物

本研究建立了多溴联苯醚（PBDEs）生物样品分析方法,获得了优化的前处理条件、气相色谱和质谱检测条件.对定性定量方法及实验条件必须满足的要求进行了评价.通过质量控制（quality control, QC）对整个方法进行了验证.结果证明,本研究所建立的分析方法满足生物样品PBDEs测定的要求,回收率在50.5%～112.3%之间,回收率相对标准偏差在5.3%～9.9%之间,方法检测限在7.1～161.8 pg/g之间.在建立的方法基础上,测定了部分养殖和野生鱼类样品,测得的野生鳜鱼和鲫鱼以及2个养殖鲈鱼样品的结果分别为1.53、1.11、5.31和6.15 ng/g(干重),其中主要的同族体为BDE47.     

利用紫外预处理加强氯苯的生物滴滤净化

试验采用主波长为185nm的低压汞灯为紫外光源、醚型聚氨酯海绵(PU-foam)为填料的紫外-生物滴滤塔联合装置净化氯苯废气.进气氯苯浓度为600mg·m-3、停留时间分别为92、69和46s时,联合装置的平均去除率分别达到99%、95%和80%;最大去除负荷达到59.6g·(m3·h)-1;联合装置和单独生物滴滤塔生物膜形成时间分别为20d和27d;联合装置的抗冲击能力较好,停留时间缩短至30s,联合装置去除效率可达75%以上,高于单独生物滴滤塔的去除效率(25%).对紫外-生物滴滤塔联合装置机制初步探讨表明,紫外氧化氯苯形成了水溶性较好的可生物降解的物质,降低生物滴滤塔氯苯的处理负荷,同时紫外辐照过程中产生的O3能有效地控制生物滴滤塔内微生物的过量生长,从而维持整个装置的最佳运行状态.     

Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

Archaeal community structure along a gradient of petroleum contamination in saline-alkali soil

The impact of petroleum on archaeal community in salinealkali soils was investigated, which will expand the knowledge of the archaeal population involved in the natural attenuation of hydrocarbons in extreme environments.     

稀释接种法测BOD5考核样品的一些注意点

用稀释接种法测定BOD5时,由于操作繁琐,全部实验时间需要5d,任一环节出现问题都会影响实验结果。在进行考核实验时,由于时间紧,样品量有限,因此每个实验操作步骤都要谨慎仔细。通过实践经验,就BOD,考核实验总结了一些注意点。     

Characteristics of atmospheric particles and heavy metals in winter in Chang-Zhu-Tan city clusters, China

To understand the pollution characteristics of atmospheric particles and heavy metals in winter in Chang-Zhu-Tan city clusters, China, total suspended particulate(TSP) and PM10samples were collected in cities of Changsha, Zhuzhou and Xiangtan from December 2011 to January 2012, and heavy metals of Cd, Pb, Cr, and As were analyzed. It shows that the average TSP concentration in Changsha, Zhuzhou and Xiangtan were(183 ± 73),(201 ± 84) and(190 ± 66) μg/m3respectively, and the average PM10 were(171 ± 82),(178 ± 65) and(179 ± 55) μg/m3respectively. The lowest TSP and PM10concentrations occurred at the background Shaping site of Changsha. The average ratio of ρ(PM10)/ρ(TSP) was 91.9%, ranging from 81.3% to 98.9%. Concerning heavy metals, in TSP samples, the concentration of Cr, As, Cd and Pb were 28.8–56.5, 18.1–76.3, 3.9–26.1 and 148.0–460.9 ng/m3, respectively, while in PM10samples, were 16.4–42.1, 15.5–67.9, 3.3–22.2 and 127.9–389.3 ng/m3, respectively. The enrichment factor of Cd was the highest, followed by Pb and As, while that of Cr was the lowest.     

环境样品中甲基汞测定方法的研究进展

甲基汞可通过血脑屏障引起中枢神经系统永久性损伤,毒性很强,因此环境样品中甲基汞的准确测定具有重要意义。文章对近年来环境样品中甲基汞的提取与富集技术及分析测定方法进行了归纳和总结。系统介绍了酸/碱提取、微波/超声辅助提取等样品前处理方法及其溶剂萃取等富集方法。通过比较分析,总结了不同环境样品适用的前处理方法。同时,对各色谱-质谱/光谱联用方法在甲基汞测定时的应用进行了归纳和比较。全自动形态汞/总汞分析仪(MERX)将环境样品中甲基汞的富集与分析有机结合,实现了环境样品中甲基汞的富集和分离与定量分析的一体化,提高了分析效率,是值得推荐的方法。     

NaOH预处理对稻草秸秆厌氧消化的影响

通过调控稻草秸秆预处理过程中的NaOH比例,以期提高厌氧消化的产气量及产气效率。试验结果表明,经NaOH处理过的稻草秸秆半纤维素、木质素含量有显著降低,产气量较对照组有明显增加,发酵时间有所缩短。其中NaOH质量百分数为6%的处理组产气率最高,为312mL/g(干物质);VS/TS去除率也最高,为53.8%/36.8%;累计产气量最高,发酵过程中甲烷体积分数最高37.7%。故采用质量百分数为6%的NaOH的预处理是最佳方式。     

微波及其组合工艺强化污泥厌氧消化研究

为提高剩余污泥的厌氧消化效能和脱水性能,考察了微波及其组合污泥预处理工艺的强化污泥厌氧消化效果,同时考察了预处理-厌氧消化过程的污泥理化特征及其脱水性能.结果表明,微波及其组合工艺可以强化污泥厌氧消化产甲烷,其中微波-过氧化氢-碱(0.2)的强化效果最为显著,不仅30 d累计产甲烷量比对照组增加了13.34%,而且产甲烷速率也得到了提升.与单独微波处理相比,过氧化氢、碱的投加显著提高了溶解性COD的释放量,这表明微波、过氧化氢、碱之间的协同作用能有效破碎污泥,进而强化厌氧消化效果;微波-酸预处理后的污泥具有良好的脱水性能,毛细吸水时间(CST)只有9.85 s,污泥脱水性能的改善与其表面电性、粒径分布的变化密切相关;不同预处理条件下的污泥经过厌氧消化后,污泥脱水性能较为接近.     

大气颗粒物来源解析

内涵解析何谓大气颗粒物来源解析?大气颗粒物来源解析是指通过化学、物理学、数学等方法定性或定量识别环境受体中大气颗粒物污染的来源。这是一项长期复杂且系统的技术性工作,涉及多种技术方法、模型选择、样品采集与分析、化学成分谱的科学构建、模拟运算以及解析结果评估与应用等,是科学、有效开展颗粒物污染防治工作的基础和前