Recycling polymeric waste from electronic and automotive sectors into value added products

The environmentally sustainable disposal and recycling of ever increasing volumes of electronic waste has become a global waste management issue. The addition of up to 25% polymeric waste PCBs (printed circuit boards) as fillers in polypropylene (PP) composites was partially successful: while the tensile modulus, flexural strength and flexural modulus of composites were enhanced, the tensile and impact strengths were found to decrease. As a lowering of impact strength can significantly limit the application of PP based composites, it is necessary to incorporate impact modifying polymers such as rubbery particles in the mix. We report on a novel investigation on the simultaneous utilization of electronic and automotive rubber waste as fillers in PP composites. These composites were prepared by using 25 wt.% polymeric PCB powder, up to 9% of ethylene propylene rubber (EPR), and PP: balance. The influence of EPR on the structural, thermal, mechanical and rheological properties of PP/PCB/ EPR composites was investigated. While the addition of EPR caused the nucleation of the β crystalline phase of PP, the onset temperature for thermal degradation was found to decrease by 8%. The tensile modulus and strength decreased by 16% and 19%, respectively; and the elongation at break increased by ~71%. The impact strength showed a maximum increase of ~18% at 7 wt.%–9 wt.% EPR content. Various rheological properties were found to be well within the range of processing limits. This novel eco-friendly approach could help utilize significant amounts of polymeric electronic and automotive waste for fabricating valuable polymer composites.

Open image in new window

     

Removal of hexavalent chromium upon interaction with biochar under acidic conditions: mechanistic insights and application

Environmental Science and Pollution Research - Chromium pollution of soil and water is a serious environmental concern due to potential carcinogenicity of hexavalent chromium [Cr(VI)] when...     

Black carbon aerosols in urban air in South Asia

We report data from a yearlong (2006–2007) study of black carbon concentrations ([BC]) measured at 5-min intervals with an Aethalometer in Karachi, Pakistan. Daily mean [BC] varied from about 1 to 15 μg m^?3. However, short-term spikes exceeding 40 μg m^?3 were common, occurring primarily during the morning and evening rush-hour periods. The [BC] values were highest during November through February, ～10 μg m^?3, and lowest during June through September, ～2 μg m^?3. Diurnal, seasonal, and day-of-the-week trends are discussed. It is demonstrated that these trends are strongly affected by meteorological patterns. A simple expression is applied to the concentration profiles to separate the effects of meteorological conditions and elucidate the underlying emissions patterns. Daily emissions varied from 14,000 to 22,000 kg of BC per day. When integrated over the year emissions for Karachi Proper were estimated at 6.7 kilometric tons per year and emissions for greater Karachi were 17.5 kilometric tons per year. Folding in the populations of each area yields BC emissions of 0.74 and 1.1 kg per person per year, respectively. Applying the model to previously collected data at Lahore, Pakistan yields emissions during November–January that are around a factor of two higher than those in Karachi, but because the BC measurements in Lahore covered only three months, no estimates of annual emissions were attempted. Given the large populations of these cities the local health impact from PM alone is expected to be severe but because of the high [BC] emissions the impact on the global climate may be equally significant.     

Variations in physico-chemical and microbiological characteristics of water during breeding of Cyprinus carpio in a closed hatchery system

Physico-chemical and microbial characteristics of culture water were examined during the induced breeding of Cyprinus carpio in a controlled environmental system. Water temperature, dissolved oxygen, nitrate, phosphate, pH, ammonia nitrogen, total bacterial count, hardness, salinity, carbonate and bicarbonate were estimated before and after spawning and hatching. Average alteration in water pH before and after spawning was 7.91-7.57 and 7.86-7.58 respectively. Total hardness, carbonate and bicarbonate showed insignificant variations. Nitrate, ammonia nitrogen and phosphate contents significantly increased after spawning and hatching p < 0.05. The average increase in nitrate was from 2.94 to 8.62 microg l(-1) after spawning and 3.10 to 8.49 microgl(-1) after hatching. Ammonia nitrogen contents were sharply increased from an average of 0.011 to 1.87 mg l(-1) after spawning and 0.013 to 0.56 mg l(-1) after hatching. The average phosphates increased from 2.59 to 4.15 microg l(-1) after spawning and 2.61 to 4.03 microg l(-1) after hatching. Dissolved oxygen was sharply depleted even after a continuous aeration. Temperature played a vital role during breeding. No successful breeding was observed at a temperature of 17 degrees C or below and 31 degrees C or above. There is a significant association between temperature, spawning and hatching (p < 0.05). By optimizing temperature, the breeding success of this carp was achieved with a statistical significance of p < 0.05. Total bacterial count was significantly increased after spawning and hatching. It was related to the amount of discharge and may cause mass mortality of fish embryo and spawn in a closed hatchery system.     

