铁盐和铝盐混凝对水中天然有机物的去除特性研究

以三氯化铁和硫酸铝为研究对象,探讨了2种混凝剂对水中天然有机物的去除效果及特点.结果表明,低投量下,硫酸铝对天然有机物的去除效果要好于三氯化铁,混凝剂投量高于15mg/L时,三氯化铁的效果较好.如混凝剂投量为10mg/L时,硫酸铝和三氯化铁处理水的TOC分别为4.19mg/L和9mg/L;当混凝剂投量为20mg/L时, TOC分别降至2.44mg/L和1.69mg/L.三氯化铁混凝后水的pH值降低幅度高于硫酸铝,形成的水解产物所带正电荷密度升高,水中有机物的质子化程度高,有利于对有机物的吸附去除.通过对UV254出和SUVA的考察可知,三氯化铁对共轭结构及不饱和有机物的去除能力要高于硫酸铝.2种混凝剂对水中不同性质有机物的去除效果不同,三氯化铁对亲水性有机物去除效果较好,对小分子量有机物去除高于硫酸铝,如混凝剂投量为20mg/L时,三氯化铁和硫酸铝对相对分子质量区间小于10 000的有机物去除率分别为16.4%和6.1%,而硫酸铝对大分子量有机物去除效率较高.     

涡流澄清池与网格澄清池处理的对比试验研究

针对传统水力循环澄清池运行中所遇到的混凝效率低、出水水质差、抗冲击负荷能力弱等瓶颈问题,该试验通过对涡流澄清池与网格澄清池的启动、除浊效果、产水能力、抗冲击负荷能力进行平行对比试验,研究了涡流澄清池实际运行效果,确定了涡流澄清池的最佳运行工况及相关设计参数,为微涡流澄清技术在水厂改造、净水装置研发及其他工程应用提供设计参数支持和推广应用依据。     

Optimum conditions for the formation of Al13 polymer and active chlorine in electrolysis process with Ti/RuO2-TiO2 anodes

A polyaluminum containing a high concentration of Al₁₃ polymer and active chlorine (PACC) was successfully synthesized by a new electrochemical reactor using Ti/RuO₂-TiO₂ anodes. PACC can potentially be used as a dual-function chemical reagent for water treatment. The obtained results indicated that the formation of Al₁₃ polymer and active chlorine, were the most active components in PACC responsible for coagulation and disinfection respectively. These components were significantly influenced by electrolyte temperature, current density, and stirring rate. It was observed that high electrolyte temperature favored the formation of Al₁₃. Increasing current density and stirring rate resulted in high current efficiency of chlorine evolution, thus favoring the generation of Al₁₃ and active chlorine in PACC. When the PACC (Al_T = 0.5 mol/L, basicity = 2.3) was prepared at the optimum conditions by electrolysis process, the Al₁₃ polymer and active chlorine in product reached above 70% of Al_T and 4000 mg/L, respectively. In the pilot scale experiment with raw polyaluminum chloride used as an electrolyte, PACC was successfully prepared and produced a high content of Al₁₃ and active chlorine products. The pilot scale experiment demonstrated a potential industrial approach of PACC preparation.     

Fractionation of residual Al in natural water treatment from reservoir with poly-aluminum-silicate-chloride (PASiC): Effect of OH/Al, Si/Al molar ratios and initial pH

An aluminum fractionation study was conducted for a surface reservoir water treatment to understand the performance of poly-aluminum-silicate-chloride (PASiC) in terms of the residual Al fractions as a function of initial pH. The coagulation performance expressed as turbidity and organic matter removal was established as supporting data. Some extra data were evaluated in terms of the residual Al ratio of the composite PASiC coagulant. The main residual Al sources were the Al fractions derived from the use of PASiC. The turbidity and organic matter removal ability was optimal at initial pH 6.00-7.00, while the concentrations of various residual Al species and the residual Al ratio of PASiC were minimal at an initial pH range of 7.00-8.00. Under the conditions of OH/Al molar ratio = 2.00 and Si/Al molar ratio = 0.05, PASiC had superior coagulation performance and comparatively low residual Al concentrations. The Al fraction in the composite PASiC coagulant seldom remained under such conditions. Experimental data also indicated that the suspended (filterable) Al fraction was the dominant species, and organic-bound or organo-Al complex Al was considered to be the major species of dissolved Al in water treated by PASiC coagulation. Additionally, the dissolved inorganic monomeric Al species dominated the dissolved monomeric Al fraction.     

