钴（Ⅱ）－过氧化氢－苯基荧光酮体系催化光度法测定痕量钴的研究

本文研究了钴（Ⅱ）催化过氧化氢氧化苯基荧光酮的褪色反应，测定了反应级数和表观活化能，建立了测定痕量地的新方法。２５℃时本法检出限为２９×１０－１３ｇ／ｍｌ，线性范围为０．０４～２ｎｇ／１０ｍｌ，催化反应表观活化能为５６．１５ＫＪ／ｍｏｌ。该方法己用于维生素Ｂ１２、人发和茶叶中痕量钴的测定．结果满意，相对标准偏差为２．４～３．４％。     

纳米TiO2/CNTs复合材料的制备及其光学性质

TiO2在碳纳米管上的复合材料可以增加材料的光催化性能,已成为新的研究热点.本文采用低温液相法成功地合成了TiO2/CNTs复合材料,并用TEM、XRD和UV-vis对材料进行了表征,结果表明,TiO2很好地分散在CNTs上,具有显著的催化效果,有很好的应用前景.     

Preparation of rare-earth metal complex oxide catalysts for catalytic wet air oxidation

Catalytic wet air oxidation (CWAO) is one of the most promising technologies for pollution abatement. Developing catalysts with high activity and stability is crucial for the application of the CWAO process. The Mn/Ce complex oxide catalysts for CWAO of high concentration phenol-containing wastewater were prepared by coprecipitation. The catalyst preparation conditions were optimized by using an orthogonal layout method and single-factor experimental analysis. The Mn/Ce serial catalysts were characterized by Brunauer-Emmett-Teller (BET) analysis and the metal cation leaching was measured by inductively coupled plasma torch-atomic emission spectrometry (ICP-AES). The results show that the catalysts have high catalytic activities even at a low temperature (80°C) and low oxygen partial pressure (0.5 MPa) in a batch reactor. The metallic ion leaching is comparatively low (Mn<6.577 mg/L and Ce<0.6910 mg/L, respectively) in the CWAO process. The phenol, COD_Cr, and TOC removal efficiencies in the solution exceed 98.5% using the optimal catalyst (named CSP). The new catalyst would have a promising application in CWAO treatment of high concentration organic wastewater. Translated from Techniques and Equipment for Environmental Pollution Control, 2005, 6(2): 40–44 [译自: 环境污染治理技术与设备]     

LPWCO method for the treatment of high concentrated organic wastewater

Based on wet air oxidation (WAO) and Fenton reagent, thispaper raises a new low pressure wet catalytic oxidation(LPWCO)which requires low pressure for the treatment of highlyconcentrated and refractory organic wastewater. Compared withgeneral wet air oxidation, the pressure of the treatment(0.1-0.6MPa) is only one of tens to percentage of latter(3.5-10MPa). Inaddition, its temperature is no more than 180℃.Compared withFenton reagent, while H2O2/COD(weight ratio) less than 1.2, theremoval of COD in the treatment is over twenty percents more thanFenton's even the value of COD is more than 14000mg/L. In thispaper, we study the effect factor of COD removal and the mechanismof this treatment. The existence of synergistic effect (catalytic oxidation and carbonization) for COD removal in H2SO4-Fenton reagent system under the condition of applied pressure and heating (0.1-0.6MPa, 104-165℃) was verified. The best condition of this disposal are as follows:H2O2/COD(weight ratio)=0.2-1.0, Fe2+ 0.6×10-3 mol, H2SO4 0.5mol, COD>1×104mg/L, the operating pressure is 0.1-0.6MPa and temperature is 104-165℃. This method suit to dispose the high-concentrated refractory wastewater, especially to the wastewater containing H2SO produced in the manufacture of pesticide, dyestuff and petrochemical works.     

