Hydrochemistry of drinking water sources and water purifiers in relation to epidemiological study in Hisar,North-West India

The concern related to the drinking of reverse osmosis (RO) water containing low levels of minerals is growing day by day. This study involves the analysis of water samples from various drinking water sources in a rural site, Mirchpur village, an Indus Valley civilization site (grid location: 29° 18′ 42.3″ N, 76° 10′ 33.0″ E) of Hisar, India, along with the health survey of human subjects. The hydrochemistry of water collected from hand pumps, river canals, tube wells, submersibles, and the RO systems installed in various homes was explored for pH, EC, TH, TDS, turbidity, cations (Na⁺, Ca²⁺, Mg²⁺), anions (CO₃²⁻, HCO₃⁻, Cl⁻, SO₄²⁻, NO₃⁻, F⁻), and elements (Fe, Pb, Se) employing the ion chromatography, flame photometry, and ICP-AES techniques. Lead (Pb) and Selenium (Se) were detected in trace amounts (0.30–2.6 μg L⁻¹; 0.10–4.1 μg L⁻¹, respectively) in all the samples, including the samples collected from RO purifiers, but Iron (Fe) was not detected in RO samples even in trace amounts. The F-levels in hand pump water (HPW) and submersible water (SW) (1.9  and 1.7 mg L⁻¹, respectively) and TDS levels in SW (3048 mg L⁻¹) were found to be above WHO and BIS safe limits. TDS levels in the river canal (900 mg L⁻¹), tube well (1104 mg L⁻¹), hand pump (1170 mg L⁻¹), and submersible samples (3048 mg L⁻¹) were found significantly higher as compared to the RO personal water (ROPW; 216 mg L⁻¹) and RO supply water (ROSW; 90 mg L⁻¹). The collected epidemiological data reveals that 21%, 19%, 13%, and 12% of natives reported skin, kidney, hair fall, liver, and stomach issues, respectively, suspecting the crucial role of high TDS and fluoride levels in the area. This study also provides a comparison between the quality of RO and the direct supply water, along with correlation matrices for different parameters, which gives a rationale for the limitations of drinking direct supply water without any purification and RO water containing low mineral content.     

水中总氮测定方法存在问题的研究及改进

碱性过硫酸钾消解紫外分光光度法测定水中总氮采用的消解器皿是玻璃比色管,易造成空白偏高、结果偏低等问题。采用双圆柱状的消解杯对水样进行消解。结果表明,消解杯消解水中总氮,线性相关系数均大于0.999,检出限为0.05 mg/L,相对标准偏差小于5%,相对误差为0.88%~1.00%;改进后的消解器皿具有较好的精密度和准确度,能够更加准确测定水中总氮的含量。     

淮河支流污染物综合降解系数动态测算

确定河流污染物综合降解系数动态变化规律对提高水环境容量测算精度和水环境管理具有重要意义。通过现场模拟法,采用一维稳态模型测算了淮河支流洪河五沟营-塔桥乡河段COD、氨氮和总磷在枯水期、平水期和丰水期的综合降解系数,COD、氨氮和总磷降解系数在各水期的关系为枯水期平水期丰水期,提出了建议值并利用实测浓度对计算结果进行了检验,结果表明,不同水期综合降解系数吻合情况较好。     

Environmental forensic investigation of the air pollution from a cement manufacturing unit

Abstract

Cement manufacturing is a process that results in the emission of significant quantities of suspended particulate matter (SPM) to the ambient air. An environmental forensic investigation was carried out in the surroundings of a major cement manufacturing unit at a place called Coimbatore in the southern Indian state of Tamil Nadu. The investigation was carried out to identify the contribution of the cement manufacturing unit to the SPM concentration of the surrounding air environment. The sampling points’ selection and sample collection were done following the principles outlined in the INTERPOL Manual for Pollution Crime Forensic Investigation. On-site monitoring of the air samples was carried out using Mini Laser Aerosol Spectrometer (GRIMM, Mini-LAS Model 11R). The instrument was capable of measuring particles ranging from 0.25 to 32 µm and classifying them into 31 size channels. The test results at majority of the monitoring locations were well above the limits specified in the National Ambient Air Quality Standards of India. Microscopic studies of the dust samples were carried out for surface texture and particle shape. The spatial distribution of particles was analysed using geographic information system (GIS) for the visual identification of the extent of the pollution by keeping the cement factory as the focal point. The results from the GIS and microscopic analysis established the role of the cement factory in the particulate matter pollution of its surroundings, specifically in the areas North-West of the factory. The successfully adopted procedure can serve as a guideline for the environmental forensic investigation of similar pollution incidences.     

