Fe2O3 particles as superior catalysts for low temperature selective catalytic reduction of NO with NH3

Fe203 particle catalysts were experimentally studied in the low temperature selective catalytic reduction （SCR） of NO with NH3. The effects of reaction temperature, oxygen concentration, [NH3]/[NO] molar ratio and residence time on SCR activity were studied. It was found that Fe203 catalysts had high activity for the SCR of NO with NH3 in a broad temperature range of 150-270℃, and more than 95% NO conversion was obtained at 180℃ when the molar ratio [NH3]/[NO] = 1, the residence time was 0.48 seconds and 02 volume fraction was 3%. In addition, the effect of SO2 on SCR catalytic activity was also investigated at the temperature of 180℃. The results showed that deactivation of the Fe2O3 particles occurred due to the presence of SO2 and the NO conversion decreased from 99.2% to 58% in 240 min, since SO2 gradually decreased the catalytic activity of the catalysts. In addition, X-ray diffraction, Thermogravimetric analysis and Fourier transform infrared spectroscopy were used to characterize the fresh and deactivated Fe2O3 catalysts. The results showed that the deactivation caused by SO2 was due to the formation of metal sulfates and ammonium sulfates on the catalyst surface during the de-NO reaction, which could cause pore plugging and result in suppression of the catalytic activity.     

Adsorption of Cr(Ⅲ) from acidic solutions by crop straw derived biochars

Cr（Ⅲ） adsorption by biochars generated from peanut, soybean, canola and rice straws is investigated with batch methods. Adsorption of Cr（Ⅲ） increased as pH rose from 2.5 to 5.0. Adsorption of Cr（Ⅲ） led to peak position shifts in the FFIR-PAS spectra of the biochars and made zeta potential values less negative, suggesting the formation of surface complexes between Cr^3＋ and functional groups on the biochars. The adsorption capacity of Cr（Ⅲ） followed the order： peanut straw char 〉 soybean straw char 〉 canola straw char 〉 rice straw char, which was consistent with the content of acidic functional groups on the biochars. The increase in Cr^3＋ hydrolysis as the pH rose was one of the main reasons for the increased adsorption of Cr（Ⅲ） by the biochars at higher pH values. Cr（llI） can be adsorbed by the biochars through electrostatic attraction between negative surfaces and Cr^3＋, but the relative contribution of electrostatic adsorption was less than 5%. Therefore, Cr（Ⅲ） was mainly adsorbed by the biochars through specific adsorption. The Langumir and Freundlich equations fitted the adsorption isotherms well and can therefore be used to describe the adsorption behavior of Cr（Ⅲ） by the crop straw biochars. The crop straw biochars have great adsorption capacities for Cr（Ⅲ） under acidic conditions and can be used as adsorbents to remove Cr（Ⅲ） from acidic wastewaters.     

不同裂解条件对生物炭稳定性的影响

在300⁵00℃温度下热裂解水稻秸秆、玉米秸秆制备生物炭,并采用红外光谱(FTIR)和元素分析的方法,以生物炭表面官能团和元素组成为主要考察指标,研究了不同裂解温度、不同保留时间对生物炭稳定性的影响。生物炭红外光谱图结果显示,生物质原材料经过裂解炭化过程,原材料分子结构中所含醚键(C-O-C)、羰基(C=O)等基团消失。随着裂解温度升高,生物炭中甲基(-CH3)和亚甲基(-CH2)也逐渐消失,而芳环结构增加,生物炭芳香化程度增强。延长生物炭制备过程中的保留时间亦有相同结果。生物炭元素组成的结果显示,裂解温度升高及保留时间延长均能使生物炭的H/C比下降,同时裂解温度对生物炭H/C的影响更加显著。相比水稻秸秆生物炭,玉米秸秆生物炭的芳环骨架更加明显,芳香化程度更高。     

加速度计在振动试验中的应用

加速度计是一种产生与加速度成正比输出的传感器,也是振动试验系统中必不可少的组成部分。介绍了加速度计的基本原理和选型,对其在振动试验中的使用进行了讨论,并着重介绍了加速度计在综合环境下的应用。     

石化企业玻璃钢设施静电特性及安全使用

通过测试玻璃钢设施的静电参数,研究分析玻璃钢设施的静电特性,表明玻璃钢设施有较大的静电危险性,提出了一般防静电措施,预防玻璃钢设施的燃爆风险。     

基于ImageJ评价泥炭岩心存储对色相与彩度的影响

利用ImageJ软件对2008年在红原泥炭地开展钻探时的泥炭岩心照片和2009年分样时的岩心照片进行表面色彩分析.对比分析发现,存储以前和存储以后泥炭岩心的表面色彩发生改变,表现在样品存储后基于RGB色彩体系的三元色值和灰度值均有降低(变暗),且各色值变化幅度降低.就各色值在剖面上的变化特征而言,样品存储前和存储后的变...     

