煤制乙二醇废水预处理装置的工业化调试

针对煤制乙二醇废水含高浓度硝酸盐氮的特点,设计了缺氧膨胀床(AEB)反应器预处理装置,并进行了工业化启动和调试运行,考察了其在反硝化连续流运行条件下的处理效果及工艺参数变化。结果表明,AEB反应器启动后,填料层生物膜挂膜快速且生长稳定。反应器在工业化调试阶段运行稳定,COD和TN的去除率和去除负荷较为稳定。在受到来水冲击后,AEB反应器处理效果稳定,出水可在短期内恢复正常。该技术的系统操控参数范围较广,易于工业化操控运行,在煤制乙二醇废水和其他含高浓度硝酸盐氮废水的处理中具有较大的推广价值。     

亲水性多孔载体在流化床中的生物膜形成过程分析

采用实验制备的一种新型亲水性多孔聚合物作为流化床反应器中生物膜附着生长的载体,实现流态化水力条件下的生物挂膜过程.在3个结构尺寸相同的流化床反应器中考察了接种污泥浓度、进水有机负荷及载体粒径对亲水性多孔载体生物挂膜量的影响,试验结果表明,接种污泥浓度为30 g VSS/L、进水TOC值为350 mg/L、载体粒径为5～8 mm时载体表面的附着生物量最大,反应器运行12 d的载体附着生物量达到4.45 g VSS/L,膜结构稳定,表现出较活性污泥法更高的活性.在进水TOC、氨氮浓度分别为350 ms/L、50 mg/L,HRT为6 h的情况下,两者的去除率分别达到了97.1%和64.3%,表明载体上的生物膜对污水中TOC及氨氮的去除表现出高效率.挂膜后载体表面上的微生物以丝状菌为主,孔壁上的微生物以球菌和杆菌为主要生物相,证明载体内外表面皆适宜微生物的生长,并且形成合理的生物相分布.     

山梨酸废水在ABR中的基质降解行为

稳态条件下,采用厌氧折流板反应器(anaerobic baffled reactor,ABR)处理山梨酸废水并进行基质降解动力学研究.实验表明,在污泥负荷为0.54～1.63 kg COD/(kg VSS·d)的范围内,COD去除率随着负荷的增加从85%降到55%.各隔室出水COD沿程递减,前3个隔室承担了去除COD的重要作用,但随着污泥负荷的增加,后部承担的COD去除率比例增大.基于各串联隔室完全混合的假定,推导ABR中山梨酸废水的基质降解动力学方程,并通过实验确定相关动力学参数及相应的动力学方程.实测值与预测值基本吻合.     

固定化微藻流化床反应器去除低碳污水中氨氮的潜力

以固定化微藻颗粒为原料,通过搭建流化床反应器强化微藻对氨氮（NH₄⁺-N）的去除,设计了藻种、污水上升流速、光周期和光照强度四组单一变量实验,系统地研究了不同条件下微藻去除NH₄⁺-N的能力.结果表明,当以固定化斜生栅藻为原料、污水上升流速为6.8m/h、光周期为8：16h和光照强度为4800Lux时,NH₄⁺-N去除效果最优（96.7%）.在最优操作条件下,探究了COD为200mg/L时微藻去除NH₄⁺-N的潜力,结果表明,当NH₄⁺-N初始浓度不高于50mg/L时,NH₄⁺-N去除率高于95%.本实验建立了一套半连续微藻流化床实验方法,该方法显著减弱了微藻在生物同化过程中对有机碳源的依赖性,为低COD条件下微藻生物脱氮工艺的设计提供了技术参考和理论基础.     

