飞机起落架材料防护技术现状及研究进展

介绍了飞机起落架高强度钢的防护工艺及其防护特点。传统的防护工艺主要是镀铬和镀镉工艺,目前出现了无氰镀镉-钛、高速火焰喷涂(HVOF)涂层、低氢脆刷镀镉等新型防护工艺。通过对各新型防护工艺与传统工艺的工艺性能及耐腐蚀性能进行对比发现,各新型防护工艺都能很好地取代传统的防护工艺应用于飞机起落架的保护。     

TiO2-Fe3+可见光催化H2O2降解阿特拉津的协同效应

以内分泌干扰物阿特拉津为模型污染物,研究了TiO2-Fe3+可见光催化H2O2降解阿特拉津的协同效应.结果表明,在H2O2存在条件下,金红石TiO2经可见光激发可持续稳定地产生.OH自由基,在Fe3+协同作用下,.OH自由基生成量急剧增加;TiO2能可见光催化H2O2降解阿特拉津,金红石TiO2显示出较锐钛矿TiO2及混晶TiO2(TiO2P25)更高的催化活性,反应60 min,阿特拉津的降解率可达40%;以Fe3+协同TiO2可见光催化H2O2降解阿特拉津时,反应效率显著加快,反应5 min即对阿特拉津的降解率达到100%,而金红石TiO2显示出更为明显的协同效应.     

H2O2处理酸性大红GR染料废水的研究

通过对废水pH值、H2O2用量、催化剂用量、反应时间、反应温度等工艺条件的考察,确定了H2O2催化氧化处理酸性大红染料废水的最佳工艺条件pH 4、H2O2用量6 mL/L、催化剂用量3 g/L、反应时间100 min、反应温度70℃.在该条件下,COD和色度的去除率分别为76.7%和99.4%;通过反应前后的紫外-可见光光谱分析表明,H2O2催化氧化处理酸性大红GR染料废水有比较好的效果,为该工艺处理酸性大红GR染料废水提供了科学依据.     

Remediation of 2,4-dichlorophenol-contaminated groundwater using nano-sized CaO2 in a two-dimensional scale tank

• Nano CaO₂ is evaluated as a remediation agent for 2,4-DCP contaminated groundwater. • 2,4-DCP degradation mechanism by different Fe²⁺ concentration was proposed. • 2,4-DCP was not degraded in the system for solution pH>10. • The 2,4-DCP degradation area is inconsistent with the nano CaO₂ distribution area. This study evaluates the applicability of nano-sized calcium peroxide (CaO₂) as a source of H₂O₂ to remediate 2,4-dichlorophenol (2,4-DCP) contaminated groundwater via the advanced oxidation process (AOP). First, the effect and mechanism of 2,4-DCP degradation by CaO₂ at different Fe concentrations were studied (Fenton reaction). We found that at high Fe concentrations, 2,4-DCP almost completely degrades via primarily the oxidation of •OH within 5 h. At low Fe concentrations, the degradation rate of 2,4-DCP decreased rapidly. The main mechanism was the combined action of •OH and O₂^•−. Without Fe, the 2,4-DCP degradation reached 13.6% in 213 h, primarily via the heterogeneous reaction on the surface of CaO₂. Besides, 2,4-DCP degradation was significantly affected by solution pH. When the solution pH was>10, the degradation was almost completely inhibited. Thus, we adopted a two-dimensional water tank experiment to study the remediation efficiency CaO₂ on the water sample. We noticed that the degradation took place mainly in regions of pH<10 (i.e., CaO₂ distribution area), both upstream and downstream of the tank. After 28 days of treatment, the average 2,4-DCP degradation level was ≈36.5%. Given the inadequacy of the results, we recommend that groundwater remediation using nano CaO₂: (1) a buffer solution should be added to retard the rapid increase in pH, and (2) the nano CaO₂ should be injected copiously in batches to reduce CaO₂ deposition.     

