煤制乙二醇废水预处理装置的工业化调试

针对煤制乙二醇废水含高浓度硝酸盐氮的特点,设计了缺氧膨胀床(AEB)反应器预处理装置,并进行了工业化启动和调试运行,考察了其在反硝化连续流运行条件下的处理效果及工艺参数变化。结果表明,AEB反应器启动后,填料层生物膜挂膜快速且生长稳定。反应器在工业化调试阶段运行稳定,COD和TN的去除率和去除负荷较为稳定。在受到来水冲击后,AEB反应器处理效果稳定,出水可在短期内恢复正常。该技术的系统操控参数范围较广,易于工业化操控运行,在煤制乙二醇废水和其他含高浓度硝酸盐氮废水的处理中具有较大的推广价值。     

阳春春湾柴草自燃现象与地震活动关系探讨

通过对广东省阳春市春湾镇龙虎坑村柴草自燃现象与地震活动时间序列以及对自燃区地质地貌、断层气测量等研究,认为,自燃现象与强震活动有密切的对应关系;柴草自燃现象是区域构造应力场加强的窗口效应.     

亲水性多孔载体在流化床中的生物膜形成过程分析

采用实验制备的一种新型亲水性多孔聚合物作为流化床反应器中生物膜附着生长的载体,实现流态化水力条件下的生物挂膜过程.在3个结构尺寸相同的流化床反应器中考察了接种污泥浓度、进水有机负荷及载体粒径对亲水性多孔载体生物挂膜量的影响,试验结果表明,接种污泥浓度为30 g VSS/L、进水TOC值为350 mg/L、载体粒径为5～8 mm时载体表面的附着生物量最大,反应器运行12 d的载体附着生物量达到4.45 g VSS/L,膜结构稳定,表现出较活性污泥法更高的活性.在进水TOC、氨氮浓度分别为350 ms/L、50 mg/L,HRT为6 h的情况下,两者的去除率分别达到了97.1%和64.3%,表明载体上的生物膜对污水中TOC及氨氮的去除表现出高效率.挂膜后载体表面上的微生物以丝状菌为主,孔壁上的微生物以球菌和杆菌为主要生物相,证明载体内外表面皆适宜微生物的生长,并且形成合理的生物相分布.     

锌精炼铅塔燃烧系统烟气温度模糊控制研究

针对锌精馏铅塔动态过程中的非线性、非最小相位特征、不稳定性、时滞和负荷干扰,基于模糊控制策略下给出了锌精馏铅塔燃烧系统新的控制方法.运用模糊控制系统对锌精馏铅塔的烟气温度进行仿真研究和实时控制结果表明,该研究所设计的模糊控制器能够克服许多干扰因素,产生了良好的控制效果.     

Comparative on Causes and Accumulation of Selenium in the Tree-rings Ambient High-selenium Coal Combustion Area from Yutangba, Hubei, China

Toxic trace elements emitted during coal combustion are the main sources of air pollution. They are released into the atmosphere mainly in the forms of fine ash, smoke and flue, and thus adversely affect plant, animal and human health. Selenium is one of toxic and the most volatile in coal. Large amount of atmospheric emission of selenium, as well as selenium present and scrubber stockpiles in ash may create serious environmental problems. In the paper, on the basis of investigating the abundance and distribution of selenium in plant-rings during recent 20 years, the bioaccumulation of selenium is explained that selenium in plant, which were collected from the village of selenium-rich coal combustion, is much higher than that in plants collected away from the village of selenium-rich coal combustion. The main origins of selenium are selenium-rich coal combustion and high-selenium rock weathered. The selenium recycle by food chain and selenium will accumulate and redistribute in environments.     

基于遥感尾气监测的柴油车气态污染物排放因子计算方法研究

采用遥感尾气测试系统实测了柴油车在实际道路工况下的CO、HC和NO排放特征,修正了排放因子的计算方法,并与车载排放测试系统（PEMS）实测结果进行了验证,获得了实测车辆的CO、HC和NO排放因子.测试结果显示,在各种遥感监测的工况下柴油车尾气中均含有较高浓度的氧气,未考虑氧气影响的燃烧方程反演获得的各污染物体积浓度计算值与PEMS实测值的偏差较大,且氧气浓度越大,偏差越大.经过氧气修正的燃烧方程反演计算的尾气浓度与PEMS实测值吻合度大幅提升,适用于实际工况下遥感检测车辆尾气的反演计算.修正算法得到CO、HC和NO的排放因子离散性较小,精确度较高,可以为量化柴油车尾气排放贡献提供科学依据.     