基于3S技术对太湖底质及水质总磷的研究

应用3S技术研究了太湖底质与水质总磷(TP)的分布情况,并结合水华频次分析了其相关性。结果表明:2016—2018年,太湖底质TP年均值在433~537 mg/kg波动,水质TP年均值从0.064 mg/L上升至0.087 mg/L。从空间分布来看,底质TP、水质TP和水华频次均呈现“西高东低”的规律,太湖西部区尤其是竺山湖区是需要开展治理的重点区域。3年间,太湖西部区水质TP上升,而底质TP与入湖河流TP下降,说明内源磷污染是太湖西部区水质TP升高的主要原因,须加强科学清淤。     

A/DAT-IAT生物膜法处理高含盐废水

以含盐量为60 000mg/L(以NaCl计)的模拟工业废水为研究对象,利用A/DAT-IAT生物膜反应器,研究A/DAT-IAT工艺对投加悬浮填料后高含盐废水的处理,并以CODCr、NH4 -N、PO43--P等作为指标评价处理效果.试验结果表明,在总水力停留时间(HRT)为13 h、pH=7,5、25℃条件下,进水ρ(CODCr)、ρ(NH4 -N)和ρ(PO43--P)分别为907.4～1 210.0 mg/L、86.2～99.7 mg/L和3.6～5.1 mg/L.CODCr、NH4 -N和PO43--P的平均去除率分别为73.9%、38.6%和93.5%,平均出水SS为198 mg/L,其中CODCr和PO43--P的去除效果较好.研究表明,A/DAT-IAT生物膜法较其他活性污泥法有了较大的提高.     

北京市PM5.0可吸入颗粒物反演及其时空分布分析

分析城市可吸入颗粒物的空间特征及影响因素对于制定更为有效的可吸入颗粒物污染控制政策具有重要的现实意义.本研究在实际采样和遥感数据处理基础上,构造差值植被指数(DVI),通过建立TM影像与对应PM5.0颗粒物实测值之间的相关关系模型,对北京市2008~2010年3 a的PM5.0的分布进行了反演计算和精度分析;研究了NDBI和NDMI对PM5.0浓度的影响,进一步揭示了北京五环区域范围内可吸入颗粒物的时空分布特征.结果表明,采用DVI反演PM5.0分布的方法可行,反演精度在可接受范围内;整体上研究区2008年PM5.0颗粒物污染最轻,西南三环和四环以及东南三四环之间为颗粒物污染的高值区,西北五环附近颗粒物污染较轻;NDBI(归一化建筑指数)、NDMI(归一化水汽指数)与PM5.0可吸入颗粒物的分布分别呈现显著的负相关和正相关关系,且二者对PM5.0的影响相近.     

都匀毛尖茶土壤中总磷含量的调查研究

目的:调查都匀毛尖茶土壤中总磷的含量;方法:以贵州省都匀市毛尖茶产地--螺丝壳山的土壤为研究对象,采用酸法消解,用钼酸铵分光光度法于700 nm波长处测定土壤中总磷含量;结果:都匀螺丝壳山中土壤中总磷含量在177.58 mg·kg-1~353.92 mg·kg-1之间;结论:都匀毛尖茶土壤中的总磷含量在全国基本水平范围以内,总磷含量与土壤的类型、土壤所处海拔高度无明显关系。     

Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines

This study investigated the filtration and continuous regeneration of a particulate filter system on an engine test bench, consisting of a diesel oxidation catalyst（DOC） and a catalyzed diesel particulate filter（CDPF）. Both the DOC and the CDPF led to a high conversion of NO to NO2 for continuous regeneration. The filtration efficiency on solid particle number（SPN） was close to100%. The post-CDPF particles were mainly in accumulation mode. The downstream SPN was sensitively influenced by the variation of the soot loading. This phenomenon provides a method for determining the balance point temperature by measuring the trend of SPN concentration.     

Evaluation of accuracy of linear regression models in predicting urban stormwater discharge characteristics

Stormwater runoff has been identified as a source of pollution for the environment, especially for receiving waters. In order to quantify and manage the impacts of stormwater runoff on the environment, predictive models and mathematical models have been developed. Predictive tools such as regression models have been widely used to predict stormwater discharge characteristics. Storm event characteristics, such as antecedent dry days （ADD）, have been related to response variables, such as pollutant loads and concentrations. However it has been a controversial issue among many studies to consider ADD as an important variable in predicting stormwater discharge characteristics. In this study, we examined the accuracy of general linear regression models in predicting discharge characteristics of roadway runoff. A total of 17 storm events were monitored in two highway segments, located in Gwangju, Korea. Data from the monitoring were used to calibrate United States Environmental Protection Agency＇s Storm Water Management Model （SWMM）. The calibrated SWMM was simulated for 55 storm events, and the results of total suspended solid （TSS） discharge loads and event mean concentrations （EMC） were extracted. From these data, linear regression models were developed. R2 and p-values of the regression of ADD for both TSS loads and EMCs were investigated. Results showed that pollutant loads were better predicted than pollutant EMC in the multiple regression models. Regression may not provide the true effect of site-specific characteristics, due to uncertainty in the data.