车用催化转化器及其对发动机性能影响的研究

本文论述了影响催化转化器性能的主要因素有催化剂，催化剂的中毒失效，催化转化器的结构和排气系统的影响，温度、发动机工作状况等；强调催化转化器的结构与发动机及排气系统匹配的重要性。     

V2O5-WO3/TiO2脱硝催化剂的制备及其性能

对选择性催化还原脱硝用催化剂V2O5-WO3/TiO2的制备工艺进行了实验研究.采用溶胶-凝胶法制得TiO2凝胶,对凝胶进行不同条件下的干燥和煅烧处理,然后通过浸渍法在TiO2上依次负载WO3和V2O5,最终得到V2O5-WO3/TiO2催化剂.结果表明,TiO2凝胶的处理温度对催化剂结构和脱除NO的性能有一定的影响,TiO2凝胶干燥温度为105 ℃时制得的催化剂活性较高,在实验条件下NO脱除率最高可达98.3%.     

磁场对酪氨酸酶活性及其催化降解酚类有机物影响的研究

研究了恒磁场对酪氨酸酶(TYR)活性及其催化降解酚类有机物的影响.结果显示,不同磁场强度(10～350 mT)处理下TYR酶活性均有提高,最佳磁场强度150mT下酶活力提高了27.1%.不同磁化时间下TYR酶活都有上升,但磁化60min后酶活上升幅度有所下降.酶经磁场处理后对温度、pH值稳定性增强,在温度为20～35 ℃、pH为5.0～10.0时均能保持较高活性,最佳温度为25℃,最佳pH为7.0;磁化后TYR酶的Michaelis常数Km为3.83 mmol·L-1,未磁化的Michaelis常数Km为2.65 mmol·L-1.磁场作用可促进TYR对酚类有机物邻苯二酚、苯酚、2,4-二氯酚的转化,反应速度依次递减,磁化处理对邻苯二酚反应的促进作用尤其明显;磁化处理后的酶对不同浓度苯酚和2,4-二氯酚的去除率均明显高于未磁化处理的酶,且随着酶用量增加,酚去除率提高.荧光发射光谱分析表明,磁化酪氨酸酶的荧光强度增强,构像发生了变化.     

复合催化氧化技术对油气田压裂返排液的处理研究

酸化压裂作业废水是石油天然气生产过程中的主要污染源,它的污染成份复杂,有害物质浓度高,特别是含有胍胶和表面活性剂等高分子物质,具有高COD、高稳定度、高粘度的特点.本文通过对压裂液的来源、水质特征、治理现状等常用方法的分析,确定了物理化学脱稳,过滤、O3/H2O2复合催化氧化、深度氧化的达标治理工艺路线.经过处理后的压裂液澄清透明,达到国家二级排放标准(GB8978-96).     

上海市大气气溶胶中铂元素污染状况调查

为调查上海市大气气溶胶中铂元素的污染状况,用PM10-2型可吸入颗粒物采样器采集了上海市大气气溶胶样品,采样时间分别为2003-12～2005-12.用微波消解密闭系统消解样品,电感耦合等离子体质谱法(ICP-MS)测定了大气气溶胶中Pt的含量.分析结果表明,同清洁对照点((0.65±0.16)pg·m-3)相比,上海市中心区大气中Pt((1.69±0.93)pg·m-3)的污染是明显的;装有三元催化转化器的汽车尾气中Pt的含量均在100ng·g-1以上,远远高于大气气溶胶样品(人民广场平均值21.7ng·g-1);不同交通密度区Pt含量分析结果表明,Pt含量与交通密度紧密相关,这说明装有三元催化器的汽车尾气是气溶胶中Pt污染的主要来源;此外,上海市大气气溶胶中Pt呈现季节性变化,并受气象条件影响.同世界其它城市相比,上海市气溶胶中铂元素污染程度还较低,但是这种潜在的重金属污染应该引起重视.     

过氧化氢催化氧化难降解废水的研究

文章以过氧化氢为氧化剂,以γ-Al2O3为载体采用浸渍法制得不同金属含量的九种催化剂进行催化氧化实验,并优选出以5.0%Co、2.5?(质量百分含量)催化剂CODcr去除率较好,并确定此催化剂在常温常压下,反应时间为30 min,pH=6,氧化剂用量为30g/L时,CODcr的去除率最高为83%,这样不仅提高了BOD5/CODcr值,而且有利于后续生化处理,减轻后续处理装置负荷.