钙钛矿型催化剂催化湿式氧化处理煤气化废水纳滤浓缩液

采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3，并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD，SEM，FTIR技术对催化剂进行了表征。表征结果显示：制备的催化剂均具有标准的钙钛矿型结构，其中，LaFe0.9Mn0.1O3的结构稳定，比表面积大。实验结果表明：制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高，且稳定性好，连续使用5次后催化活性未见明显减弱；在H2O2投加量3.0 g/L、n（H2O2）∶n（LaFe0.9Mn0.1O3）=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下，COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%，BOD5/COD由0.02提升至0.40，可生化性大幅提高。     

Subcritical water oxidation of propham by H2O2 using response surface methodology (RSM)

This study was conducted to investigate the degradation of propham, which is a compound that pollutes water and seriously threatens human health, by subcritical water oxidation and using H₂O₂ as an oxidising agent. The maximum total organic carbon removal rate of propham was obtained as 73.65% at 40 min of treatment time and 60 mM of H₂O₂ concentration and 373 K of temperature. In addition, response surface method based on the Box-Behnken design was applied to design the degradation experiments of propham for determination of the combined effects of process variables, namely temperature, concentration of oxidising agent and treatment time. The proposed quadratic model of propham degradation, which was examined with the analysis of variance, was used for navigating the design space. The R² and adjusted R² values of the model were determined as 0.9921 and 0.9819 respectively. It was shown that propham was effectively degraded, thus could be removed from the water by using an environmentally friendly method.     

臭氧氧化—湿式钙法吸收工艺对烟气的同时脱硫脱硝

采用臭氧氧化—湿式钙法吸收工艺对模拟烟气进行同时脱硫脱硝处理。O₃于150 ℃下具有较高的热稳定性,可将NO氧化为高价态氮氧化物,且NO氧化率随n（O₃）∶n（NO）的增大而逐渐提高。烟气中SO₂和H₂O的存在对NO氧化率的影响不大。O₃对SO₂的氧化率较低,约为5%。3%（w）石灰石浆液对SO₂的吸收率接近100%,NO_x吸收率随n（O₃）∶n（NO）的增大而逐渐提高,当n（O₃）∶n（NO）为1.6时NO_x吸收率可达约65%。SO₂能促进吸收液对NO_x的脱除。石灰石浆液中加入0.2%（w）的（NH₄）₂SO₃或Na₂SO₃后NO_x吸收率可达约85%或82%,且吸收率随添加剂加入量的增加而提高,添加（NH₄）₂SO₃的NO_x吸收率略高于添加Na₂SO₃。     

微波强化CWPO工艺CuO_x-CeO_2/GAC催化剂的制备及其对二甲亚砜的降解

以颗粒活性炭(GAC)为载体、铜为活性组分、铈为助剂组分、草酸钠为沉淀剂,采用浸渍焙烧法制得CuO_x-CeO_2/GAC催化剂。以H_2O_2为氧化剂,微波强化催化湿式过氧化氢氧化(CWPO)处理二甲亚砜(DMSO)初始质量浓度为1 000 mg/L的废水,处理3 min后DMSO去除率达93.8%。催化剂第7次使用时DMSO去除率仍保持在75%以上。初始废水pH在3~9范围内,DMSO去除率均在85%以上。助剂Ce的加入提高了催化剂表面活性组分的分散性和稳定性,使催化剂的活性稳定性和使用寿命显著提高。     

固定化斜生栅藻净化畜禽废水中氨氮和磷的影响因素

为探讨Cu2+、p H和流速对固定化斜生栅藻去除畜禽废水中NH+4-N、TP效果的影响,在实验室条件下模拟实际污水处理过程,并采用正交实验方案对结果进行分析。结果表明低质量浓度Cu2+(0~0.05 mg/L)改善藻的净化效果,高质量浓度Cu2+(0.50~5.00 mg/L)抑制藻的净化效果;在p H较高的条件下(p H=9),固定化斜生栅藻的净化效果明显提高;流速对结果没有明显影响。通过正交实验,得出固定化斜生栅藻去除畜禽废水中NH+4-N、TP的优化条件如下:Cu2+质量浓度为0.05 mg/L,p H为9,流速为0.3 m/s。此时NH+4-N去除率为96.11%,TP去除率为97.53%。     

