镍渣制备建筑用微晶玻璃的初步研究

对从镍渣中提取铁同时制备建筑用微晶玻璃的进行了研究.结果表明,熔渣中铁的质量分数可以降到0.5%左右,满足制备微晶玻璃的要求.对微晶玻璃样品进行了显微镜、X射线衍射、扫描电镜分析.其主晶相是透辉石(CaO·MgO·2SiO2),晶体的形貌为短柱状,分布均匀.本文所介绍的制备工艺是可行的.     

Simultaneous photocatalytic treatment of Cr(VI), Ni(II) and SDBS in aqueous solutions: Evaluation of removal efficiency and energy consumption

Simultaneous photocatalytic reduction of poisonous Cr(VI) and Ni(II) ions, coupled with photocatalytic oxidation of sodium dodecyl benzene sulfonate (SDBS) were studied with a trace amount of commercial titania nanoparticles and by means of a direct-photo-irradiation reactor. The co-presence of metal ions and SDBS causes metal ions reduction as well as SDBS oxidation to enhance and energy efficiency to improve. XRD, XPS and FTIR analysis were used to characterize TiO₂ particles before and after usage with the aim of evaluating the mechanism of reactions. The effect of major operating parameters, pH and temperature, was investigated. Under conditions of [Cr(VI)]₀ = [Ni(II)]₀ = 5 mg/L, [SDBS]₀ = 10 mg/L, [TiO₂] = 40 mg/L, pH 6 and T = 35 °C; the removal efficiencies of 55.4%, 71.2% and 57.2% were obtained, respectively, for Cr(VI) and Ni(II) reduction, as well as for SDBS oxidation, after 110 min operation. The relevant kinetic model jointed with the Arrhenius equation was introduced. Pseudo-first-order reactions are relevant. Energy consumption (electrical and thermal) evaluations revealed that operations at higher temperatures provide significant cost reduction. Meantime, a criterion was proposed for a consistent assessment of this kind of processes.     

中和共沉淀—铁氧体法处理含镍、铬废水的实验研究

利用中和共沉淀—铁氧体法处理甘肃某稀有金属生产企业产生的含镍、铬废水,同时对该废水的处理工艺条件进行了实验研究。经测定,废水中Ni 2+质量浓度为50mg/L,Cr(Ⅲ)质量浓度为87mg/L。通过实验得到处理工艺的最佳条件:投料摩尔比(Fe2+/(Ni 2++Cr2O2-7))为9,pH=9,温度为70℃。出水中镍、铬均可达到《污水综合排放标准》(GB 8978—1996)中第一类污染物最高允许排放浓度的要求,为中和共沉淀—铁氧体法处理混合重金属废水的工艺条件研究提供了参考。     

磁性生物炭负载Mg-Fe水滑石的制备及其吸附水中Cd（Ⅱ）和Ni（Ⅱ）的性能

合成了一种高吸附容量的磁性生物炭负载Mg-Fe水滑石复合材料（L-BC）,并用于去除水中的Cd²⁺和Ni²⁺。表征结果表明,采用浸渍联合热解法成功制备了磁性生物炭（M-BC）,水热合成法成功地将Mg-Fe水滑石负载在M-BC上。动力学研究结果表明,Cd²⁺和Ni²⁺吸附符合伪二级动力学模型,化学吸附为速率控制步骤。等温吸附研究结果表明,L-BC对Cd²⁺和Ni²⁺的吸附符合Langmuir模型,为单分子层化学吸附,最大吸附量分别为263.156 mg/g和43.291 mg/g。吸附机理主要为Mg-Fe水滑石层间CO₃^2-和表面羟基与Cd²⁺和Ni²⁺产生表面共沉淀。L-BC具有良好的吸附和重复利用性能,是一种很有前景的去除Cd²⁺和Ni²⁺的吸附材料。     

镍渣的重金属浸出特性

在分析镍渣的矿物相组成和重金属元素含量的基础上,鉴定了镍渣样品的浸出毒性,并考察了pH、液固比和浸出时间等条件对镍渣样中铬、铅、铜和锌等重金属浸出特性的影响。结果表明,镍渣中的重金属总量约为渣样的0.9%,且铬、铜和锌的含量较高,需进行安全管理。实验所用镍渣样品为第Ⅰ类一般工业固体废物。在强酸条件下镍渣中重金属浸出浓度较大,pH3后浸出浓度显著降低;液固比40 L/kg时,镍渣中重金属不断溶出,液固比40 L/kg后,浸出达到饱和,浸出浓度趋于平衡;随着浸出时间的增加,重金属离子的浸出浓度先增加后减少,但由于各重金属性质不同,各重金属达到最大浸出浓度的时间不同。     

