珠江口沉积物中生物有效性硅的赋存形态及释放研究

运用A Tessier逐步化学连续提取法,研究了珠江口沉积物中各种生物有效性硅:Ⅰ-可交换离子态、Ⅱ-碳酸盐结合态、Ⅲ-铁锰氧化物结合态、Ⅳ-有机质和硫化物结合态.研究表明:表层沉积物中,Ⅲ为优势赋存态.在沉积柱C2中,Ⅲ＞Ⅳ＞Ⅱ＞Ⅰ,Ⅰ、Ⅱ随深度变化无规律性,Ⅲ随深度先升高后下降,Ⅳ表层含量较高,到达一定深度(18 cm左右)后骤降.释放试验表明:振荡在一定时间内有利于硅释放;而盐度对硅释放的影响比较复杂,低盐度(5%以内),随盐度升高,释放量下降.当盐度继续升高时释放量又增加,但高盐度对硅释放影响不大;硅的释放在pH值=3～8范围内随着pH值升高而减少.     

Stabilization of heavy metals in MSWI fly ash using silica fume

The objective of this work was to investigate the feasibility and effectiveness of silica fume on stabilizing heavy metals in municipal solid waste incineration (MSWI) fly ash. In addition to compressive strength measurements, hydrated pastes were characterized by X-ray diffraction (XRD), thermal-analyses (DTA/TG), and MAS NMR (²⁷Al and ²⁹Si) techniques. It was found that silica fume additions could effectively reduce the leaching of toxic heavy metals. At the addition of 20% silica fume, leaching concentrations for Cu, Pb and Zn of the hydrated paste cured for 7 days decreased from 0.32 mg/L to 0.05 mg/L, 40.99 mg/L to 4.40 mg/L, and 6.96 mg/L to 0.21 mg/L compared with the MSWI fly ash. After curing for 135 days, Cd and Pb in the leachates were not detected, while Cu and Zn concentrations decreased to 0.02 mg/L and 0.03 mg/L. The speciation of Pb and Cd by the modified version of the European Community Bureau of Reference (BCR) extractions showed that these metals converted into more stable state in hydrated pastes of MSWI fly ash in the presence of silica fume. Although exchangeable and weak-acid soluble fractions of Cu and Zn increased with hydration time, silica fume addition of 10% can satisfy the requirement of detoxification for heavy metals investigated in terms of the identification standard of hazardous waste of China.     

Mapping of tritium emissions using absorption vapour samplers

Püspökszilágy Radioactive Waste Treatment and Disposal Facility (RWTDF) is a typical near-surface engineered repository designated to store low- and intermediate-level wastes from various institutes, research facilities and hospitals in Hungary. Two automatic combined ¹⁴C–tritium sampling units installed at the facility sample the air 2 m above surface. The one installed near the vaults detects tritium (T) activities two orders of magnitude higher than the far reference sampling unit. To localize the T emissions, 19 small absorption vapour samplers filled with silica gel were settled onto the ground surface. After the saturation of the silica gel, the water was recovered and its T concentration was measured with a low-background liquid scintillation counter. The absorption vapour samplers are cheap, simple and easy-to-use. We present the samplers and the T distribution map constructed from the data, which helps to localize the T emission.     

Potential concerns related to using octadecyltrichlorosilane (OTS) in rendering soils and porous ceramics hydrophobic

The treatment of hydrophilic porous ceramics to render them hydrophobic and wetting to non-aqueous phase liquids (NAPLs) is frequently needed in multiphase flow experiments to control the flow or to measure the pressure of the NAPL. In addition, research dealing with soil wettability implies a need for hydrophobic or NAPL-wet soils. The traditional procedure, which has been widely used in literature, to render hydrophilic porous ceramics and soils hydrophobic is achieved by placing the hydrophilic solid in a 5% (by volume) octadecyltrichlorosilane (OTS) solution in ethanol followed by rinsing in ethanol. This research assesses the use of this procedure as it was found that this treatment procedure resulted in excess OTS on the surface of treated hydrophobic solids which can dissolve in an organic phase and in turn alter the wettability condition of adjacent hydrophilic soils. A modified procedure, which results in hydrophobic solids free of excess OTS, is presented.     

Laboratory investigation of Waelz slag stabilization

Electric Arc Furnace dusts are considered hazardous waste due to their high heavy metals content (zinc, lead, etc.). The Waelz process is one of the most efficient technologies, in terms of capacity and quality, able to recover nearly the 90% of zinc contained in such EAF dusts. Unfortunately, the resulting slag still has eco-compatibility problems, although its mechanical and chemical properties are suitable for civil engineering applications. Stabilization tests, by quartz addition, were performed on EAF dusts in a laboratory furnace. Temperature, treatment time and cooling rate were varied in order to define the best conditions for regulating the formation of a stable microstructure able to hinder the release of substances. Microstructural characterization was carried-out using SEM and XRD analysis. Leaching tests were performed according to EN 12457-2 standards and water analyses were performed using ICP-OES. The best chemical stability was achieved when dust powders were mixed with 20% of silica and water-cooled.     

