菌株Pseudomonas sp. JF122降解苯酚同时还原Cr(VI)的条件优化及生长特性研究

采用富集培养法,从钢铁厂附近河流污泥中分离筛选到1株能同时降解苯酚与还原Cr(VI)的菌株JF122.在600 mg·L^-1苯酚与1.2 mg·L^-1 Cr(VI) 的条件下,采用单因素实验考察了温度、初始pH、该菌接种量等因素对其同时降解苯酚与还原Cr(VI)的影响,并通过正交试验L₉(3³)获得适宜的苯酚降解与Cr(VI)还原条件.结果表明,菌株JF122降解苯酚与还原Cr(VI)的适宜条件为:30 ℃、初始pH=6和接种量1%,此条件下,菌株JF122在56 h内能够降解600 mg·L^-1苯酚同时还原1.2 mg·L^-1 Cr(VI).应用响应曲面法建立了菌株JF122的生长与温度、初始pH、接种量等因素间关系的数学模型,并对其生长条件进行了优化.结果表明,菌株JF122最优生长条件与其降解苯酚并同时还原Cr(VI)的最优条件具有一致性.     

羧基化碳纳米管载铂催化剂对微生物燃料电池阴极氧还原性能的影响

阴极催化剂是影响微生物燃料电池(microbial fuel cell,MFC)性能的关键要素.为了考察不同羧基化方法改性的碳纳米管(carbon nanotube,CNT)负载Pt的催化氧还原效率,分别在80℃和95℃条件下对CNT进行了羧基化,采用浸渍-沉淀法制备了Pt/CNT催化剂(Pt/CNT-80和Pt/CNT-95),并在空气阴极MFC体系中验证了其催化氧还原效果(MFC-80、MFC-95和MFC-C).结果表明,MFC-95和MFC-80的最大功率密度分别为568.8 mW.m-2和412.8 mW.m-2,内阻分别为204.7Ω和207.7Ω,开路电压分别为0.719 V和0.651 V.而对照MFC-C的最大功率密度仅为5.4 mW.m-2,内阻为826.2Ω.XPS和XRD分析结果显示,Pt/CNT-95催化氧还原效果优于Pt/CNT-80,原因可能是95℃羧基化过程在CNT表面引入了丰富的含氧基团.     

零价铁对脱色希瓦氏菌S12偶氮还原的促进作用

以脱色希瓦氏菌(Shewanella decolorationis)S12为实验菌株,研究了零价铁(ZVI)存在条件下微生物的厌氧偶氮还原特性及其最佳反应条件.结果表明,ZVI可显著促进菌株S12的厌氧偶氮还原速率.培养30 h后含有20 mmol.L-1微米级ZVI和S12菌的培养体系中,菌株S12对1 mmol.L-1苋菜红的脱色率达100%,比不含ZVI的S12菌培养体系和只含ZVI的体系的偶氮还原率分别提高了23.16%和94.66%;在额外含20 mmol.L-1甲酸钠的培养体系中,ZVI的存在也使S12菌对苋菜红的脱色率提高了20.54%.此外,ZVI的存在可显著提高培养体系对偶氮染料的耐受能力.在投加ZVI和菌株S12培养体系中,连续批量投加浓度为1 mmol.L-1的苋菜红可在276 h内实现11次有效脱色,而不含ZVI的S12菌培养体系中只能实现3次有效脱色.进一步的研究发现,ZVI与菌株S12协同培养体系的最适反应pH为9.0,最适ZVI投加量为60 mmol.L-1.与毫米级和纳米级ZVI颗粒相比,微米级ZVI颗粒具有更强的促进作用.本研究结果将为利用ZVI协同促进偶氮染料的生物治理效果提供科学参数.     

直接大红4BE的磷钨酸均相光催化还原脱色

以磷钨酸(H3PW12O40,PW12)为光催化剂,异丙醇(Isopropanol)作为电子给体的条件下对偶氮染料直接大红4BE进行均相光催化还原脱色研究,考察PW12用量、IS浓度、直接大红4BE和盐浓度等因素的影响,结果表明杂多蓝(PW1-2)对直接大红4BE具有明显的还原脱色作用.pH=2.0,直接大红4BE初始浓度50 mg·L-1,PW12浓度为600 mg·L-1,IS浓度为0.13mol·L-1,50 min直接大红4BE的脱色率可达到90.39%.4BE的光催化还原脱色速率随PW12和IS浓度的增加而增加,最后趋于恒定;直接大红4BE初始浓度增加,其光反应一级速率常数降低;PW12、IS和4BE浓度之间存在交互影响.离子强度增加,4BE脱色速率减小,表现为负的盐效应,推测4BE与光反应生成的杂多蓝(PW1-2)进行复合,然后发生电子转移引起偶氮染料还原脱色和杂多蓝氧化复原.本研究结果表明PW12/IS/UV能够有效用于偶氮染料直接大红4BE的还原脱色处理.     

有机蒙脱石负载纳米铁去除溶液中四溴双酚A的研究

研究了改性蒙脱石负载纳米铁材料(NZVI-CMT)在甲醇-水体系中对四溴双酚A(TBBPA)的去除作用,并确定了反应温度、TBBPA初始浓度以及材料投加量等因素对去除效果的影响.结果表明,在25℃条件下,0.02 g NZVI-CMT对初始浓度为10 mg·L-1TBBPA溶液的去除率可达97.5%,而且NZVI-CMT对TBBPA的去除率明显高于两种单一材料即纳米零价铁(NZVI)及有机蒙脱石(CMT)的去除率(18.3%、67.3%),同时也大于两者之和(85.6%).利用NZVI-CMT对TBBPA进行重复去除实验时,前3次的去除率均可达到90%以上.通过检测降解产物并分析材料对TBBPA去除过程的特性,发现NZVI-CMT对TBBPA的去除以吸附为主,并伴有少量还原脱溴反应发生,而且较高的反应温度对降解反应有利.     

