我国生活垃圾焚烧二恶英污染现状及减排建议

生活垃圾焚烧的二恶英污染问题在我国已经引起全社会的广泛关注。在分析我国生活垃圾焚烧行业现状与发展趋势和我国部分焚烧厂二恶英排放情况的基础上,提出了我国生活垃圾焚烧二恶英污染防治和减排的建议。     

危险废弃物焚烧处置预处理及烟气净化工艺设计

危险废弃物因其对人类健康、生态环境的严重危害性和破坏性而需特殊处置。以某市危险废弃物焚烧处置工程为例,通过对其预处理系统及烟气净化系统的组成、工程原理、工艺流程等的分析论证,探讨一种危险废物焚烧处置预处理系统及烟气净化系统工艺设计的工程原理和性能特点,为今后在工程实际中的运用提供参考。     

云南省城市生活垃圾处理温室气体排放特征

根据《IPCC国家温室气体清单指南》和《省级温室气体清单编制指南》方法,建立2018年云南省16个州(市)城市生活垃圾处理温室气体排放清单,包括生活垃圾填埋和焚烧处理过程,并分析了温室气体排放的时间分布、空间分布和影响因素等。结果表明;(1)2018年云南省生活垃圾处理温室气体总排放量为536万t CO_2当量,各州(市)间排放量差异明显,滇中经济发达地区和滇东北人口密度较高地区排放量明显高于滇西北地区。(2)2005—2018年,云南省生活垃圾处理排放的温室气体量增长了191.3%,温室气体排放组成发生明显变化,CH4比重不断下降,CO_2比重不断增加。(3)城镇人口数量、生活垃圾处理量、经济发展水平与温室气体排放量显著相关,其中人口数量更为明显。     

Characteristics of the stabilized/solidified municipal solid wastes incineration fly ash and the leaching behavior of Cr and Pb

Fly ash is a hazardous byproduct of municipal solid wastes incineration (MSWI). An alkali activated blast furnace slag-based cementitious material was used to stabilize/solidify the fly ash at experimental level. The characteristics of the stabilized/solidified fly ash, including metal leachability, mineralogical characteristics and the distributions of metals in matrices, were tested by toxic characteristic leaching procedure (TCLP), X-ray diffraction (XRD) and scanning electron microscopy-energy dispersive spectrometer (SEM-EDS) respectively. Continuous acid extraction was utilized to extract metal ions and characterize their leaching behavior. The stabilization/solidification procedure for MSWI fly ash demonstrates a strong fixing capacity for the metals by the formation of C-S-H phase, hydrated calcium aluminosilicate and ettringite. The stabilized/solidified fly ash shows a dense and homogeneous microstructure. Cr is mainly solidified in hydrated calcium aluminosilicate, C-S-H and ettringite phase through physical encapsulation, precipitation, adsorption or substitution mechanisms, and Pb is mainly solidified in C-S-H phase and absorbed in the Si-O structure.     

臭氧-曝气生物滤池深度处理垃圾焚烧渗滤液可行性研究

研究了臭氧-曝气生物滤池(BAF)代替纳滤和反渗透深度处理垃圾焚烧渗滤液达标排放的技术可行性.半间歇臭氧氧化试验表明,实验用水的可生化性随着氧化时间的增加而增加,色度及UV254, 15min内去除率分别达91%和64%;氧化时间为45min时COD去除率59%, 45min后COD去除较慢, 120min时去除率77%.确定臭氧氧化时间为1h,在同样臭氧浓度与流量下进行了臭氧-BAF处理垃圾焚烧渗滤液的连续实验.结果发现,此工艺对COD、色度和UV254的去除率分别可达75%,95%和90%,其中2/3运行时间里COD低于排放标准100 mg/L.其中出水色度可稳定保持在40度以下达标排放.经过进一步优化,臭氧-BAF有望用于垃圾焚烧渗滤液的达标处理.GC-MS检测表明烷烃,芳香族化合物及含氮杂环化合物是试验用水的主要污染物,臭氧-BAF能够有效去除后两类化合物,但难以去除烷烃.     

