Acrylamide in bread: a review on formation,health risk assessment,and determination by analytical techniques

Environmental Science and Pollution Research - Acrylamide is a water-soluble toxicant found in high-protein and carbohydrate-containing foods exposed to high temperature like bread as the staple...     

Concentration and characterization of airborne particles in Tehran’s subway system

Particulate matter is an important air pollutant, especially in closed environments like underground subway stations. In this study, a total of 13 elements were determined from PM₁₀ and PM_2.5 samples collected at two subway stations (Imam Khomeini and Sadeghiye) in Tehran’s subway system. Sampling was conducted in April to August 2011 to measure PM concentrations in platform and adjacent outdoor air of the stations. In the Imam Khomeini station, the average concentrations of PM₁₀ and PM_2.5 were 94.4?±?26.3 and 52.3?±?16.5 μg m^?3 in the platform and 81.8?±?22.2 and 35?±?17.6 μg m^?3 in the outdoor air, respectively. In the Sadeghiye station, mean concentrations of PM₁₀ and PM_2.5 were 87.6?±?23 and 41.3?±?20.4 μg m^?3 in the platform and 73.9?±?17.3 and 30?±?15 μg m^?3, in the outdoor air, respectively. The relative contribution of elemental components in each particle fraction were accounted for 43 % (PM₁₀) and 47.7 % (PM_2.5) in platform of Imam Khomeini station and 15.9 % (PM₁₀) and 18.5 % (PM_2.5) in the outdoor air of this station. Also, at the Sadeghiye station, each fraction accounted for 31.6 % (PM₁₀) and 39.8 % (PM_2.5) in platform and was 11.7 % (PM₁₀) and 14.3 % (PM_2.5) in the outdoor. At the Imam Khomeini station, Fe was the predominant element to represent 32.4 and 36 % of the total mass of PM₁₀ and PM_2.5 in the platform and 11.5 and 13.3 % in the outdoor, respectively. At the Sadeghiye station, this element represented 22.7 and 29.8 % of total mass of PM₁₀ and PM_2.5 in the platform and 8.7 and 10.5 % in the outdoor air, respectively. Other major crustal elements were 5.8 % (PM₁₀) and 5.3 % (PM_2.5) in the Imam Khomeini station platform and 2.3 and 2.4 % in the outdoor air, respectively. The proportion of other minor elements was significantly lower, actually less than 7 % in total samples, and V was the minor concentration in total mass of PM₁₀ and PM_2.5 in both platform stations.     

Partitioning and bioaccumulation of metals from oil sands process affected water in indigenous Parachlorella kessleri

This paper studies the partitioning and bioaccumulation of ten target metals (⁵³Cr, Mn, Co, ⁶⁰Ni, ⁶⁵Cu, ⁶⁶Zn, As, ⁸⁸Sr, ⁹⁵Mo and Ba) from oil sands tailings pond water (TPW) by indigenous Parachlorella kessleri. To determine the role of extracellular and intracellular bioaccumulation in metal removal by P. kessleri, TPW samples taken from two oil sands operators (Syncrude Canada Ltd. and Albian Sands Energy Inc.) were enriched with nutrient supplements.Results indicate that intracellular bioaccumulation played the main role in metal removal from TPW; whereas extracellular bioaccumulation was only observed to some extent for Mn, Co, ⁶⁰Ni, ⁶⁵Cu, ⁸⁸Sr, ⁹⁵Mo and Ba. The FTIR scan and titration of functional groups on the cell surface indicated low metal binding capacity by indigenous P. kessleri. However, it is believed that the dissolved cations and organic ligand content in TPW (such as naphthenic acids) may interfere with metal binding on the cell surface and lower extracellular bioaccumulation. In addition, the total bioaccumulation and bioconcentration factor (BCF) varied during the cultivation period in different growth regimes.     

Preparation and Characterization of Polyamide Thin Film Composite Nanofiltration Membrane Based on Polyurethane Nanofibrous Support

Journal of Polymers and the Environment - Polyurethane nanofibers recognized to perform as a sub-layer were employed herein as a medial-layer of high porosity in the fabrication of a novel class of...     

Survival and Inactivation by Advanced Oxidative Process of Foodborne Viruses in Model Low-Moisture Foods

Enteric viruses, such as human norovirus (NoV) and hepatitis A virus (HAV), are the major causes of foodborne illnesses worldwide. These viruses have low infectious dose, and may remain infectious for weeks in the environment and food. Limited information is available regarding viral survival and transmission in low-moisture foods (LMF). LMFs are generally considered as ready-to-eat products, which undergo no or minimal pathogen reduction steps. However, numerous foodborne viral outbreaks associated with LMFs have been reported in recent years. The objective of this study was to examine the survival of foodborne viruses in LMFs during 4-week storage at ambient temperature and to evaluate the efficacy of advanced oxidative process (AOP) treatment in the inactivation of these viruses. For this purpose, select LMFs such as pistachios, chocolate, and cereal were inoculated with HAV and the norovirus surrogates, murine norovirus (MNV) and feline calicivirus (FCV), then viral survival on these food matrices was measured over a four-week incubation at ambient temperature, by both plaque assay and droplet-digital RT-PCR (ddRT-PCR) using the modified ISO-15216 method as well as the magnetic bead assay for viral recovery. We observed an approximately 0.5 log reduction in viral genome copies, and 1 log reduction in viral infectivity for all three tested viruses following storage of select inoculated LMFs for 4 weeks. Therefore, the present study shows that the examined foodborne viruses can persist for a long time in LMFs. Next, we examined the inactivation efficacy of AOP treatment, which combines UV-C, ozone, and hydrogen peroxide vapor, and observed that while approximately 100% (4 log) inactivation can be achieved for FCV, and MNV in chocolate, the inactivation efficiency diminishes to approximately 90% (1 log) in pistachios and 70% (< 1 log) in cereal. AOP treatment could therefore be a good candidate for risk reduction of foodborne viruses from certain LMFs depending on the food matrix and surface of treatment.

