钴氨溶液脱除NO研究

利用Co(NH₃)₆²⁺离子作主催化剂(由可溶性钴盐溶于氨水中形成),烟道气中的O₂作氧化剂,碘阴离子作助催化剂,在液相中实现NO的催化氧化和回收、SO₂的吸收和氧化.与过氧化氢和Fe-EDTA法相比该法具有持续时间长、效率高等优点,NO的脱除率可达80%以上;SO₂的脱除率可达100%,能实现高效率地同时脱硫脱硝.     

栅藻对金属离子的异质敏感性与其细胞周期的关系

研究同一种群中不同状态的藻细胞对毒物的应答对理解生物体敏感性以及毒物的致毒机理十分重要.应用流式细胞技术研究了栅藻对重金属元素(Cd²⁺和Ni²⁺)的敏感性.将同一种群的栅藻细胞按其体积大小(FSC参数)分为不同组分,在暴露于毒物后分析不同组分细胞的酯酶活性.结果显示随着细胞体积的增加,其对2种金属离子的抗性逐渐增强.在分析各组分细胞的DNA量时发现栅藻的细胞大小与其所处的细胞周期具有一定关系:随着体积的增大,栅藻细胞逐渐从G₁期进入G₂/M期,其中,G₂/M期的藻细胞对金属离子具有较强的抗性.进一步表明处于不同的细胞周期可能是决定同一种群中栅藻细胞对金属离子具有不同敏感性的重要原因.     

染料废水电催化氧化及降解动力学研究

以新型钛基二氧化铅电极为阳极、石墨为阴极、活性炭-纳米二氧化钛为催化粒子电极降解染料模拟废水酸性红B溶液,考察了槽电压、pH值、催化剂量等对处理效果的影响。实验结果表明:纳米二氧化钛催化剂的催化效果显著,该反应器能够有效的降解酸性红B,降解机制主要是电致H2O2、.OH对有机物的氧化、降解。同时用一级反应拟合了酸性红B溶液COD去除反应,由实验数据确定了反应动力学方程。     

介质阻挡放电联合催化臭氧化降解甲苯

采用介质阻挡放电区后结合MnOx/Al2O3/发泡镍去除甲苯,考察甲苯进气方式、臭氧产生方法及湿度对甲苯与O3同时去除的影响。结果表明,O3是等离子体区后催化降解甲苯的主要物种,介质阻挡放电联合催化臭氧化可实现甲苯及O3的同时高效去除。输入电压为9.0 kV时,甲苯的去除效率达92.8%,在80 min内O3的去除效率维持在99%以上。水蒸气对催化剂催化分解臭氧的活性没有直接的影响,O3浓度较高时湿度对甲苯降解效率的影响很小。GC-MS分析结果表明,甲苯降解的主要气相副产物有烷烃、酸、酮和含苯环有机物,提出了甲苯的降解途径。     

镍基催化剂对污泥微波热解制生物气效能的影响

为实现污水污泥减量化、无害化及资源化的目标,在微波热解污水污泥基础上,进行了镍基催化剂对制取生物气效能影响的研究。采用元素分析对污泥元素进行检测,气/质联用分析(GC-MS)和气相色谱(GC)对热解生物气的组成和含量进行测定。实验结果表明,镍基催化剂的添加对微波热解污水污泥制取生物气有较大促进作用。5%添加量与800℃热解终温条件下具有最佳催化效果:生物气中H2、CO产量最大,H2产量由29 g/kg增加到35.8 g/kg,提升23.4%,CO产量由302.7 g/kg增加到383.3 g/kg,提升26.6%;同时催化剂还能提高热能利用效率,降低热解终温,即5%添加量在700℃热解终温时可达到空白800℃时的产气效果;镍基催化剂主要在500~600℃时发挥催化作用,加快了H2和CO的释放。微波热解污泥制取的生物气具有产量大、富含H2与CO等优点,可推动污水污泥的资源化进程。     

溴酸钾对二茂铁(Fc)非均相Fenton效能的影响

研究了KBrO3对二茂铁(Fc)非均相Fenton效能的影响,深入考察了KBrO3对体系中Fc溶解、H2O2分解和羟基自由基(·OH)生成的影响。结果表明,KBrO3的加入对不同反应阶段Fc/Fenton体系的效能均有明显的促进作用,初始阶段主要是由于KBrO3对·OH产生的促进作用所致,后期主要是由于KBrO3促进了体系中Fc的溶解,使得体系中溶解态的Fc催化的均相Fenton反应的比例增加,体系中H2O2的分解加快,·OH的表观生成率增加,进而促进了反应的进行。无KBrO3添加,pH=4,MB初始浓度为10 mg/L,Fc的量为1.6×10-3mol/L,[H2O2]/[MB]=3.14时,45 min时,MB的剩余率为9.1%,105 min时为0。当KBrO3的用量为3×10-4mol/L时,反应45 min后MB的去除率即可达到100%。随着KBrO3浓度的增加,其对Fc/Fenton效能的促进作用增强。     

