高烈度地震区隧道软硬围岩交接段刚柔并济抗减震技术研究*

为提高高烈度地震区隧道抗震性能，以某铁路隧道为研究背景，分析3种抗减震措施下隧道不同监测点隧道拱顶沉降、边墙收敛、衬砌结构PGA及最小安全系数，通过对比分析得到最优抗减震措施。结果表明:相比于工况1，工况2隧道拱顶沉降减小10.54%~81.10%，边墙收敛减小13.92%~78.77%，衬砌结构PGA减小31.42%~72.02%，最小安全系数增加18.04%~66.13%；相比于工况1，工况3结构拱顶沉降减小3.04%~18.02%，边墙收敛减小4.70%~32.00%，PGA增加13.95%~27.48%，最小安全系数增加7.49%~30.99%；工况4即“减震层+SFRC衬砌”刚柔并济法，相比于工况1，隧道拱顶沉降减小18.46%~83.98%，结构边墙收敛减小17.54%~85.47%，PGA减小30.00%~69.98%，最小安全系数增加47.95%~83.56%；4种工况抗减震性能由高到低依次为:工况4＞工况2＞工况3＞工况1。研究结果可为隧道软硬围岩交接段抗震设防提供理论参考。     

Enhancing the adsorption function of biochar by mechanochemical graphitization for organic pollutant removal

• Mechanochemical treatment reduced the calcination temperature for biochar synthesis. • Biochar is converted to graphite after mechanochemical treatment. • Biochar was reduced to nanoscale after mechanochemical treatment. Biochar (BC) has been extensively studied as adsorbent for the treatment of water pollution. Despite the distinct advantages, the high calcination temperature and low adsorption capacity of pristine BC limit its practical applications. Most of the former studies focused on the structure and/or surface modification to improve the adsorption capacity of BC. However, the harsh experiment conditions involved in the biochar modification limited the application in industrial level. Herein, we introduced mechanical treatment into BC preparation to reduce the calcination temperature and improve the adsorption capacity simultaneously. The results indicated that the calcination temperature was reduced and the adsorption capacity of the treated BC was improved after mechanochemical treatment. Characterization of the samples disclosed that BCs were graphitized with the particle size reduced to nanoscale after treatment. Adsorption tests indicated that the mechanochemically treated BCs showed much better removal performance of organic contaminants than that of pristine BCs. For instance, among four pristine BCs (BC600, BC700, BC800, and BC900), only BC900 has strong adsorption capacity for MB, while BC600 has low adsorption capacity (1.2 mg/g). By comparison, the adsorption capacity of MB increased greatly to 173.96 mg/g by BC600-500/1 (treated at 500 r/min for 1 hour). To optimize the mechanochemical treatment, the effects of rotation speed and agitation duration were also investigated.     

钙钛矿型催化剂催化湿式氧化处理煤气化废水纳滤浓缩液

采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3，并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD，SEM，FTIR技术对催化剂进行了表征。表征结果显示：制备的催化剂均具有标准的钙钛矿型结构，其中，LaFe0.9Mn0.1O3的结构稳定，比表面积大。实验结果表明：制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高，且稳定性好，连续使用5次后催化活性未见明显减弱；在H2O2投加量3.0 g/L、n（H2O2）∶n（LaFe0.9Mn0.1O3）=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下，COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%，BOD5/COD由0.02提升至0.40，可生化性大幅提高。     

高含盐废水脱盐处理技术研究进展

综述了几种常见的高含盐废水脱盐处理技术的发展历程、工艺原理、优缺点及目前的研究进展，分析了热分离、膜分离、电渗析、离子交换、电吸附、微生物脱盐等方法的优缺点，展望了未来废水脱盐工艺的发展方向。指出：脱盐方法将根据各类水体的水质特点更加精细化；多种脱盐技术联合应用也是今后废水脱盐的发展方向。     

臭氧氧化—湿式钙法吸收工艺对烟气的同时脱硫脱硝

采用臭氧氧化—湿式钙法吸收工艺对模拟烟气进行同时脱硫脱硝处理。O₃于150 ℃下具有较高的热稳定性,可将NO氧化为高价态氮氧化物,且NO氧化率随n（O₃）∶n（NO）的增大而逐渐提高。烟气中SO₂和H₂O的存在对NO氧化率的影响不大。O₃对SO₂的氧化率较低,约为5%。3%（w）石灰石浆液对SO₂的吸收率接近100%,NO_x吸收率随n（O₃）∶n（NO）的增大而逐渐提高,当n（O₃）∶n（NO）为1.6时NO_x吸收率可达约65%。SO₂能促进吸收液对NO_x的脱除。石灰石浆液中加入0.2%（w）的（NH₄）₂SO₃或Na₂SO₃后NO_x吸收率可达约85%或82%,且吸收率随添加剂加入量的增加而提高,添加（NH₄）₂SO₃的NO_x吸收率略高于添加Na₂SO₃。     

