生活垃圾催化热解液体产物特性

为探索生活垃圾催化热解液体产物特性变化规律,选取Na2CO3、CaO、Fe2O33种催化剂,利用固定床实验、红外分析(FT-IR)进行生活垃圾热解液体产物产率和组分特性研究.结果表明,热解终温600℃无催化剂时,生活垃圾热解液产率为39.80 wt％,添加3种催化剂后热解液产率均降低;生活垃圾分别添加1％的Na2CO3和CaO后,热解油氧含量由22.49％分别降低到20.12％和18.53％,低位热值由30.30 MJ/kg分别提高到33.79和32.74 MJ/kg;无催化剂时热解油成分为脂肪类、含氧化合物及少量芳香类混合物,加催化剂后热解油中芳香类物质峰面积比例显著增加,而含氧化合物峰面积比例降低,羟基类及羧酸类含氧化合物峰面积比例明显减少,其他含氧物峰面积比例却增加;CaO催化效果较明显,生活垃圾添加1％的CaO热解油中芳香类物质峰面积比例从4.36％增加到29.46％,含氧化合物峰面积比例由49.42％降低到23.12％,其中羟基类和羧酸类化合物峰面积比例分别由34.03％和10.65％降低到0.00％和3.34％,其他含氧化合物峰面积比例由4.73％增加到19.77％.     

等离子体催化降解甲苯途径的原位红外研究

考察了在常温常压条件下,等离子体分别协同SiO₂、Al₂O₃、NiO/Al₂O₃降解甲苯的性能,并从材料的介电常数、对甲苯的吸附性及臭氧分解能力等角度分析了不同活性表现的原因,同时,采用原位红外技术研究了甲苯降解过程中催化剂表面吸附物种的变化.结果表明,当甲苯浓度为100 ppm,气体流量为100 mL·min^-1时,一定范围内,甲苯降解率随着能量密度、介电常数、吸附性及臭氧分解能力的提高而提高.甲苯在催化剂表面的吸附对其降解途径有十分重要的影响:在放电区域中加入SiO₂,甲苯仍然在气相中完成降解;而存在Al₂O₃ 及NiO/Al₂O₃时,甲苯氧化成苯甲酸的过程主要发生在催化剂表面,是甲苯催化降解的关键步骤,苯甲酸在活性位点的积累将降低催化剂的反应活性.     

浅谈火焰原子吸收分光光度计应用重金属分析的优缺点

随着逐渐使用原子吸收分光光度计来分析重金属,本文阐述实际使用火焰原子吸收分光光度计中的一些优缺点,达到爱护贵重仪器,同时提高分析应用水准目的。     

减小浊度对水中六价铬测定产生影响的方法

简要介绍了二苯碳酰二肼分光光度法测定六价铬时,几种减小浊度对测定产生影响的较为适用、快捷的预处理方式.     

固相萃取-红外分光光度法测定水中的总油

建立了固相萃取(SPE)-红外分光光度测定水中总油的方法,并对固相萃取条件进行了优化,实验表明,对于1L添加2mg标准油的水样,其总油的回收率为86%-93%,多次重复实验测定的相对标准偏差为2.9%(n=6)。     

Degradation of direct azo dye by Cucurbita pepo free and immobilized peroxidase

Enzymatic decolourization of the azo dye, Direct Yellow (DY106) by Cucurbita pepo (courgette) peroxidase (CP) is a complex process, which is greatly affected by pH, temperature, enzyme activity and the concentrations of H₂O₂ and dye. Courgette peroxidase was extracted and its performance was evaluated by using the free-CP (FCP) and immobilized-CP (ICP) forms in the decolourization of DY106. Immobilization of peroxidase in calcium alginate beads was performed according to a strategy aiming to minimize enzyme leakage and keep its activity at a maximum value by optimizing sodium alginate content, enzyme loading and calcium chloride concentration. The initial conditions at which the highest DY106 decolourization yield was obtained were found at pH 2, temperature 20℃, H₂O₂ dose 1 mmol/L (FCP) and 100 mmol/L (ICP). The highest decolourization rates were obtained for dye concentrations 50 mg/L (FCP) and 80 mg/L (ICP). Under optimal conditions, the FCP was able to decolorize more than 87% of the dye within 2 min. While with ICP, the decolourization yield was 75% within 15 min. The decolourization and removal of DY106 was proved by UV-Vis analysis. Fourier transform infrared (FT-IR) spectroscopy analysis was also performed on DY106 and enzymatic treatment precipitated byproduct.     