膜电解法退镀废ABS电镀件及回收铜和镍

采用膜电解法对废丙烯腈-丁二烯-苯乙烯（ABS）电镀件进行退镀处理。以退镀废液作为阴极液和阳极液，在阳极室退镀ABS电镀件，在阴极室电解退镀废液，进行铜镍分离，回收铜粉和NiCl₂。实验结果表明：在阴极电流密度为500 A/m²、初始铜离子质量浓度为24.00 g/L的条件下电解160 min，阴极铜回收率可达97.65%，电流效率达86.60%，得到的铜粉纯度为97%~99%，处理1 L退镀废液可回收铜粉20.0 g，2 mol/L盐酸0.87 L，NiCl₂晶体43.8 g;在阳极电流密度为500 A/m²、液固比为6的条件下电解60 min， ABS电镀件的退镀率为77.22%。     

Ti/SnO_2-Sb阳极-空气阴极电催化降解染料废水

为解决电化学法处理高盐染料废水存在的能耗大、成本高等问题,分别采用溶胶-凝胶法和辊压法制备Ti/SnO_2-Sb阳极和空气阴极,构建了Ti/SnO_2-Sb阳极-空气阴极双极体系(TSSA-ADC)。甲基橙(MO)作为高盐染料废水的典型污染物,考察了电流强度、MO浓度、电解液浓度和初始p H对TSSA-ADC体系和TSSA单阳极体系降解MO的影响。结果表明:与TSSA单阳极体系相比,TSSA-ADC体系具有更好的抗有机负荷冲击、抗盐分冲击、抗酸碱波动能力,能够维护酸碱平衡防止硬度离子结垢。最佳反应条件为电流强度为0.030 A,电解液浓度为3%,MO浓度为100 mg/L,初始pH=6。以MO去除率达到98%为基准,TSSA-ADC体系比TSSA体系可节能74.26%。     

NiO-CuO/ZSM-5催化剂对催化裂化烟气的脱硫脱硝性能

采用浸渍法制备了不同NiO和CuO质量分数的NiO-CuO/ZSM-5催化剂，并以CH4为还原剂研究了NiO-CuO/ZSM-5催化剂对催化裂化烟气的脱硫脱硝活性。XRD分析结果表明，NiO质量分数为4%、CuO质量分数为6%的催化剂4%NiO-6%CuO/ZSM-5中的ZSM-5结构完好，CuO和NiO高度分散在ZSM-5骨架中，表明具有较好的催化活性。4%NiO-6%CuO/ZSM-5的脱硫脱硝起活温度均较低，无氧条件下最高NO转化率和SO2转化率分别为94.7%和95.9%，O2体积分数为1.0%时的NO转化率和SO2转化率分别为97.7%和89.0%。     

Enhancement of UV and chromate mutagenesis by nickel ions in the Chinese hamster HGPRT Assay †

1. The HGPRT (Hypoxanthine‐Guanine‐Phospho‐Ribosyl‐Transferase) assay with Chinese Hamster V79 cells was used to measure the mutagenic effects of UV irradiation, potassium dichromate and nickel chloride. The agents were tested separately and in the combinations of UV plus nickel and dichromate plus nickel.

2. UV, Cr(VI) and Ni(II) were confirmed to be mutagenic in the V79 cell assay. The combination of UV(5J/m²) and Ni(II) (0.5 mM) caused a mutation rate 11.2 times above that corresponding to the sum of the individual mutation rates of these agents. The combined action of Cr(VI) (0.1 mM) and Ni(II) (0.5 mM) produced a mutation rate 2.8 fold above that corresponding to the sum of the individual rates of the separate agents.

3. The enhancing effect of nickel chloride on the mutagenicity of UV or Cr(VI) is interpreted by an interference of Ni(II) with the repair of DNA lesions.     

电解法处理含镍废水及纯镍的回收

采用电解回收法处理Ni2+含量为2g/L的废水,在阴极回收纯镍。研究了电解电流、极距、NH4Cl浓度、pH值等因素对Ni2+去除率、槽压、阴极能耗的影响,得出最优工艺参数为:温度20℃,电解时间20min时、电解电流300mA,极距15mm,NH4Cl浓度5g/L,pH值8.0,该条件下Ni2+去除率为96.926%,槽压16.21V,阴极能耗22.418kW.h/kg,在阴极可得到沉积6.45μm厚的镍板。