Fungicidal values of bio-oils and their lignin-rich fractions obtained from wood/bark fast pyrolysis

Pine wood, pine bark, oak wood and oak bark were pyrolyzed in an auger reactor. A total of 16 bio-oils or pyrolytic oils were generated at different temperatures and residence times. Two additional pine bio-oils were produced at the National Renewable Energy Laboratory in a fluidized-bed reactor at different temperatures. All these bio-oils were fractionated to obtain lignin-rich fractions which consist mainly of phenols and neutrals. The pyrolytic lignin-rich fractions were obtained by liquid-liquid extraction. Whole bio-oils and their lignin-rich fractions were studied as potential environmentally benign wood preservatives to replace metal-based CCA and copper systems that have raised environmental concerns. Each bio-oil and several lignin-rich fractions were tested for antifungal properties. Soil block tests were conducted using one brown-rot fungus (Gloeophyllum trabeum) and one white-rot fungus (Trametes versicolor). The lignin-rich fractions showed greater fungal inhibition than whole bio-oils for a impregnation solution 10% concentration level. Water repellence tests were also performed to study wood wafer swelling behavior before and after bio-oil and lignin-rich fraction treatments. In this case, bio-oil fractions did not exhibit higher water repellency than whole bio-oils. Comparison of raw bio-oils in soil block tests, with unleached wafers, at 10% and 25% bio-oil impregnation solution concentration levels showed excellent wood preservation properties at the 25% level. The good performance of raw bio-oils at higher loading levels suggests that fractionation to generate lignin-rich fractions is unnecessary. At this more effective 25% loading level in general, the raw bio-oils performed similarly. Prevention of leaching is critically important for both raw bio-oils and their fractions to provide decay resistance. Initial tests of a polymerization chemical to prevent leaching showed some success.     

Comparison of Two Manual Methods of Nitrogen Dioxide Determination in Ambient Air

Sodium arsenite (modified Jacobs and Hochheiser method; hereafter referred as SA), the most widely used manual monitoring method for determination of nitrogen dioxide (NO₂) in ambient air, particularly in developing countries has been evaluated and compared with US EPA recommended equivalent method of TGS-ANSA (hereafter referred as ANSA). NO₂ concentrations generated from laboratory test atmosphere were analyzed by these two methods and were compared statistically. Laboratory evaluations showed that SA method has high sensitivity to different sampling conditions, which normally vary during actual field monitoring. Hence, correction factors for absorption efficiency were estimated for SA and ANSA methods. Absorption efficiency of NO₂ in SA method was found to be much lower (64%) as against the reported value of 82% at the method recommended sampling conditions, whereas for ANSA method, it was found 1.0 as against the reported value of 0.93. After applying derived correction factors, both the methods produced almost similar concentration values of NO₂.     

Biosequestration of lead using Bacillus strains isolated from seleniferous soils and sediments of Punjab

The present study was conducted to isolate and explore bacterial strains with a potential to sequester lead (Pb) and tolerate other heavy metals from industrial effluents and sediments. Out of the six bacterial strains isolated from seleniferous sites of Punjab, three isolates (RS-1, RS-2, and RS-3) were screened out for further growth-associated lead sequestration and molecular characterization on the basis of their tolerance toward lead and other heavy metals. Biomass and cell-free supernatant were analyzed for lead contents using ICP-MS after growth-associated lead sequestration studies in tryptone soya broth (pH?=?7.2?±?0.2) under aerobic conditions at 37 °C temperature. Almost 82 % and 70 % divalent lead was sequestered in cell pellets of RS-1 and RS-3, respectively while only 45 % of lead was found in cell pellet of RS-2 in the first 24 h. However, significant biosequestration of lead was observed in RS-2 after 48 h of incubation with concomitant increase in biomass. Simultaneously, morphological, biochemical, and physiological characterization of selected strains was carried out. 16S rRNA gene sequence of these isolates revealed their phylogenetic relationship with class Bacillaceae, a low G + C firmicutes showing 98 % homology with Bacillus sp.     

Insights into aqueous carbofuran removal by modified and non-modified rice husk biochars

Biochar has been considered as a potential sorbent for removal of frequently detected pesticides in water. In the present study, modified and non-modified rice husk biochars were used for aqueous carbofuran removal. Rice husk biochars were produced at 300, 500, and 700 °C in slow pyrolysis and further exposed to steam activation. Biochars were physicochemically characterized using proximate, ultimate, FTIR methods and used to examine equilibrium and dynamic adsorption of carbofuran. Increasing pyrolysis temperature led to a decrease of biochar yield and increase of porosity, surface area, and adsorption capacities which were further enhanced by steam activation. Carbofuran adsorption was pH-dependant, and the maximum (161 mg g^?1) occurred in the vicinity of pH 5, on steam-activated biochar produced at 700 °C. Freundlich model best fitted the sorption equilibrium data. Both chemisorption and physisorption interactions on heterogeneous adsorbent surface may involve in carbofuran adsorption. Langmuir kinetics could be applied to describe carbofuran adsorption in a fixed bed. A higher carbofuran volume was treated in a column bed by a steam-activated biochar versus non-activated biochars. Overall, steam-activated rice husk biochar can be highlighted as a promising low-cost sustainable material for aqueous carbofuran removal.     

