Physical Modeling of Emissions from Naturally Ventilated Underground Parking Garages

The dispersion of pollutants from naturally ventilated underground parking garages has been studied in a boundary layer wind tunnel. Two idealized model setups have been analysed, one was simulating pollutant dispersion around an isolated rectangular building and one was representing dispersion in a finite array of idealized building blocks. Flow and dispersion close to modelled ground level emission sources was measured. The results illustrate the complexity of the flow around buildings and provide insight in pollutant transport from ground level sources located directly on building surfaces. As a result, areas critical with respect to high pollutant concentrations could be visualized. Particularly, the results show high concentration gradients on the surface of the buildings equipped with modelled emission sources. Inside the boundary layers on the building walls, a significant amount of pollutants is transported to upwind locations on the surface of the building. The paper documents the potential of physical modelling to be used for the simulation and measurement of dispersion close to emission sources and within complex building arrangements.     

广州市在用机动车排气抽检工作若干问题探讨

介绍了广州市在用机动车抽检工作情况和程序,分析了排气抽检工作中存在的问题,提出了解决问题的建议和方法。     

NaOH溶液吸收CO2的试验研究

为了满足国际海事组织对船舶CO2排放的要求,建立了一种针对船舶尾气CO2的循环吸收系统,利用NaOH溶液吸收CO2.NaOH溶液完成第一步吸收反应后在第二步反应中被还原,从而可以循环利用.分析了初始反应温度、NaOH浓度及溶液中的Na2CO3对CO2吸收率的影响,并计算了循环反应中NaOH的再生率和CaO的过量系数.结果表明,CaO过量系数为1.2时对CO2固化效果最佳,此时NaOH溶液再生率达79.31％.研究表明,NaOH溶液吸收船舶尾气中CO2的循环系统效率高、成本低.     

长大区间隧道抽出式串联通风机排烟能力实验研究*

为实现有效通风以降低隧道火灾带来的损失和伤亡,依托青岛市地铁8号线大洋站至青岛北站区间隧道,建立线性比尺为1∶15的隧道通风排烟模型实验系统,针对通风机串联单抽,围绕3种通风机频率匹配组合,测定单机的变频频率值、电功消耗、排烟道与行车道的断面平均风速以及右侧行车道静压。研究结果表明:在相同功率消耗下,不同频率匹配的串联通风机排烟效果存在差异;针对此差异,利用气体挡烟墙性能及其计算欧拉数值比较发现,风井近端的通风机频率较大时,下游对污染气流的抵抗力更强,拥有更好的排烟效果。研究结果可为隧道火灾提供更有效率的防灾救灾数据支持,并从欧拉数方面为研究隧道临界风速提供新角度。     

街道峡谷内车辆流动对反应性污染物传播特性影响的模拟研究

采用CFD（计算流体力学）数值模拟的研究方法,使用动网格技术,分析简单光化学反应下车辆流动及不同来流风速对双车道三维街道峡谷内污染物传播特性的影响.结果表明,车辆移动改变了峡谷内气流结构,以及背风侧与迎风侧活性污染物浓度分布的相对大小,有利于污染物在峡谷中的传播扩散;来流风使机动车尾气向建筑背风侧汇聚,并随着风速增加而加强,对近迎风侧车道车辆尾气淹没射流的影响比近背风侧车道大.在车辆移动与来流风的综合作用下,污染物的扩散能力得到显著增强.     

民用飞机实验室APU开车高温尾气排放影响因素分析

目的 对民用飞机APU在气候实验室内开展极端气候环境下的起动和工作试验,建立一种APU高温尾气安全排放方法。方法 用CFD仿真手段对采用排气管道将APU高温尾气排出气候实验室的可行性及影响因素(包括管道直径、距离、背压等)进行系统性分析研究。结果 气管道入口距离APU管道出口过近时,将有利于APU排气,引射比ε与排气管道出口压力Pex及排气管道直径D线性相关,排放温度tex与管道直径D成反比。在排气管道入口设置平滑收敛段,利于消除涡流,减轻负压程度,并在一定范围内提高引射比。结论 采用管道被动排气是可行的,合适的排气管道设计为D/d=2.0,L/d=1.5,并在管道入口设置平滑收敛段。     

浅析珠三角地区有机废气治理技术的开发应用

珠江三角洲地区大气污染最明显的特点就是臭氧浓度的升高导致大气氧化性增强,而挥发性有机化合物(VOCs)和氮氧化物是大气臭氧生成的重要前体物。珠三角地区工业体系发达,VOCs的生产及使用企业众多,由于VOCs的种类繁多,性质各异,排放条件多样,目前已经形成了一系列的VOCs废气实用治理技术。     