UASB启动运行特征及互营丙酸氧化菌定量分析

为揭示升流式厌氧污泥床（UASB）反应器启动运行效能与互营丙酸降解菌群数量之间的关系,以稀释的玉米淀粉生产废水为底物,考察了UASB启动期的运行特征,并采用实时荧光定量PCR技术（qPCR）分析了互营丙酸降解菌群（丙酸氧化菌和产甲烷菌）的演替规律.结果表明,在进水COD 2000mg/L和水力停留时间（HRT）24h条件下,经过38d的连续运行,COD去除率达到了91.9%.当HRT分阶段缩短至8h时,比产甲烷速率达到了315LCH₄/（kg COD·d）,且形成了沉降性能良好的颗粒污泥.qPCR检测结果表明,至少有5种已鉴定的丙酸氧化菌存在于UASB反应器中.Pelotomaculum propionicum为接种污泥中的主要丙酸氧化菌,约占检测到丙酸氧化菌总数的45.7%.它的数量随着HRT缩短不断减少.而Syntrophobacter sulfatireducens和S.wolinii的数量随着HRT缩短不断增加,并在启动完成时达到最大值,分别为1.3×10³,5.5×10³个16S rRNA基因拷贝数/ng DNA,演替成为成熟颗粒污泥中的优势丙酸氧化菌群.Methanobacterium和Methanosarcina为接种污泥中的主要氢营养型产甲烷菌和乙酸营养型产甲烷菌,其数量随着HRT的缩短而逐渐减少,而Methanospirillum和Methanosaeta的数量随HRT的缩短逐渐增加,成为成熟颗粒污泥中的优势产甲烷菌群.     

火焰原子吸收分光光度法测定鱼内脏及河流底泥中的铜

采用火焰原子吸收分光光度法测定鱼内脏及河流底泥中的铜。鱼内脏经组织捣碎机捣成匀浆后，加硝酸消解；底泥则经氢氟酸和高氯酸消化。该方法具有灵敏度高，精密度和回收率较好等特点。     

Metal Pollution Assessment of Sediment and Water in the River Hindon, India

The metal pollution in water and sediment of the River Hindon in western Uttar Pradesh (India) was assessed for Cd, Cr, Cu, Fe, Mn, Ni, Pb and Zn. The metal concentrations in water showed wide temporal variation compared with bed sediment because of variability in water discharge and variations in suspended solid loadings. Metal concentrations in bed sediments provided a better evaluation of the degree and the extent of contamination in the aquatic environment, Santagarh and Atali being the most polluted sites of the river. The ratio of heavy metals to conservative elements (Fe, Al, etc.) may reveal the geochemical imbalances due to the elevated metal concentrations normally attributed to anthropogenic sources. Metal/Al ratios for the bed sediments of the river Hindon were used to determine the relative mobility and general trend of relative mobility occurred Fe > Mn > Zn > Cr > Ni > Pb > Cu > Cd.     

高浓度印染废水处理工程工艺条件与实例分析

研究以三相生物流化床作为工程化反应器处理印染废水的工程工艺条件及操作特性，分别测定流化床内的气相含率，兴体循环速度及体积氧传质系数。     

Improvement of the antifouling characteristics in a bioreactor of polypropylene microporous membrane by the adsorption of Tween 20

Surface modification by physical adsorption of Tween 20 was accomplished on polypropylene microporous membranes (PPMMs). Attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR) and scanning electron microscope (SEM) were used to characterize the chemical and morphological changes on the membrane surfaces. Water contact angles and relative pure water fluxes were measured. The data showed that the hydrophilic performance for the modified membranes increased with the increase in the adsorption amount of Tween 20 onto the surface or into the pores of polypropylene microporous membranes. To test the antifouling property of the membranes by the adsorption of Tween 20 in a membrane bioreactor (MBR), filtration for active sludge was performed using synthetic wastewater. With the help of the data of water fluxes and the FE-SEM photos of the modified PPMMs before or after operating in a MBR for about 12 d, the PPMMs with monolayer adsorption of Tween 20 showed higher remained flux and stronger antifouling ability than unmodified membrane and other modification membranes studied.     

Mechanics Principle and Engineering Application of Split Layer and Bed Separation of Mining Overburden

<正>To control land surface subsidence caused the underground mineral exploitation and the catastrophic phenomena such as serious damage of buildings, waterbodies, cultivated lands, railways, bridges caused by land subsidence, bed separation grouting technology of overburden is put forward. To provide theoretical support for the technology, the characteristics and the mechanics mechanism of mining overburden from layer-split to formation of bed separation are studied. On the basis of elastic sheet board theory, calculation formula of rock sheet deflection is presented, and the mechanics criteria of the separation formation and the calculation formula of bed separation volume are set up. Finally, the applications and technics of bed separation grout technology of mining overburden to control land subsidence in china are introduced.