舟山高浊度海水混凝除浊研究

测定了舟山高浊度海水悬浮物的粒度分布,分析了高浊度海水自由沉降特性,选用氯化铁(FeCl)3、聚合氯化铁(PFC)、聚合硫酸铁(PFS)3种混凝剂,利用正交试验方法对高浊度海水进行混凝沉淀对比试验,采用极差分析方法研究了影响混凝效果的因素。试验结果表明:舟山海域悬浮物组成以粉砂为主,用自然沉降的方法是很难去除;各因素对浊度去除率影响的主次顺序均为:慢搅时间>慢搅速度>快搅时间>快搅速度;对于高浊度海水混凝除浊最佳水力条件为:快搅时间为2 min,快搅速度为300 r/min,慢搅时间为15 min,慢搅速度为60 r/min;聚合硫酸铁是较理想的絮凝剂,最佳投药量范围在15～25 mg/L,对浊度去除率高达99%以上。     

高锰酸钾强化PAC混凝处理温瑞塘河黑臭水体试验研究

以浙江省温州市温瑞塘河某河段黑臭地表水为研究对象,考察高锰酸钾强化PAC混凝工艺的除污效能,获得处理温瑞塘河黑臭水体的最佳工艺条件,为恢复河流水体生态自净功能提供基础。试验结果表明,高锰酸钾的最优投加方式为在混凝剂PAC前投加,最佳预氧化时间5 min,最佳投加量1.5 mg/L。将本实验得出的最优混凝处理条件应用于温瑞塘河实际黑臭水体的处理时发现,处理后水质明显改善,此表明高锰酸钾强化混凝应急处理温瑞塘河黑臭水体是切实可行的,可为实际的应急处理工艺提供了理论依据和技术指导。     

Removal and transformation of organic matters in domestic wastewater during lab-scale chemically enhanced primary treatment and a trickling filter treatment

To find a simple and economical way for treating the domestic wastewater in small counties and towns, a process combining chemically enhanced primary treatment and a trickling filter (CEPT-TF, representing the physical and biological effects) was constructed and operated in laboratory conditions. The characteristic behaviors of dissolved organic matter in raw wastewater and effluents were examined during steady-state operation. Experimental results showed that the process of CEPT and TF in series was beneficial for the removal of hydrophobic and hydrophilic organics. Specially, the hydrophobic and aromatic materials could be preferentially removed in the CEPT unit, and the hydrophilic fraction in the TF. Structural changes of the organic fractions during the operation of the different units were also characterized via spectrum analysis.     

高铁酸钾对水中藻类及其次生嗅味污染物二甲基三硫醚同步去除研究

模拟高藻期碱性水源水,采用高铁酸钾对水中以颤藻和二甲基三硫醚为代表的藻类及微量嗅味污染物进行同步控制研究.在高铁酸钾与聚合氯化铁(PFC)单独混凝对藻类的控制效果对比的基础上,展开了高铁酸钾与高锰酸钾预氧化-PFC联用方法对藻类及嗅味污染物的控制效果对比,探讨了pH、预氧化时间和浊度等条件对控制效果的影响.结果表明,PFC单独混凝除藻率最高为90.6%,以Fe计的等量投加条件下,高铁酸钾控藻效果较PFC混凝好,除藻率可达92.4%.高锰酸钾对PFC具有强化混凝效果,可明显提高除藻率(94.5%).高铁酸钾较高锰酸钾预氧化对二甲基三硫醚的去除效果理想,且氧化时间大大缩短,高铁酸钾氧化时间1 min可去除92.5%二甲基三硫醚,高于高锰酸钾预氧化10 min后达到的去除率(74.6%).     

聚合氯化铁-聚(环氧氯丙烷-二甲胺)复合絮凝剂在模拟水处理中的混凝特性研究

制备出一系列具有不同聚合氯化铁(PFC)的碱化度(B)、不同聚(环氧氯丙烷-二甲胺)[P(EPI-DMA)]质量分数[ω(E)]和黏度(η)的PFC-P(EPI-DMA)复合混凝剂,并将其用于模拟染料废水和模拟天然地表水的絮凝脱色处理,对比探讨了ω(E)、η和B对PFC-P(EPI-DMA)中铁的形态分布及其混凝效果的影响,以及混凝作用机制.结果表明,复合絮凝剂中铁的有效形态含量随ω(E)的增大而不断降低;η=850 mPa.s时,复合混凝剂中铁的有效形态含量最高;随B值的增大,Feb含量先增大后减少,而Fec含量逐渐增大.一定程度上使用预水解程度较低、有机成分黏度较大的PFC-P(EPI-DMA)有利于混凝效果的提高,复合混凝剂中有机成分质量分数对混凝效果的影响则与处理对象有关.在模拟水处理中,复合混凝剂依靠电性中和及架桥吸附能力发挥混凝特性.     

强化混凝去除微污染原水胶体颗粒的研究

对珠江水系统进行了强化混凝处理，燕利用准弹性激光散射技术（PCS）对常规混凝和强化混凝前后水中胶体颗粒（小于0.45um)的大小与分布进行了测定,探讨了搅拌条件对混凝效果的影响。