模拟车用工况下5kW燃料电池尾气净化系统

模拟了车用工况下燃料电池发动机脉冲式排氢的特点,设计开发了一套质子交换膜燃料电池的尾气净化系统,并以5 kW燃料电池的尾气排放为例,研究其净化效果。研究了电池阳极排放氢气缓冲前后尾气中氢气浓度的变化,以及不同空速条件下氢气的去除效果。结果表明：电堆阳极排放氢气经过缓冲处理后,尾气中氢气浓度趋于平稳,大部分工况下处在2%以下,达到了安全处理的要求;尾气中氢气的去除效果与空速密切相关。对自制的整体式催化剂而言,当空速低于20000 h^-1时,氢气的去除率能达到约95%,而当空速达到39270 h^-1时,氢气的去除率仅为10.9%。鉴于这一问题,提出通过采用尾排空气的分流手段调整催化燃烧反应器对空速的要求,以提高尾气中氢气的去除率。     

Improvement of an efficient separation method for chemicals in diesel exhaust particles: analysis for nitrophenols

GOAL, SCOPE, AND BACKGROUND: Diesel exhaust is believed to consist of thousands of organic constituents and is a major cause of urban pollution. We recently reported that a systematic separation procedure involving successive solvent extractions, followed by repeated column chromatography, resulted in the isolation of vasodilatory active nitrophenols. These findings indicated that the estimation of the amount of nitrophenols in the environment is important to evaluate their effect on human health. The isolation procedure, however, involved successive solvent extractions followed by tedious, repeated chromatography, resulting in poor fractionation and in a significant loss of accuracy and reliability. Therefore, it was crucial to develop an alternative, efficient, and reliable analytical method. Here, we describe a facile and efficient acid-base extraction procedure for the analysis of nitrophenols. MATERIALS AND METHODS: Diesel exhaust particles (DEP) were collected from the exhaust of a 4JB1-type engine (ISUZU Automobile Co., Tokyo, Japan). Gas chromatography-mass spectrometry (GC-MS) analysis was performed with a GCMS-QP2010 instrument (Shimadzu, Kyoto, Japan). RESULTS: A solution of DEP in 1-butanol was extracted with aqueous NaOH to afford a nitrophenol-rich oily extract. The resulting oil was methylated with trimethylsilyldiazomethane and subsequently subjected to GC-MS analysis, revealing that 4-nitrophenol, 3-methyl-4-nitrophenol, 2-methyl-4-nitrophenol, and 4-nitro-3-phenylphenol were present in significantly higher concentrations than those reported previously. DISCUSSION: Simple acid-base extraction followed by the direct analysis of the resulting extract by GC-MS gave only broad peaks of nitrophenols with a poor detection limit, while the GC-MS analysis of the sample pretreated with (trimethylsilyl)diazomethane gave satisfactorily clear chromatograms with sharp peaks and with a significantly lowered detection limit (0.5 ng/ml, approximately 100 times). CONCLUSION: The present method involving an acid-base extraction, in situ derivatization, and GC-MS analysis has shown to be a simple, efficient, and reliable method for the isolation and identification of the chemical substances in DEP.     

Spatial & temporal variations of PM10 and particle number concentrations in urban air

The size of particles in urban air varies over four orders of magnitude (from 0.001 μm to 10 μm in diameter). In many cities only particle mass concentrations (PM10, i.e. particles <10 μm diameter) is measured. In this paper we analyze how differences in emissions, background concentrations and meteorology affect the temporal and spatial distribution of PM10 and total particle number concentrations (PNC) based on measurements and dispersion modeling in Stockholm, Sweden. PNC at densely trafficked kerbside locations are dominated by ultrafine particles (<0.1 μm diameter) due to vehicle exhaust emissions as verified by high correlation with NOx. But PNC contribute only marginally to PM10, due to the small size of exhaust particles. Instead wear of the road surface is an important factor for the highest PM10 concentrations observed. In Stockholm, road wear increases drastically due to the use of studded tires and traction sand on streets during winter; up to 90% of the locally emitted PM10 may be due to road abrasion. PM10 emissions and concentrations, but not PNC, at kerbside are controlled by road moisture. Annual mean urban background PM10 levels are relatively uniformly distributed over the city, due to the importance of long range transport. For PNC local sources often dominate the concentrations resulting in large temporal and spatial gradients in the concentrations. Despite these differences in the origin of PM10 and PNC, the spatial gradients of annual mean concentrations due to local sources are of equal magnitude due to the common source, namely traffic. Thus, people in different areas experiencing a factor of 2 different annual PM10 exposure due to local sources will also experience a factor of 2 different exposure in terms of PNC. This implies that health impact studies based solely on spatial differences in annual exposure to PM10 may not separate differences in health effects due to ultrafine and coarse particles. On the other hand, health effect assessments based on time series exposure analysis of PM10 and PNC, should be able to observe differences in health effects of ultrafine particles versus coarse particles.