氨气敏电极法和纳氏试剂分光光度法对地表水中氨氮的比对测试

采用不同质量浓度的氨氮标准样品和实际样品,用氨气敏电极法和纳氏试剂分光光度法进行同步测试。结果表明,2种分析方法在水样氨氮质量浓度在0. 159～2. 81 mg/L范围内具有良好的可比性、精密性和准确性。氨气敏电极法的检出限为0. 03 mg/L,平行6次测定样品的相对标准偏差为0. 4%～4. 2%,加标回收率为85. 0%～110%;纳氏试剂分光光度法的检出限为0. 025 mg/L,平行6次测定样品的相对标准偏差为0. 5%～6. 4%,加标回收率为93. 0%～99. 8%。同时氨气敏电极法在样品预处理、试剂配制和分析时间上要优于纳氏试剂分光光度法。氨气敏电极法能够满足地表水自动监测在线比对实际工作的需求,该方法具有良好的适用性。     

网络版摘要

超临界水处理垃圾渗滤液膜过滤浓缩液的研究严光亮1张美兰1董宇2夏前勇2申哲民2(1.上海老港废弃物处置有些公司,上海201302;2.上海交通大学环境科学与工程学院,上海200240)研究了超临界水在不同条件下处理垃圾渗滤液膜过滤浓缩液(以下简称浓缩液)的效果,并使用紫外分光光度计对处理前后的浓缩液进行分析。结果表明,采用超临界水处理     

紫外分光光度法测定海水中石油类的不确定度评定

对紫外分光光度法测定海水中石油类浓度进行了不确定度评定。通过对标准溶液、标准工作曲线拟合、前处理过程等影响测定结果的不确定度分量进行分析,计算出测定结果的扩展不确定度,并找出影响该不确定度的主要因素。结果表明,紫外分光光度法测定海水中石油类浓度的不确定度的主要来源是实验中前处理过程的不确定度,本次实验所测海水中石油类浓度的不确定度报告为19.98±1.326 mg/L。     

基于OP-FTIR技术的炼油装置VOCs排放量监测

随着挥发性有机物排污收费政策的逐步实施,快速准确地监测企业VOCs排放量已成为环保部门和企业共同面对的难题。介绍了开路式傅里叶变换红外光谱技术原理及优势,研究了质量通量模式VOCs排放量计算方法,并以300 m×300 m某装置区域为例,完成了现场红外光谱测量、气象数据采集、数据有效性分析和VOCs排放量计算。研究结果表明,开路红外光谱技术极大提高了VOCs排放数据采集效率和准确性,进一步计算得出该装置区域VOCs年排放量平均值为98.7 t,为企业开展VOCs排放量核算提供了参考。     

分光光度法测定总氮的准确度研究

采用碱性过硫酸钾消解紫外分光光度法测定水中总氮时常出现空白值偏高、样品平行性较差、实验准确度不高等现象.为此,从总氮的测定过程出发,探讨了影响总氮测定的主要因素,有利于提高水质总氮测定的准确度.结果表明,分析试剂纯度、实验用水水质、器皿的清洗程度等对总氮的测定均有一定影响,适当延长消解时间与提高消解温度也有利于降低总氮的空白值.因此可通过优化各实验条件来提高实验的准确性,以保证实验室的设备仪器、检测人员和环境等条件满足分析要求.     

等离子体催化降解甲苯途径的原位红外研究

考察了在常温常压条件下,等离子体分别协同SiO₂、Al₂O₃、NiO/Al₂O₃降解甲苯的性能,并从材料的介电常数、对甲苯的吸附性及臭氧分解能力等角度分析了不同活性表现的原因,同时,采用原位红外技术研究了甲苯降解过程中催化剂表面吸附物种的变化.结果表明,当甲苯浓度为100 ppm,气体流量为100 mL·min^-1时,一定范围内,甲苯降解率随着能量密度、介电常数、吸附性及臭氧分解能力的提高而提高.甲苯在催化剂表面的吸附对其降解途径有十分重要的影响:在放电区域中加入SiO₂,甲苯仍然在气相中完成降解;而存在Al₂O₃ 及NiO/Al₂O₃时,甲苯氧化成苯甲酸的过程主要发生在催化剂表面,是甲苯催化降解的关键步骤,苯甲酸在活性位点的积累将降低催化剂的反应活性.     

浅谈火焰原子吸收分光光度计应用重金属分析的优缺点

随着逐渐使用原子吸收分光光度计来分析重金属,本文阐述实际使用火焰原子吸收分光光度计中的一些优缺点,达到爱护贵重仪器,同时提高分析应用水准目的。     

Degradation of direct azo dye by Cucurbita pepo free and immobilized peroxidase

Enzymatic decolourization of the azo dye, Direct Yellow (DY106) by Cucurbita pepo (courgette) peroxidase (CP) is a complex process, which is greatly affected by pH, temperature, enzyme activity and the concentrations of H₂O₂ and dye. Courgette peroxidase was extracted and its performance was evaluated by using the free-CP (FCP) and immobilized-CP (ICP) forms in the decolourization of DY106. Immobilization of peroxidase in calcium alginate beads was performed according to a strategy aiming to minimize enzyme leakage and keep its activity at a maximum value by optimizing sodium alginate content, enzyme loading and calcium chloride concentration. The initial conditions at which the highest DY106 decolourization yield was obtained were found at pH 2, temperature 20℃, H₂O₂ dose 1 mmol/L (FCP) and 100 mmol/L (ICP). The highest decolourization rates were obtained for dye concentrations 50 mg/L (FCP) and 80 mg/L (ICP). Under optimal conditions, the FCP was able to decolorize more than 87% of the dye within 2 min. While with ICP, the decolourization yield was 75% within 15 min. The decolourization and removal of DY106 was proved by UV-Vis analysis. Fourier transform infrared (FT-IR) spectroscopy analysis was also performed on DY106 and enzymatic treatment precipitated byproduct.     

Fe2O3 particles as superior catalysts for low temperature selective catalytic reduction of NO with NH3

Fe203 particle catalysts were experimentally studied in the low temperature selective catalytic reduction （SCR） of NO with NH3. The effects of reaction temperature, oxygen concentration, [NH3]/[NO] molar ratio and residence time on SCR activity were studied. It was found that Fe203 catalysts had high activity for the SCR of NO with NH3 in a broad temperature range of 150-270℃, and more than 95% NO conversion was obtained at 180℃ when the molar ratio [NH3]/[NO] = 1, the residence time was 0.48 seconds and 02 volume fraction was 3%. In addition, the effect of SO2 on SCR catalytic activity was also investigated at the temperature of 180℃. The results showed that deactivation of the Fe2O3 particles occurred due to the presence of SO2 and the NO conversion decreased from 99.2% to 58% in 240 min, since SO2 gradually decreased the catalytic activity of the catalysts. In addition, X-ray diffraction, Thermogravimetric analysis and Fourier transform infrared spectroscopy were used to characterize the fresh and deactivated Fe2O3 catalysts. The results showed that the deactivation caused by SO2 was due to the formation of metal sulfates and ammonium sulfates on the catalyst surface during the de-NO reaction, which could cause pore plugging and result in suppression of the catalytic activity.     

测定总氮中影响因素的探讨

本文研究了过硫酸钾氧化紫外分光光度法测定总氮的过程中,通过标准曲线、标准物质、具体试样的一系列测定探讨,发现试剂、实验用水、实验器皿、实验环境等对测定结果有很大影响。