延时曝气对常温低氨氮SBR亚硝化影响及恢复

常温条件[(22±1)℃]下,采用SBR反应器,探讨延时曝气对常温低氨氮生活污水亚硝化的影响及寻找一种因延时曝气失稳的亚硝化高效恢复策略.结果表明,延时曝气可为NOB创造一个迅速增殖的有利环境,经23d的延时曝气(延迟时间1h)最终使亚硝化系统失稳;且失稳后仅通过限氧无法实现其恢复,而通过增设1h前置厌氧搅拌并缩短曝气时间控制氨氧化率在50%左右,经过60个周期(20d)实现了亚硝化的恢复.     

佛山水道及其支涌复氧试验研究

对几种曝气方式的溶解氧提升情况、充氧动力效率,及COD、氨氮的去除率进行了简单比较,得出微孔雾化曝气和橡胶坝曝气是适合佛山水道及其支涌河流人工复氧的最佳方法.     

花卉废物和牛粪联合堆肥中的氮迁移

以花卉废物和牛粪为原料,进行了温度反馈的通气量控制联合堆肥中的氮迁移中试研究.采用自制的静态好氧床进行一次发酵,过程控制采用温度反馈通气量控制方法,发酵周期20d;采用周期性翻堆进行物料二次腐熟,腐熟周期40d.研究了堆肥过程中总氮、有机氮、无机氮、氨氮、硝氮等氮素形态转化随时间的变化特征及温度反馈的通气量控制对氮迁移的影响.结果表明:堆肥初期的氨化作用和反硝化作用显著,氮素总量损失累计达41.98%,其中主要是有机氮的损失,99.95%的氮损失发生在一次发酵阶段;氮素损失主要是在pH和温度较高条件下的氨气大量挥发造成的.对通风进行有效控制、提高物料C/N及添加酸性物质有望减少N损失.对于C/N较低,硝态氮含量较高的物料堆肥,NH₄⁺-N≤0.04%、NH₄/NO₃≤0.16不能作为腐熟度指标.     

三峡小城镇污水处理厂污水处理工艺探讨

在调查研究三峡库区重庆段小城镇污水处理现状的基础上,根据库区水质特征、水环境保护的特殊要求和库区地理环境与经济条件特点,对适用污水处理工艺和技术进行比选,认为利用地形高差,采用跌水曝气式生物滤塔+氧化沟处理工艺适用于库区小城镇污水处理。     

扰动强化污染底泥有机物自净的研究

扰动能够强化水体溶解氧的恢复并加快传质,增强水体的自净作用,有利于水体和底泥COD的降解,是一种常用的污染水体的修复方法。文章通过人工模拟的水体,构建搅拌和曝气两种上覆水扰动条件,研究了在这两种条件下水体中有机物含量以及底泥中微生物量的变化情况,探讨了扰动对水体有机物去除的影响。研究结果表明：（1）与对照情况相比,在搅拌、曝气条件下水中ρ（溶解氧）分别由0.2 mg.L^-1提高到1.0和8.0 mg.L^-1左右;曝气条件下底泥中蛋白含量及细菌数均最高;（2）底泥中w（脱氢酶活性）在搅拌和曝气条件下分别为0.52和0.46μg.g^-1左右;（3）曝气条件下对上覆水中有机物的去除呈现出较好的降解趋势。因此,运用曝气技术既能加速有机物的生化降解,改善水质;又可强化水体溶解氧的恢复,创造了微生物生长繁殖的适宜环境,增强了水体中微生物的活性,促进了水体自净能力的提高,在治理河道污染的应用中具有广阔的前景。     