Fe2O3 particles as superior catalysts for low temperature selective catalytic reduction of NO with NH3

Fe203 particle catalysts were experimentally studied in the low temperature selective catalytic reduction （SCR） of NO with NH3. The effects of reaction temperature, oxygen concentration, [NH3]/[NO] molar ratio and residence time on SCR activity were studied. It was found that Fe203 catalysts had high activity for the SCR of NO with NH3 in a broad temperature range of 150-270℃, and more than 95% NO conversion was obtained at 180℃ when the molar ratio [NH3]/[NO] = 1, the residence time was 0.48 seconds and 02 volume fraction was 3%. In addition, the effect of SO2 on SCR catalytic activity was also investigated at the temperature of 180℃. The results showed that deactivation of the Fe2O3 particles occurred due to the presence of SO2 and the NO conversion decreased from 99.2% to 58% in 240 min, since SO2 gradually decreased the catalytic activity of the catalysts. In addition, X-ray diffraction, Thermogravimetric analysis and Fourier transform infrared spectroscopy were used to characterize the fresh and deactivated Fe2O3 catalysts. The results showed that the deactivation caused by SO2 was due to the formation of metal sulfates and ammonium sulfates on the catalyst surface during the de-NO reaction, which could cause pore plugging and result in suppression of the catalytic activity.     

快速消解分光光度法测定低浓度水样化学需氧量的不确定度评定

摘要：运用测量不确定度评定的方法和程序,分析了快速消解分光光度法（HJ／T399—2007）测量水质化学需氧量测试过程中不确定度的来源,主要是标准溶液配制、标准曲线拟合、样品重复测定、分光光度计、取水样体积这五部分引入的不确定度。本次测量相对合成不确定度为0．027;最大的相对不确定度分量是标准曲线拟合引起的,相对不确定度为0．015;最小的相对不确定度分量是取水样体积引起的,相对不确定度为0．0032;本次测量结果为：56．0mg／L±3．04mg／L,k=2。     

水质氨氮自动分析仪分析方法研究

氨氮自动分析仪是根据纳氏试剂分光光度法的原理,通过自动进样,自动蒸馏,来实现快速准确的分析水质氨氮样品。近年来,氨氮自动分析仪广泛应用于环境监测领域,该方法能够快速、准确、方便地测定水质中的氨氮。利用标准方法纳氏试剂分光光度法进行实验室内的比对实验,通过实验分析,氨氮自动分析仪的分析曲线线性较好,相关系数达到0．9998,方法检出限、准确率和精密度能够满足当前环境监测标准的要求,实际样品测定结果理想,适合在环境监测领域推广应用。     

污水处理厂污泥水溶解性有机物的光谱特性分析

污泥水是污水处理厂污泥浓缩、稳定、脱水等环节产生的废水,具有污染物浓度高、成分复杂的特点.采用三维荧光光谱和红外光谱研究了污泥水中溶解性有机物(DOM)的光谱特性.污泥水荧光性DOM(FDOM)可利用平行因子分析划分为6个荧光组分,分别为类蛋白质组分C1(275/355 nm)、C4(235/350 nm)和C6(275/305 nm),及类腐殖酸组分C2(250,340/440nm)、C3(320/380 nm)和C5(250/465 nm).重力浓缩和机械浓缩污泥水中COD与所有类腐殖酸组分均正显著相关(P0.01),类蛋白质组分对其影响不大.离心脱水污泥水中组分C1、C4和C5含量明显上升.深度脱水污泥水中FDOM荧光峰位置和强度与其它污泥水存在显著差异,C3和C6分别较离心脱水污泥水升高15.63和7.30倍.与浓缩污泥水相比,离心脱水污泥水中多糖和腐殖酸吸收峰增强,而深度脱水污泥水中蛋白质大量释放,金属离子会与腐殖酸和蛋白质络合引起DOM结构变化.