非离子表面活性剂对污泥调理脱水效果的影响

现有污泥脱水技术仅使污泥含水率降到80%左右,难以满足日益严格的污泥处置要求.以污泥比阻（SRF）、脱水率为考察指标,比较了两大类非离子型表面活性剂（辛基酚聚氧乙烯醚OPEO型和烷基糖苷APG）对剩余污泥的脱水效果,并对原泥及调理后污泥进行了显微观察.结果表明,非离子表面活性剂可使污泥絮体粒径变小,不规则程度降低,改善了污泥的脱水性能,而且烷基糖苷APG脱水效果优于OPEO型.APG投加量为0.05%干固体时,污泥比阻即可降低到原泥的42%,脱水率可达到93%.以烷基糖苷APG为调理剂进行板框脱水实验,结果表明,当APG投加量为0.05%干固体时,脱水泥饼含水率比原泥脱水泥饼含水率低约10%,脱水率可达到97%.本研究为APG应用于污泥脱水,改善污泥脱水性能提供一些参考.     

超滤处理洗涤污水循环利用的中试研究

采用不同材质国产超滤膜聚丙烯（PP）、聚丙烯腈（PAN）和聚砜（PS）,进行了洗涤污水处理循环利用的现场中试研究.结合超滤工艺出水水质和膜污染分析,3种膜材质中PAN膜较优,有效去除了水中浊度、悬浮物、油脂等污染物,一定程度保留了游离阴离子表面活性剂（LAS）,长期循环洗涤对衣物的白度无不良影响.根据相关性分析,超滤出水较高COD值很大程度上是由水中LAS引起的.超滤膜对细菌、大肠菌群的去除率较低,出水通过紫外消毒,当紫外线密度≥3?750 J/m²时,微生物水平能够达到国家饮用水水质标准.根据不同水力反冲洗条件下膜渗透通量和净产水量比较,PAN膜最佳水力反冲洗条件为0.5 h反冲洗2 min.长期运行时超滤膜化学清洗方法采用碱洗法方便有效.     

好氧颗粒污泥膜生物反应器污泥性状研究

采用厌氧-好氧运行方式的颗粒污泥膜生物反应器（GMBR）,连续运行近120　d表现出良好的有机物去除及同步硝化反硝化能力.对GMBR中污泥粒径分布变化研究表明,GMBR中污泥浓度的增加主要是由于粒径0.18～0.45　mm的小颗粒污泥及小于0.18　mm的絮状污泥的增加造成的,粒径大于0.45　mm的颗粒污泥能够基本稳定维持其颗粒形态,反应器运行末期,GMBR中颗粒污泥（粒径大于0.18　mm的污泥）含量稳定在污泥总量的60％～65％以上.污泥表面电荷量随着污泥组成形态的变化电负性逐渐增加,80　d后稳定在-0.42～-0.80　meq·g^-1之间.污泥表面电荷的负电性增加主要是由小于0.45　mm的污泥造成的,其中小于0.18　mm的絮状污泥对其影响最大.并且,污泥粒径越大污泥表面负电荷量越少,两者具有较好的线性关系.另外,GMBR中SVI稳定在60～90 mL/g之间,并且随着污泥表面电荷负电性的增加污泥SVI值增加,两者之间具有一定的相关性.     

模拟可见光下土壤表面石油的光化学降解研究

在模拟可见光照射下,分析了土壤中的初始含油量、土壤类型和土壤pH值对石油在土壤表面光降解过程的影响,并利用紫外-可见分光光度法(UV-Vis)、气相色谱-氢火焰离子化检测器(GC-FID)和傅立叶红外光谱(FTIR)等方法对石油在光降解过程中的演变规律进行研究.结果表明,石油在土壤表面上的光化学降解行为符合准一级反应动力学,实验测得石油的光解速率常数为0.002 6～0.017 2 h^-1,半衰期为40～267 h.GC-FID分析结果表明,在光降解50 h后,石油的饱和烃组分中高碳数的烷烃相对含量降低,低碳数的烷烃相对含量提高;芳香烃组分的大部分色谱峰有明显地降低或消失.红外光谱分析发现,光照60 h后土壤萃取液中可能产生了羰基类化合物,说明石油在光降解过程中逐渐发生氧化.