二氧化钛复合型催化剂制备及其微波辅助催化氧化甲苯性能

实验采用溶胶凝胶法和传统浸渍法制备了TiO2-分子筛复合载体及复合载体负载过渡金属与稀土元素催化剂,通过微波辅助催化氧化甲苯的性能实验考察其催化活性.结果表明,复合TiO2明显提高了载体结构的稳定性与耐温性,并使过渡金属铜(Cu)、锰(Mn)和稀土元素铈(Ce)等活性组分在催化剂表面的分散更均匀;在复合载体吸附、吸波性能与多相活性组分催化的共同作用下,Cu-Mn-Ce/TiO2-分子筛催化剂微波辅助催化氧化甲苯的完全燃烧温度仅为175℃,此时甲苯去除率可达99％;15 h的连续性实验表明,TiO2复合型催化剂具有良好的催化活性与稳定性.由催化剂表征分析结果可知,活性组分颗粒的均匀分布与铜、锰氧化物及铜锰尖晶石固溶物等活性相的存在促进了甲苯的催化氧化,锐钛矿型TiO2较高的电子迁移速率与催化剂孔径的增大均有助于甲苯的氧化降解.     

等离子体催化降解甲苯途径的原位红外研究

考察了在常温常压条件下,等离子体分别协同SiO₂、Al₂O₃、NiO/Al₂O₃降解甲苯的性能,并从材料的介电常数、对甲苯的吸附性及臭氧分解能力等角度分析了不同活性表现的原因,同时,采用原位红外技术研究了甲苯降解过程中催化剂表面吸附物种的变化.结果表明,当甲苯浓度为100 ppm,气体流量为100 mL·min^-1时,一定范围内,甲苯降解率随着能量密度、介电常数、吸附性及臭氧分解能力的提高而提高.甲苯在催化剂表面的吸附对其降解途径有十分重要的影响:在放电区域中加入SiO₂,甲苯仍然在气相中完成降解;而存在Al₂O₃ 及NiO/Al₂O₃时,甲苯氧化成苯甲酸的过程主要发生在催化剂表面,是甲苯催化降解的关键步骤,苯甲酸在活性位点的积累将降低催化剂的反应活性.     

Leaching of styrene and other aromatic compounds in drinking water from PS bottles

Bottled water may not be safer, or healthier, than tap water. The present studies have proved that styrene and some other aromatic compounds leach continuously from polystyrene （PS） bottles used locally for packaging. Water sapmles in contact with PS were extracted by a preconcentration technique called as ＂purge and trap＂ and analysed by gas chromatograph-mass spectrometer （GC/MS）. Eleven aromatic compounds were identified in these studies. Maximum concentration of styrene in PS bottles was 29.5 μg/L. Apart from styrene, ethyl benzene, toluene and benzene were also quantified but their concentrations were much less than WHO guide line values. All other compounds were in traces. Quality of plastic and storage time were the major factor in leaching of styrene. Concentration of styrene was increased to 69.53 μg/L after one-year storage. In Styrofoam and PS cups studies, hot water was found to be contaminated with styrene and other aromatic compounds. It was observed that temperature played a major role in the leaching of styrene monomer from Styrofoam cups. Paper cups were found to be safe for hot drinks.     

Effects of seed aerosols on the growth of secondary organic aerosols from the photooxidation of toluene

Hydroxyl radical （.OH）-initiated photooxidation reaction of toluene was carried out in a self-made smog chamber. Four individual seed aerosols such as ammonium sulfate, ammonium nitrate, sodium silicate and calcium chloride, were introduced into the chamber to assess their influence on the growth of secondary organic aerosols （SOA）. It was found that the low concentration of seed aerosols might lead to high concentration of SOA particles. Seed aerosols would promote rates of SOA formation at the start of the reaction and inhibit its formation rate with prolonging the reaction time. In the case of ca. 9000 pt/cm^3 seed aerosol load, the addition of sodium silicate induced a same effect on the SOA formation as ammonium nitrate. The influence of the four individual seed aerosols on the generation of SOA decreased in the order of calcium chloride〉sodium silicate and ammonium nitrate〉ammonium sulfate.     

一起甲苯爆炸事故的调查与分析

分析了利用压缩空气压送甲苯混合物时发生爆炸事故的直接原因和间接原因,提出了相应的对策.     

Modeling the influence of ethanol on the adsorption and desorption of selected BTEX compounds on bentonite and kaolin

The study investigated the effects of ethanol on the adsorption properties of bentonite and kaolin for benzene and toluene removal.     

双组分VOCs的催化氧化及动力学分析

考察了微波加热与管式炉加热下挥发性有机化合物(VOCs)甲苯与氯苯的催化氧化性能,并对双组分VOCs的反应动力学进行了分析.结果表明,VOCs的竞争吸附使得双组分中甲苯和氯苯的转化率比单组分降低3%~12%;微波的"热点效应"与"非热效应"使得VOCs转化效率明显优于管式炉加热,尤其是氯苯的转化率提高了31%~38%;微波加热降低了氧化反应温度和处理能耗.动力学分析表明,微波加热下甲苯和氯苯的反应活化能比管式炉加热下减少了2146 J·mol-1和1450J·mol-1,微波加热下氯苯的化学反应速率常数是管式炉加热的35倍,甲苯的反应速率常数提高了6倍.     

吸附增效低温等离子体法去除甲苯废气的研究

采用150Hz中频高压交流电源作为低温等离子体发生源,选用典型的微孔γ-Al2O3球形颗粒吸附剂(以下简称γ-Al2O3)作为等离子体反应器填充材料,协同低温等离子体法催化降解甲苯废气。考察了在不同条件下,γ-Al2O3的甲苯吸脱附效果和吸附增效低温等离子体法的甲苯去除效果。结果表明,甲苯降解反应主要发生在γ-Al2O3的表面,甲苯的去除率在一定的浓度范围内与γ-Al2O3表面吸附的甲苯量成正比关系;填充γ-Al2O3有利于提高甲苯去除率及等离子体反应器能量利用率;γ-Al2O3对臭氧的降解表现出一定的促进作用。     

MnxCe1-xO2／γ-Al2O3催化剂的制备及其催化甲苯的燃烧性能

以γ-Al2O3为载体，以MnxCe1-xO2为催化活性组分，采用浸渍法制备了一系列负载型MnxCe1-xO2／γ-Al2O3催化剂（x=0、0．2、0．4、0．6、0．8、0．9、1），在固定床反应器中评价了催化剂对甲苯的催化燃烧性能。结果表明，MnxCe1-xO2／γ-Al2O3催化剂的催化活性与催化剂的焙烧温度、活性组分MnxCe1-xO2的负载量以及Mn、Ce摩尔比有显著关系，其中焙烧温度550℃、负载量为20％、Mn、Ce摩尔比为4：1时，即MnxCe1-xO2／γ-Al2O3催化剂对甲苯的催化性能最佳，反应温度为180℃时，甲苯的转化率达到95％。并在连续100h的稳定性操作后，催化剂的活性基本无变化。采用XRD、BET以及SEM等分析测试手段对催化剂的结构以及表面进行了表征。