声凝并联合雾化预处理及其在过滤除尘中的应用

根据声凝并理论和雾化湿式除尘理论,建立了燃煤飞灰在声场联合雾化加湿作为预处理的过滤式除尘实验装置。分别在声场、雾化加湿、声场与雾化加湿相结合3种预处理条件下进行实验,确定合适的加湿量范围,得出不同条件下燃煤飞灰的去除效果。在声场联合雾化加湿条件下,分别研究了声压级和雾化加湿量对飞灰的去除率的影响。结果表明,声场和雾化加湿联合作用能有效提高燃煤PM2.5去除率。以声场联合雾化加湿作为预处理进行过滤除尘实验,结果表明,虽然对高效滤料的除尘效率提高作用有限,但是该预处理可减轻滤袋负荷,有效延缓压差增长,降低清灰频率。由于采用表面覆膜滤材,加湿量控制得当可避免产生"糊袋"现象。     

水华束丝藻与铜绿微囊藻净化水体氮磷及其脂质积累过程比较

选取水华束丝藻与铜绿微囊藻作为典型水华蓝藻,探索水华蓝藻净化水体及合成生物柴油的潜力.采用氮磷浓度为NH4-N 7.5 mg/L,PO43--P 1.0 mg/L的模拟污水,重点考察了在光照强度与温度不同的条件下2种微藻对氮磷的去除率,并利用尼罗红荧光染色法测定了微藻中的中性脂含量.结果表明,2种藻对PO43--P的去除率均较高,最高达到98％,对NH4+-N的去除率稍低,最高为52％.水华束丝藻及铜绿微囊藻均具有较强积累中性脂的能力,适宜的温度与光照条件有利于微藻对氮磷的去除及细胞中脂类的积累.2种藻均在光照强度为12 000 lx时中性脂含量更高.水华束丝藻在温度为18 ～22℃条件下,生长更优,氮磷净化效果较好,中性脂积累能力更强.而铜绿微囊藻在温度为22～ 26℃时表现更好.     

某电厂600MW火电机组脱硫增容改造方案探讨

按照国家环保部文件要求，大唐集团河北某电厂600 MW机组湿法脱硫系统需进行增容改造。该电厂根据实际情况，归纳了3种可行的脱硫增容改造方案，即原吸收塔增加喷淋层和高度、双吸收塔串联、双吸收塔双循环，阐述了各自的技术特点，结合性能保证、工程投资、施工周期等影响因素，比较了各方案的优缺点。经过对比和论证，双吸收塔方案比单吸收塔方案更适合于本次工程改造。     

畜禽环境中抗生素的去除及其风险评估

抗生素作为饲料添加剂广泛应用于畜禽养殖业,造成养殖环境抗生素大量蓄积,尤其是在畜禽粪便中,长期的积累不仅污染养殖场内土壤环境,残留的抗生素还会随畜禽粪便进入周边水体及农田环境,威胁农作物及人体健康。目前,国内相关研究主要集中在抗生素的降解工艺及降解规律方面,而对其去除效率的影响因素及风险评价研究相对较少。笔者综述了国内外抗生素的降解转化及去除方式等的研究进展,并概述了抗生素在畜禽环境中的生态风险评估的研究现状,为抗生素的高效去除、风险预估及畜禽粪便资源化安全利用提供理论基础和技术支撑。     

In situ formation of bimetallic FeNi nanoparticles on sand through green technology: Application for tetracycline removal

• In situ preparation of FeNi nanoparticles on the sand via green synthesis approach. • Removal of tetracycline using GS-FeNi in batch and column study. • Both reductive degradation and sorption played crucial role the process. • Reusability of GS-FeNi showed about 77.39±4.3% removal on 4th cycle. • TC by-products after interaction showed less toxic as compared with TC. In this study, FeNi nanoparticles were green synthesized using Punica granatum (pomegranate) peel extract, and these nanoparticles were also formed in situ over quartz sand (GS-FeNi) for removal of tetracycline (TC). Under the optimized operating conditions, (GS-FeNi concentration: 1.5% w/v; concentration of TC: 20 mg/L; interaction period: 180 min), 99±0.2% TC removal was achieved in the batch reactor. The removal capacity was 181±1 mg/g. A detailed characterization of the sorbent and the solution before and after the interaction revealed that the removal mechanism(s) involved both the sorption and degradation of TC. The reusability of reactant was assessed for four cycles of operation, and 77±4% of TC removal was obtained in the cycle. To judge the environmental sustainability of the process, residual toxicity assay of the interacted TC solution was performed with indicator bacteria (Bacillus and Pseudomonas) and algae (Chlorella sp.), which confirmed a substantial decrease in the toxicity. The continuous column studies were undertaken in the packed bed reactors using GS-FeNi. Employing the optimized conditions, quite high removal efficiency (978±5 mg/g) was obtained in the columns. The application of GS-FeNi for antibiotic removal was further evaluated in lake water, tap water, and ground water spiked with TC, and the removal capacity achieved was found to be 781±5, 712±5, and 687±3 mg/g, respectively. This work can pave the way for treatment of antibiotics and other pollutants in the reactors using novel green composites prepared from fruit wastes.