高氨氮废水半短程硝化控制及曝气经济性运行优化

本研究进水模拟了污泥消化液、晚期垃圾渗滤液等高氨氮低碱度低碳氮比的废水,在碱度缺乏（不足以实现完全短程硝化）条件下获得了稳定的半短程硝化,并通过曝气量和污泥浓度（MLSS）双因素调控,实现了半短程硝化的高效经济运行.研究表明,进水碱度缺乏条件下短程硝化体系出水亚硝氮/氨氮浓度比值y与进水HCO₃^-∶NH₄⁺物质的量的比x之间存在化学计量关系 y=x/（2-x）,当进水HCO₃^-∶NH₄⁺物质的量的比为1,即进水碱度/氨氮浓度（mg·L^-1）比值为3.6时可实现半短程硝化,并通过游离氨（FA）和游离亚硝酸（FNA）联合抑制能够实现稳态运行,亚硝酸盐积累率平均可达95%以上.实验探究了MLSS和曝气量对短程硝化反应器曝气经济性和氨氧化率的影响,通过平衡两因素作用,在保证处理效果的同时最大程度提升了反应系统的曝气经济性：当曝气量为36 L·h^-1和MLSS为2243 mg·L^-1时,反应器的曝气经济性较好,可节省约40%曝气量,且能维持较高的容积氨氮负荷（0.93 kg·m^-3·d^-1）.     

改进型Orbal氧化沟在污水处理厂的应用

介绍了江山市鹿溪污水处理厂的设计概况和特色。工程一期处理规模为4.0万m3/d。采用"微孔曝气+推流器"的方式,充氧调节幅度为45%～100%,同时设计水深增加到5.5m,有效减少氧化沟的占地面积,节约运行费用。污水厂进水的主要污染指标为COD和NH3-N,主要处理工艺为改进型Orbal氧化沟。此外为了适应雨季的水量冲击,系统采用灵活的进水方式,雨季污水直接进入中沟,在保证出水达标的同时,减少了污泥流失。两年多的运行结果表明,该工艺具有良好的环境和经济效益。     

昆船污水处理站微孔曝气池的启动研究

昆明船舶公司生活区污水处理站采用改进型的A2/O工艺,直接利用其生活污水培养污泥,并随时观察和分析工艺中的微孔曝气池运行状况。结果表明:采用自然培菌的方法,通过近3个半月的污泥培养,顺利实现微孔曝气池的启动。其中,COD、NH3-N的去除变化反映了曝气池启动的进程,至曝气池启动结束,COD和NH3-N的去除率分别达到了78.4%、75.7%。     

Performance of completely autotrophic nitrogen removal over nitrite process under different aeration modes and dissolved oxygen

In this study, three sequential batch biofilm reactors (SBBRs) were operated for 155 days to evaluate the performance of completely autotrophic nitrogen removal over nitrite (CANON) process under different aeration modes and dissolved oxygen (DO). Synthetic wastewater with 160-mg NH4 ⁺-N/L was fed into the reactors. In the continuously-aerated reactor, the efficiency of the ammonium nitrogen conversion and total nitrogen (TN) removal reached 80% and 70%, respectively, with DO between 0.8–1.0 mg/L. Whereas in the intermittently-aerated reactor, at the aeration/non-aeration ratio of 1.0, ammonium was always under the detection limit and 86% of TN was removed with DO between 2.0–2.5 mg/L during the aeration time. Results show that CANON could be achieved in both continuous and intermittent aeration pattern. However, to achieve the same nitrogen removal efficiency, the DO needed in the intermittently-aerated sequential batch biofilm reactor (SBBR) during the aeration period was higher than that in the continuously-aerated SBBR. In addition, the DO in the CANON system should be adjusted to the aeration mode, and low DO was not a prerequisite to CANON process.     

Household organic waste composting using bins with different types of passive aeration

The objective of this study was to study the performances of six 200-L polyethylene bins, each with different design for passive aeration to organic wastes composting. Food scraps and dry leaves (1.6 kg) were added to each bin once a day until the bin was full. Temperatures at the middle portion were measured daily. The compost from each bin was taken once a week for 120 days for analysis of C, N, volatile solids, and a germination index once a week for 120 days. After 120 days, the compost sample from each bin was taken to determine the mass reduction, size distribution, CEC, N, P and K values. The results showed that the temperatures inside the bins were in the ranges of 24 °C-57 °C. The composts in all bins were found to be stable at around 56-91 days. The wastes decayed fastest in bins with lateral and vertical systems of natural ventilation. It took about two months to stabilize the organic wastes, with a 59-62% decrease of mass. The C/N ratio, CEC, N, P, and K values of the final composts were 14.8-16.0, 66-68 cmol/kg, and 1.26-1.50% N, 0.52-0.56% P₂O₅ and 1.66-1.92% K₂O, respectively.