Evaluation of the technoeconomic feasibility of electrochemical hydrogen peroxide production for decentralized water treatment

• Gas diffusion electrode (GDE) is a suitable setup for practical water treatment. • Electrochemical H₂O₂ production is an economically competitive technology. • High current efficiency of H₂O₂ production was obtained with GDE at 5–400 mA/cm². • GDE maintained high stability for H₂O₂ production for ~1000 h. • Electro-generation of H₂O₂ enhances ibuprofen removal in an E-peroxone process. This study evaluated the feasibility of electrochemical hydrogen peroxide (H₂O₂) production with gas diffusion electrode (GDE) for decentralized water treatment. Carbon black-polytetrafluoroethylene GDEs were prepared and tested in a continuous flow electrochemical cell for H₂O₂ production from oxygen reduction. Results showed that because of the effective oxygen transfer in GDEs, the electrode maintained high apparent current efficiencies (ACEs,>80%) for H₂O₂ production over a wide current density range of 5–400 mA/cm², and H₂O₂ production rates as high as ~202 mg/h/cm² could be obtained. Long-term stability test showed that the GDE maintained high ACEs (>85%) and low energy consumption (<10 kWh/kg H₂O₂) for H₂O₂ production for 42 d (~1000 h). However, the ACEs then decreased to ~70% in the following 4 days because water flooding of GDE pores considerably impeded oxygen transport at the late stage of the trial. Based on an electrode lifetime of 46 days, the overall cost for H₂O₂ production was estimated to be ~0.88 $/kg H₂O₂, including an electricity cost of 0.61 $/kg and an electrode capital cost of 0.27 $/kg. With a 9 cm² GDE and 40 mA/cm² current density, ~2–4 mg/L of H₂O₂ could be produced on site for the electro-peroxone treatment of a 1.2 m³/d groundwater flow, which considerably enhanced ibuprofen abatement compared with ozonation alone (~43%–59% vs. 7%). These findings suggest that electrochemical H₂O₂ production with GDEs holds great promise for the development of compact treatment technologies for decentralized water treatment at a household and community level.     

Assessment of oxidative and UV-C treatments for inactivating bacterial biofilms from groundwater wells

Microorganisms are ubiquitous in natural environments and in water supply infrastructure including groundwater wells. Sessile-state microorganisms may build up on well surfaces as biofilms and, if excessive, cause biofouling that reduces well productivity and water quality. Conditions can be improved using biocides and other traditional well rehabilitation measures; however, biofilm regrowth is inevitable given the continuous introduction of microorganisms from the surrounding environment. Alternative and less invasive well maintenance approaches are desirable for reducing biofilm densities while also minimizing harmful disinfection-by-products. The primary objective of this research was to evaluate effectiveness of alternative treatments for inactivating microorganisms comprising biofilms. A novel approach was designed for in situ growth of biofilms on steel coupons suspended from ‘chandeliers’. After more than 100 days of in situ growth, biofilms were harvested, sampled, and baseline biofilm densities quantified through cultivation. Ultraviolet-C (UV-C) and oxidative treatments including hydrogen peroxide (H₂O₂), ozone (O₃) and mixed oxidants were then applied to the biofilms in laboratory-scale treatments. Microbial inactivation was assessed by comparing treated versus baseline biofilm densities. H₂O₂ was the most effective treatment, and decreased density below baseline by as much as 3.1 orders of magnitude. Mixed oxidants were effective for the well having a lower density biofilm, decreasing density below baseline by as much as 1.4 orders of magnitude. Disparity in the response to treatment was apparent in the wells despite their spatial proximity and common aquifer source, which suggests that microbiological communities are more heterogeneous than the natural media from which they originate.     

Limiting explosible concentration of hydrogen–oxygen–helium mixtures related to the practical operational case