Cesium migration in saturated silica sand and Hanford sediments as impacted by ionic strength

Large amounts of 137Cs have been accidentally released to the subsurface from the Hanford nuclear site in the state of Washington, USA. The cesium-containing liquids varied in ionic strengths, and often had high electrolyte contents, mainly in the form of NaNO3 and NaOH, reaching concentrations up to several moles per liter. In this study, we investigated the effect of ionic strengths on Cs migration through two types of porous media: silica sand and Hanford sediments. Cesium sorption and transport was studied in 1, 10, 100, and 1000 mM NaCl electrolyte solutions at pH 10. Sorption isotherms were constructed from batch equilibrium experiments and the batch-derived sorption parameters were compared with column breakthrough curves. Column transport experiments were analyzed with a two-site equilibrium-nonequilibrium model. Cesium sorption to the silica sand in batch experiments showed a linear sorption isotherm for all ionic strengths, which matched well with the results from the column experiments at 100 and 1000 mM ionic strength; however, the column experiments at 1 and 10 mM ionic strength indicated a nonlinear sorption behavior of Cs to the silica sand. Transport through silica sand occurred under one-site sorption and equilibrium conditions. Cesium sorption to Hanford sediments in both batch and column experiments was best described with a nonlinear Freundlich isotherm. The column experiments indicated that Cs transport in Hanford sediments occurred under two-site equilibrium and nonequilibrium sorption. The effect of ionic strength on Cs transport was much more pronounced in Hanford sediments than in silica sands. Effective retardation factors of Cs during transport through Hanford sediments were reduced by a factor of 10 when the ionic strength increased from 100 to 1000 mM; for silica sand, the effective retardation was reduced by a factor of 10 when ionic strength increased from 1 to 1000 mM. A two order of magnitude change in ionic strength was needed in the silica sand to observe the same change in Cs retardation as in Hanford sediments.     

介孔硅材料及化学改性在水处理中的应用

随着人们对水环境污染严重性的高度关注,人们越来越重视良好吸附材料的开发。活性炭是一种最有效的吸附剂,拥有较大比表面积,但再生过程中有大量的损失,因此人们开始开发新的可循环使用的无机吸附材料。本文介绍了三种介孔硅吸附材料的合成方法,以及介孔硅吸附材料的化学改性应用,并且提出对吸附材料应用前景的建议。     

Neutralization of interleukin-11 attenuates silica particles-induced pulmonary inflammation and fibrosis in vivo

Environmental exposure to crystalline silica particles can lead to silicosis, which is one of the most serious pulmonary interstitial fibrosis around the world. Unfortunately, the exact mechanism on silicosis is unclear, and the effective treatments are lacking to date. In this study, we aim to explore the molecular mechanism by which interleukin-11 (IL-11) affects silica particles-induced lung inflammation and fibrosis. We observed that IL-11 expressions in mouse lungs were significantly increased after silica exposure, and maintained at high levels across both inflammation and fibrosis phase. Immunofluorescent dual staining further revealed that the overexpression of IL-11 mainly located in mouse lung epithelial cells and fibroblasts. Using neutralizing anti-IL-11 antibody could effectively alleviate the overexpression of pro-inflammatory cytokines (i.e., interleukin-6 and tumor necrosis factor-α) and fibrotic proteins (i.e., collagen type I and matrix metalloproteinase-2) induced by silica particles. Most importantly, the expressions of IL-11 receptor subunit α (IL-11Rα), Glycoprotein 130 (GP130), and phosphorylated extracellular signal-regulated kinase (p-ERK) were significantly increased in response to silica, whereas blocking of IL-11 markedly reduced their levels. All findings suggested that the overexpression of IL-11 was involved in the pathological of silicosis, while neutralizing IL-11 antibody could effectively alleviate the silica-induced lung inflammation and fibrosis by inhibiting the IL-11Rα/GP130/ERK signaling pathway. IL-11 might be a promising therapeutic target for lung inflammation and fibrosis caused by silica particles exposure.     

空气中联苯——联苯醚的气相色谱法测定

以国产硅胶担体为固体吸附剂,采集空气中联苯-联苯醚。经热解吸、制冷、闪蒸后,用气相色谱法测定。实验结果,在常温下,国产硅胶对联苯-联苯醚的吸附率达100％;解吸回收率为97.5％:变异系数<5％;方法的检测限为0.4μg。