固定化微藻流化床反应器去除低碳污水中氨氮的潜力

以固定化微藻颗粒为原料,通过搭建流化床反应器强化微藻对氨氮（NH₄⁺-N）的去除,设计了藻种、污水上升流速、光周期和光照强度四组单一变量实验,系统地研究了不同条件下微藻去除NH₄⁺-N的能力.结果表明,当以固定化斜生栅藻为原料、污水上升流速为6.8m/h、光周期为8：16h和光照强度为4800Lux时,NH₄⁺-N去除效果最优（96.7%）.在最优操作条件下,探究了COD为200mg/L时微藻去除NH₄⁺-N的潜力,结果表明,当NH₄⁺-N初始浓度不高于50mg/L时,NH₄⁺-N去除率高于95%.本实验建立了一套半连续微藻流化床实验方法,该方法显著减弱了微藻在生物同化过程中对有机碳源的依赖性,为低COD条件下微藻生物脱氮工艺的设计提供了技术参考和理论基础.     

Investigation to meet China II emission legislation for marine diesel engine with diesel methanol compound combustion technology

In order to reduce the pollutant emission and alleviate the pressure of petroleum resources shortage and greenhouse gas emission at the same time, the use of clean and renewable alternative fuel for marine engines is a promising option. In this study, a marine diesel engine, which was modified to run in diesel methanol compound combustion (DMCC) mode, was investigated. After the diesel injection parameters were calibrated, and combined with a sample after-treatment device DOC (diesel oxidation catalyst), the engine could meet the requirements of China II legislation. The overall MSP (methanol substitute percent) reached 54.1%. The value of each pollutant emission was much lower than that in China II emission legislation, and there was almost no methanol and formaldehyde emissions. When methanol was injected into the inlet manifold, the intake air temperature decreased a lot, as well as the exhaust gas temperature, which were beneficial to increase engine thermal efficiency and improve engine room environment. Compared with the engine running in pure diesel mode, when the engine ran in diesel/methanol dual fuel mode, the combustion phase was advanced, and the combustion duration became shorter. Therefore, the engine thermal efficiency increased, and fuel consumption decreased significantly.     

UASB启动运行特征及互营丙酸氧化菌定量分析

为揭示升流式厌氧污泥床（UASB）反应器启动运行效能与互营丙酸降解菌群数量之间的关系,以稀释的玉米淀粉生产废水为底物,考察了UASB启动期的运行特征,并采用实时荧光定量PCR技术（qPCR）分析了互营丙酸降解菌群（丙酸氧化菌和产甲烷菌）的演替规律.结果表明,在进水COD 2000mg/L和水力停留时间（HRT）24h条件下,经过38d的连续运行,COD去除率达到了91.9%.当HRT分阶段缩短至8h时,比产甲烷速率达到了315LCH₄/（kg COD·d）,且形成了沉降性能良好的颗粒污泥.qPCR检测结果表明,至少有5种已鉴定的丙酸氧化菌存在于UASB反应器中.Pelotomaculum propionicum为接种污泥中的主要丙酸氧化菌,约占检测到丙酸氧化菌总数的45.7%.它的数量随着HRT缩短不断减少.而Syntrophobacter sulfatireducens和S.wolinii的数量随着HRT缩短不断增加,并在启动完成时达到最大值,分别为1.3×10³,5.5×10³个16S rRNA基因拷贝数/ng DNA,演替成为成熟颗粒污泥中的优势丙酸氧化菌群.Methanobacterium和Methanosarcina为接种污泥中的主要氢营养型产甲烷菌和乙酸营养型产甲烷菌,其数量随着HRT的缩短而逐渐减少,而Methanospirillum和Methanosaeta的数量随HRT的缩短逐渐增加,成为成熟颗粒污泥中的优势产甲烷菌群.     

火焰原子吸收分光光度法测定鱼内脏及河流底泥中的铜

采用火焰原子吸收分光光度法测定鱼内脏及河流底泥中的铜。鱼内脏经组织捣碎机捣成匀浆后，加硝酸消解；底泥则经氢氟酸和高氯酸消化。该方法具有灵敏度高，精密度和回收率较好等特点。