A2O工艺好氧末段溶解氧变化对脱氮除磷影响

采用连续流A2O工艺处理实际的生活污水,研究好氧末段在不同溶解氧(DO)浓度条件下对污泥沉降性能、系统脱氮除磷的影响,同时考察了DO对污泥硝化活性、厌氧释磷速率和反硝化脱氮速率的影响.结果表明,随着末段溶解氧的提高,污泥容积指数SVI从140降至100左右,后又升高到120～170;系统的硝化效果提高,氨氮的去除率从6...     

不同流量分配比对多级A/O工艺去除有机物及脱氮的影响

采用三级A/O工艺分段进水工艺处理低碳源生活污水,考察了进水流量分配比对系统去除有机物、硝化反硝化能力以及去除TN的影响。通过对水质指标沿程监测结果表明,不同流量分配比(4∶3∶3,5∶3∶2,6∶3∶1)对系统去除有机物及硝化效率影响不大,出水COD、氨氮分别均在30 mg/L、1 mg/L以下。但反硝化效果受流量分配比的影响较大,在流量比为5∶3∶2时,有效利用原水中碳源进行反硝化,反硝化效果最好。在流量比为5∶3∶2的情况下,TN出水为5.7 mg/L去除率为82.9%,优于流量分配比为6∶3∶1和4∶3∶3时的脱氮效果。总体而言,分段进水工艺在对碳源的有效利用及能耗节省方面优于单点进水。     

Fe3O4/SDS磁性纳米颗粒吸附水体中的Cd2+和Zn2+

一种新型纳米固相萃取吸附剂,由阴离子表面活性剂十二烷基磺酸钠(SDS)包裹在Fe3O4磁性纳米颗粒表面形成,用于吸附水溶液中的重金属离子。研究了吸附过程的主要影响因素(如SDS浓度、溶液pH等)以及解吸过程的最佳条件,并对其机理进行了初步的探讨。研究结果表明,共沉淀法制备的Fe3O4颗粒粒径分布均匀,平均粒径约为54 nm;SDS浓度为300 mg/L时,Fe3O4/SDS磁性纳米颗粒吸附Cd2+和Zn2+的能力最强;在一定浓度范围内,Fe3O4/SDS体系对Cd2+和Zn2+的吸附平衡数据符合Langmuir吸附等温方程,饱和吸附量分别为22.42 mg/g和13.95 mg/g。最终结果表明,Fe3O4/SDS磁性纳米颗粒具有较强磁分离能力和较好的吸附效果。     

A/O工艺N_2O的产生与释放的影响因素

采用A/O工艺,在连续运行条件下,以DO、SRT和硝化液回流比(R)为影响因素,对A/O生物脱氮工艺处理模拟城市生活污水过程中N2O的释放进行了研究。实验结果表明,SRT对A/O工艺N2O释放的影响最大,其次是DO,R的影响最小。N2O转化率随着SRT的升高而降低,当SRT从10 d升高到20 d时,总N2O平均转化率从0.319%下降到0.002%。总N2O转化率随着好氧池DO的升高先降低后有所升高,当DO分别为0.6 mg O2/L、1.2 mg O2/L、2.5 mg O2/L时,反应器的总N2O平均转化率分别为0.306%、0.007%和0.013%。R对N2O释放的影响差异不明显,总N2O平均转化率在300%时最低,为0.007%。N2O释放量最低的工艺运行条件组合是SRT为20 d、DO为1.2 mg O2/L、R为300%。     

异波折板水解酸化-A~2O一体化反应器实验研究

设计了异波折板水解酸化-A2O一体化反应器,进行生活污水处理的实验研究。10个月的实验结果表明,系统的最佳水力停留时间(HRT)为8 h时,最适COD进水浓度为240~600 mg/L,最佳混合液回流比(r)-污泥回流比(R)为250%~100%。控制反应器于以上运行参数下,25±2℃所对应的COD、TN和TP去除率分别为96.84%、67.55%和81.92%。当温度降至7℃时,其COD、TP和TN分别降至86.35%、50.25%和65.68%。基于实验分析结果,阐明了一体化反应器高效性的机理在于异波折板水解酸化段具有高效传质特性和A2O段具有复合式活性污泥-接触氧化好氧池的特点。     

