Legacy and alternative halogenated flame retardants in Lake Geneva fish

Environmental Science and Pollution Research - Legacy (i.e., polybrominated diphenyl ethers (PBDEs) and hexabromocyclododecane (HBCDD)) and alternative halogenated flame retardants (HFRs) were...     

One-Component Spray Polyurethane Foam from Liquefied Pinewood Polyols: Pursuing Eco-Friendly Materials

The use of petroleum-derived products should be avoided regarding the principles of green and sustainable chemistry. The work reported herein, is aimed at the liquefaction of pine shavings for the production of an environmentally-friendly polyol suitable to be used in the formulations of sprayable polyurethane foams. The biopolyols were obtained in high yield and were used to replace those derived from fossil sources, to produce more “greener” polyurethane foams and therefore, less dependent on petroleum sources, since the polyol component was substituted by products resulting from biomass liquefaction. The partial and fully exchange of the polyols was accomplished, and the results compared with a reference foam. The foams were afterward, chemical, physical, morphological, and mechanically characterized. The complete replacement of polyether polyol and polyol polyester has presented some similar characteristics as that used as a reference, validating that the path chosen for the development of more sustainable materials is on the right track for the contribution to a cleaner world.     

Analysis and residue levels of forchlorfenuron (CPPU) in watermelons

This paper describes the application of liquid chromatography-tandem mass spectrometry (LC/MS-MS) for analysis of residues of forchlorfenuron (CPPU), a new plant growth regulator, in watermelons, after a sample preparation step based on the buffered Quick, Easy, Cheap, Effective, Rugged and Safe extraction method. Analytical determinations were carried out in a triple quadrupole system fitted with an electrospray interphase operating in the positive ionisation mode (ESI+). Three simultaneous MS-MS transitions of the quasi-molecular ion m/z 248 (precursor ion) were monitored for data acquisition (248 > 129, 248 > 155, and 248 > 248), using the transition 248 > 129 for quantitation. Recovery studies on watermelons at levels of 1-200 microg/kg, performing five replicates at each level and using bracketing single-level calibration with matrix-matched standards for quantitation, gave forchlorfenuron mean recoveries ranging from 82 to 106% with relative standard deviations (RSD) lower than 18%. The limit of determination was established at 1 microg/kg. The method was applied to evaluate the persistence of forchlorfenuron residues in watermelons grown in plastic greenhouses, after applying an individual spray treatment to the flower ovary at the anthesis stage (45 mu g/flower and 60 mu g/flower for cv "Extazy" and cv "reina de corazones" watermelons, respectively). One month after treatment, 20 "Extazy" watermelon units (1.5-2 kg/unit) and 20 "Reina de corazones" watermelon units (4-5 kg/unit) were collected and analyzed individually. None of the samples contained forchlorfenuron residues higher than 1 microg/kg.     

Relationships between anaerobic consortia and removal efficiencies in an UASB reactor degrading 2,4 dichlorophenol (DCP)

To gain more insight into the interactions between anaerobic bacteria and reactor performances (chemical oxygen demand-COD, 2,4 dichlorophenol-2,4 DCP removals, volatile fatty acid-VFA, and methane gas productions) and how they depended on operational conditions the microbial variations in the anaerobic granular sludge from an upflow anaerobic sludge blanket (UASB) reactor treating 2,4 DCP was studied. The study was composed of two parts. In the first part, the numbers of methanogens and acedogens in the anaerobic granular sludge were counted at different COD removal efficiencies. The relationships between the numbers of methanogens, the methane gas production and VFA production were investigated. The COD removal efficiencies increased to 74% from 30% while the number of total acedogens decreased to 10 from 30 cfu ml(-1). The number of total methanogens and acedogens varied between 11 x 10(3) and 10 x 10(9)MPN g(-1) and 10 and 30 cfu ml(-1) as the 2,4 DCP removal efficiencies were obtained between 60% and 99%, respectively. It was seen that, as the number of total acedogens decreased, the COD removal efficiencies increased. However, the number of total methanogens increased as the COD removal efficiencies increased. Correlations between the bacterial number and with the removal efficiencies obtained in different operational conditions were investigated. From the results presented in this paper a high correlation between the number of bacteria, COD removals, methane gas percentage, 2,4 DCP removals and VFA was observed. In the second part, methanogen bacteria in the anaerobic granular sludge were identified. Microbial observations and biochemical tests were applied to identify the anaerobic microorganisms from the anaerobic granular sludge. In the reactor treating 2,4 DCP, Methanobacterium bryantii, Methanobacterium formicicum, Methanobrevibacter smithii, Methanococcus voltae, Methanosarcina mazei, Methanosarcina acetivorans, Methanogenium bourgense and Methanospirillum hungatei were identified.     

