沈阳城市化进程对大气边界层影响研究

利用沈阳气象站2000-2010年高空观测数据,统计分析了各年探空温度和风速曲线,还依据统计得到的中性层结风速廓线资料,利用莫宁-奥布霍夫相似理论计算了下垫面的空气动力学参数,综合研究了沈阳城市化进程对大气边界层的影响。结果表明:(1)随着城市化进程的发展,地面平均温度呈逐年升高的趋势,但升温幅度很小;高层温度也有增加的趋势,增温幅度很小。(2)垂直温度递减率有增加的趋势,这表示城市化程度的发展对边界层的影响也是显著的。(3)由于下垫面城市化程度的提高,在不同高度上风速都有不同程度的减小的趋势。(4)摩擦速度逐年增加,对风速的消减作用逐渐增强;粗糙度逐年增高和零平面位移逐年增大,可见沈阳下垫面城市化的程度逐年增加。     

酒石酸淋洗过程中土壤重金属解吸动力学特征

采用批处理淋洗的方法,研究了酒石酸淋洗修复张士污灌区土壤过程中镉、铅、铜、锌4种重金属离子解吸动力学特征。结果表明,酒石酸在12h条件下,达到对污染土壤中镉离子的最大去除率,铅、铜、锌3种重金属离子达到最大去除率则需要24h。4种重金属离子的解吸动力学过程可以用Elovich方程很好的描述,说明酒石酸去除重金属离子的过程是一种非均相扩散过程。此外,解吸速率曲线显示,反应初期相同时刻上酒石酸对铅离子的解吸速率最快,其次是铜和锌,最后是镉离子;反应后期同一时刻上铜和锌的解吸速率大于铅和镉。     

中试厌氧氨氧化反应器的运行性能及其过程动力学特性

研究了上流式中试厌氧氨氧化(anaerobic ammonium oxidation,ANAMMOX)反应器在环境温度下的运行性能及其过程动力学特性.基质浓度试验表明,中试厌氧氨氧化反应器可在进水亚硝酸盐浓度为(380.4±18.3)mg.L-1稳定运行,继续提升至(480.5±21.9)mg.L-1时,反应器性能恶化.在水力停留时间(hydraulic retention time,HRT)试验中,HRT可缩短至3.43 h,反应器容积基质氮去除速率可达3.45 kg.(m3.d)-1.长期运行中,温度对中试厌氧氨氧化反应器的性能影响较大.采用改进型的Stover-Kincannon模型可较好地模拟非抑制状态下中试厌氧氨氧化反应器在不同温度范围下的行为.获得的Stover-Kincannon模型动力学参数及其出水总基质浓度预测公式和总基质去除率预测公式,可用于指导中试厌氧氨氧化反应器的实际操作.     

蜂窝陶瓷催化臭氧化降解水中微量硝基苯的动力学研究

实验表明单独臭氧氧化和臭氧/蜂窝陶瓷氧化在温度20℃、初始pH值6.87条件下对硝基苯的降解均遵循一级反应动力学模型,该条件下单独臭氧氧化和臭氧/蜂窝陶瓷氧化工艺对硝基苯的降解主要来源于高活性羟基自由基的氧化作用,同时证明了不同体系温度（10～40℃）和溶液初始pH值（3.00～10.96）下硝基苯的降解同样符合一级反应动力学.2种工艺对硝基苯的降解反应速率都随着温度的升高而增加,单独臭氧氧化的反应速率常数由0.37×10^-3 s^-1升高到1.49×10^-3 s^-1,臭氧/蜂窝陶瓷氧化的反应速率常数由0.56×10^-3 s^-1升高到2.46×10^-3 s^-1,温度越高反应速率提高的幅度却越小.随着pH的升高,单独臭氧氧化对硝基苯降解的反应速率常数从0.15×10^-3 s^-1增加到2.69×10^-3 s^-1,在pH值3.00～9.23范围内,臭氧/蜂窝陶瓷氧化工艺反应速率常数从0.17×10^-3 s^-1增加到1.90×10^-3 s^-1,在pH为10.96时反应速率常数下降到1.64×10^-3 s^-1.     

氟苯胺同系物降解性能对比实验研究

利用驯化污泥研究了邻氟苯胺、对氟苯胺、2,4-二氟苯胺的好氧生物降解性能.结果表明,3种氟苯胺的好氧生物降解性能从高到低依次为,对氟苯胺、邻氟苯胺和2,4-二氟苯胺.降解动力学分析表明,在初始浓度在8～50 mg·L^-1范围内,除2,4-二氟苯胺在实验浓度8.56 mg/L时为一级反应,其他为零级反应.且它们的降解规律都符合Monod方程.污染物化学结构特性与其生物降解性能相关性研究表明,热力学参数与氟苯胺好氧生物降解性能相关性最好,空间参数次之,而电性参数最差.并研究了共代谢条件下葡萄糖和苯胺对2,4-二氟苯胺的好氧降解的影响,葡萄糖的引入有促进作用,而苯胺只在一定浓度范围内有促进作用.因而,氟苯胺的生产废水与生活污水合并处理以及多种组分混合废水处理是可行的.     

