Role of microbes,metabolites and effector compounds in host–microbiota interaction: a pharmacological outlook

Environmental Chemistry Letters - Microbial cells react with intestinal surfaces and produce enzymes and metabolites that influence human health, host metabolism and immunity. Gut...     

Suspended Particulate Matter Distribution in Rural-Industrial Satna and in Urban-Industrial South Delhi

An air quality sampling program was designed and implemented to collect the baseline concentrations of respirable suspended particulates (RSP = PM₁₀), non-respirable suspended particulates (NRSP) and fine suspended particulates (FSP = PM_2.5). Over a three-week period, a 24-h average concentrations were calculated from the samples collected at an industrial site in Southern Delhi and compared to datasets collected in Satna by Envirotech Limited, Okhla, Delhi in order to establish the characteristic difference in emission patterns. PM_2.5, PM₁₀, and total suspended particulates (TSP) concentrations at Satna were 20.5 ± 6.0, 102.1 ± 41.1, and 387.6 ± 222.4 μg m⁻³ and at Delhi were 126.7 ± 28.6, 268.6 ± 39.1, and 687.7 ± 117.4 μg m⁻³. Values at Delhi were well above the standard limit for 24-h PM_2.5 United States National Ambient Air Quality Standards (USNAAQS; 65 μg m⁻³), while values at Satna were under the standard limit. Results were compared with various worldwide studies. These comparisons suggest an immediate need for the promulgation of new PM_2.5 standards. The position of PM₁₀ in Delhi is drastic and needs an immediate attention. PM₁₀ levels at Delhi were also well above the standard limit for 24-h PM₁₀ National Ambient Air Quality Standards (NAAQS; 150 μg m⁻³), while levels at Satna remained under the standard limit. PM_2.5/PM₁₀ values were also calculated to determine PM_2.5 contribution. At Satna, PM_2.5 contribution to PM₁₀ was only 20% compared to 47% in Delhi. TSP values at Delhi were well above, while TSP values at Satna were under, the standard limit for 24-h TSP NAAQS (500 μg m⁻³). At Satna, the PM₁₀ contribution to TSP was only 26% compared to 39% in Delhi. The correlation between PM₁₀, PM_2.5, and TSP were also calculated in order to gain an insight to their sources. Both in Satna and in Delhi, none of the sources was dominant a varied pattern of emissions was obtained, showing the presence of heterogeneous emission density and that nonrespirable suspended particulate (NRSP) formed the greatest part of the particulate load.     

Synthesis, characterization and application of Lagerstroemia speciosa embedded magnetic nanoparticle for Cr(VI) adsorption from aqueous solution

Lagerstroemia speciosa bark (LB) embedded magnetic nanoparticles were prepared by co-precipitation of Fe²⁺ and Fe³⁺ salt solution with ammonia and LB for Cr(VI) removal from aqueous solution. The native LB, magnetic nanoparticle (MNP), L. speciosa embedded magnetic nanoparticle (MNPLB) and Cr(VI) adsorbed MNPLB particles were characterized by SEM–EDX, TEM, BET-surface area, FT-IR, XRD and TGA methods. TEM analysis confirmed nearly spherical shape of MNP with an average diameter of 8.76 nm and the surface modification did not result in the phase change of MNP as established by XRD analysis, while led to the formation of secondary particles of MNPLB with diameter of 18.54 nm. Characterization results revealed covalent binding between the hydroxyl group of MNP and carboxyl group of LB particles and further confirmed its physico-chemical nature favorable for Cr(VI) adsorption. The Cr(VI) adsorption on to MNPLB particle as an adsorbent was tested under different contact time, initial Cr(VI) concentration, adsorbent dose, initial pH, temperature and agitation speed. The results of the equilibrium and kinetics of adsorption were well described by Langmuir isotherm and pseudo-second-order model, respectively. The thermodynamic parameters suggest spontaneous and endothermic nature of Cr(VI) adsorption onto MNPLB. The maximum adsorption capacity for MNPLB was calculated to be 434.78 mg/g and these particles even after Cr(VI) adsorption were collected effortlessly from the aqueous solution by a magnet. The desorption of Cr(VI)-adsorbed MNPLB was found to be more than 93.72% with spent MNPLB depicting eleven successive adsorption–desorption cycles.     

