论深入广泛推行清洁生产

在全面分析了国内推行清洁生产现状的基础上，根据中国的工业和资源特点，阐述了推行清洁生产的必要必,现时，从技术和管理两方面指出了中国推行清洁生产的巨大潜力，最后，有针对性地提出了深入广泛推行清洁生产的4条措施：（1）加快完善清洁生产政策，（2）深入实施清洁生产审计，（3）加强清洁生产技术的理论研究，（4）积极在中小企业中广泛推广清洁生产。     

Experimental study on static and dynamic mechanical properties of phosphogypsum

Environmental Science and Pollution Research - Phosphogypsum (PG) is a solid waste product of the wet-process phosphoric acid industry that accumulates in large amounts on the ground, forming PG...     

泉州湾表层沉积物中多环芳烃的含量分布特征及污染来源

采用气相色谱-质谱联用(GC-MS)方法,对泉州湾表层沉积物中16种优先控制多环芳烃(PAHs)进行定量分析,采用LMW/HMW、BaA/(BaA+Chr)、InP/(InP+BgP)、Ppi等特定比值对PAHs来源进行分析.结果表明,沉积物中PAHs的总含量在182.8-721.1ng·g-1之间,以3-5环为主;P...     

印染废水处理的磁混凝－高梯度磁分离协同作用

混凝过程作为工业废水的预处理技术普遍受到重视,在混凝过程中降低污泥产生量并提高污泥分离速度是该技术发展的方向,基于上述目标,通过将磁粉引入絮体使之磁化并在自行研制的高梯度磁分离装置中实现磁混凝与磁分离的协同作用.以高浊度的印染废水作为试验废水,以色度、COD及SS作为考核指标,重点考察了磁混凝反应及磁分离的影响因素.当印染废水的色度约为900倍、COD约为595 mg/L、SS约为500 mg/L时,在pH=8.5、FeSO4500 mg/L、PAM3.5 mg/L、磁粉400 mg/L的适宜磁混凝反应条件下,相应指标去除率比传统混凝法分别高出17.3%、21.7%及24.2%,此时絮团沉降速度增大了64.3%,污泥体积减少了61%,污泥压缩比为0.39.在电流强度8 A、流速2.5 L/min和介质填充率1%的操作条件下,该磁性絮体流经高梯度磁分离装置时的水力表面负荷达到61.0 m3/m2·h,处理出水达到国家二级排放标准.     

利用悬浮填料附着生物膜同步去除碳氮磷

采用移动床生物膜反应器（MBBR）处理配制模拟废水，实验结果表明，水力停留时间为6h、悬浮填料填充率为40％时，在不同C／N／P比率条件下，MBBR对COD、NH4＋-N和TN去除性能好且稳定，平均去除率分别达到90％、94．8％和62．39％以上，而TP的去除率受C／N／P值影响较大，当C／N／P的比值为100／10／1．8时，平均去除率达到58．03％。一定的溶解氧（DO）质量浓度能保证反应器中COD、NH4-N高效稳定的去除，同时是TN和TP同时去除的重要影响因素，在MBBR中最佳DO值约为3mg／L。由于附着在悬浮填料生物膜内部存在厌氧、缺氧微环境条件，在反应器中存在少量的反硝化聚磷菌。     

Experimental study on the mechanism effect of seepage on microstructure of tailings

The deformation of microstructure of tailings caused by seepage is the main factor that leads the tailings dam to be damaged and lose stability. The effect of seepage on microstructure of tailings has been studied by a self-made observation testing apparatus of micro-mechanics and deformation of tailings, and its mechanism also has been explained in mechanics of particulate matter. The results show that the deformation response to microstructure of tailings is fast under load. The settlement of sample increases stepwise. Firstly, the fine particles crumble, then skeleton particles move, so as to noticeable settlement. Because the loose particles migrate taken by seepage water, the upper pores become bigger and lower pores become smaller. The relation of seepage water and settlement changing with time could be divided into two stages. In each stage, the rates of seepage and settlement reduce with time, and between the two stages, the rate of settlement increases significantly and the rate of seepage reduces with time. The seepage has significant effect on the particle size distribution of tailings in different depths, which has a little effect on the coarse tailings; the proportion of fine tailings increases significantly with the depth increasing; the minimum particle size decreases gradually and median diameter reduces stepwise with the depth increasing.     

