汾渭平原复杂地形影响下冬季PM2.5污染分布特征、来源及成因分析

汾渭平原受其复杂地形特征及产业结构影响,和京津冀、长三角地区一起被列为大气污染重点防治区域.本研究应用2014—2019年冬季中国环境监测总站汾渭平原各城市的六大空气污染物逐小时数据,结合欧洲中心ERA-5数据,利用HYSPLIT后向轨迹模型及T-model斜交旋转主成分分析法（PCT）,揭示过去6年汾渭平原冬季颗粒物浓度演变规律,厘清汾渭平原复杂地形影响下大气污染来源特征、潜在源区及成因,识别影响汾渭平原冬季空气污染的主要天气系统类型.HYSPLIT模拟结果表明,冬季喇叭口地形城市主要受本地和邻近区域污染源影响;山区盆地地形城市更易受到100~300 km距离以内污染源的传输影响,其中,来自陕北的气团对其影响最大;峡谷地形城市更易受到300~600 km范围内污染源的传输影响;平原地形城市的污染物浓度受区域传输的影响较大.影响汾渭平原冬季颗粒物重污染的天气系统可分为高压前部型、高压后部型、均压场型及低压倒槽型,其中,高压前部型是汾渭平原冬季重污染时段最易出现的天气形势.     

精密离心机静态半径测量不确定度的温度特性分析

目的研究温度对精密离心机静态半径测量不确定度的影响。方法以静态半径测量反算法为基础,推导静态半径测量不确定度的温度特性模型,设计精密恒温装置,并进行试验,获取加速度计在1 g离心机场下不同温度时的输出数据,并进行分析。结果基于温度特性模型,确定了影响静态半径测量不确定度的主要因素。试验数据结果表明,在加速度计工作范围内(50~60℃),静态半径测量不确定度随温度递增呈现“先增后减”的分布规律,且在50℃时进入到了10‒7量级。结论加速度计的温度敏感性是影响静态半径测量不确定度的最主要因素,精密控温能显著提高静态半径测量精度。     

北京东灵山地区主要大气污染物浓度变化特征

2009年8月～2011年6月在北京东灵山森林站连续观测了SO2、NOx、O3和PM2.5的浓度,利用观测数据分析了大气污染物的月变化、季节变化和统计日变化特征,结合气流轨迹探讨了传输对污染物的影响.结果表明,观测期间NO、NO2、NOx、O3、SO2和PM2.5浓度的平均值分别为(2.0±1.6)、(13.2±7.2)、(15.3±8.2)、(61.0±19.6)、(3.6±3.6)、(35.6±32.0)μg.m-3,均低于北京城区的观测值.NOx浓度秋季最高,夏季最低,分别为(17.0±8.0)μg.m-3和(13.8±4.1)μg.m-3.O3浓度春、夏季高于秋、冬季,最高值出现在6月份.SO2冬季浓度最高,夏季浓度最低,冬季与夏季的比值约为2.7.PM2.5夏季的浓度要远高于其他3个季节,达到56.4μg.m-3.NOx、O3和SO2浓度日变化显著,其中NOx日变化为双峰型,O3和SO2日变化为单峰型,PM2.5日变化幅度较小.     

Combined Effects of Physical Demands and Shift Working on Low Back Disorders Among Nursing Personnel

The aim of this study was to investigate the synergistic effects of physical demands and shift working on low back disorders (LBDs) among nursing personnel. The study used 2 questionnaires: a self-administered questionnaire composed of parts of Nordic musculoskeletal questionnaire to assess LBDs and job content questionnaire to assess physical demands. The participants were divided into 4 groups: from group 1 (low physical demands day workers) to group 4 (high physical demands shift workers). In regression analysis, high physical demands were associated with the prevalence of LBDs independently (OR 4.4, 95% CI [2.40, 8.00] and p < .05), but there was no association between shift working and LBDs (p > .05). Odds ratio in high physical demands shift workers was 9.33 compared to the reference group (p < .001). Calculated synergistic index was 7.37. Simultaneous impacts of shift working and high physical demands may increase the prevalence of LBDs among nursing personnel.     