用H2O2/Fe^3＋处理高浓度含甲醛废水的研究

研究采用H2O2/Fe^3＋催化氧化处理高浓度含甲醛废水,探讨了双氧水和催化剂投加量、反应pH及反应温度等操作条件对处理效果的影响,并通过酸溶解回用失活催化剂。结果表明,较优的操作条件为：H2O2/COD（质量比）=2.2～2.6,Fe^3＋/H2O2（摩尔比）=0.048～0.058,反应pH1.80～2.68,反应温度50℃,反应时间40 min;在上述操作条件下,甲醛去除率达到99%以上,COD去除率达到85%以上。失活的催化剂可通过稀酸溶解后循环使用,其效果与三价铁盐作催化剂的基本相同。采用H2O2/Fe^3＋处理含甲醛废水具有比采用H2O2/Fe^2＋较优的效果。     

The evolution of the Canadian mining industry: The role of regulatory punctuation

In this study, we analyze the evolution of Canada's mining industry from 1929 to 2006, focussing on the determinants of the number of firms in the industry and why this number changed over that period. Most empirical studies of industry evolution have focused on manufacturing industries that share similar structural characteristics. Perhaps because of this, extant models of industry evolution tend to ignore industry-specific and national-specific factors that can cause atypical trajectories, that is, heterogeneous industry evolution. Initial inspection of the Canadian mining industry shows that it is atypical in that it exhibits “negative skew” over time in the number of firms rather than the typical “positive skew.” We review two dominant theoretical approaches to industry evolution: the density-dependence theory and variants of industrial organization economics. We also consider possible sources of industry evolution heterogeneity, focussing particularly on “regulatory punctuation”. Using Canadian mining data, we find that the traditional models do not fully explain the changes in population size in Canada's mining industry. As a result, we introduce a number of hybrid models. The results from these hybrid models suggest that Canadian-specific regulatory punctuations, particularly the introduction of significant new taxes, environmental legislation, and incentives have shaped the trajectory of mining firm participation.     

Natural resources dynamics: Exhaustible and renewable resources,and the rate of technical substitution

In this paper we study both exhaustible and renewable resources in an endogenous growth model. In particular, we consider the hypotheses in which the rate of technical substitution (RTS) between those two inputs is or is not equal to one. Moreover, we depart from a basic theoretical framework to account for the negative externality constituted by waste accumulation. Finally, a comparative analysis is made between Pigouvian tax and waste recycling, as an environmental policy to correct market failure represented by refuse accumulation.     

Impact of carbon,oxygen and sulfur content of microscale zerovalent iron particles on its reactivity towards chlorinated aliphatic hydrocarbons

Zerovalent iron (ZVI) abiotically degrades several chlorinated aliphatic hydrocarbons (CAHs) via reductive dechlorination, which offers perspectives for in situ groundwater remediation applications. The difference in reactivity between ZVI particles is often linked with their specific surface area. However, other parameters may influence the reactivity as well. Earlier, we reported for a set of microscale zerovalent iron (mZVI) particles the disappearance kinetic of different CAHs which were collected under consistent experimental conditions. In the present study, these kinetic data were correlated with the carbon, oxygen and sulfur content of mZVI particles. It was confirmed that not only the specific surface area affects the disappearance kinetic of CAHs, but also the chemical composition of the mZVI particles. The chemical composition, in addition, influences CAHs removal mechanism inducing sorption onto mZVI particles instead of dechlorination. Generally, high disappearance kinetic of CAHs was observed for particles containing less oxygen. A high carbon content, on the other hand, induced nonreactive sorption of the contaminants on the mZVI particles. To obtain efficient remediation of CAHs by mZVI particles, this study suggested that the carbon and oxygen content should not exceed 0.5% and 1% respectively. Finally, the efficiency of the mZVI particles may be improved to some extent by enriching them with sulfur. However, the impact of sulfur content on the reactivity of mZVI particles is less pronounced than that of the carbon and oxygen content.     

Comparative Evaluation of Biomonitoring Techniques of Tropospheric Ozone

During a survey of tropospheric ozone pollution carried out using tobacco plants (Nicotiana tabacum L.) cv. Bel-W3, ozone- supersensitive, and cv. Bel-B, ozone-resistant, as bioindicators, the effectiveness of the traditional biomonitoring method, based on the use of adult plants, was compared with an innovative miniaturized kit of seedlings. The ratio of foliar and cotyledonar necrosis, respectively, was estimated as ozone injury rate. The miniaturized kit proved to be advantageous, since seedlings need only easy growth procedures and a large number of individuals can be placed in a small space, supplying good data amounts for statistical elaboration. Moreover, correlation studies among cotyledonar and foliar injury index and ozone levels monitored through physico-chemical measurements and results of analysis of variance tests highlighted the high sensitivity of the innovative methodology.