纳氏试剂光度法测定水和废水中氨氮方法的改进

对纳氏试剂光度法进行了改进,水样取样量改为10ml,在不改变反映体系pH值的前提下,纳氏试剂的用量改为0.10ml.改进法的校准曲线相关数γ＞0.999,最低检出限0.03mg/L,显色体系在90min内稳乏,RSD＜5%,加标回收率为91.6%～104%.通过地下水、地表水、生活污水和工业废水的比对实验表明,改进法与标准法的测定结果无显著性差异.     

土壤中矿物油含量测定方法研究

建立了土壤中矿物油含量的分析方法。采集的土壤鲜样,采用无水硫酸钠进行化学干燥。用四氯化碳提取土壤中的油类物质,采用硅酸镁去除提取液中的动植物油等极性化合物后,使用红外分光测油仪测定提取液中的矿物油含量。此方法具有良好的线性关系,相关系数在0.9999以上。测定下限为1.85 mg/l,测定上限为100 mg/l,测量范围为9 mg/kg～500 mg/kg,方法的灵敏度为1.05。试剂空白加标回收率56%～83%,实际样品加标回收率在69%～74%之间。该法简便快速,灵敏准确,具有广泛的应用前景。     

漆酶催化酚类、苯胺类化合物的动力学分析及其测定废水中邻苯二酚的应用研究

含酚、苯胺类废水是环境中水污染的重要来源之一.本研究以漆酶分析酚类及苯胺类底物的动力学特性为基础,建立酚类、苯胺类化合物的分析方法.以分光光度法测定漆酶催化0～10mg/L酚类及苯胺类底物的反应速率,作出底物浓度与反应速率的标准曲线,采用漆酶筛查并检测了3种焦化废水中非挥发酚类含量.结果表明,漆酶的酚类及苯胺类底物主要以多元酚、氨基酚及多元胺为主,其中酚类的最适pH在7.0左右,苯胺类在4.5～5.0之间,各底物Km值大小在0.4～10mmol/L之间.除联苯胺外,分光光度法所得到的标准曲线均具有较好的一级反应动力学线性关系,相关系数R2在0.96以上.3种焦化废水中邻苯二酚含量分别为190.5、265.8和155.3mg/L,回收率介于91.9%～115.8%之间.     

Removal of heavy metal ions from aqueous solution using red loess as an adsorbent

The adsorption behaviors of heavy metals onto novel low-cost adsorbent, red loess, were investigated. Red loess was characterized by X-ray diffraction, scanning electron microscopy and Fourier transform infrared spectra. The results indicated that red loess mainly consisted of silicate, ferric and aluminum oxides. Solution pH, adsorbent dosage, initial metal concentration, contact time and temperature significantly influenced the efficiency of heavy metals removal. The adsorption reached equilibrium at 4 hr, and the experimental equilibrium data were fitted to Langmuir monolayer adsorption model. The adsorption of Cu(II) and Zn(II) onto red loess was endothermic, while the adsorption of Pb(II) was exothermic. The maximum adsorption capacities of red loess for Pb(II), Cu(II) and Zn(II) were estimated to be 113.6, 34.2 and 17.5 mg/g, respectively at 25°C and pH 6. The maximum removal efficiencies were 100% for Pb(II) at pH 7, 100% for Cu(II) at pH 8, and 80% for Zn(II) at pH 8. The used adsorbents were readily regenerated using dilute HC1 solution, indicating that red loess has a high reusability. All the above results demonstrated that red loess could be used as a possible alternative low-cost adsorbent for the removal of heavy metals from aqueous solution.     

Potential particulate pollution derived from UV-induced degradation of odorous dimethyl sulfide

UV-induced degradation of odorous dimethyl sulfide (DMS) was carried out in a static White cell chamber with UV irradiation. The combination of in situ Fourier transform infrared (FT-IR) spectrometer, gas chromatograph-mass spectrometer (GC-MS), wide-range particle spectrometer (WPS) technique, filter sampling and ion chromatographic (IC) analysis was used to monitor the gaseous and potential particulate products. During 240 min of UV irradiation, the degradation e ciency of DMS attained 20.9%, and partially oxidized sulfur-containing gaseous products, such as sulfur dioxide (SO2), carbonyl sulfide (OCS), dimethyl sulfoxide (DMSO), dimethyl sulfone (DMSO2) and dimethyl disulfide (DMDS) were identified by in situ FT-IR and GC-MS analysis, respectively. Accompanying with the oxidation of DMS, suspended particles were directly detected to be formed by WPS techniques. These particles were measured mainly in the size range of accumulation mode, and increased their count median diameter throughout the whole removal process. IC analysis of the filter samples revealed that methanesulfonic acid (MSA), sulfuric acid (H2SO4) and other unidentified chemicals accounted for the major non-refractory compositions of these particles. Based on products analysis and possible intermediates formed, the degradation pathways of DMS were proposed as the combination of the O(1D)- and the OH- initiated oxidation mechanisms. A plausible formation mechanism of the suspended particles was also analyzed. It is concluded that UV-induced degradation of odorous DMS is potentially a source of particulate pollutants in the atmosphere.     