Effect of transition metal doping under reducing calcination atmosphere on photocatalytic property of TiO2 immobilized on SiO2 beads

TiO₂ immobilized on SiO₂ (TiO₂/SiO₂) have been prepared by sol-gel method and various ions of transition metals (Cr³⁺, Co²⁺, Ni²⁺, Cu²⁺, and Zn²⁺) were doped on the photocatalyst using wet impregnation method under reducing calcination atmosphere. The photocatalytic activity of metal doped TiO₂/SiO₂ towards phenol degradation under black light irradiation were investigated and compared with undoped TiO₂/SiO₂. The results showed that the photoresponse of Cu²⁺ and Zn²⁺ doped TiO₂/SiO₂ were larger than undoped TiO₂/SiO₂, indicating that the photogenerated carriers were separated more efficiently in Cu²⁺ and Zn²⁺ doped TiO₂/SiO₂. The reactivity was in the order of Cu²⁺ > Zn²⁺ > Ni²⁺ > Cr³⁺ > Co²⁺. The different photoreactivity was ascribed to combine effect of the different ionic radii and photocorrison tendency of the dopants. The sample was also characterized by surface analytical methods such as X-ray diffraction, scanning electron micrograph/electron dispersive X-ray analyzer and UV-Vis absorption spectrum.     

不同Fe(Ⅲ)对活性污泥异化铁还原及除磷影响研究

以SBBR反应器活性污泥作为铁还原菌菌种来源,采用兼性厌氧/严格厌氧恒温培养试验,投加不同Fe(Ⅲ)考察各条件下的异化铁还原能力同时比较对磷的去除效果.结果表明:2种条件下Fe(Ⅲ)还原能力具有较好的一致性,依次为:Fe(OH)3＞氧化铁皮＞青矿＞红矿,其中严格厌氧条件下较好.同时,除磷效果与其呈正相关,富集培养至7d,Fe(OH)3及氧化铁皮体系出水磷浓度均达到2mg/L以下,之后继续降低,最终达到0.5mg/L以下.结合异化铁还原除磷机理,可以证明,不同Fe(Ⅲ)表面吸附作用对TP的去除贡献较小,其主要作用为铁还原菌驱动下的化学沉淀去除.     

两段式还原铬渣中Cr(Ⅵ)的试验研究

比对了多种还原剂处理六价铬的解毒效果,确定了焦亚硫酸钠、硫酸亚铁两段式还原处理铬渣浸出液中六价铬和总铬的还原剂投加顺序和投加量。结果表明,该技术能使解毒后铬渣中Cr6+浓度达到0.17 mg/L,满足HJ/T 301—2007《铬渣污染治理环境保护技术规范(暂行)》解毒后铬渣六价铬≤0.5 mg/的要求,且具有较好的长期稳定性,解毒彻底,可为该技术的工程应用提供理论依据。     

Fe2O3 particles as superior catalysts for low temperature selective catalytic reduction of NO with NH3

Fe203 particle catalysts were experimentally studied in the low temperature selective catalytic reduction （SCR） of NO with NH3. The effects of reaction temperature, oxygen concentration, [NH3]/[NO] molar ratio and residence time on SCR activity were studied. It was found that Fe203 catalysts had high activity for the SCR of NO with NH3 in a broad temperature range of 150-270℃, and more than 95% NO conversion was obtained at 180℃ when the molar ratio [NH3]/[NO] = 1, the residence time was 0.48 seconds and 02 volume fraction was 3%. In addition, the effect of SO2 on SCR catalytic activity was also investigated at the temperature of 180℃. The results showed that deactivation of the Fe2O3 particles occurred due to the presence of SO2 and the NO conversion decreased from 99.2% to 58% in 240 min, since SO2 gradually decreased the catalytic activity of the catalysts. In addition, X-ray diffraction, Thermogravimetric analysis and Fourier transform infrared spectroscopy were used to characterize the fresh and deactivated Fe2O3 catalysts. The results showed that the deactivation caused by SO2 was due to the formation of metal sulfates and ammonium sulfates on the catalyst surface during the de-NO reaction, which could cause pore plugging and result in suppression of the catalytic activity.     

Effects of physical and chemical characteristics of surface sediments in the formation of shallow lake algae-induced black bloom

Surface sediments are closely related to lake black blooms. The dissolved oxygen （DO） distribution and its penetration depth in surface sediments as well as the migration and transformation of redox sensitive elements such as Fe and S at the sediment-water interface are important factors that could influence the formation of the black bloom. In this study, dredged and undredged sediment cores with different surface properties were used to simulate black blooms in the laboratory. The Micro Profiling System was employed to explore features of the DO and ∑H2S distribution at the sediment-water interface. Physical and chemical characteristics in sediments and pore waters were also analyzed. The results showed that sediment dredging effectively suppressed the black blooms. In the undredged treatment, DO penetration depth was only 50 μm. Fe^2＋ concentrations, ∑H2S concentrations, and ∑H2S production rates were remarkably higher in surface sediments and pore waters compared to control and dredged treatments. Furthermore, depletion of DO and accumulation of Fe^2＋ and ∑H2S in surface sediments and pore waters provided favorable redox environments and necessary material sources for the blooms. The study results proved that physical and chemical characteristics in surface sediments are important factors in the formation of the black bloom, and could provide scientific guidance for emergency treatment and long-term pre-control of black blooms.