长江汉口边滩防洪及环境综合治理的研究

武汉市国管院批准的防洪重点城市，长江武汉河段是重点治理河段之一。该河段河道演变复杂，洲滩冲淤，是影响主流，航道变迁及汛期泄洪。左岸汉口边滩上密集的房屋，杂乱无序，成为行洪障碍及污染污染源，破坏环境及景观。市政府决定实施防洪及环境综合治理，该工程属省，部级重大科研项目。从定，动床河工模型试验及环境保护进行分析研究。定床试验，研究工程实施后，本河段的水位，流速，流态及天兴洲左右汊分流比的变化；动床试验，研究在不同典型水文年条件下的河势，河道冲淤变化及疏浚区的回淤回，为治理方案的优化比选及工程决策提供科学依据。这是长江干流滨江城市河道整治的先声，是城市规划建设中环境保护工程实施的首例，意义非常和重大。     

通海杞麓湖退塘还湖及生态修复工程研究

介绍了杞麓湖现状,在此基础上提出了退塘还湖及生态修复工程方程。具体提出了湖滨生态修复的范围、分区,主要技术经济指标,主要工程内容与规模,工程实施计划及对策措施,湖泊生态管理措施,对策建议等。     

Feasibility and simulation model of a pilot scale membrane bioreactor for wastewater treatment and reuse from Chinese traditional medicine

The lack and pollution of water resource make wastewater reuse necessary. The pilot scale long-term tests for submerged membrane bioreactor were conducted to treat the effluents of anaerobic or aerobic treatment process for the high-strength Chinese traditional medicine wastewater. This article was focused on the feasibility of the wastewater treatment and reuse at shorter hydraulic retention time （HRT） of 5.0, 3.2 and 2.13 h. MLSS growth, membrane flux, vacuum values and chemical cleaning periods were also investigated. The experimental results of treating two-phase anaerobic treatment effluent demonstrated that the CODfilt was less than 100 mg/L when the influent COD was between 500-10000 mg/L at HRT of 5.0 h, which could satisfy the normal discharged standard in China. The experimental results to treat cross flow aerobic reactor effluent demonstrated that the average value of CODfilt was 17.28 mg/L when the average value of influent COD was 192.84 mg/L at HRT of 2.13 h during 106 d, which could completely meet the normal standard for water reuse. The maximum MLSS and MLVSS reached 24000 and 14500 mg/L at HRT of 3.2 h respectively. Membrane flux had maximal resume degrees of 94.7% at vacuum value of 0.02 MPa after cleaning. Chemical cleaning periods of membrane module were 150 d. A simulation model of operational parameters was also established based on the theory of back propagation neural network and linear regression of traditional mathematical model. The simulation model showed that the optimum operational parameters were suggested as follows： HRT was 5.0 h, SRT was 100 d, the range of COD loading rate was between 10.664-20.451 kg/（m3.d）, the range of MLSS was between 7543-13694 mg/L.     

冷冻取芯过程煤芯瓦斯解吸特性试验研究*

为探究冷冻取芯过程煤芯瓦斯解吸特性,基于模拟试验的相似性,依托自主研发的含瓦斯煤冷冻取芯响应特性测试平台,开展不同变质程度煤样（长焰煤、贫瘦煤、无烟煤）及不同吸附平衡压力（1.0,2.0,3.0,4.0 MPa）下冷冻取芯过程煤芯瓦斯解吸特性试验研究。研究结果表明:冷冻取芯过程中,煤芯瓦斯解吸量与吸附平衡压力及煤变质程度呈正相关关系;在煤芯瓦斯解吸过程中存在倒吸现象,煤与瓦斯初始吸附平衡压力越大,煤的变质程度越高,倒吸开始时间越迟;冷冻取芯过程中,瓦斯解吸速度与吸附平衡压力及煤变质程度呈正相关关系,且瓦斯解吸速度随吸附平衡压力及煤变质程度变化曲线符合幂函数关系。     

Build back better: implementation in Victorian bushfire reconstruction

The ‘build back better’ (BBB) concept signals an opportunity to decrease the vulnerability of communities to future disasters during post‐disaster reconstruction and recovery. The 2009 Victorian bushfires in Australia serve as a case study for this assessment of the application of core BBB principles and their outcomes. The results show that several BBB measures were successfully implemented in Victoria and are relevant for any post‐disaster reconstruction effort. The BBB initiatives taken in Victoria include: land‐use planning determined by hazard risk‐based zoning; enforcement of structural design improvements; facilitated permit procedures; regular consultations with stakeholders; and programmes conducted for social and economic recovery. Lessons from the Victorian recovery urge the avoidance of construction in high‐risk zones; fairness and representativeness in community consultations; adequate support for economic recovery; the advance establishment of recovery frameworks; and empowerment of local councils.     

基于反赋权与MBCT-SR多维云模型算法岩爆预测研究

基于岩爆事故的模糊性与随机性特征,为解决在当前岩爆烈度等级预测研究中,通过正向云发生器经验式计算多维云模型特征值进而导致预测结果主观性较强的问题.本文选取应力比Ts=σθ/σt、岩石脆性指数B=σc/σt以及弹性应变储能指数Wet作为评价指标,结合机器学习理论,采用多维逆向MBCT-SR云发生器算法对岩爆等级进行预测,...