表面铜螯合磁性二氧化硅固定化漆酶及其催化降解水中2，4-二氯酚

利用磁性二氧化硅表面接枝的聚丙烯酰胺络合Cu2＋离子,制备了表面铜螯合磁性SiO：材料,采用傅立叶红外光谱（FT．IR）,X射线衍射（XRD）对该磁性材料进行了表征,并通过配位作用固定化漆酶,考察了其对水中2,4-二氯酚（2,4-DCP）的催化降解效能及主要影响因素。结果表明,表面铜螯合磁性SiO：固定化漆酶对2,4-DCP具有较好的催化降解效能,利用8g／L固定化漆酶催化降解50mL初始浓度为24．25mg／L的2,4-DCP,反应12h2,4-DCP去除率达91％;当pH值在3．0～6．0范围内时,2,4-DCP的去除率随反应pH值的增加而升高;2,4-DCP初始浓度在14．39～257．6mg／L范围内时,反应12h,2,4-DCP的去除率均达85％以上;给酶量增加促进2,4-DCP的去除,但过多的给酶量导致单位质量固定化漆酶催化降解2,4-DCP的速率下降;水中硫酸根离子对固定化漆酶催化降解2,4-DCP具有明显的促进作用,而碳酸氢根离子明显抑制反应的进行。     

微波诱导催化技术在环境治理中的应用研究

微波诱导催化技术以其快速、高效和无二次污染等特点,日益受到环保研究者的重视。目前,微波诱导催化技术已在大气污染控制、水污染控制及固体废弃物处理与处置等环境治理领域取得了显著效果。阐述了微波诱导催化技术的基本原理、催化反应的催化剂和载体及催化反应的机制,归纳了微波诱导催化技术在环境治理中的应用现况及实例,分析了微波诱导催化技术在实际应用中存在的问题,并提出相应的解决措施,最后对微波诱导催化技术在环境治理领域中的进一步应用进行了展望。     

Ozone facilitated degradation of caffeine using Ce-TiO2 catalyst

The ozone initiated oxidation of 1,3,7-trimethylxanthine (caffeine), commonly found in wastewaters as model compound is reported using cerium (Ce)/titanium dioxide (TiO₂) as catalyst. The effect of pH and loading of ceria on titania were investigated. Effect of reaction conditions on degradation of caffeine based on their pseudo first-order rate constants were compared. The combination of catalyst Ce-TiO₂ and ozone aeration significantly enhanced the degradation of caffeine compared to uncatalysed ozonation. The oxidation of caffeine ensued via the free radical mechanism, through enhanced ozone decomposition into OH radicals. Ce/TiO₂(0.5?wt%) showed good activity in degradation of caffeine at pH 6, in both natural stream and river water samples showing about 60% total organic carbon removal in 2?h ozonation period. Using liquid chromatography-mass spectroscopy, degradation products were analysed. A reaction intermediate and one final product were positively identified. Nano-catalysts with different loadings of Ce on TiO₂ synthesized by sol-gel route were characterized by scanning electron microscope, transmission electron microscopy, BET and powder X-ray diffraction spectrum techniques. The results showed that the material retained a highly ordered mesoporous structure and possessed large surface area.     

The chemical exploitation of nickel phytoextraction: An environmental, ecologic and economic opportunity for New Caledonia

Herein, we explore the outlines of an innovative method based on the chemical recovery of metal-rich biomass produced in phytoextraction technologies. Taking advantage of the adaptive capacity of some New Caledonian plants to hyperaccumulate Ni²⁺ cations in their aerial parts, this technique is based on the direct use of metals derived from plants as “Lewis acid” catalysts in organic chemistry. Metallic cations contained in New Caledonian nickel hyperaccumulators are recovered through a simple cost-effective process and serve the preparation of heterogeneous catalysts used in synthetic transformations allowing access to molecules with high added-value. The design of all processes is in line with the principles of green chemistry; it is adapted to the new economic constraints; it offers a new relevant outlet for metal-rich biomass; and it represents an alternative to non-renewable mineral materials.