中国集成电路制造行业VOCs排放特征及控制对策

中国电子信息产业发展迅速,集成电路等电子器件产量不断增加.在集成电路制造的过程中,大量有机溶剂的使用导致VOCs的产生和排放,从而对大气环境造成影响.为掌握集成电路制造行业VOCs的排放特征,系统分析了其工艺流程和产排污环节,分析了行业废气收集和治理现状,通过对典型企业VOCs的排放监测,获得VOCs排放水平;采用排放因子法核算行业VOCs历史排放量,并基于行业排放特征及减排潜力分析,提出了相应的污染防治对策.结果表明：在集成电路制造中,VOCs排放环节主要集中在光刻、清洗、去胶等过程,1 m²集成电路产量约使用87 g有机溶剂,VOCs产生量较大;通过采取高效的VOCs治理技术,集成电路制造行业有组织排放水平较低,平均浓度为2.1 mg·m^-3,但厂界无组织排放浓度相对较高,平均浓度为0.78 mg·m^-3,接近国家标准的排放限值.根据排放量核算结果,2011—2016年中国集成电路制造行业VOCs排放量呈逐年上升的趋势,主要受产量增加而相应污染控制技术水平提升有限的影响,无组织排放量比重大,占排放总量的38.1%~45.1%.     

控制系统在污水处理中的应用

介绍了污水控制系统的工艺流程、系统配置和软件设计，并对由PLC和上位机组成的自动控制系统的主要功能进行了说明。上位机通过组态软件设计承担监控和管理任务，下位机通过编程软件实现实时数据采集和自动控制功能。     

啤酒废水处理站的工程设计

本项目以哈尔滨啤酒(沈阳)有限公司啤酒厂为设计对象,其啤酒废水处理规模为1500m3/d,进水CODCr2000~2800mg/L。采用预处理-预酸化-IC反应器-活性污泥法-过滤为主体工艺,出水达到《辽宁省污水与废气排放标准》(DB21-60-89中一级标准)。为啤酒行业废水综合治理提供了较好的工艺途径。     

Quantitative structure activity relationships for carp kidney ATPase endpoint

ＩｎｔｒｏｄｕｃｔｉｏｎＭｏｓｔｏｆｎｉｔｒｏａｒｏｍａｔｉｃｓａｒｅｉｍｐｏｒｔａｎｔｅｎｖｉｒｏｎｍｅｎｔａｌｐｏｌｌｕｔａｎｔｓ.ＴｈｅｃａｒｐｉｓｔｈｅｍａｊｏｒｅｃｏｎｏｍｉｃｆｉｓｈｉｎＣｈｉｎａａｎｄｉｓｏｎｅｏｆｔｈｅｆｉｖｅｓｔａｎ?..     

富Ca^2＋柠檬酸废水的处理

采用近三年废水处理厂的实际运行数据，分析了Ca^2 对厌氧和好氧的影响。在选用的工艺中，IC塔能适应高Ca^2 废水，不论是厌氧还是氧，Ca^2 对COD的去除都无影响。     

两种方法监测近岸大气NOX浓度的比较

分别用常规法和离子色谱法对近岸海域大气ＮＯＸ 进行同步监测，并对两方法间的相关性和测定结果的换算进行了研究。结果表明： 两者呈极显著的正相关，相关系数达０－８３５（ｎ＝ ９） ，其测定结果是可换算的。为此，建立了采用离子色谱法测定气溶胶ＮＯ－３ 浓度预测近岸大气ＮＯＸ 浓度的方法。     

Pyrolysis technologies for municipal solid waste: A review

Pyrolysis has been examined as an attractive alternative to incineration for municipal solid waste (MSW) disposal that allows energy and resource recovery; however, it has seldom been applied independently with the output of pyrolysis products as end products. This review addresses the state-of-the-art of MSW pyrolysis in regards to its technologies and reactors, products and environmental impacts. In this review, first, the influence of important operating parameters such as final temperature, heating rate (HR) and residence time in the reaction zone on the pyrolysis behaviours and products is reviewed; then the pyrolysis technologies and reactors adopted in literatures and scale-up plants are evaluated. Third, the yields and main properties of the pyrolytic products from individual MSW components, refuse-derived fuel (RDF) made from MSW, and MSW are summarised. In the fourth section, in addition to emissions from pyrolysis processes, such as HCl, SO₂ and NH₃, contaminants in the products, including PCDD/F and heavy metals, are also reviewed, and available measures for improving the environmental impacts of pyrolysis are surveyed. It can be concluded that the single pyrolysis process is an effective waste-to-energy convertor but is not a guaranteed clean solution for MSW disposal. Based on this information, the prospects of applying pyrolysis technologies to dealing with MSW are evaluated and suggested.     

SBR法处理低C/N污水的工程应用——以某基地污水处理站改造工程为例

低C/N污水的生化处理过程中,由于碳源不足,不能满足硝化和反硝化的要求,造成出水NH3-N超标。采用SBR工艺对某基地污水处理站厌氧处理后的低C/N污水进行改造,处理后出水COD去除率达到97%以上,NH3-N去除率达到93%以上。     

IC反应器处理MTO废水的中试研究

中试研究了内循环(IC)反应器处理甲醇制烯烃(MTO)废水的启动和运行过程,同时考察了颗粒污泥的性状及沼气产量的变化情况。试验过程运行稳定,系统抗冲击性强。以絮状污泥为接种污泥,经过131 d的启动和运行,IC反应器的COD去除负荷可达10 kg/(m~3·d)以上,COD去除率可达90%以上。IC反应器中的成熟颗粒污泥形状规则、密实、粒径大、沉降速率快。IC反应器的沼气产量符合理论预期。     

Comparison of criteria for prediction of runaway reactions in the sulphuric acid catalyzed esterification of acetic anhydride and methanol

Loss of temperature control is one of the major reasons that can lead to runaway reaction. This occurrence is commonly named thermal runway. The aim of this paper is the application of thermal runaway criteria in order to predict the onset of runaway phenomena and define the range of stability related to operating conditions in the reactor, with specific reference to the esterification of acetic anhydride and methanol catalysed by sulphuric acid tested in isoperibolic conditions. The isoperibolic calorimeter has also been used to obtain thermodynamic, kinetic and physical chemistry data necessary to develop a model for the reaction. Some runaway criteria applied in this work require a model for the process, so a model for the analyzed system been developed.Because of the modest reaction enthalpy and low activation energy this reacting system provide a severe test to the runaway criteria.In this work, various runaway criteria have been applied to the experimental and simulated data and the results obtained have been compared.