垃圾渗滤液预处理工艺的研究

本文结合工程实例,对生活垃圾焚烧发电厂垃圾渗滤液进行预处理工艺的研究,结果表明,预处理单元在垃圾焚烧厂渗滤液的整个处理系统中具有重要的作用和地位,渗滤液中部分污染物和无机离子能在预处理单元中得到较好的去除,在一定程度上减轻后续处理工艺的负荷。     

Comparative study on the efficiency and environmental impact of two methods of utilizing polyvinyl chloride waste based on life cycle assessments

Two processes of utilizing polyvinyl chloride （PVC） waste, an incineration process and a vacuum pyrolysis process, for energy conversion were compared to determine their efficiency and environmental perfor- mance. We carried out a life cycle assessment with each of the two processes to evaluate their environmental impact and defined the goals and limits of our remit. As well, we established an inventory of PVC waste from incineration and vacuum pyrolysis based on process analysis, data collection and calculations. The results show that electrical power output per unit mass of PVC waste in the incineration process was twice as high as that of the vacuum pyrolysis process. Incineration had a larger total environmental impact potential than vacuum pyrolysis. The total environmental impact potential of PVC waste from incineration was three times higher than that from vacuum pyrolysis. Incineration of PVC disposed 300 ng. 100 kgI of dioxins and vacuum pyrolysis 98.19 ng- 100 kgI of dioxins. As well, we analyzed the data for their uncertainty with results quantified in terms of three uncertainties： basic uncertainty, additional uncertainty, and computational uncertainty. The coefficients of variation of the data were less than 25% and the quality of the inventory data was acceptable with low uncertainty. Both PVC waste disposal processes were of similar quality and their results comparable. The results of our life cycle impact assessment （LCIA） showed considerable reliability of our methodology. Overall, the vacuum pyrolysis process has a number advantages and greater potential for development of PVC disposal than the incineration process.     

印染污泥焚烧烟气污染控制案例分析

以广东省某两家印染厂的印染污泥焚烧项目为主要研究对象,从污泥处理技术路线、焚烧设备及烟气处理流程等各方面入手,对各厂印染污泥与煤混烧烟气中颗粒物、NOx、SO2、酸性气体(HF、HCl)和重金属等污染物的进行采样分析,并对各厂现有烟气污染物控制设施的运行效果进行调研,结果表明,布袋除尘的效果较为理想,除尘效率可达99%以上;使用印染废水作为吸收液的湿法脱硫技术对SO2及酸性气体的去除效果不理想;SNCR对NOx具有一定的去除效果,是一种较为经济、高效的脱硝技术;焚烧后,大部分重金属最终以飞灰的形式被除尘器去除,但仍有部分重金属如Hg在出口烟气中的浓度仍然很高,需要采取必要的措施控制烟气中的重金属. 此外,基于印染污泥焚烧实例分析,提出适于印染污泥与煤混烧烟气处理工艺流程.     

MESIP∗: Modelling environmental scenarios in ponds

MESIP is a fugacity model which can predict the fate of organic hydrophobic chemicals in aquatic ecosystems. In this paper a short introduction to the mathematical model is presented together with a more detailed listing of the required input data. Comparison of the calculated and measured fate of a fluorescent whitening compound in an artificial outdoor pond is shown     

中国城市垃圾典型可行焚烧技术的综合评价

中国城市垃圾处理的主要方式正在由卫生填埋向垃圾焚烧转变. 基于中国城市垃圾焚烧处置需求特征分析,建立了技术评价指标体系,采用层次分析法,从技术的可靠性、经济性和适用性三方面,对国内外现有4种主要城市垃圾焚烧技术进行了综合评价. 结果表明:流化床技术和层燃技术在技术成熟度、技术能力和二NFDA1英污染控制等方面相对可靠,适用于我国多数大城市的垃圾焚烧处置. 国产流化床焚烧技术更加适应当前国内垃圾分类水平较差的大部分城市;层状焚烧技术则比较适用于城市垃圾管理水平高、垃圾分类较好、热值较高、垃圾处置集中度高和规模较大的城市;旋转焚烧和热解焚烧技术则较适用于垃圾成分复杂、尺寸不均匀的小城镇、工业园区垃圾处置或医疗废物处置,但二者均需加强二NFDA1英排放控制.