The efficient removal of thallium from sintering flue gas desulfurization wastewater in ferrous metallurgy using emulsion liquid membrane

The removal of thallium ions in flue gas desulfurization wastewater from ferrous metallurgic industry was studied by emulsion liquid membrane (ELM) method using 2-ethylhexyl phosphoric acid-2-ethylhexyl ester (P507) as carrier, aviation kerosene (AK) as organic solvent, polyisobutylene succinimide (T154) as surfactant, polyisobutylene (PIB) as additive, and sulfuric acid as internal reagent. Some important influence parameters such as concentrations of carrier, surfactant and stripping agent, agitation speed, extraction time, volume ratios of feed solution to emulsion phase and internal phase to membrane phase, and their effects on the removal efficiency of Tl in the ELM process were investigated and optimized. Under the optimum operating conditions of 2% of carrier, 5% of surfactant, 0.5 M of stripping agent, 350 rpm of agitation speed, 12.5:1 of volume ratio of feed solution to emulsion phase, and 3:1 volume ratio of membrane to internal phase, the maximum extraction efficiency of thallium reached 99.76% within 15-min reaction time. The ICP-MS analysis indicated that the thallium concentration in treated wastewater was below 5 μg/L and could meet the emission standard demand for industrial wastewater enacted by the local government of Hunan province of China. Meanwhile, the extraction of impurity ions calcium and magnesium in the ELM system was investigated. The result showed that an acidic environment would be in favor of the removal of Tl from calcium and magnesium contained in wastewater.

Open image in new window

Graphical abstract ?

     

促进经济与环境效益协调发展的重要手段--清洁生产

阐述了清洁生产的定义。通过与末端治理的比较，分析了清洁生产的优点：（1）能满足持续发展的要求，（2）可最大限度地利用资源和能源，（3）减少了末端治理的压力和二次污染的可能，（4）改善了劳动条件和工作环境，（5）解决了环境与经济两层皮的矛盾。并以3个具体例子进一步说明清洁生产是促进经济与环境效益协调发展的有效手段，是实现可持续发展战略的一项重要措施。     

黔中木本植物叶功能性状对退化喀斯特土壤特性的响应

研究不同退化背景下优势木本植物功能性状的适应机制,有助于从功能生态学的角度来解释喀斯特山区的群落演替过程。本研究以贵州普定不同退化背景样地优势木本为研究对象,测定LT、LA、SLA、LDMC、LTD、Chlc6个叶片功能性状指标,分析土壤特性对区域内植被叶片功能性状的作用及影响,揭示喀斯特山区植物对不同环境的适应策略及其演替过程。结果表明:①喀斯特区退化环境下植被叶片向增大化趋势发展,以退耕地经济林最显著;火烧、火烧砍伐、退耕下植被性状差异显著,以LA、LTD、SLA变化范围最大,在相应样地可分别高达121.9%、118.08%、86.00%。②退化样地内叶片性状在乔木、灌木和藤本物种间差异显著,总体上灌木与藤本物种种间变异高于乔木物种,群落处于演替前中期阶段。③不同退化背景下土壤特性差异较大,与植被叶功能性状间具有显著相关性,其中土层深度、土壤养分与土壤含水率是植被叶功能性状的关键土壤特性因子。④退化区域植被叶性状表现出LA大、LT较小、SLA和LTD低、LDMC高、Chlc较低,趋向于发展贫瘠干旱性状组合。揭示了黔中退化喀斯特次生林内在差异性的演替规律,为喀斯特次生林的管理和生物多样性保护提供科学依据。     

中国南海CDOM三维荧光光谱特征研究

利用三维荧光光谱技术,分析了中国南海有色溶解有机物(CDOM)荧光组分的垂直分布特征.结果表明,中国南海CDOM含有类腐殖质荧光峰M和类蛋白质荧光峰T;CDOM的荧光强度(λEx/λE m:350 nm/450 nm)在表层较低,垂直分布呈现随深度增加而增加,在300 m处达到峰值,然后逐渐下降,在500~600 m间达最小峰值,而后保持相对稳定的分布规律.荧光指数FI均在1.4~2.0间,腐殖化指数HIX值偏低,生物源指数BIX在0.7~1.1之间,T峰为主要贡献者,说明南海CDOM主要为海洋自生来源,受海洋微生物作用过程影响较大.M峰和T峰的荧光强度在垂直分布上具有相似的变化趋势,表层荧光强度都最小,说明南海表层CDOM丰度分布受光降解影响较大.研究表明,南海CDOM的垂直分布受光化学反应、海洋微生物活动及颗粒有机物再矿化的共同影响.