Accumulation of metals in the soil of an overland flow wastewater treatment system

Accumulation of Co, Cu, Cr, Mo, Ni, Pb and Zn was evaluated in a soil profile of an overland flow system used for the post-treatment of urban wastewater. A pilot version of the overland flow system received urban wastewater from five up-flow anaerobic filters filled with bamboo (Bambusa tuldoides) rings. The anaerobic effluent was applied as feed over 18 months at rates varying from 7 to 28 L min(-1), to a vegetated slope length covered with Tifton 85 (Cynodon) sp. grass. Soil and plant samples were collected in triplicate from the top to the bottom of the slope. In addition, the soils were sampled at the depths 0-20 and 20-40 cm. The metal concentrations found in the overall system were compared to those obtained in a control area located at the beginning of the slope onto which nothing was applied. A month of monitoring the urban wastewater of Limeira City (S?o Paulo State, Brazil) showed a drastic change in metals concentration due to the irregular discharge of industrial waste. This irregular discharge introduces Cr, Cu, Ni, Pb and Zn into the system used to treat domestic wastewater. The mass balance indicates the accumulation of metals in the soil and the translocation to the plants; also that they could be evapotranspirated, percolated and discharged.     

Sampling Benthic Macroinvertebrates in a Large Flood-Plain River: Considerations of Study Design, Sample Size, and Cost

Estimation of benthic macroinvertebrate populations over large spatial scales is difficult due to the high variability in abundance and the cost of sample processing and taxonomic analysis. To determine a cost-effective, statistically powerful sample design, we conducted an exploratory study of the spatial variation of benthic macroinvertebrates in a 37 km reach of the Upper Mississippi River. We sampled benthos at 36 sites within each of two strata, contiguous backwater and channel border. Three standard ponar (525 cm²) grab samples were obtained at each site ('Original Design'). Analysis of variance and sampling cost of strata-wide estimates for abundance of Oligochaeta, Chironomidae, and total invertebrates showed that only one ponar sample per site ('Reduced Design') yielded essentially the same abundance estimates as the Original Design, while reducing the overall cost by 63%. A posteriori statistical power analysis ( = 0.05, = 0.20) on the Reduced Design estimated that at least 18 sites per stratum were needed to detect differences in mean abundance between contiguous backwater and channel border areas for Oligochaeta, Chironomidae, and total invertebrates. Statistical power was nearly identical for the three taxonomic groups. The abundances of several taxa of concern (e.g., Hexagenia mayflies and Musculium fingernail clams) were too spatially variable to estimate power with our method. Resampling simulations indicated that to achieve adequate sampling precision for Oligochaeta, at least 36 sample sites per stratum would be required, whereas a sampling precision of 0.2 would not be attained with any sample size for Hexagenia in channel border areas, or Chironomidae and Musculium in both strata given the variance structure of the original samples. Community-wide diversity indices (Brillouin and 1-Simpsons) increased as sample area per site increased. The backwater area had higher diversity than the channel border area. The number of sampling sites required to sample benthic macroinvertebrates during our sampling period depended on the study objective and ranged from 18 to more than 40 sites per stratum. No single sampling regime would efficiently and adequately sample all components of the macroinvertebrate community.