全文获取类型
收费全文 | 5480篇 |
免费 | 435篇 |
国内免费 | 840篇 |
专业分类
安全科学 | 1428篇 |
废物处理 | 178篇 |
环保管理 | 443篇 |
综合类 | 3061篇 |
基础理论 | 672篇 |
污染及防治 | 351篇 |
评价与监测 | 461篇 |
社会与环境 | 73篇 |
灾害及防治 | 88篇 |
出版年
2024年 | 34篇 |
2023年 | 140篇 |
2022年 | 169篇 |
2021年 | 223篇 |
2020年 | 214篇 |
2019年 | 253篇 |
2018年 | 139篇 |
2017年 | 183篇 |
2016年 | 262篇 |
2015年 | 254篇 |
2014年 | 518篇 |
2013年 | 345篇 |
2012年 | 382篇 |
2011年 | 368篇 |
2010年 | 284篇 |
2009年 | 239篇 |
2008年 | 373篇 |
2007年 | 404篇 |
2006年 | 279篇 |
2005年 | 242篇 |
2004年 | 183篇 |
2003年 | 190篇 |
2002年 | 153篇 |
2001年 | 134篇 |
2000年 | 103篇 |
1999年 | 93篇 |
1998年 | 107篇 |
1997年 | 88篇 |
1996年 | 80篇 |
1995年 | 65篇 |
1994年 | 59篇 |
1993年 | 36篇 |
1992年 | 42篇 |
1991年 | 46篇 |
1990年 | 34篇 |
1989年 | 35篇 |
1988年 | 1篇 |
1986年 | 1篇 |
排序方式: 共有6755条查询结果,搜索用时 15 毫秒
81.
零价铁(ZVI)去除Cu2+的特性及机制研究 总被引:3,自引:2,他引:1
研究了零价铁去除水溶液中铜离子的影响因素及动力学特性,并利用X射线衍射(XRD)分析对反应机制进行了探讨.结果表明,当溶液中Cu2+的浓度为300 mg/L,零价铁的用量为1 g/L时,Cu2+的去除率99%.Cu2+的去除速度很快,且反应前30min零价铁去除Cu2+的过程可以用一级反应动力学方程模拟.零价铁去除Cu2+的机制主要基于氧化还原反应,Cu2+的还原产物主要为Cu和Cu2O. 相似文献
82.
83.
研究了pH和铜离子对倏逝波全光纤免疫传感器检测微囊藻毒素-LR(MC-LR)的影响及其消除措施.研究表明,过酸或过碱条件对MC-LR免疫检测均有较强烈的影响,当pH<6或pH>8时,系统检测的信号随pH的降低或增大明显下降;而当pH在6~8之间时,检测标准曲线的IC50为1.01~1.04 μg/L,检测区间在0.12~10.5 μg/L之间,较适合MC-LR的检测.低浓度铜离子对MC-LR免疫检测的影响不大,当CuSO4浓度>5 mg/L时,系统检测荧光信号明显下降,而当CuSO4浓度达到10 mg/L时,系统检测信号下降70%以上.在预反应混合物中添加1%的螯合剂EDTA,能有效抑制铜离子对免疫检测的影响. 相似文献
84.
对饮用水消毒过程中一氯胺的衰减过程,采用二级反应速率模型对其衰减规律进行了非线性拟合;分别考察了pH值、温度、碳酸盐、溴离子、碘离子和天然有机物(NOM)浓度等水质参数变化对一氯胺衰减速率的影响.结果表明,pH值是影响一氯胺衰减速率的重要因素,pH<7.0时尤为明显;温度和碳酸盐对一氯胺的衰减速率均有明显影响;在pH=6.60时,随着溴离子浓度的增加一氯胺的衰减加快;在pH>7.60,0.1 mg/L的溴离子浓度对一氯胺的衰减影响不明显,碘离子对一氯胺的衰减影响较相同反应条件下溴离子的影响明显.此外,一氯胺衰减动力学模拟结果表明,采用二级动力学反应模型可以较好地拟合在卤素离子(Br-I、-)共存条件下的一氯胺衰减规律,对在沿海地区饮用水消毒工艺中不同条件下氯胺消毒剂浓度预测可以提供一定的理论和技术支持. 相似文献
85.
86.
氧化铝负载镧去除水中F-的研究 总被引:2,自引:0,他引:2
通过固相反应合成了氧化铝负载的氧化镧吸附剂并研究了其对水中F-的吸附.结果表明.合成的材料对F-有很好的去除效果,最大吸附量达到53.4 mg·g-1;适当提高吸附温度和氧化镧负载量都能在一定范围内提高吸附量;较低的固相反应焙烧温度有利于提高去除率,随着焙烧温度的升高,吸附量从170℃焙烧的42.2 mg·g-1下降到了350℃焙烧的32.9 mg·g-1.同时,吸附剂表现出了很好的适应性,在较宽的pH范围内都能保持较高的吸附量. 相似文献
87.
The study was to investigate the adsorption behavior of arsenite (As(Ⅲ)) and arsenate (As(Ⅴ)) on two variable charge soils, i.e., Haplic Acrisol and Rhodic Ferralsol at different ionic strengths and pH with batch methods. Results indicated that the amount of As(Ⅲ) adsorbed by these two soils increased with increasing solution pH, whereas it decreased with increasing ionic strength under the acidic condition. This suggested that As(Ⅲ) was mainly adsorbed on soil positive charge sites through electrostatic attraction under the acidic condition. Moreover, intersects of As(Ⅴ) adsorption-pH curves at different ionic strengths (a characteristic pH) are obtained for both soils. It was noted that above this pH, the adsorption of As(Ⅴ) was increased with increasing ionic strength, whereas below it the reverse trend was true. Precisely the intersect pH was 3.6 for Haplic Acrisol and 4.5 for Rhodic Ferralsol, which was near the values of PZSE (soil point of zero salt effect) of these soils. The effects of ionic strength and pH on arsenate adsorption by these soils were interpreted by the adsorption model. The results of zeta potential suggested that the potential in adsorption plane becomes less negative with increasing ionic strength above soil PZSE and decreases with increasing ionic strength below soil PZSE. These results further supported the hypothesis of the adsorption model that the potential in the adsorption plane changes with ionic strength with an opposite trend to surface charge of the soils. Therefore, the change of the potential in the adsorption plane was mainly responsible for the change of arsenate adsorption induced by ionic strength on variable charge soils. 相似文献
88.
89.
离子膜辅助电催化氧化法预处理焦化废水的研究 总被引:3,自引:0,他引:3
焦化废水是属有毒有害、难降解的有机废水,常规的生物处理工艺对其去除效果不甚理想,从而导致出水中难降解污染物含量较高,COD和NH3-N不能达标。论文针对焦化废水的水质特点,采用离子膜电解技术进行预处理。对焦化废水中主要污染物苯酚降解效果的几种因素进行了研究,得出了苯酚降解的最佳工艺条件并在此工艺参数下,对模拟焦化废水电解2.5h,苯酚、COD的去除率分别为84%,45%,氨氮去除率和回收率别为99.5%和96.5%,总能耗27kwh/m3,可以为后续生化处理大大减轻负担,采用该方法作为焦化废水的预处理手段比较经济合理。 相似文献
90.