Feasibility of landfill gas as a liquefied natural gas fuel source for refuse trucks

The purpose of this paper is to develop a methodology to evaluate the feasibility of using landfill gas (LFG) as a liquefied natural gas (LNG) fuel source for heavy-duty refuse trucks operating on landfills. Using LFG as a vehicle fuel can make the landfills more self-sustaining, reduce their dependence on fossil fuels, and reduce emissions and greenhouse gases. Acrion Technologies Inc. in association with Mack Trucks Inc. developed a technology to generate LNG from LFG using the CO2 WASH process. A successful application of this process was performed at the Eco Complex in Burlington County, PA. During this application two LNG refuse trucks were operated for 600 hr each using LNG produced from gases from the landfill. The methodology developed in this paper can evaluate the feasibility of three LFG options: doing nothing, electricity generation, and producing LNG to fuel refuse trucks. The methodology involved the modeling of several components: LFG generation, energy recovery processes, fleet operations, economic feasibility, and decision-making. The economic feasibility considers factors such as capital, maintenance, operational, and fuel costs, emissions and tax benefits, and the sale of products such as surplus LNG and food-grade carbon dioxide (CO2). Texas was used as a case study. The 96 landfills in Texas were prioritized and 17 landfills were identified that showed potential for converting LFG to LNG for use as a refuse truck fuel. The methodology was applied to a pilot landfill in El Paso, TX. The analysis showed that converting LFG to LNG to fuel refuse trucks proved to be the most feasible option and that the methodology can be applied for any landfill that considers this option.     

Evaluation of physiological, growth and yield responses of a tropical oil crop (Brassica campestris L. var. Kranti) under ambient ozone pollution at varying NPK levels

A field study was conducted to evaluate the impact of ambient ozone on mustard (Brassica campestris L. var. Kranti) plants grown under recommended and 1.5 times recommended NPK doses at a rural site of India using filtered (FCs) and non-filtered open top chambers (NFCs). Ambient mean O₃ concentration varied from 41.65 to 54.2 ppb during the experiment. Plants growing in FCs showed higher photosynthetic rate at both NPK levels, but higher stomatal conductance only at recommended NPK. There were improvements in growth parameters and biomass of plants in FCs as compared to NFCs at both NPK levels with higher increments at 1.5 times recommended. Seed yield and harvest index decreased significantly only at recommended NPK in NFCs. Seed quality in terms of nutrients, protein and oil contents reduced in NFCs at recommended NPK. The application of 1.5 times recommended NPK provided protection against yield loss due to ambient O₃.     

Productivity of rainfed wheat as affected by climate change scenario in northeastern Punjab, India

Wheat (Triticum aestivum L.) is grown as a rainfed crop in the sub-mountainous region of the Punjab state of India, with low crop and water productivity. The present study aims to assess the effect of climate change scenario (A1B) derived from PRECIS—a regional climate model—on wheat yield and water productivity. After minimizing bias in the model climate data for mid-century (2021–2050), evapotranspiration (ET) and yield of wheat crop were simulated using Decision Support System for Agrotechnology Transfer, version 4.5, model. In the changed climate, increased temperature would cause reduction in wheat yield to the extent of 4, 32 and 61 % in the mid-century periods between 2021–2030, 2031–2040 and 2041–2050, respectively, by increasing water stress and decreasing utilization efficiency of photosynthetically active radiation. The decreases in crop water productivity would be 40, 56 and 76 %, respectively, which are caused by decreased yield and increased ET. Planting of wheat up to November 25 till the years 2030–2031 seems to be helpful to mitigate the climate change effect, but not beyond that.     

