消费电子产品生产过程中挥发性有机物(VOCs)排放特征的研究

选取塑胶零件、印刷线路板及主板3类消费电子产品部件为研究对象,利用活性炭管采样,样品溶剂解吸后采用GC/MS分析,获得了各排气筒及车间内VOCs含量水平与组分特征.通过计算排放量,得出了分物种VOCs排放系数.结果表明,塑胶零件生产线排气筒总挥发性有机物(TVOCs)浓度为48.01~115.05 mg·m-3,印刷线路板为6.08~11.36 mg·m-3,主板为29.81~30.21 mg·m-3.塑胶零件生产车间内TVOCs浓度为4.23~120.58 mg·m-3,印刷线路板为1.50~2.02 mg·m-3,主板为7.01~9.93 mg·m-3.环烷烃类、酯类、苯类为主要排放物质.对于不同产品生产线的排气筒及车间废气,浓度和物种均有很大差异;对于相同产品,浓度有差异但物种基本相同.按产品分类,共计算得出了36个分物种VOCs排放系数,其中,塑胶零件、印刷线路板及主板TVOCs排放系数分别为0.626 kg·kg-1涂料用量、0.123 kg·kg-1油墨用量、0.028 kg·kg-1印刷线路板用量.通过排放量计算结果分析,3种产品中,塑胶零件生产为VOCs主要排放源,车间内无组织排放为主要排放方式.     

Rapid and simple spectrophotometric determination of persulfate in water by microwave assisted decolorization of Methylene Blue

A rapid and simple method for determination of persulfate in aqueous solution was developed. The method is based on the rapid reaction of persulfate with Methylene Blue(MB) via domestic microwave activation, which can promote the activation of persulfate and decolorize MB quickly. The depletion of MB at 644 nm(the maximum absorption wavelength of MB) is in proportion to the increasing concentration of persulfate in aqueous solution. Linear calibration curve was obtained in the range 0–1.5 mmol/L, with a limit of detection of 0.0028 mmol/L. The reaction time is rapid(within 60 sec), which is much shorter than that used for conventional methods. Compared with existing analytical methods, it need not any additives, especially colorful Fe2+, and need not any pretreatment for samples, such as p H adjustment.     

Microwave-assisted continuous flow phytosynthesis of silver nanoparticle/reduced graphene oxide composites and related visible light catalytic performance

The creation of an environmentally friendly synthesis method for silver nanomaterials (AgNPs) is an urgent concern for sustainable nanotechnology development. In the present study, a novel straightforward and green method for the preparation of silver nanoparticle/reduced graphene oxide (AgNP/rGO) composites was successfully developed through the combination of phytosynthesis, continuous flow synthesis and microwave-assistance. Oriental persimmon (Diospyros kaki Thunb.) extracts were used as both plant reducing and capping agents for fast online synthesis of AgNP/rGO composites. The experimental parameters were optimized and the morphologies of the prepared materials were investigated. The characterization results reveal that spherical AgNPs were quickly synthesized and uniformly dispersed on rGO sheets using the proposed online system. Fourier transform infrared spectroscopy analysis confirmed that phenols, flavonoids, and other substances in the plant extracts played a decisive role in the synthesis of AgNP/rGO composites. Using sodium borohydride (NaBH₄) degradation of p-nitrophenol (4-NP) as a model, the catalytic activity of the prepared AgNP/rGO materials was evaluated. The complete degradation of 4-NP was achieved within 12 min through the use of AgNP/rGO materials, and the composite had a much better catalytic activity than the bare AgNPs and rGO had. Compared with the conventional chemical method, our online method is facile, fast, cost-efficient, and environmentally friendly.     

印制电路板项目竣工验收监测工作探讨

以福建省莆田市为例,研究分析了印制电路板项目竣工环境保护验收监测现场踏勘中存在的问题,提出要加强对项目的现场核查,以及对环保设施建设及运行、建设内容变更、环境风险、危险废物处理等的建议与对策。     

血压监护系统的电路分析和印刷电路板设计

本文介绍了血压监护系统的电路设计,其中前端电路的设计采用差分多级放大电路,达到放大的效果。应用PSpice软件对滤波电路进行了仿真,得到了带通滤波器的通带频率,验证了滤波器设计的可行性。同时本文对血压监护系统印刷电路板中电磁兼容问题进行了研究,对血压监护系统电路板的布局布线规则进行了规划和设计。     

热带海洋环境条件对印制电路板性能参数的影响分析

分析了热带海洋环境条件对印制电路板影响的主要敏感电气参数,采用典型印制电路板工艺样件开展了西沙自然大气暴露试验,根据试验结果,对敏感参数的变化规律进行了分析。     

“混凝沉淀+纳米零价铁”处理印刷电路板生产废水中试研究

提出一种新纳米零价铁反应器(Nanoscale Zero-Valent Iron Reactor,简称NIR)及"混凝沉淀+纳米零价铁"处理工艺,通过实际生产废水进行中试,考察和研究该工艺和NIR技术处理江苏省某市印刷电路板(Printed Circuit Board,简称PCB)工业园区废水的效果。结果表明,此工艺对PCB生产废水中Cu、TP及COD Cr去除率分别可达到97.3%、73.7%、26%,其中Cu处理效果最佳;XRD结果表明,纳米零价铁(Nanoscale Zero-Valent Iron,nZVI)与PCB生产废水反应后含有γ-Fe2O3、Fe3O4、γ-FeOOH、CuO、Cu2O、Cu0等产物。"混凝沉淀+纳米零价铁"工艺处理废水时具有处理效果好、工艺耐冲击性能好、产泥量小、不易造成二次污染等优点。     

铁炭微电解预处理电路板废水

采用铁炭微电解法预处理电路板废水.结果表明,在进水pH为2.00、铁炭质量比为4:1、振荡时间为20 min的铁炭微电解静态实验最佳条件下,絮凝出水COD去除率为30%;在进水pH为2.00、铁炭质量比为4:1、水力停留时间为50 min的铁炭微电解柱动态实验最佳条件下,连续曝气.絮凝出水COD为11021 mg/L,COD去除率约为34%,BOD5/COD从0.12上升到0.32,可生化性提高,Cu2+质量浓度从9.11 mg/L下降至0.76 mg/L,降低了废水的生物毒性,为生化处理创造了条件.     

水样中有机磷的微波消解

采用微波消解系统对水样中有机磷进行消解，考察了消解时间、功率等不同实验条件对样品微波消解的影响；并将该法与总磷测定的常规消解方法进行了比较，结果表明，微波消解法简便、快速、准确、可靠     

微波萃取技术在分析土壤中有机污染物的应用

介绍了微波萃取技术及其使用的试剂、设备和条件，对微波萃取在分析土壤中有机污染物的应用予以综述，阐述了微波萃取技术是分析土壤中有机污染物的好方法。