Usability of non-standard lower anchor configurations for child restraint system (CRS) installation

Abstract

Objectives: The objective of this study was to determine whether the amount of tension required for proper child restraint system (CRS) installation varies with lower anchor spacing and to determine whether nonexperts can produce adequate tension on wider-than-standard lower anchor configurations.

Methods: CRSs were installed by certified child passenger safety technicians (CPSTs; n?=?6 subjects, n?=?72 installations) and nonexperts (n?=?30 subjects, n?=?120 installations) on a mock-up vehicle seat fixture with lower anchors set at 11 (standard), 15, 19, and 23 in. apart from one another. Each CPST installed a rear-facing (RF) infant base, RF convertible, and forward-facing (FF) convertible into each of the 4 spacing configurations in random order. The CPSTs were instructed to tighten the lower connector strap until the tension was exactly at the threshold between passing and failing the 1-in. test. Each nonexpert installed one CRS model into all 4 spacing conditions in random order. Nonexperts were instructed to install the CRS to the best of their ability. The tension produced on the lower connector strap was recorded via load cell in the lower anchor assembly of the vehicle seat. Resultant tension magnitudes were compared across spacing conditions using matched pair t-tests. The CPSTs’ mean 1-in. test threshold values were compared to tensions produced by nonexperts. Installations were visually evaluated for errors and qualitative usability feedback was collected via survey.

Results: CPSTs installed the infant base with higher tensions in the 15-, 19-, and 23-in. configurations compared to the standard 11-in. configuration (P = .034, .032, and .003, respectively). The nonexperts installed the infant base with higher tension in the 15- and 23-in. configurations compared to the 11-in. configuration (P = .004 and .026, respectively). The RF convertible and FF convertible installations showed no significant differences in tension among any of the spacing configurations for either group. Only 19% of the nonexperts’ installations were tight enough to pass CPST thresholds, and the pass rate did not vary with respect to lower anchor spacing. In feedback surveys, the nonexpert group did not show a consistent preference for either standard or wider-than-standard lower anchor configurations.

Conclusions: The amount of tension required to pass the 1-in. rule did not vary with lower anchor spacing configurations for the RF and FF convertible CRS, but the infant base required more tension in wider anchor configurations. Nonexperts tended to produce less than ideal tension in all configurations, although their tension magnitudes increased for the infant base in wider configurations.     

美国环保局拟与工商界开展清洁技术合作

美国环境保护局拟推出一项与美国工商界合作扶持美国技术出口的战略.这项举措是针对人们日益关注促进新的、更高效的和环境上安全的可持续发展技术的需要而设计的.在一份给国会的报告<环保局促进美国环境出口的战略>中,该局提出了一项关于传播环境无害的环境保护技术的计划.这种战略的一种附加效益是要增加美国工商界的商业机会.     

Organic compound emissions from a landfarm used for oil and gas solid waste disposal

Solid or sludgy hydrocarbon waste is a by-product of oil and gas exploration and production. One commonly used method of disposing of this waste is landfarming. Landfarming involves spreading hydrocarbon waste on soils, tilling it into the soil, and allowing it to biodegrade. We used a dynamic flux chamber to measure fluxes of methane, a suite of 54 nonmethane hydrocarbons, and light alcohols from an active and a remediated landfarm in eastern Utah. Fluxes from the remediated landfarm were not different from a polytetrafluoroethylene (PTFE) sheet or from undisturbed soils in the region. Fluxes of methane, total nonmethane hydrocarbons, and alcohols from the landfarm in active use were 1.41 (0.37, 4.19) (mean and 95% confidence limits), 197.90 (114.72, 370.46), and 4.17 (0.03, 15.89) mg m^?2 hr^?1, respectively. Hydrocarbon fluxes were dominated by alkanes, especially those with six or more carbons. A 2-ha landfarm with fluxes of the magnitude we observed in this study would emit 95.3 (54.3, 179.7) kg day^?1 of total hydrocarbons, including 11.2 (4.3, 33.9) kg day^?1 of BTEX (benzene, toluene, ethylbenzene, and xylenes).

Implications: Solid and sludgy hydrocarbon waste from the oil and gas industry is often disposed of by landfarming, in which wastes are tilled into soil and allowed to decompose. We show that a land farm in Utah emitted a variety of organic compounds into the atmosphere, including hazardous air pollutants and compounds that form ozone. We calculate that a 2-ha landfarm facility would emit 95.0 ± 66.0 kg day^?1 of total hydrocarbons, including 11.1 ± 1.5 kg day^?1 of BTEX (benzene, toluene, ethylbenzene, and xylenes).     

Diesel particulate emissions and the implications for the soiling of buildings

Summary The sources of dark smoke and particulate elemental carbon (PEC) in the London and United Kingdom atmospheres have been estimated from emission inventories. Diesels are responsible for about 60 percent of the dark smoke and 95 percent of the PEC in London, and about 30 percent of the dark smoke and 90 percent of the PEC in the UK. The role of PEC in the soiling of materials is considered. An experimental programme in the Hatfield Tunnel revealed a soiling rate constant of 1.9 yr^–1. The socio-economic implications of building soiling are considered.Dr Trudie Mansfield completed her postgraduate training at Middlesex Polytechnic, where her research supervisor, Dr Ron Hamilton, and Bryan Ellis are members of staff in the Urban Pollution Research Centre (address, Bounds Green Road, London N11 2NQ) and Peter Newby is a staff member in the School of Geography (address, Queensway, Enfield EN3 4SF). Trudie Mansfield is a Senior Scientific Officer in the Air Quality Division of the Department of the Environment.     