This paper presents data on the limiting (minimum) concentrations of hydrogen in oxygen, in the presence of added helium, at elevated temperature and pressure related to the practical operational case. A 5 L explosion vessel, an ignition sub-system and a transient pressure measurement sub-system were used. Through a series of experiments carried out using this system, the limiting concentrations of hydrogen in oxygen and helium at different initial pressures and temperatures for the practical operational case were studied, and the influence of ignition energy and initial temperature on the limiting concentration of hydrogen in oxygen and helium was analyzed and discussed. The variation of ignition energy within the studied range is found to have a significant effect on the limiting concentration of hydrogen in oxygen and helium at lower initial temperature. However, when the ignition energy is higher than 32 mJ, the limiting hydrogen concentration remains almost changeless as the initial temperature increases from 21 °C to 90 °C. The limiting explosible concentration of hydrogen–oxygen–helium mixture decreases as the ignition energy increases when the initial temperature is lower. When the initial temperature is higher, the ignition energy has little effect on the limiting hydrogen concentration of hydrogen–oxygen–helium mixtures. When the initial temperature reaches 90 °C, the limiting hydrogen concentration remains almost changeless with an increase in ignition energy. The limiting explosible concentration of hydrogen in the mixtures, at the initial temperature of 21 °C and the ignition energy of 0.5 mJ, is 8.5% and that of oxygen is 11.25%.     

Validation of the UN test method N.5

Many substances react with water in such a way that flammable gases are formed. For transport issues this reaction may possess a considerable hazard especially if the cargo is wetted by rain or by water from other sources. In the UN Recommendations on the Transport of Dangerous Goods these kinds of problems are addressed. The UN test N.5 “Test method for substances which in contact with water emit flammable gases” corresponds to this hazard. Classification according to the test method is done by measurement of the gas evolution rate of the flammable gas by any suitable procedure. At BAM a gravimetric approach is used to measure the gas evolution rate. In this paper we present the evaluation of the apparatus by means of an absolute calibration routine utilizing a reaction where a known amount of gas is produced as well as the evaluation of important parameters influencing the gas evolution rate using different substances. It can be shown that the apparatus is capable of measuring absolute gas volumes as low as 6 mL with an acceptable error of about 17% as determined from the reaction of Mg with demineralized water.     

Thermodynamic method for the prediction of solid CO2 formation from multicomponent mixtures

The increase in GHG concentration has a direct effect on global climate conditions. Among the possible technologies to mitigate GHG emissions, CCS is being accepted to gain emission reduction. Such technology also involves cryogenic CO₂ capture processes based on CO₂ freeze-out or where the formation of solid CO₂ must be avoided. Captured CO₂ is usually transported in pipelines for the reinjection.The risk associated to the release of CO₂ is due to the changing temperatures and pressures the system may experience, which can lead to the deposition of solid CO₂ where it must be avoided. Prolonged exposure to dry ice can cause severe skin damage and its resublimation could pose a danger of hypercapnia. It is, thus, necessary to build up a tool able to predict the conditions in which CO₂ can freeze-out.A thermodynamic methodology based on cubic EoSs has been developed which is able to predict solid–liquid–vapor equilibrium of CO₂ mixtures with n-alkanes or H₂S which are usually found in equipment for acidic gas, mainly natural gas, treatment.The focus is a detailed analysis of the method performances when more than two components are present since, for such a case, literature does not provide significant modeling results.     

Effect of white African mineral hair dye on the activities of phosphatases and malondialdehyde level in selected tissues of albino rats

The effect of white African mineral dye Yombofita (YF) on the activities of alkaline phosphatase (ALP), acid phosphatase (ACP) and malondialdehyde (MDA) levels in the skin, liver, kidney and serum of albino rats was investigated. The chemical analysis of the dye was first carried out using solubility test, pH determination and X-ray fluorescence (XRF) elemental analysis. Six different concentrations (0.05, 0.15, 0.25, 0.5, 0.75 and 1.00%) of the dye were prepared using hydrogen peroxide (30 volume) as solvent. A total of 80 albino rats (Rattus norvegicus) were used for the study. The rats were divided into 8 groups of 10 each and were maintained on commercial feed for the period of the experiment i.e. 30 days. In group 1, the control group, the animals were applied distilled water on their heads, whereas in group 2 the vehicle i.e. hydrogen peroxide was applied. In groups 3 to 8 various concentrations of YF (white) dye ranging from 0.05, 0.15, 0.25, 0.5, 0.75 to 1.00% was applied respectively. At the end of the experiment, blood samples were collected and portions of the selected tissues were excised for the determination of ALP and ACP activities. The MDA level was also determined in the skin of experimental animals. The results revealed a significant decrease (p?p?相似文献