Removal of phosphate by Fe-coordinated amino-functionalized 3D mesoporous silicates hybrid materials

Phosphate removal from aqueous waste streams is an important approach to control the eutrophication downstream bodies of water. A Fe(III) coordinated amino-functionalized silicate adsorbent for phosphate adsorption was synthesized by a post-grafting and metal cation incorporation process. The surface structure of the adsorbent was characterized by X-ray di raction, N2 adsoropion/desoprotion technique, and Fourier transform infrared spectroscopy. The experimental results showed that the adsorption equilibrium data were well fitted to the Langmuir equation. The maximum adsorption capacity of the modified silicate material was 51.8 mg/g. The kinetic data from the adsorption of phosphate were fitted to pseudo second-order model. The phosphate adsorption was highly pH dependent and the relatively high removal of phosphate fell within the pH range 3.0–6.0. The coexistence of other anions in solutions has an adverse e ect on phosphate adsorption; a decrease in adsorption capacity followed the order of exogenous anions: F?? > SO2?? 4 > NO??3 > Cl??. In addition, the adsorbed phosphate could be desorbed by NaOH solutions. This silicate adsorbent with a large adsorption capacity and relatively high selectivity could be utilized for the removal of phosphate from aqueous waste streams or in aquatic environment.     

Fabrication and photoelectrocatalytic properties of nanocrystalline monoclinic BiVO4 thin-film electrode

Monoclinic bismuth vanadate(BiVO4) thin film was fabricated on indium-tin oxide glass from an amorphous heteronuclear complex via dip-coating.After annealation at 400,500,and 600°C,the thin films were characterized by X-ray diffraction,field emission scanning electron microscopy,X-ray photoelectron spectroscopy,and UV-Vis spectrophotometry.The BiVO4 particles on the ITO glass surface had a monoclinic structure.The UV-Visible diffuse reflection spectra showed the BiVO4 thin film had photoabsorption propertie...     

几种水合金属氧化物的磷酸根吸附性能

利用简单的碱沉淀法制备不同的水合金属氧化物,并对所得七种水合金属氧化物的磷酸根吸附等温线进行了系统的探讨比较.研究表明,25℃条件下,Al、Fe、Ni、Cu和Ce的水合金属氧化物对磷酸根的吸附最符合Langmuir线性吸附方程,而水合氧化锌和水合氧化钴吸附剂最符合线性等温线模型.所有这七种水合金属氧化物对磷酸根的吸附都...     

土壤阴离子表面活性剂总量亚甲基蓝法研究

文章通过设计正交试验,针对提取的主要因素提取液配比、提取时间、提取温度和提取剂用量确定最优的前处理方法,建立与国标《水质阴离子表面活性剂亚甲基蓝分光光度法》(GB7494-87)对应的土壤阴离子表而活性剂(LAS)的亚甲基蓝分光光度法.土壤样品烘干后经20 mL乙醇水溶液(70％)提取,水浴恒温振荡仪45℃下振荡2h,...     

水中总氮测定相关问题的实验探讨

通过对国家标准测定方法《碱性过硫酸钾消解紫外分光光度法》进行水样中总氮的测定,进一步理解在220nm、275nm波长处进行吸光度测定的重要性。并提出：在已经知道水样中没有氨氮、亚硝酸盐氮,只有硝酸盐氮的情况下．就能通过快速的方法一即不加氧化剂、不加压,可以进行总无机氮的测定。快速测定无机总氮对于工程应用来说很有意义。因为国标的方法需要半天时间测定。而用此方法则仅需几分钟就可完成测定。、另外对于有机物对于测定结果的影响,参考吸光度比值（A275／A220×100％）应小于20％,越小越好,超过时应予鉴别。