Improving the dynamic response of frequency and power in a wind integrated power system by optimal design of compensated superconducting magnetic energy storage

The frequency deviation and power fluctuation need to be controlled in a wind-integrated power system (WIPS) for keeping the balance between system power generation and demand, which support the quality and stability of overall power system. The present paper addresses this problem while concerning the integration of intermittent wind power and load disturbance into the WIPS. With this intent, it proposes the compensated superconducting magnetic energy storage (CSMES) system with proportional integral derivative (PID) controller for improving the frequency and power deviation profile. A novel swarm intelligence-based artificial bee colony (ABC) algorithm is used for optimal design of PID-CSMES system. Robustness of the proposed ABC-based PID-CSMES control strategy is tested in WIPS under various disturbance patterns of load and wind power. To demonstrate the improved dynamic response, their simulation results are compared with particle swarm optimization-based PID-CSMES, PID with SMES, and only PID controller technique. The performance indices and transient response characteristics of frequency and power deviation are used to evaluate and compare the accuracy and efficiency of each controller. Stability of various system configurations is analyzed using eigenvalue location. Comparing the results of different controller in WIPS indicates a substantial improvement in the dynamic response of system frequency and power deviations by utilizing the proposed control strategy.     

Identification of sources affecting fog formation using receptor modeling approaches and inventory estimates of sectoral emissions

Positive matrix factorization (PMF) was used to identify factors affecting fog formation in Kanpur during the ISRO-GBP land campaign-II (LC-II) in December 2004. PMF predicted factors were validated by contrasting the emission strength of sources in the foggy and clear periods, using a combination of potential source contribution function (PSCF) analysis and quantitative emission inventory information. A time series aerosol chemical data set of 29 days and 12 species was decomposed to identify 4-factors: Secondary species, Biomass burning, Dust and Sea salt. PMF predicted particle mass with a satisfactory goodness-of-fit (slope of 0.83 ± 0.17 and R² of 0.8), and strong species within 11–12% relative standard deviation. Mean contributions of anthropogenic factors were significantly higher during the foggy period for secondary species (2.9 ± 0.3) and biomass burning (1.2 ± 0.09) compared to the clear period. Local sources contributing to aerosols that mediated fog events at Kanpur, based on emissions in a 200 km × 200 km area around Kanpur city were thermal power plants and transportation (SO₂) and biofuel combustion (BC and OM). Regional scale sources influencing emissions during the foggy period, in probable source regions identified by PSCF included thermal power plants, transportation, brick kilns and biofuel combustion. While biofuel combustion and transportation are distributed area sources, individual point sources include coal-fired thermal power plants located in Aligarh, Delhi, Ghaziabad, Jhansi, Kanpur, Rae Bareli and Rupnagar and brick kilns located in Allahabad, Agra, Farrukhabad, Ghaziabad, Kanpur, Ludhiana, Lucknow and Rae Bareli. Additionally, in the foggy period, large areas of probable source regions lay outside India, implying the significance of aerosol incursion from outside India.     

Estimates of upwelling rates in the Arabian Sea and the equatorial Indian Ocean based on bomb radiocarbon

Radiocarbon measurements were made in the water column of the Arabian Sea and the equatorial Indian Ocean during 1994, 1995 and 1997 to assess the temporal variations in bomb 14C distribution and its inventory in the region with respect to GEOSECS measurements made during 1977-1978. Four GEOSECS stations were reoccupied (three in the Arabian Sea and one in the equatorial Indian Ocean) during this study, with all of them showing increased penetration of bomb 14C along with decrease in its surface water activity. The upwelling rates derived by model simulation of bomb 14C depth profile using the calculated exchange rates ranged from 3 to 9 m a(-1). The western region of the Arabian Sea experiencing high wind-induced upwelling has higher estimated upwelling rates. However, lower upwelling rates obtained for the stations occupied during this study could be due to reduced 14C gradient compared to that during GEOSECS.