SMBBR-AF-SMBBR组合工艺处理高氨氮农药废水

采用特异性移动床生物膜反应器(SMBBR)和厌氧生物滤池(AF)组合工艺处理高氨氮农药废水。考察了HRT、pH和DO等工艺条件对SMBBR-AF-SMBBR组合工艺运行稳定期COD和氨氮去除率的影响。试验结果表明,在进水COD为2 408~7 440 mg/L、ρ(NH_4~+-N)为160.21~433.84 mg/L、TN为208.27~537.65 mg/L、HRT为8d、pH为8.0、DO为4 mg/L的条件下,处理后出水平均COD为342 mg/L,COD去除率达92.3%;ρ(NH_4~+-N)小于4.0mg/L,氨氮平均去除率为89.2%;TN小于50 mg/L,平均TN去除达83.0%。出水各指标均优于原A2O工艺出水。     

微波强化CWPO工艺CuO_x-CeO_2/GAC催化剂的制备及其对二甲亚砜的降解

以颗粒活性炭(GAC)为载体、铜为活性组分、铈为助剂组分、草酸钠为沉淀剂,采用浸渍焙烧法制得CuO_x-CeO_2/GAC催化剂。以H_2O_2为氧化剂,微波强化催化湿式过氧化氢氧化(CWPO)处理二甲亚砜(DMSO)初始质量浓度为1 000 mg/L的废水,处理3 min后DMSO去除率达93.8%。催化剂第7次使用时DMSO去除率仍保持在75%以上。初始废水pH在3~9范围内,DMSO去除率均在85%以上。助剂Ce的加入提高了催化剂表面活性组分的分散性和稳定性,使催化剂的活性稳定性和使用寿命显著提高。     

Effects of EGR on performance and emissions of a diesel engine fuelled with balanites aegyptiaca/diesel blends

In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NO_x emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NO_x and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate.     

活性炭吸附和两级Fenton氧化组合工艺处理高盐对氨基苯酚生产废水

采用活性炭吸附和两级Fenton氧化组合工艺对高盐度对氨基苯酚生产废水进行了处理实验研究。结果表明,p H值对活性炭去除有机物的影响较小。当活性炭投加量为4 g/L时,TOC去除率61%。分级加药可以有效提高Fenton氧化对有机物的去除效率。在温度为25℃、p H为3、30%H2O2投加量为3%(V/V)、Fe2+/H2O2摩尔比为0.05时,两级Fenton氧化处理后,出水TOC降至150 mg/L以下。此外,Fenton氧化后形成氢氧化铁污泥颗粒粒径为4.5μm,经过聚丙烯酰胺(PAM)絮凝之后,污泥的粒径明显增加,过滤特性改善。PAM絮凝效果依赖于溶液的p H值,当p H超过10后会失去作用,故在使用过程中需要严格控制溶液的p H值。     

新制备生物炭的特性表征及其对石油烃污染土壤的吸附效果

生物炭作为一种绿色环保的功能材料因其在污水处理和污染土壤修复方面具有显著效果而受到极大关注.采用红外光谱、元素分析仪及微孔分析对不同温度(200、300、400、500和600℃)条件下制备的木屑和麦秆生物炭进行特性表征,并采用制备的生物炭净化石油污染土壤,分别考察了污染物性质、生物质原料和热解温度对其净化效果的影响.结果表明,随着热解温度的增高,生物炭芳香化程度增加,极性降低,微孔结构逐渐发育,表面积增大.加入生物炭33 d后,污染土壤中总石油烃及其组分烷烃的浓度比对照略有降低,而PAHs浓度下降显著.随着热解温度升高,2种生物炭对PAHs的吸附强度均逐渐增大,芳香度增高、表面积增大是强吸附的主要原因.2种生物炭在400℃及以下温度制备时对PAHs的吸附强度为:木屑生物炭＞麦秆生物炭;而400℃以上温度制备的生物炭吸附强度则相反,即麦秆生物炭＞木屑生物炭,说明生物炭原料对其吸附强度也具有显著影响.