     

Using Design-Expert to Optimize the Properties of a Polyethersulfone Ultrafiltration Membrane Through the Incorporation of NH2-MIL-53(Fe) and PVP for Maximum Cr(VI) Removal and Flux

Journal of Polymers and the Environment - In this study, an NH2-MIL-53(Fe) functionalized membrane was fabricated for Cr(VI) removal from contaminated groundwater. Design-Expert was employed to...     

Preparation and investigation of poly(methylmethacrylate) nano-capsules containing haloxyfop-R-methyl and their release behavior

Abstract

In this study, the preparation and characterization of haloxyfop-R-methyl herbicide loaded in poly(methylmethacrylate) (PMMA) nano-capsules by emulsion polymerization and its release behavior were investigated. The chemical characterizations of PMMA/haloxyfop-R-methyl nano-capsules were confirmed by FT-IR spectroscopy method, and the surface morphology was studied by field emission scanning electron microscopy and transmission electron microscopy. Also, the herbicide loading and encapsulation efficiency were analyzed for the herbicide-loaded nano-capsules. The release rate of PMMA/haloxyfop-R-methyl nano-capsules was determined by UV-visible spectroscopy. The thermal properties and thermal stability of nano-capsules were explored by the thermal gravimetric analysis method. The diameter of the nano-capsules was in the range of 100–300?nm. Increasing the amount of herbicide in nano-formulations significantly affected the surface of the nano-capsules and reduced their surface smoothness. Triton-X100 was identified as the best surfactant for the preparation of nano-capsules, and the sample containing the lowest herbicide content showed the best performance in terms of encapsulation and loading efficiency. This sample showed a steady-state release rate during the six days.     

Impact of the mixing boundary layer on the relationship between PM2.5 and aerosol optical thickness

The purpose of this paper is to study the relationship between columnar aerosol optical thickness and ground-level aerosol mass. A set of Sun photometer, elastic backscattering lidar and TEOM measurements were acquired during April 2007 in Lille, France. The PM2.5 in the mixed boundary layer is estimated using the lidar signal, aerosol optical thickness, or columnar integrated Sun photometer size distribution and compared to the ground-level station measurements. The lidar signal recorded in the lowest level (240 m) is well correlated to the PM2.5 (R² = 0.84). We also show that the correlation between AOT-derived and measured PM2.5 is significantly improved when considering the mixed boundary layer height derived from the lidar. The use of the Sun photometer aerosol fine fraction volume does not improve the correlation.     

Planetary Stewardship in an Urbanizing World: Beyond City Limits

Cities are rapidly increasing in importance as a major factor shaping the Earth system, and therefore, must take corresponding responsibility. With currently over half the world’s population, cities are supported by resources originating from primarily rural regions often located around the world far distant from the urban loci of use. The sustainability of a city can no longer be considered in isolation from the sustainability of human and natural resources it uses from proximal or distant regions, or the combined resource use and impacts of cities globally. The world’s multiple and complex environmental and social challenges require interconnected solutions and coordinated governance approaches to planetary stewardship. We suggest that a key component of planetary stewardship is a global system of cities that develop sustainable processes and policies in concert with its non-urban areas. The potential for cities to cooperate as a system and with rural connectivity could increase their capacity to effect change and foster stewardship at the planetary scale and also increase their resource security.     

Upper trapezius fatigue in carpet weaving: the impact of a repetitive task cycle

Introduction. Shoulder disorders are one of the most prevalent musculoskeletal disorders among carpet weavers. The most important cause of these disorders is muscle fatigue. The aim of the present study is to investigate the effect of carpet weaving characteristics on upper trapezius (UTr) muscle fatigue during a task cycle. Method. In this cross-sectional study, 9 women and 3 men participated. During an 80-min cycle of carpet weaving, a times-series model was applied to assess electromyography amplitude and frequency changes. Result. According to the joint analysis of electromyogram spectrum and amplitude method, the participants experienced 0% force decrease, 0.9% recovery, 18% force increase and 72% fatigue in the left UTr. Furthermore, the rates of force decrease, recovery, force increase and fatigue in the right UTr were 18%, 18%, 18% and 45%, respectively. Fatigue in the right and the left UTr was reported to be the dominant state during one carpet weaving task cycle. Conclusion. Task cycle appears to have a significant impact on UTr fatigue in participants, and UTr fatigue can be considered a serious risk factor in shoulder musculoskeletal disorders. Hence, further studies should focus on better workstations and work–rest periods during various subtasks.