Survival and remigration probabilities for loggerhead turtles (Caretta caretta) nesting in the eastern Gulf of Mexico

Few long-term mark-recapture tagging datasets exist to estimate population parameters for loggerhead sea turtle (Caretta caretta) recovery units. Using a two-state open robust design model, we analyzed a 20-year (1990–2009) mark-recapture dataset from the Keewaydin Island loggerhead nesting assemblage off the southwest coast of Florida (USA) in the eastern Gulf of Mexico. For this analysis, 2,292 turtle encounters were evaluated, representing 841 individual nesting turtles. Survival was estimated at 0.73 (95 % CI 0.69–0.76). This estimate is comparable with survival estimates elsewhere in the Peninsular Florida subpopulation and is among the lowest estimates for the Northwest Atlantic loggerhead population. We documented no changes in remigration rates or clutch frequency over time. These are the first survival and remigration probabilities estimated for a loggerhead nesting assemblage in the eastern Gulf of Mexico.     

Evaluation of interventions to make top tether hardware more visible during child restraint system (CRS) installations

Objectives: The objective of the study is to determine whether specific child restraint system (CRS) or vehicle conditions improve top tether attachment rates during volunteer installations.

Methods: A factorial randomized controlled trial was designed to evaluate 4 different experimental categories: (1) Color of tether adjuster casing (black or red), (2) labeling on tether adjuster casing (labeled with “Tether: Use for forward-facing” or unlabeled), (3) storage location of tether (bundled in a rubber band on the back of CRS or Velcroed over the forward-facing belt path), and (4) labeling in vehicle (labeled under head restraint and below anchor or unlabeled). Ninety-six volunteers were randomly assigned to one combination of conditions. One installation per volunteer was completed. The primary outcome measure was acceptable attachment of the top tether to the tether anchor. The secondary outcome measure was overall secureness of the installation. Pearson’s chi-square tests were used to identify significant predictors of acceptable outcomes and logistic regression was used to investigate interaction effects.

Results: A total of 66/96 subjects (68.8%) attached the top tether in an acceptable manner, with either zero errors (n?=?50) or minor errors (n?=?16). A total of 30/96 subjects (31.2%) had unacceptable tether outcomes, with either major errors (n?=?10) or nonuse the tether at all (n?=?20). None of the 4 experimental categories significantly affected tether outcomes. Subjects who opted to install the CRS with the lower anchors (LAs) had higher rates of acceptable tether attachment compared to subjects who installed using the seat belt or those who used both LA and seat belt together (χ² = 6.792, P = .034). Tether outcomes were not correlated with previous CRS experience, use of instruction manual(s), age, or sex. Only 15.6% of subjects produced overall correct and tight installations. Of those who used the seat belt in some manner, 70.2% neglected to switch the retractor into locking mode.

Conclusions: Conditions in this study including tether color, tether labeling, storage location, and vehicle labeling did not significantly affect tether attachment rates. High rates of tether misuse and nonuse warrant further exploration to find effective solutions to this usability problem.     

Effect of SO2 on the reproduction of pea aphids, Acyrthosiphon pisum, and the impact of SO2 and aphids on the growth and yield of peas

Pea aphids feeding from birth to maturity on pea plants (Pisum sativum) exposed to SO(2) concentrations of 50 nl litre(-1) or 80 nl litre(-1) showed a significant 19% increase in the rate of nymph production during the reproductive period, compared to control aphids feeding on plants in charcoal-filtered air. The higher nymph production resulted in a mean 4.6% increase in the intrinsic rate of population increase (rm). In longer term glasshouse fumigation experiments pea aphid populations were, on average, 1.8 times greater on pea plants in ambient air plus 45 nl litre(-1) SO(2) than in ambient air alone. Aphid infestation in ambient air caused a 42% reduction in pea yield and affected most plant parameters adversely. Ambient air plus SO(2) had no direct effect on yield, but, in combination with aphid infestation, a further 10% reduction in yield was recorded.     

A large-scale fumigation system for investigating interactions between air pollution and cold stress on plants

A new large-scale closed chamber fumigation system with cooling facilities is described for studying effects of low concentrations of SO(2), NO(2) and O(3) and low temperatures on woody species and herbaceous plants. The system is based on modified hemispherical greenhouses with a forced air ventilation system. This provides a chamber environment with low spatial variability of pollutant gas concentrations and rapid air circulation which allows exposure of plants at near ambient temperatures and relative humidity. Large capacity cooling units come into operation when ambient temperatures fall below 0 degrees C, and these allow chamber temperatures to be lowered by an additional 4 to 8 degrees C in experiments designed to test whether exposure to pollutants enhances the frost sensitivity of plants.     

Buying Time: Real and Hypothetical Offers

This article provides the results of a field test of contingent valuation estimates within a willingness to accept framework. Using dichotomous choice questions in telephone–mail–telephone interviews, we compare survey respondents' responses to real and hypothetical offers for the opportunity to spend time in a second set of interviews on an undisclosed topic. Five hundred and forty people were randomly split between the real and hypothetical treatments. Our findings indicate no significant differences between people's choices with real and hypothetical offers. Choice models werenotsignificantly different between real and hypothetical offers.