Sludge concentration dynamic distribution and its impact on the performance of UNITANK

UNITANK is a biological wastewater treatment process that combines the advantages of traditional activated sludge process and sequencing batch reactor, which is divided into Tank A, B and C. In this study, the sludge distribution and its impact on performance of UNITANK were carried out in Liede Wastewater Plant （WWTP） of Guangzhou, China. Results showed that there was a strong affiliation between Tank A and B of the system in sludge concentration distribution. The initial sludge concentration in Tank A could present the sludge distribution of the whole system. The sludge distribution was mainly influenced by hydraulic condition. Unsteady sludge distribution had an impact on variations of substrates in reactors, especially in decisive reactor, and this could lead to failure of system. Settler could partially remove substrates such as COD and NO3-N, but there was adventure of sludge deterioration. The rational initial sludge concentration in Tank A should be 4000-6000 mg/L MLSS.     

有机改性粘土对赤潮藻絮凝沉降的动力学研究

采用分光光度计法和活体荧光计法,研究了吉米奇类表面活性剂双烷基聚氧乙烯基三季铵盐（DPQAC）改性粘土对2种赤潮生物赤潮异弯藻和锥状斯氏藻的絮凝沉降动力学,比较了2种实验方法的不同,并对几种影响絮凝沉降的因素进行了研究.结果表明,传统的分光光度计法进行动力学研究时,有机粘土对赤潮藻的絮凝沉降较好地符合双分子反应动力学模型,而采用活体荧光计法进行实验时,有机粘土对赤潮藻的絮凝沉降很好地符合双曲线动力学模型,利用活体荧光计法进行实验时避免了前者由于粘土沉降导致的体系透光率的快速变化,更好地反映了赤潮藻细胞絮凝沉降实质.2种动力学实验方法都表明,高岭土体系的沉降速率要略高于膨润土体系,提高粘土、改性剂的用量以及体系的pH值都能加快沉降速率,其中提高改性剂的用量是增加去除率和加快沉降速率的最有效方法.     

内分泌干扰物4-叔丁基苯酚在水中的氯化动力学研究

对典型内分泌干扰物4-叔丁基苯酚（4-TBP）在水中的氯化反应动力学进行了研究.结果发现,在不同HOCl初始浓度和pH条件下,4-TBP能够迅速被氯氧化,4-TBP的氯化反应符合二级反应动力学.表观速率常数k_app与pH值有关,在pH为5和9左右时,k_app分别达到最小值和最大值;对氯化反应中的每一个基元反应的反应速率常数进行了计算, HOCl与4-TBP的酸催化反应及ClO^-与4-TBP反应的速率常数分别为4.99×10⁶　L²·（mol²·min）^-1和1.96×10⁴　L·(mol·min)^-1,而HOCl与4-TBP的反应及HOCl与4-TBP^-的反应较慢,4-TBP^-与ClO^-不发生反应.水处理中氯消毒工艺对4-TBP的降解有一定的影响,在氯投加量为3 mg/L时,4-TBP的半衰期为12.1　min.     

Residual dynamics of thiacloprid in medical herbs marjoram, thyme, and camomile and in soil

Thiacloprid is a new insecticide of the chloronicotinyl family. To assess its risk after application, residual characteristics of thiacloprid in marjoram, thyme, and camomile and in soil were studied under field conditions. The active ingredient was extracted from the plant material using a mixture of acetone-water. After filtration, the extract was concentrated to the aqueous phase, diluted with water, and portioned against ethyl acetate on a matrix solid phase dispersion column. Thiacloprid was extracted from soil using a mixture of methanol-water, filtered, and re.extracted （clean up） with dichloromethane. The residues were quantified using HPLC-MS-MS. The methods were validated by recovery experiments. Thiacloprid residues in marjoram, thyme, and camomile and in soil persisted beyond 10, 14, 14, and 21 d but no residues were detected after 14, 21, 21, and 28 d, respectively. The data obtained in this study indicated that the biexponential model is more suitable than the first-order function to describe the decline of thiacloprid in fresh marjoram, fresh thyme, and dried camomile flowers with half-life （t1/2） of 1.1, 0.7, and 1.2 d, respectively. However, both the first-order function and biexponential model were found to be applicable for dissipation of thiacloprid in soil with almost the same t1/2 values of 3.5 and 3.6 d. The results indicated that thiacloprid dissipates rapidly and does not accumulate in the tested herbs and in soil.     

Kinetics of selective catalytic reduction of NO by NH3 on Fe-Mo/ZSM-5 catalyst

The catalyst of Fe-Mo/ZSM-5 has been found to be more active than Fe-ZSM-5 and Mo/ZSM-5 separately for selective catalytic reduction (SCR) of nitric oxide (NO) with NH3. The kinetics of the SCR reaction in the presence of O2 was studied in this work. The results show that the observed reaction orders were 0.74-0.99, 0.01-0.13, and 0 for NO, O2 and NH3, respectively, at 350-450℃. And the apparent activation energy of the SCR was 65 kJ/mol on the Fe-Mo/ZSM-5 catalyst. The SCR mechanism was also deduced. Adsorbed NO species can react directly with adsorbed ammonia species on the active sites to form N2 and H2O. Gaseous O2 might serve as a reoxidizing agent for the active sites that have undergone reduction in the SCR process. It is also important to note that a certain amount of NO was decomposed directly over the Fe-Mo/ZSM-5 catalyst in the absence of NH3.