Determination of cadmium in water and herbal medicine by Penicillium chrysogenum immobilized on silica gel for flame atomic absorption spectroscopy

Penicillium chrysogenum was immobilized on silica to develop a simple and cost effective method for solid phase extraction of Cd(II) and determination using flame atomic absorption spectrometry (FAAS). The sorbent was characterized by Fourier transform infrared spectroscopy and packed into a column. The conditions for quantitative sorption and desorption of Cd(II) were optimized. The preconcentration factor was 100 while detection limit was 0.61 µg L^?1 with a relative standard deviation of 1.0%. The method was applied for determination of Cd in herbal medicine and tap water.     

A linear and nonlinear approach for interpretation of groundwater quality based on water quality index

In this study using linear and nonlinear approach, aggregate indices for various water quality parameters were analyzed. Using a linear and nonlinear interpolating surface, various water quality variables at grid points were investigated that is essential for mapping. The values help in constituting a key approach for determining the water quality index (WQI), which converts pollutant concentration data into subindex values and then combines them into a single score. One of the biggest advantages of WQI is its summary and intuitive communication capability which will be extremely helpful for demarcating safe aquifer zones of groundwater and in the selection of suitable method for remedial. The present study also describes pollution potential in ground water of Madhya Pradesh, India. The aggregate indices suggest intermediate to high pollution susceptibility in some region of Madhya Pradesh that may increase further if not managed. The overall interpretation of the study will be helpful in formulating suitable approach for water quality interpretation and sustainable planning of groundwater resources.     

Nano-inspired systems in food technology and packaging

Creation of food-based nanomaterials for food processing and packaging applications is actually gaining in importance. Indeed, the design of a suitable food carrier system controls the encapsulation efficiency, the product stability and release of bioactives such as micronutrients, antimicrobial compounds and antioxidants. The smaller size of nanomaterials provides higher thermodynamic and kinetic stability. Whereas the higher surface area enhances compound solubility. Nanoemulsions both encapsulate bioactive compounds effectively and address the food safety concerns of the fresh produce associated with foodborne pathogens. Nanoliposomes encapsulate bioactive whey peptides and fat-soluble vitamins with improved functionalities. Encapsulated bioactive molecules are released by diffusion into the surrounding environment after degradation of the surrounding polymeric matrix.     

Pilot project at Hazira,India, for capture of carbon dioxide and its biofixation using microalgae

The objective of the present study was to set up a small-scale pilot reactor at ONGC Hazira, Surat, for capturing CO₂ from vent gas. The studies were carried out for CO₂ capture by either using microalgae Chlorella sp. or a consortium of microalgae (Scenedesmus quadricauda, Chlorella vulgaris and Chlorococcum humicola). The biomass harvested was used for anaerobic digestion to produce biogas. The carbonation column was able to decrease the average 34 vol.% of CO₂ in vent gas to 15 vol.% of CO₂ in the outlet gas of the carbonation column. The yield of Chlorella sp. was found to be 18 g/m²/day. The methane yield was 386 l CH₄/kg VS_fed of Chlorella sp. whereas 228 l CH₄/kg VS_fed of the consortium of algae.     

Effect of malathion on reproductive system of male rats

The pesticides are one of the most potentially harmful chemicals liberated in the environment in an unplanned manner Malathion is widely used as a potent pesticide in many countries and has been shown to produce some adverse health effects. A study was conducted to asses the effects of malathion on the male reproductive system of wistar rats. The pesticide was administered to rats orally at dose levels of 50, 150 and 250 mg/kg/body wt/day for 60 days. In comparison to the control rats, there was a significant reduction in the weight of testes, epididymis, seminal vesicle and ventral prostate. Testicular and epididymal sperm density were decreased in the animals treated with malathion. Pre and post fertility test showed 80% negative results after treatment Biochemical profile of the testis revealed a significant decline in the contents of sialic acid and glycogen. Whereas a significant increase in the protein content of testis and testicular cholesterol was observed. The activity of testicular enzyme acid phosphatase increased significantly while decreased alkaline phosphatase activity was found. Malathion also suppressed the level of testosterone significantly Results of the present study clearly suggest that malathion induce toxic effects on the male reproductive system of rats.     

Bacterial and archaeal diversity in oil fields and reservoirs and their potential role in hydrocarbon recovery and bioprospecting

Environmental Science and Pollution Research - Hydrocarbon is a primary source of energy in the current urbanized society. Considering the increasing demand, worldwide oil productions are declining...