Simultaneous removal of cyanobacterial blooms and production of clean water by coupling flocculation with a rotary drum filter

Environmental Science and Pollution Research - A mechanical harvesting technology based on coupling flocculation with a rotary drum filter (RDF, 35-μm) was applied to remove cyanobacterial...     

A combined radical and non-radical oxidation processes for efficient degradation of Acid Orange 7 in the homogeneous Cu(II)/PMS system: important role of chloride

Environmental Science and Pollution Research - Trace copper ion (Cu(II)) in water and wastewater can trigger peroxymonosulfate (PMS) activation to oxidize organic compounds, but it only works under...     

Research progress and hot spots of hydrothermal liquefaction for bio-oil production based on bibliometric analysis

Environmental Science and Pollution Research - Hydrothermal liquefaction (HTL) of biomass used HTL reaction under high temperature and pressure to produce bio-oil. This technology is considered as...     

Coincidence and Upgrade： A Typical Case Study of Rural Ecotourism Development

At present, internal rural tourism is at the stage of upgrading and renewing, and ecotourism has been considered to be the main direction. This paper discussed the concepts and criteria of rural tourism and ecotourism, analyzed a typical case of Nongke Village of Chengdu City-being considered to be the first rural tourism site in China, went deep into the problems of the contents and criteria of the development of rural ecotourism, and tried to probe into the principles of the development of rural ecotourism both theoretically and practically so as to understand the rules of the development of rural ecotourism .     

金属加工过程中应力状态的分析方法

分析简单地拉伸、压缩和扭转的情况时,应力状态能容易地被确定.但是,实际上在金属加工过程中材料是承受复杂的应力状态,在模具——工件接触面上增加有摩擦力.而且,这些应力和摩擦力一般地沿着接触面变化.准确的计算或预测载荷、力、应力和温度,不但对设计适宜的设备是重要的,而且对研究工艺期间材料的变化过程也是重要的.本文将讨论材料变形过程中所运用的主要分析方法及其优缺点.     

硫化亚铁处理含砷废水中砷的形态变化

本文对用硫化亚铁处理含砷废水时，在气相、液相和固相中砷的形态进行了研究结果表明，在气相中无ＡａＨ３，但在Ａｓ（Ｖ）废水的液相中有Ａｓ（Ｖ）和Ａｓ（Ⅲ）共同存在，在固相中有Ａｓ（０），ＦｅＡｓＯ４（ＦｅＡｓＯ３），Ａｓ２Ｓ３（Ａｓ２Ｓ５）和吸附砷，砷的形态变化表明，硫化亚铁处理含砷废水能取得良好的效果，是沉淀、沉淀转化、氧化还原、吸附共沉淀和中和五种反应共同作用的结果。     

Study on the regional atomized dust suppression technological system based on the measured law of dust concentration distribution in longwall fully mechanized mining faces

Environment, Development and Sustainability - In order to reveal the distribution and migration law of downwind and upwind coal cutting, total dust (TD) and respirable dust (RD) concentration...     

供水管网生物膜有机物的二氯乙腈与二氯乙酰胺生成特性

在饮用水输配系统中,来源于管壁生物膜的有机物可能耗氯并生成消毒副产物(DBPs),包括二氯乙腈(DCAN)与二氯乙酰胺(DCAcAm)等高毒性含氮DBPs(N-DBPs).研究考察管网常见的细菌与其胞外聚合物(EPS)以及模拟管壁生物膜氯化与氯胺化后DCAN与DCAcAm的生成,并与天然有机物(NOM)和水源水有机物进行比较.结果显示,铜绿假单胞菌、恶臭假单胞菌与藤黄微球菌与氯反应生成的DCAN、DCAcAm浓度分别为1.48～2.02、0.21～0.38μg·mg~(-1)(mg~(-1)以TOC计),高于同反应条件下NOM的生成量;相比于氯化反应,3株细菌细胞氯胺化生成的DCAN与DCAcAm浓度明显更低.3株菌的EPS也是氯与氯胺化反应生成DCAN与DCAcAm的前体物,且其氯胺化反应生成的DCAcAm浓度高于氯化反应生成的.与NOM、水源水相比,模拟管壁生物膜氯化后生成的N-DBPs与三氯甲烷(TCM)浓度比更高,表明生物膜有机物比NOM与水源水有机物更倾向生成DCAN与DCAcAm类N-DBPs,且模拟管壁生物膜氯胺化的DCAcAm生成量高于氯化反应的,说明管壁生物膜有机物是供水管网系统中DCAN与DCAcAm类N-DBPs的重要前体物.     

基于两种再分析资料的一次四川盆地大气污染过程气象要素数值模拟研究

利用ECMWF-ERA5和NCEP-FNL再分析资料作为中尺度气象模式WRF（The Weather Research and Forecasting）初始场,对四川盆地2018年1月一次大气污染过程气象要素进行了模拟,对比分析了气温、风速、风向、相对湿度、边界层高度、温廓线的模拟效果,并结合大气超级站观测数据对模拟结果进行评估.结果表明：两种资料均能较好地模拟出气象要素的变化情况,但由于两套资料时空分辨率、采用的模式、同化方案、数据来源和质量控制方案存在一定区别,导致各要素模拟效果并不一致.与NCEP-FNL相比,ECMWF-ERA5模拟的平均相对湿度（59.23%）与观测值差异更小,且均方根误差、偏差较小,分别为9.83%和-0.83%,但NCEP-FNL模拟的平均气温（8.99℃）更接近观测值,且偏差值较小,为-0.04℃.两组模拟结果均显示盆地内部为模拟区域的低风速区,相对湿度模拟值在60%以上,气温高于西部山地地区.NCEP-FNL模拟的盆地内部气温、相对湿度、风速小于ECMWF-ERA5模拟值,但边界层高度模拟值较大.ECMWF-ERA5模拟的逆温强度相比较小,且温度露点差较小.此次污染过程PM_2.5和PM₁₀日均浓度最大值分别为190.1 μg·m^-3和261.0 μg·m^-3,相对湿度增大引发的颗粒物吸湿增长是导致PM_2.5和PM₁₀质量浓度突增的主要原因.