Case study of landfill leachate recirculation using small-diameter vertical wells

A case study of landfill liquids addition using small diameter (5 cm) vertical wells is reported. More than 25,000 m³ of leachate was added via 134 vertical wells installed 3 m, 12 m, and 18 m deep over five years in a landfill in Florida, US. Liquids addition performance (flow rate per unit screen length per unit liquid head) ranged from 5.6 × 10^?8 to 3.6 × 10^?6 m³ s^?1 per m screen length per m liquid head. The estimated radial hydraulic conductivity ranged from 3.5 × 10^?6 to 4.2 × 10^?4 m s^?1. The extent of lateral moisture movement ranged from 8 to 10 m based on the responses of moisture sensors installed around vertical well clusters, and surface seeps were found to limit the achievable liquids addition rates, despite the use of concrete collars under a pressurized liquids addition scenario. The average moisture content before (51 samples) and after (272 samples) the recirculation experiments were 23% (wet weight basis) and 45% (wet weight basis), respectively, and biochemical methane potential measurements of excavated waste indicated significant (p < 0.025) decomposition.     

Developing an effectiveness index for biomedical waste management in Indian states using a composite indicators approach

Environmental Science and Pollution Research - The waste from healthcare facilities (HCFs) is most devastating as they induce health hazards and pollute the environment. The effective management of...     

Can adaptive modulation of traits to urban environments facilitate Ricinus communis L. invasiveness?

This paper addresses the phenotypic variation among Ricinus communis L. populations in four urban habitat types (road verges, garbage dumps, construction debris, and natural area) in Delhi, India, by evaluating important traits such as plant height, basal circumference, seeds per plant, seed size, seed weight, specific leaf area, and reproductive index. An important biochemical marker, proline, considered as a good plant performance indicator under stress was also quantified in leaves of R. communis to evaluate its response in different habitats. Interestingly, the species showed significant variation in plant height, specific leaf area, seed size, seed weight, and leaf proline content in different habitat types. Leaf proline content was positively related to plant height, specific leaf area, and seed size while negatively related to the total number of seeds/plant. Interestingly, reproductive index, calculated as a ratio of the total number of seeds to the plant height also showed a negative relation with leaf proline content. Results indicated that R. communis exhibits adaptive modulation of growth, reproductive traits, and leaf proline content in various urban habitats which contributes to invasiveness, range expansion, and establishment of the species. The study also gives evidence of how morphological and physiological traits could directly affect invasiveness of R. communis.     

Indoor–outdoor concentrations of RSPM in classroom of a naturally ventilated school building near an urban traffic roadway

A study on indoor–outdoor RSPM (PM₁₀, PM_2.5 and PM_1.0) mass concentration monitoring has been carried out at a classroom of a naturally ventilated school building located near an urban roadway in Delhi City. The monitoring has been planned for a year starting from August 2006 till August 2007, including weekdays (Monday, Wednesday and Friday) and weekends (Saturday and Sunday) from 8:0 a.m. to 2:0 p.m., in order to take into account hourly, daily, weekly, monthly and seasonal variations in pollutant concentrations. Meteorological parameters, including temperature, rH, pressure, wind speed and direction, and traffic parameters, including its type and volume has been monitored simultaneously to relate the concentrations of indoor–outdoor RSPM with them. Ventilation rate has also been estimated to find out its relation with indoor particulate concentrations. The results of the study indicates that RSPM concentrations in classroom exceeds the permissible limits during all monitoring hours of weekdays and weekends in all seasons that may cause potential health hazards to occupants, when exposed. I/O for all sizes of particulates are greater than 1, which implies that building envelop does not provide protection from outdoor pollutants. Further, a significant influence of meteorological parameters, ventilation rate and of traffic has been observed on I/O. Higher I/O for PM₁₀ is indicating the presence of its indoor sources in classroom and their indoor concentrations are strongly influenced by activities of occupants during weekdays.     

Post-irrigation impact of domestic sewage effluent on composition of soils,crops and ground water--a case study

Long-term irrigation with sewage water adds large amounts of carbon, major and micro- nutrients to the soil. We compared the spatial distribution of N, P, K and other micronutrients and toxic elements in the top 0.6 m of an alluvial soil along with their associated effects on the composition of crops and ground waters after about three decades of irrigation with domestic sewage effluent as a function of distance from the disposal point. Use of sewage for irrigation in various proportions improved the organic matter to 1.24-1.78% and fertility status of soils especially down to a distance of 1 km along the disposal channel. Build up in total N was up to 2908 kg ha(-1), available P (58 kg ha(-1)), total P (2115 kg ha(-1)), available K (305 kg ha(-1)) and total K (4712 kg ha(-1)) in surface 0.15 m soil. Vertical distribution of these parameters also varied, with most accumulations occurring in surface 0.3 m. Traces of NO3-N (up to 2.8 mg l(-1)), Pb (up to 0.35 mg l(-1)) and Mn (up to 0.23 mg l(-1)) could also be observed in well waters near the disposal point thus indicating initiation of ground water contamination. However, the contents of heavy metals in crops sampled from the area were below the permissible critical levels. Though the study confirms that the domestic sewage can effectively increase water resource for irrigation but there is a need for continuous monitoring of the concentrations of potentially toxic elements in soil, plants and ground water.