Simultaneous removal of cyanobacterial blooms and production of clean water by coupling flocculation with a rotary drum filter

Environmental Science and Pollution Research - A mechanical harvesting technology based on coupling flocculation with a rotary drum filter (RDF, 35-μm) was applied to remove cyanobacterial...     

湖北九宫山甜槠群落结构与优势种的空间分布格局研究

通过对湖北九宫山国家级自然保护区甜槠群落建立的1ha固定森林样地进行植物群落调查,分析了样地内木本植物物种组成、区系成分、种群径级结构和空间分布格局,结果表明:(1)样地内木本植物(DBH≥1 cm)共有132种,隶属于42科78属,其中,杜鹃花科、壳斗科、樟科、蔷薇科、冬青科等是优势科,短柄袍、鹿角杜鹃、青冈、长叶石栎、甜槠等是优势种.(2)样地内植物科、属的分布类型均以泛热带分布类型为主,分别为30.95％和20.51％.(3)样地内所有木本植物个体的径级结构均呈倒"J"型,幼龄个体数量大,森林群落更新状况良好.(4)样地内木本植物个体的空间分布格局以聚集分布为主,部分优势物种在小尺度上呈聚集分布,而在较大尺度上则为随机分布.     

Study on coupling between mineral resources exploitation and the mining ecological environment in Shanxi Province

Environment, Development and Sustainability - Due to rapid socioeconomic development, seeking the coordination of resources exploitation and the ecological environment has become an objective...     

原子荧光法测定水中汞的原子化条件研究

分别采用热原子化原子荧光法(热汞法)和冷原子化原子荧光法(冷汞法)测定水中汞,比较了两种方法的检出限、线性相关系数、准确度和精密度的差异。冷汞法和热汞法的检出限分别为0.003和0.01μg/L,标准曲线相关系数分别为0.999 9和0.999 7,加标回收率范围分别为102%~106%和106%~113%。结果表明,冷汞法比热汞法具有更低的检出限,灵敏度和准确度也略优于热汞法。对于冷汞法,提高负高压有利于提高方法的灵敏度、准确度,并具有更低的方法检出限。     

Enhanced Interfacial Adhesion and Characterisation of Recycled Natural Fibre-Filled Biodegradable Green Composites

The structural, thermal, mechanical, and biodegradable properties of composite materials made from polylactide (PLA) and agricultural residues (arrowroot (Maranta arundinacea) fibre, AF) were evaluated. Melt blended glycidyl methacrylate-grafted polylactide (PLA-g-GMA) and coupling agent-treated arrowroot fibre (TAF) formed the PLA-g-GMA/TAF composite, which had better properties than the PLA/AF composite. The water resistance of the PLA-g-GMA/TAF composite was greater than that of the PLA/AF composite; the release of PLA in water from the PLA/AF and PLA-g-GMA/TAF composites indicated good biological activity. The PLA-g-GMA/TAF material had better mechanical properties than PLA/AF. This behaviour was attributed to better compatibility between the grafted polymer and TAF. The results indicated that the T_g of PLA was increased by the addition of fibre, which may have improved the heat resistance of PLA. Furthermore, the mass losses following burial in soil compost indicated that both materials were biodegradable, especially at high levels of AF or TAF substitution.     

利用毒代动力学模型研究氟虫腈在夹杂带丝蚓体内的手性选择性积累过程

农药的生物积累直接影响其毒性,但是手性农药在生物体内的选择性积累过程仍不明确.本文在恒定环境水浓度的条件下,开展手性农药氟虫腈的外消旋体及其对映体在底栖无脊椎动物夹杂带丝蚓体内的生物积累实验.在96 h和72 h的吸收和消除实验过程中,测定生物体内的氟虫腈的外消旋体和对映体浓度随时间的变化情况,构建毒代动力学模型,获取吸收和消除速率常数.结果表明夹杂带丝蚓对R-氟虫腈的生物浓缩因子(1981 L·kg~(-1)脂肪)比对S-氟虫腈(1748 L·kg~(-1)脂肪)更大.R-氟虫腈和S-氟虫腈的吸收速率常数相当,分别为311±11 L·kg~(-1)脂肪·h~(-1)和313±13 L·kg~(-1)脂肪·h~(-1),而R-氟虫腈的消除速率常数小于S-氟虫腈,分别为0.157±0.006 h~(-1)和0.179±0.008 h~(-1),因此相对较慢的消除是导致R-氟虫腈在夹杂带丝蚓体内更高生物积累的主要原因.研究说明毒代动力学参数可有效阐释手性外源物质在生物体内选择性积累的差异.     

电化学开关表面活性剂对芘的可逆增溶作用

表面活性剂增强修复技术(SER)是目前行之有效的有机污染土壤修复技术,但SER技术存在表面活性剂与污染物分离困难、易导致二次污染、成本高等问题.基于此,提出采用具有电化学开关特性的表面活性剂(N,N-二甲基二茂铁甲基十二烷基溴化铵,Fc12)代替SER技术中的常规表面活性剂,发展基于开关表面活性剂的可逆增强修复技术(RSER).选取芘作为目标物,研究了Fc12在氧化和还原态对芘的增溶作用以及常见环境因素,如pH和温度对Fc12可逆增溶的影响.结果表明,相对于氧化态Fc12,还原态Fc12在其临界胶束浓度(CMC)以上时对芘表现出显著的增溶作用,且增溶能力随表面活性剂浓度增大而增强.温度对Fc12的增溶作用影响显著,例如,还原态Fc12在浓度为3 mmol·L~(-1)、25℃条件下时,芘的表观溶解度为0.779 mg·L~(-1),当温度增加到40℃时,芘的表观溶解度为0.971 mg·L~(-1),其表观溶解度增加了24.6%;但氧化态条件下,芘的表观溶解度仅增加了6.5%;芘的解吸率(芘在还原和氧化态Fc12的表观溶解度差值与还原态Fc12增溶芘的比值)由63.67%增加到71.27%.pH也显著影响Fc12的增溶,当pH值在6—10范围变化时,还原态Fc12的增溶作用呈现先增加后减小的趋势,且在pH 9附近增溶能力最强,而pH 8时芘的解吸果最好.     

Optimal Absorbent Evaluation for the CO2 Separating Process by Absorption Loading,Desorption Efficiency,Cost, and Environmental Tolerance

The CO₂ absorption capacities of potassium glycinate, potassium sarcosinate (choline, proline), mono-ethanolamine (MEA), and tri-ethanolamine were evaluated to find the optimal absorbent for separating CO₂ from gaseous products by a CO₂ purification process. The absorption loading, desorption efficiency, cost, and environmental tolerance were assessed to select the optimal absorbent. MEA was found to be the optimum absorbent for separating the CO₂ and H₂ mixture in gaseous product. The maximum absorption loading rate was 0.77 mol CO₂ per mol MEA at temperature of 20°C and absorbent concentration of 2.5 mol/L, whereas desorption efficiency was 90% by heating for 3 h at 130°C. MEA was found to be an optimal absorbent for the purification process of CO₂ during gaseous production.     

土壤中挥发性芳香烃的顶空前处理方法研究

本方法针对土壤中挥发性芳香烃顶空前处理条件进行了研究,优化了顶空密封垫的选择、顶空平衡温度、加热平衡时间、进样时间和顶空瓶压力等顶空前处理条件,测定条件科学、准确,完全能够满足土壤中挥发性芳香烃监测分析的灵敏度和准确度相关的技术要求。该方法精密度为1.7%~9.8%,准确度为34.3%~83.7%,检出限为2.0~4.2μg/kg。为制订土壤中挥发性芳香烃监测分析方法提供了技术支持。     

How does population structure affect pollutant discharge in China? Evidence from an improved STIRPAT model

Environmental Science and Pollution Research - China is the most populous country in the world, and the pollution caused by the excessive population should not be underestimated. In recent years,...